Search NASA⌕ Search

SEARCH · Search NASA

Results for “program understanding”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44

A Small Warm Tributary Provides Prespawning Resources for Colorado Pikeminnow in a Cold Dam-Regulated River

Abstract Riverine habitat mosaics, including tributaries, are an important reason the Green River subbasin supports the largest remaining population of federally endangered Colorado Pikeminnow Ptychocheilus lucius in the Colorado River Basin. Upstream Colorado Pikeminnow distribution is limited by Flaming Gorge Dam and few typically occurred in the reach immediately downstream of the dam, which is the reach most affected by thermal and hydrologic alterations. However, fish captures and passive integrated transponder (PIT) antenna sampling of previously tagged individuals from 2011 to 2021 revealed seasonal congregations of up to 75 Colorado Pikeminnow annually in the mouth of Vermillion Creek, a small tributary in the regulated reach. Approximately 11% (N = 93 individuals) of the entire 2017–2018 Green River basin population were encountered in Vermillion Creek over the 11-y study, an underestimate of use considering that untagged fish were not detected by antennas. Colorado Pikeminnow used Vermillion Creek primarily when Green River spring flows from Flaming Gorge Dam were high and cold in May through mid-June when the confluence was a large, deep backwater warmer than the main channel and supported forage fishes. Intra-annual encounters revealed seasonal residence times for individual Colorado Pikeminnow up to 91 d, and multiple inter-annual encounters indicated site fidelity. Frequent detections of individual Colorado Pikeminnow in a Yampa River spawning area soon after their detections in Vermillion Creek indicate this tributary may be an important resource for reproductive adults. The intensive and basin-wide PIT tagging and detection program for Colorado Pikeminnow enhanced our understanding of the importance of small habitat nodes such as Vermillion Creek in the Green River drainage network. Understanding and protecting these seasonally available riverine habitat mosaics used for prespawning conditioning may assist with recovery of Colorado Pikeminnow.

Biodiversity & Conservation↗

Laboratory study of sonic booms and their scaling laws

This program undertook to seek a basic understanding of non-linear effects associated with caustics, through laboratory simulation experiments of sonic booms in a ballistic range and a coordinated theoretical study of scaling laws. Two cases of superbooms or enhanced sonic booms at caustics have been studied. The first case, referred to as acceleration superbooms, is related to the enhanced sonic booms generated during the acceleration maneuvers of supersonic aircrafts. The second case, referred to as refraction superbooms, involves the superbooms that are generated as a result of atmospheric refraction. Important theoretical and experimental results are briefly reported.

Toong, T. Y.↗

Investigation related to multispectral imaging systems

A summary of technical progress made during a five year research program directed toward the development of operational information systems based on multispectral sensing and the use of these systems in earth-resource survey applications is presented. Efforts were undertaken during this program to: (1) improve the basic understanding of the many facets of multispectral remote sensing, (2) develop methods for improving the accuracy of information generated by remote sensing systems, (3) improve the efficiency of data processing and information extraction techniques to enhance the cost-effectiveness of remote sensing systems, (4) investigate additional problems having potential remote sensing solutions, and (5) apply the existing and developing technology for specific users and document and transfer that technology to the remote sensing community.

Nalepka, R. F.↗

Silicon germanium technology program at JPL

Review of the results of a program aimed at obtaining a better understanding of the long-term performance of a thermoelectric generator using silicon germanium. The results obtained concern the contact resistivity of the thermoelectric couples, the electrical resistance of the multifoil thermal insulation, and the application of resistance coatings to the unicouples in order to prevent the loss of output power due to internal shunting paths.

Stapfer, G.↗

NASA compendium of satellite communications programs

A comprehensive review is given of worldwide satellite communication programs that range in time from the inception of satellite communications to mid-1974. Particular emphasis is placed on program results, including experiments conducted, communications system operational performance, and technology employed. The background for understanding these results is established through brief summaries of the program organization, system configuration, and satellite and ground terminal characteristics. Major consideration is given to the communications system aspects of each program, but general spacecraft technology and other experiments conducted as part of the same program are mentioned summarily.

Source record↗

Dynamic modeling for evaluation of solar collector performance

Dynamic modeling is being developed to provide a tool for systematic analysis of performance characteristics in energy systems where time-dependent behavior is important. A dynamic model program designed to aid in the understanding of solar collector behavior over the full range of operating conditions was constructed and tested in the evaluation of a conceptual collector design.

Hamilton, C. L.↗

The NASA program on upper atmospheric research

The purpose of the NASA Upper Atmospheric Research Program is to develop a better understanding of the physical and chemical processes that occur in the earth's upper atmosphere with emphasis on the stratosphere.

Source record↗

Management of optics

American Science and Engineering, Inc., designed the large X-ray optic for the HEAO-2 X-ray Telescope. The key element in this project was the High Resolution Mirror Assembly (HRMA), subcontracting the fabrication of the optical surfaces and their assembly and alignment. The roles and organization of the key participants in the creation of HRMA are defined, and the degree of interaction between the groups is described. Management of this effort was extremely complex because of the intricate weaving of responsibilities, and AS&E, as HEAO-2 Program managers, needed to be well versed in the scientific objectives, the technical requirements, the program requirements, and the subcontract management. Understanding these factors was essential for implementing both technical and management controls, such as schedule and budget constraints, in-process control, residence requirements, and scientist review and feedback. Despite unforeseen technical problems and interaction differences, the HEAO-2 was built on schedule and to specification.

