Experimental transient three-dimensional heat transfer analysis
Time function, and transient three-dimensional heat transfer analysis
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Time function, and transient three-dimensional heat transfer analysis
In this paper the zero modes of the de Donder gauge Faddeev-Popov operator for three-dimensional gravity with negative cosmological constant are analyzed. It is found that the AdS{sub 3} vacuum produces (infinitely many) normalizable smooth zero modes of the Faddeev-Popov operator. On the other hand, it is found that the Banados-Teitelboim-Zanelli black hole (including the zero mass black hole) does not generate zero modes. This differs from the usual Gribov problem in QCD where, close to the maximally symmetric vacuum, the Faddeev-Popov determinant is positive definite while 'far enough' from the vacuum it can vanish. This suggests that the zero mass Banados-Teitelboim-Zanelli black hole could be a suitable ground state of three-dimensional gravity with negative cosmological constant. Because of the kinematic origin of this result, it also applies for other covariant gravity theories in three dimensions with AdS{sub 3} as maximally symmetric solution, such as new massive gravity and topologically massive gravity. The relevance of these results for supersymmetry breaking is pointed out.
A dual potential decomposition of the velocity field into a scalar and a vector potential function is extended to three dimensions and used in the finite-difference simulation of steady three-dimensional inviscid rotational flows and viscous flow. The finite-difference procedure was used to simulate the flow through the 80 by 120 ft wind tunnel at NASA Ames Research Center. Rotational flow produced by the stagnation pressure drop across vanes and screens which are located at the entrance of the inlet is modeled using actuator disk theory. Results are presented for two different inlet vane and screen configurations. The numerical predictions are in good agreement with experimental data. The dual potential procedure was also applied to calculate the viscous flow along two and three dimensional troughs. Viscous effects are simulated by injecting vorticity which is computed from a boundary layer algorithm. For attached flow over a three dimensional trough, the present calculations are in good agreement with other numerical predictions. For separated flow, it is shown from a two dimensional analysis that the boundary layer approximation provides an accurate measure of the vorticity in regions close to the wall; whereas further away from the wall, caution has to be exercised in using the boundary-layer equations to supply vorticity to the dual potential formulation.
A numerical and experimental study of three dimensional liquid sloshing inside a partially-filled spherical container undergoing an orbital rotating motion is described. Solutions of the unsteady, three-dimensional Navier-Stokes equations for the case of a gradual spin-up from rest are compared with experimental data obtained using a rotating test rig fitted with two liquid-filled spherical tanks. Data gathered from several experiments are reduced in terms of a dimensionless free surface height for comparison with transient results from the numerical simulations. The numerical solutions are found to compare favorably with the experimental data.
With increasing interest in studying biological systems across spatial scales—from centimeters down to nanometers—histology continues to be the gold standard for tissue imaging at cellular resolution, providing an essential bridge between macroscopic and nanoscopic analysis. However, its inherently destructive and two-dimensional nature limits its ability to capture the full three-dimensional complexity of tissue architecture. Here, we show that phase-contrast X-ray microscopy can enable three-dimensional virtual histology with subcellular resolution. This technique provides direct quantification of electron density without restrictive assumptions, allowing for direct characterization of cellular nuclei in a standard laboratory setting. By combining high spatial resolution and soft tissue contrast, with automated segmentation of cell nuclei, we demonstrated virtual Hematoxylin and Eosin (H&E) staining using machine learning-based style transfer, yielding volumetric datasets compatible with existing histopathological analysis tools. Furthermore, by integrating electron density and the sensitivity to nanometric features of the dark field contrast channel, we achieve stain-free, high-content imaging capable of distinguishing nuclei and extracellular matrix.
The way in which a three-dimensional network of water molecules accommodates an excess proton is hard to discern from the broad vibrational spectra of dilute acids. The sharper bands displayed by cold gas-phase clusters, H + (H 2 O) n , are therefore useful because they encode the network-dependent speciation of the proton defect and yet are small enough to be accurately treated with electronic structure theory. We identified the previously elusive spectral signature of the proton defect in the three-dimensional cage structure adopted by the particularly stable H + (H 2 O) 21 cluster. Cryogenically cooling the ion and tagging it with loosely bound deuterium (D 2 ) enabled detection of its vibrational spectrum over the 600 to 4000 cm -1 range. The excess charge is consistent with a tricoordinated H 3 O + moiety embedded on the surface of a clathrate-like cage.
