Search NASA⌕ Search

SEARCH · Search NASA

Results for “Solar Analysis”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44

Stress Analysis and Design of Silicon Solar Cell Arrays and Related Material Properties

A systematic approach is presented for the design of solar cell arrays to eliminate mechanical failures that might arise in components of the arrays in a thermal environment. A prerequisite to the approach is the characterization of material properties at different temperatures. Significant data is obtained for the thermal behavior of the silicon solar cell material and adhesives. Upon determining the mechanical and thermal material properties of the components of the solar cell array, utilizing a finite element idealization for predicting the stress fields in the components, and employing the von Mises failure criterion, potential failure areas in various design configurations in a given thermal environment are identified. Guide lines and means to optimize a given design are illustrated by two examples.

Salama, A. M.↗

X-radiation /E greater than 10 keV/, H-alpha and microwave emission during the impulsive phase of solar flares.

A study has been made of the variation in hard (E greater than 10 keV) X-radiation, H-alpha and microwave emission during the impulsive phase of solar flares. Analysis shows that the rise-time in the 20-30-keV X-ray spike depends on the electron hardness. The impulsive phase is also marked by an abrupt, very intense increase in H-alpha emission in one or more knots of the flare. Properties of these H-alpha kernels include: (1) a luminosity several times greater than the surrounding flare, (2) an intensity rise starting about 20-30 sec before, peaking about 20-25 sec after, and lasting about twice as long as the hard spike, (3) a location lower in the chromosphere than the remaining flare, (4) essentially no expansion prior to the hard spike, and (5) a position within 6000 km of the boundary separating polarities, usually forming on both sides of the neutral line near both feet of the same tube of force. Correspondingly, impulsive microwave events are characterized by: (1) great similarity in burst structure with 20-32 keV X-rays but only above 5000 MHz, (2) typical low frequency burst cutoff between 1400-3800 MHz, and (3) maximum emission above 7500 MHz.

Vorpahl, J. A.↗

Operations analysis (study 2.1). Program SEPSIM (solar electric propulsion stage simulation)

Program SEPSIM is a FORTRAN program which performs deployment, servicing, and retrieval missions to synchronous equatorial orbit using a space tug with a continuous low thrust upper stage known as a solar electric propulsion stage (SEPS). The SEPS ferries payloads back and forth between an intermediate orbit and synchronous orbit, and performs the necessary servicing maneuvers in synchronous orbit. The tug carries payloads between the orbiter and the intermediate orbit, deploys fully fueled SEPS vehicles, and retrieves exhausted SEPS vehicles when, and if, required. The program is presently contained in subroutine form in the Logistical On-orbit VEhicle Servicing (LOVES) Program, but can also be run independently with the addition of a simple driver program.

Lang, T. J.↗

Outdoor flat-plate collector performance prediction from solar simulator test data

Solar collector performance data obtained from tests with a simulator was modified for real-life conditions. The data obtained with the simulator was corrected for the variable conditions of ambient temperature, wind, incident angle, flow rate, etc., that are encountered outdoors. Modification of simulator data was accomplished by combining experiment with theory. The technique was demonstrated by application to a spectrally selective and a nonselective type of collector. This kind of modified simulator collector performance data should be valuable in solar systems analysis and for collector performance ranking based on all-day calculated conditions.

Simon, F. F.↗

Reformulation of the relativistic conversion between coordinate time and atomic time

The relativistic conversion between coordinate time and atomic time is reformulated to allow simpler time calculations relating analysis in solar system barycentric coordinates (using coordinate time) with earth-fixed observations (measuring 'earth-bound' proper time or atomic time). After an interpretation in terms of relatively well-known concepts, this simplified formulation, which has a rate accuracy of about 10 to the minus 15th, is used to explain the conventions required in the synchronization of a worldwide clock network and to analyze two synchronization techniques - portable clocks and radio interferometry. Finally, pertinent experimental tests of relativity are briefly discussed in terms of the reformulated time conversion.

