Search NASA⌕ Search

SEARCH · Search NASA

Results for “antenna arraying”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 811 records · Page 45

Far-infrared embedding impedance measurements

A technique which allows the measurement of detector embedding impedance has been developed. By using a bismuth microbolometer as a variable resistance load the impedance of one element in a bow-tie antenna array operating at 94 GHz was inferred. The technique is frequency insensitive, and could be used throughout the far-infrared.

Neikirk, D. P.↗

A note on the proposed UK VHF radar

The proposal for the establishment of a VHF radar in the UK is still under active consideration, although for financial reasons no start has yet been made on an installation. Several changes have been made to the scheme as described and these are listed. (1) The initial installation will be suitable for stratosphere-troposphere (ST) operation only using 64 antennas and 2 power modules. (2) An existing site is being examined on the west coast of Wales, which because it is a former Loran ground station is provided with the buildings, power and communications facilities to enable a radar to be assembled much more quickly than a green field site would allow. Because the site is not within a mountain valley as originally intended, careful early attention will have to be given to the possible problems of local interference and sea-surface returns. (3) Preliminary discussions with the UK licensing authorities suggest that a frequency of 47 MHz is more likely than 50 MHz. (4) Minor changes are planned in the antenna array connection scheme of the 400-element mesosphere-stratosphere-troposphere (MST) array to allow more precise sidelobe suppression to be achieved in the receive mode.

Hall, A. J.↗

Distributed synthetic aperture radar simulation

Synthetic aperture radar (SAR) depends primarily on attainable frequency resolution rather than on large physical size of the antenna array. The distributed architecture concept (DSAR) incorporates active elements (amplifiers) at or near the elemental radiators of the array. Since SAR's are expensive to build and expensive to test, a computer modeling approach is a feasible method of predicting the quality or nature of the SAR image from the proposed system parameters. The goal of this project is to produce a DSAR simulation software package. This report describes the progress made thus far and the work which remains to be done. Extensive work on this project had been done previously by two NASA contractors. The principal task remaining involved the creation of a suitable interface between these programs and the hardware and software available at the Johnson Space Center.

Bourgeois, B. A.↗

Remote sensing of the earth with spaceborne imaging radars

Recent scientific and technological developments are reviewed in the field of earth observation with spaceborne imaging radars. Such developments, beginning with Seasat in 1978 and continuing with the Space Shuttle in 1981 and 1984, were made possible by the use of new large spaceborne lightweight planar array antennas (2 x 10 m) with printed radiating elements. Transmitters were solid-state 1-kW peak power units operating at L-band (1.2 GHz). Images were obtained to monitor sea ice, soil moisture, and geologic, biologic and oceanographic features. Optical and digital processing was done to achieve high resolution (25 to 40 m). More advanced systems are under development, including multispectral, multipolarization imaging radar systems for flight in the late 1980s. An overview of planned activities in the 1980s is given.

Elachi, C.↗

Middle Atmosphere Program. Handbook for MAP, volume 20

Various topics related to investigations of the middle atmosphere are discussed. Numerical weather prediction, performance characteristics of weather profiling radars, determination of gravity wave and turbulence parameters, case studies of gravity-wave propagation, turbulence and diffusion due to gravity waves, the climatology of gravity waves, mesosphere-stratosphere-troposphere radar, antenna arrays, and data management techniques are among the topics discussed.

Bowhill, S. A.↗

Recent progress in the Urbana MST radar

The Urbana radar, which operates at 40.92 MHz with a peak power of about 1.2 MW into a 100 x 120 m phased array antenna was improved. An accelerated data-acquisition system, a beam-steering system, and a transmit/receive switch were installed. With these changes, the radar is in regular operations for two hours every day around local noon gathering stratospheric and mesospheric data. Special campaigns are mounted in addition under severe weather conditions.