We are developing computational tools for the simulations of three-dimensional flows past bodies undergoing arbitrary motions. High resolution viscous vortex methods have been developed that allow for extended simulations of two-dimensional configurations such as vortex generators. Our objective is to extend this methodology to three dimensions and develop a robust computational scheme for the simulation of such flows. A fundamental issue in the use of vortex methods is the ability of employing efficiently large numbers of computational elements to resolve the large range of scales that exist in complex flows. The traditional cost of the method scales as Omicron (N(sup 2)) as the N computational elements/particles induce velocities at each other, making the method unacceptable for simulations involving more than a few tens of thousands of particles. In the last decade fast methods have been developed that have operation counts of Omicron (N log N) or Omicron (N) (referred to as BH and GR respectively) depending on the details of the algorithm. These methods are based on the observation that the effect of a cluster of particles at a certain distance may be approximated by a finite series expansion. In order to exploit this observation we need to decompose the element population spatially into clusters of particles and build a hierarchy of clusters (a tree data structure) - smaller neighboring clusters combine to form a cluster of the next size up in the hierarchy and so on. This hierarchy of clusters allows one to determine efficiently when the approximation is valid. This algorithm is an N-body solver that appears in many fields of engineering and science. Some examples of its diverse use are in astrophysics, molecular dynamics, micro-magnetics, boundary element simulations of electromagnetic problems, and computer animation. More recently these N-body solvers have been implemented and applied in simulations involving vortex methods. Koumoutsakos and Leonard (1995) implemented the GR scheme in two dimensions for vector computer architectures allowing for simulations of bluff body flows using millions of particles. Winckelmans presented three-dimensional, viscous simulations of interacting vortex rings, using vortons and an implementation of a BH scheme for parallel computer architectures. Bhatt presented a vortex filament method to perform inviscid vortex ring interactions, with an alternative implementation of a BH scheme for a Connection Machine parallel computer architecture.
An extension is presented of the three-dimensional vortex-in-cell (VIC) method that allows for the simulation of incompressible turbulent flows such as plane mixing layers and wakes with exact boundary conditions in the normal direction. The vorticity is assumed to be confined between two parallel planes and the turbulence is assumed to be homogeneous in the two directions parallel to the planes. As an application, an analysis is presented of the evolution of the plane mixing layer subjected to random two- and three-dimensional initial disturbances.
A quasi-three-dimensional approximation has been developed for a blade boundary layer which involves the calculation of the effect of nonzero pressure gradients, turbulent flow, and blade twist, but includes only a simple coupling between streamlines. The resulting set of equations is solved using Keller's box scheme. The solution scheme is checked against available incompressible flow solutions and then applied to a NASA low aspect ratio transonic compressor stage for which extensive experimental and computational data are available. It is found that the three-dimensional boundary layer separates significantly sooner and has a much larger influence on rotor performance than would be expected from a two-dimensional analysis.
Here, the main challenges associated with silicon anodes are their poor conductivity and severe structural degradation during cycling. Here we design a three-dimensional sandwich hierarchical structure that tackles these problems, and we demonstrate its use in flexible, large-area silicon anode assemblies. The design of the electrode is achieved via plasma enhanced chemical vapor deposition of silicon nanoparticles onto three-dimensional nickel foam followed by conformal coating of cyclized-PAN on the silicon surface, thus forming a sandwiched cyclized-PAN/Si/Ni hierarchical structure. The three-dimensional networks provide abundant electroactive zones and conductive transport paths, the conformal coating of cyclized-PAN accommodates volume change during cycling, and the monolithic electrode configuration without additional binders or conductive agents improves the energy density of the whole electrode. Furthermore, as a result of the sandwich hierarchical arrangement, the solid-electrolyte interface of the anode remains stable and spatially confined, leading to an increased reversible capacity and improved cycling stability (910 mA h g –1 after 100 cycles at 1.0 A g –1 ).
A three-dimensional computational technique was used to obtain flowfield solutions to the Euler equations over selected hypersonic missile configurations. The General Interpolants Method (GIM) computer code was used with interpolation functions in an algebraic approach to generate a discrete computational grid for each configuration. The spatial marching version of the GIM code, which treats the parabolized Navier-Stokes (PNS) equations or the Euler equations with a shock capturing, 'MacCormack-like' scheme, was used to advance the solution hyperbolically over each configuration. The inviscid flowfield solutions over the two three-dimensional missile configurations, calculated using the GIM hyperbolic scheme, are presented here. The flow field over a wing/body configuration at zero degree angle of attack is presented. Flow over the fuselage of a tactical missile, termed the TAME 10, at both zero degree and 7.5 degree angles of attack is presented. In addition, an inviscid, two-dimensional analysis of an inlet configuration designed to mount on the TAME 10 is included. Contour maps of velocity and pressure are included for each configuration. Comparison of calculation and data show good agreement.