Kirchner, T. E.↗

Assessment of Superflux relative to marine science and oceanography

A general assessment of the Superflux project is made in relation to marine science and oceanography. It is commented that the program clearly demonstrated the effectiveness of state-of-the-art technology required to study highly dynamic estuarine plumes, and the necessity of a broadly interdisciplinary, interactive remote sensing and shipboard program required to significantly advance the understanding of transport processes and impacts of estuarine outflows.

Esaias, W. E.↗

A program in global biology

NASA's Global Biology Research Program and its goals for greater understanding of planetary biological processes are discussed. Consideration is given to assessing major pathways and rates of exchange of elements such as carbon and nitrogen, extrapolating local rates of anaerobic activities, determining exchange rates of ocean nutrients, and developing models for the global cycles of carbon, nitrogen, sulfur, and phosphorus. Satellites and sensors operating today are covered: the Nimbus, NOAA, and Landsat series. Block diagrams of the software and hardware for a typical ground data processing and analysis system are provided. Samples of the surface cover data achieved with the Advanced Very High Resolution Radiometer, the Multispectral Scanner, and the Thematic Mapper are presented, as well as a productive capacity model for coastal wetlands. Finally, attention is given to future goals, their engineering requirements, and the necessary data analysis system.

Mooneyhan, D. W.↗

Science Applications, Part 2

The goals of the Geopotential Research Program are to contribute to the understanding of the solid earth; the origin and evolution of the earth; its internal structure and the dynamics of the core and the mantle; the movements and deformations of the tectonic plates that make up the surface of the earth; its rotational dynamics; the changes in the rotation rate of the earth; the orientation of the pole in space; variations of the gravity and magnetic field of the earth; the origin of the earth and the way in which the solid earth interacts with the oceans and the atmosphere.

Murphy, J. P.↗

Modelling direction solidification

The overall objective of this program is to develop an improved understanding of some phenomena of importance to directional solidification. The aim of this research is also to help predict differences in behavior between solidification on Earth and solidification in space. In this report, the validity of the Burton-Primslichter equation is explored. The influence of operating variables on grain and twin generation and propagation in single crystals of In sub (x) Ga sub (1-x) Sb is also investigated.

Wilcox, W. R.↗

Silicon sheet surface studies

Results of the program are presented on developing an understanding of the basic mechanisms of abrasion and wear of silicon and on the nondestructive measurement of residual stresses in sheet silicon. Experiments were conducted at various temperatures and in the presence of various fluids. In abrasive wear, it was shown that dislocations, microtwins, and cracks are generated beneath the contact surface. Residual stresses in ribbon by the edge defined film growth process were measured by use of a shadow moire interferometry technique.

Danyluk, S.↗

Development of optimized detector/spectrophotometer technology for low background space astronomy missions

This program was directed towards a better understanding of some of the important factors in the performance of infrared detector arrays at low background conditions appropriate for space astronomy. The arrays were manufactured by Aerojet Electrosystems Corporation, Azusa. Two arrays, both bismuth doped silicon, were investigated: an AMCID 32x32 Engineering mosiac Si:Bi accumulation mode charge injection device detector array and a metal oxide semiconductor/field effect transistor (MOS-FET) switched array of 16x32 pixels.

Jones, B.↗

Historical development

The history of the U.S. Microgravity Science and Applications program is summarized, noting significant discoveries in the first decade of the program. The experiments were performed to understand the behavior of liquid propellants (and other fluids), liquid melt zones, and containerless liquid suspension systems in microgravity. Investigations were carried out with a drop tower, on KC-135 and solid rocket flights, and during Apollo, Skylab and Apollo-Soyuz missions.

Naumann, R. J.↗

Research papers and publications (1981-1987): Workload research program

An annotated bibliography of the research reports written by participants in NASA's Workload Research Program since 1981 is presented, representing the results of theoretical and applied research conducted at Ames Research Center and at universities and industrial laboratories funded by the program. The major program elements included: 1) developing an understanding of the workload concept; 2) providing valid, reliable, and practical measures of workload; and 3) creating a computer model to predict workload. The goal is to provide workload-related design principles, measures, guidelines, and computational models. The research results are transferred to user groups by establishing close ties with manufacturers, civil and military operators of aerospace systems, and regulatory agencies; publishing scientific articles; participating in and sponsoring workshops and symposia; providing information, guidelines, and computer models; and contributing to the formulation of standards. In addition, the methods and theories developed have been applied to specific operational and design problems at the request of a number of industry and government agencies.

Hart, Sandra G.↗

An integrated CFD/experimental analysis of aerodynamic forces and moments

Aerodynamic analysis using computational fluid dynamics (CFD) is most fruitful when it is combined with a thorough program of wind tunnel testing. The understanding of aerodynamic phenomena is enhanced by the synergistic use of both analysis methods. A technique is described for an integrated approach to determining the forces and moments acting on a wind tunnel model by using a combination of experimentally measured pressures and CFD predictions. The CFD code used was FLO57 (an Euler solver) and the wind tunnel model was a heavily instrumented delta wing with 62.5 deg of leading-edge sweep. A thorough comparison of the CFD results and the experimental data is presented for surface pressure distributions and longitudinal forces and moments. The experimental pressures were also integrated over the surface of the model and the resulting forces and moments are compared to the CFD and wind tunnel results. The accurate determination of various drag increments via the combined use of the CFD and experimental pressures is presented in detail.

Melton, John E.↗