Bowhill, S. A.↗

HISCAT: A proposed new scatter facility in Northern Scandinavia

It is proposed that a new versatile ionospheric and atmospheric scatter radar be constructed in northern Scandavia through a multinational collaborative effort. The new facility tentatively named HISCAT (High frequency, High power, High latitude, Heating and Ionospheric Scatter facility), should be used for scientific investigations of: the physics of the neutral (middle) atmosphere; fundamental plasma phenomena, natural or artificially induced in the ionosphere; electrodynamic conditions at high altitudes above the auroral region and in the polar cap ionosphere; plasma waves in the solar atmosphere. The system should thus be able to operate as a mesosphere-stratosphere-troposphere (MST) radar, a so-called ionospheric modification facility, incoherent-scatter radar, coherent-scatter radar, and solar radar. Basically, the new facility should be a device that can operate simultaneously on several frequencies in the frequency range 5 to 50 MHz not covered by other instruments. It should comprise: powerful transmitters, capable of delivering a total average power of several megawatts; an advanced phased antenna array of high gain forming one or two steerable and well collimated beams; and an advanced data collection and analysis system.

Bostrom, R.↗

Detection of radio-frequency modulated optical signals by two and three terminal microwave devices

An interdigitated photoconductor (two terminal device) on GaAlAs/GaAs heterostructure was fabricated and tested by an electro-optical sampling technique. Further, the photoresponse of GaAlAs/GaAs HEMT (three terminal device) was obtained by illuminating the device with an optical signal modulated up to 8 GHz. Gain-bandwidth product, response time, and noise properties of photoconductor and HEMT devices were obtained. Monolithic integration of these photodetectors with GaAs microwave devices for optically controlled phased array antenna applications is discussed.

Bhasin, K. B.↗

Radiation characteristics of a source in a thin substrate mounted over a dielectric medium

The radiation pattern of a line source is calculated for the case in which the source is lying on the top or the bottom surface of a lossless dielectric substrate that is mounted on the top of semiinfinite dielectric medium. It is found that in both cases the pattern along the interfaces has a null; that the pattern in the upper semiinfinite medium has a single lobe; and that the pattern in the lower semiinfinite medium has many lobes, the number of which varies with the substrate thickness. In both cases, the power radiated into the lower medium is more than that radiated into the upper medium. Applications of this calculation to remote sensing, microstrip antenna technology, and antenna arrays are discussed.

Engheta, Nader↗

Detection of radio-frequency modulated optical signals by two and three terminal microwave devices

An interdigitated photoconductor (two terminal device) on GaAlAs/GaAs heterostructure was fabricated and tested by an electro-optical sampling technique. Further, the photoresponse of GaAlAs/GaAs HEMT (three terminal device) was obtained by illuminating the device with an optical signal modulated up to 8 GHz. Gain-bandwidth product, response time, and noise properties of photoconductor and HEMT devices were obtained. Monolithic integration of these photodetectors with GaAs microwave devices for optically controlled phased array antenna applications is discussed.

Bhasin, K. B.↗

Optically controlled phased-array technology for space communication systems

Using MMICs in phased-array applications above 20 GHz requires complex RF and control signal distribution systems. Conventional waveguide, coaxial cable, and microstrip methods are undesirable due to their high weight, high loss, limited mechanical flexibility and large volume. An attractive alternative to these transmission media, for RF and control signal distribution in MMIC phased-array antennas, is optical fiber. Presented are potential system architectures and their associated characteristics. The status of high frequency opto-electronic components needed to realize the potential system architectures is also discussed. It is concluded that an optical fiber network will reduce weight and complexity, and increase reliability and performance, but may require higher power.

Kunath, Richard R.↗

NASA-GSFC research developments evolve into HRSO satellite concepts

Shaped omni and modular array-antenna concepts are being baselined for use on operations with the NASA space network and the High-Resolution Solar Observatory (HRSO) satellite free-flyer concept. This mission requires 16-MBPS return links, 1-KBPS multiple-access links, and a completely redundant set of gimballed antennas to support these links with 90-percent continuous coverage from TDRSS. Here, attention is given to the ways in which the flexibility of these components enabled mission planners to trade off spacecraft options without sacrificing mission objectives.