A three-dimensional laminar/turbulent boundary-layer method is developed for transonic flow over swept wings. The governing equations and curvature terms are written for a nonorthogonal body-oriented curvilinear coordinate system. The viscous method is coupled to the full-potential inviscid code, FLO-30, through a displacement-surface interaction. Typically, for transonic Mach numbers and moderate sweep angles, between 5 and 12 viscous updates are required for convergence. The method is applied to a variety of wing planforms, and the results are also compared to those obtained with the three-dimensional integral inviscid-viscous interaction method TAWFIVE (Streett and Melson, 1983).
Purpose: To determine in a Phase I study the maximum tolerated dose of weekly gemcitabine concurrent with radiotherapy in locally advanced non-small-cell lung cancer (NSCLC), as well as the relationship between the volume of the esophagus irradiated and severe esophagitis. Methods and Materials: Twenty-one patients with Stage III NSCLC received gemcitabine initially at 150 mg/m{sup 2}/wk over 7 weeks concurrently with chest radiotherapy to 63 Gy in 34 fractions. The first 9 patients underwent treatment with two-dimensional (2D) radiotherapy; the remaining 12 patients, with three-dimensional conformal radiotherapy (3D-CRT) and target volume reduced to clinically apparent disease. Consolidation was 4 cycles of gemcitabine at 1000 mg/m{sup 2}/wk and cisplatin 60 mg/m{sup 2}. Results: In the 2D group, the dose-limiting toxicity, Grade 3 esophagitis, occurred in 3 of 6 patients in the 150-mg/m{sup 2}/wk cohort and 2 of 3 patients in the 125-mg/m{sup 2}/wk cohort. No cases of Grade 3 esophagitis occurred at these doses in the 3D group. At gemcitabine 190 mg/m{sup 2}/wk, 2 of 6 patients in the 3D cohort had Grade 3 esophagitis. The mean percentages of esophagus irradiated to 60 Gy were 68% in the 2D cohort and 18% in the 3D cohort. Conclusions: We could not escalate the dose of gemcitabine with concurrent radiotherapy when using 2D planning because of severe acute esophagitis. However, we could escalate the dose of gemcitabine to 190 mg/m{sup 2}/wk when using 3D planning. The Phase II dose is 150 mg/m{sup 2}/wk. Three-dimensional CRT permitted the use of higher doses of gemcitabine.
Three-dimensional compressor flow theory and real flow effect
Optimization of supersonic portion of three- dimensional flow geometry in rocket motor nozzle for maximum thrust
In order to generate good quality systems for complicated three-dimensional spatial domains, the grid-generation method used must be able to exert rather precise controls over grid-point distributions. Several techniques are presented that enhance control of grid-point distribution for a class of algebraic grid-generation methods known as the two-, four-, and six-boundary methods. These techniques include variable stretching functions from bilinear interpolation, interpolating functions based on tension splines, and normalized K-factors. The techniques developed in this study were incorporated into a new version of GRID3D called GRID3D-v2. The usefulness of GRID3D-v2 was demonstrated by using it to generate a three-dimensional grid system in the coolent passage of a radial turbine blade with serpentine channels and pin fins.
A diffractive optical element with a three-dimensional liquid crystal (LC) alignment structure for advanced control of polarized beams was fabricated by a highly efficient one-step photoalignment method. This study is of great significance because different two-dimensional continuous and complex alignment patterns can be produced on two alignment films by simultaneously irradiating an empty glass cell composed of two unaligned photocrosslinkable polymer LC films with three-beam polarized interference beam. The polarization azimuth, ellipticity, and rotation direction of the diffracted beams from the resultant LC grating widely varied depending on the two-dimensional diffracted position and the polarization states of the incident beams. These polarization diffraction properties are well explained by theoretical analysis based on Jones calculus.
In this paper we calculate the Casimir energy for a massless fermionic field confined inside a three-dimensional rectangular box. We use the MIT bag model boundary condition for the confinement. We use the direct mode summation method along with the Abel-Plana summation formula to compute the Casimir energy, without any use of regularization or analytic continuation techniques. We obtain a negative Casimir energy, as opposed to the previously reported result for the interior of a three-dimensional sphere.