Thomas, J. B.↗

SESOP: Program for solar-energy heating-systems analysis

Space heating and cooling loads are calculated for each building based on outside environment, desired inside conditions, building construction and geometry, domestic power usage, occupancy rate, and occupant metabolic rate. Loads are summed to determine requirements of central and alternative utility systems.

Source record↗

The Surface Chemical Composition of Lunar Samples and Its Significance for Optical Properties

The surface iron, titanium, calcium, and silicon concentration in numerous lunar soil and rock samples was determined by Auger electron spectroscopy. All soil samples show a large increase in the iron to oxygen ratio compared with samples of pulverized rock or with results of the bulk chemical analysis. A solar wind simulation experiment using 2 keV energy alpha -particles showed that an ion dose corresponding to approximately 30,000 years of solar wind increased the iron concentration on the surface of the pulverized Apollo 14 rock sample 14310 to the concentration measured in the Apollo 14 soil sample 14163, and the albedo of the pulverized rock decreased from 0.36 to 0.07. The low albedo of the lunar soil is related to the iron + titanium concentration on its surface. A solar wind sputter reduction mechanism is discussed as a possible cause for both the surface chemical and optical properties of the soil.

Gold, T.↗

Analysis of GaAs and Si solar energy hybrid systems

Various silicon hybrid systems are modeled and compared with a gallium arsenide hybrid system. The hybrid systems modeled produce electric power and also thermal power which can be used for heating or air conditioning. Various performance indices are defined and used to compare the system performance: capital cost per electric power out; capital cost per total power out; capital cost per electric power plus mechanical power; annual cost per annual electric energy; and annual cost per annual electric energy plus annual mechanical work. These performance indices indicate that concentrator hybrid systems can be cost effective when compared with present day energy costs.

Heinbockel, J. H.↗

Prototype residential solar-energy system-engineering analysis

Tests indicate performance very close to theoretical predictions. Major objectives were to verify system installation techniques, operation, and performance; to verify performance of individual subsystems; and to provide general test data base comparison with field data.

Source record↗

Solar Cell High Efficiency and Radiation Damage

Silicon solar cell analysis and fundamental measurements, silicon cell technology, gallium arsenide research and technology, and radiation effects on silicon and gallium arsenide cells, are reported.

Source record↗

A probabilistic model of insolation for the Mojave Desert area

A discussion of mathematical models of insolation characteristics suitable for use in analysis of solar energy systems is presented and shows why such models are essential for solar energy system design. A model of solar radiation for the Mojave Desert area is presented with probabilistic and deterministic components which reflect the occurrence and density of clouds and haze, and mimic their effects on both direct and indirect radiation. Multiple comparisons were made between measured total energy received per day and the corresponding simulated totals. The simulated totals were all within 11 percent of the measured total. The conclusion is that a useful probabilistic model of solar radiation for the Goldstone, California, area of the Mojave Desert has been constructed.

Hester, O. V.↗

Ground tracking system phase fluctuation spectra

Spectral analysis of solar wind plasma fluctuation requires knowledge of the average ground tracking system phase fluctuation spectrum. Typical ground tracking system phase fluctuation spectra are presented as deduced from two-way S-band Doppler noise measured at large Sun-Earth-Probe angles.

Berman, A. L.↗

Present obliquity oscillations of Mars - Fourth-order accuracy in orbital e and I

A long period analysis of solar system orbital evolution, correct to fourth order in orbital eccentricities and inclinations (Bretagnon, 1974), and an improved value of the planet's moment of inertia (Reasenberg, 1977) have been incorporated in a recalculation of the obliquity oscillations of Mars. A linearized solution predicts a maximum oscillation amplitude of 13.6 deg centered on a long-term average value of 24.4 deg. A numerical integration of the obliquity for the past 10,000,000 years is also presented. Epochs of minimal oscillation like the present occur at intervals of the order of 4 m.y.

Ward, W. R.↗