Hilliard, Lawrence M.↗

Monolithic Optoelectronic Integrated Circuit

Monolithic optoelectronic integrated circuit (OEIC) receives single digitally modulated input light signal via optical fiber and converts it into 16-channel electrical output signal. Potentially useful in any system in which digital data must be transmitted serially at high rates, then decoded into and used in parallel format at destination. Applications include transmission and decoding of control signals to phase shifters in phased-array antennas and also communication of data between computers and peripheral equipment in local-area networks.

Bhasin, Kul B.↗

Performance of a 300 Mbps 1:16 serial/parallel optoelectronic receiver module

Optical interconnects are being considered for the high speed distribution of multiplexed control signals in GaAs monolithic microwave integrated circuit (MMIC) based phased array antennas. The performance of a hybrid GaAs optoelectronic integrated circuit (OEIC) is described, as well as its design and fabrication. The OEIC converts a 16-bit serial optical input to a 16 parallel line electrical output using an on-board 1:16 demultiplexer and operates at data rates as high as 30b Mbps. The performance characteristics and potential applications of the device are presented.

Richard, M. A.↗

High performance millimeter-wave microstrip circulators and isolators

Millimeter wave systems, phased array antennas, and high performance components all require wideband circulators (and isolators) to perform diplexing and switching, to improve isolation and Voltage Standing Wave Ratio (VSWR), and to construct IMPATT diode reflection amplifiers. Presently, most of the millimeter-wave circulators and isolators are available in the configurations of waveguide or stripline, both of which suffer from the shortcomings of bulky size/weight, narrow bandwidth, and poor compatibility with monolithic millimeter-wave integrated circuits (MMIC). MMW microstrip circulators/isolators can eliminate or improve these shortcomings. Stub-tuned microstrip circulator configuration were developed utilizing the electromagnetic fields perturbation technique, the adhesion problems of microstrip metallization on new ferrite substrate were overcome, the fabrication, assembly, packaging techniques were improved, and then successfully designed, fabricated a Ka band circulator which has isolation and return loss of greater than 16dB, insertion loss less than 0.7dB. To assess the steady and reliable performance of the circulator, a temperature cycling test was done over the range of -20 to +50 C for 3 continuous cycles and found no significant impact or variation of circulator performance.

Shih, Ming↗

Effects of desired signal on the performance of a sidelobe canceller

The performance of a sidelobe canceller is studied in a communication system where the desired signal is continually present and its amplitude in the auxiliary antennas may be large (above thermal noise). In such a system, to avoid the cancellation of the desired signal, one can use a reference signal and adjust the auxiliary antenna weights to minimize the error between the reference signal and the sidelobe canceller output or one can use a steering vector. It is shown that in spite of the reference signal or a steering vector, the presence of the desired signal in the auxiliary antennas degrades the interference suppression provided by a sidelobe canceller. The amount of degradation depends on the number of degrees of freedom, the strength of the various signals, and the angular resolution of the auxiliary antenna array. Signal scenarios involving a single interfering signal as well as those involving multiple interfering signals are considered.

Gupta, Inder J.↗

A high-speed GaAs MESFET optical controller

Optical interconnects are being considered for control signal distribution in phased array antennas. A packaged hybrid GaAs optical controller with a 1:16 demultiplexed output that is suitable for this application is described. The controller, which was fabricated using enhancement/depletion mode MESFET technology, operates at demultiplexer-limited input data rates up to 305 Mb/s and requires less than 200 microW optical input power.

Claspy, P. C.↗

Optical technology for microwave applications IV; Proceedings of the Meeting, Orlando, FL, Mar. 28, 29, 1989

Among the topics discussed at the meeting are high-speed laser and electrooptical technologies, detectors and detector arrays, microwave delay lines, and photon-microwave interactions. In addition, optical link applications are discussed, along with electronic warfare receivers and acoustooptical signal processing. Emphasis is placed on laser diode technology, direct modulation of laser diodes, external electrooptical laser modulation techniques, and microwave fiber-optic delay lines. Attention is given to such optical link applications as multigigahertz links as well as to signal processing for phased-array antennas and channelized microwave receiver technologies.

Yao, Shi-Kay↗