Search NASA⌕ Search

SEARCH · Search NASA

Results for “Aircraft Stability”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Pilot/vehicle control optimization using averaged operational mode and subsystem relative performance index sensitivities

A method is presented for designing optimal feedback controllers for systems having subsystem sensitivity constraints. Such constraints reflect the presence of subsystem performance indices which are in conflict with the performance index of the overall system. The key to the approach is the use of relative performance index sensitivity (a measure of the deviation of a performance index from its optimum value). The weighted sum of subsystem and/or operational mode relative performance index sensitivies is defined as an overall performance index. A method is developed to handle linear systems with quadratic performance indices and either full or partial state feedback. The usefulness of this method is demonstrated by applying it to the design of a stability augmentation system (SAS) for a VTOL aircraft. A desirable VTOL SAS design is one that produces good VTOL transient response both with and without active pilot control. The system designed using this method is shown to effect a satisfactory compromise solution to this problem.

Leininger, G. G.↗
NASA NTRS1973

Development of visual-display aid to air navigation

The developments are discussed in the design of a liquid-crystal, visual display, air navigation aid, which uses two VOR signals to locate the aircraft. The system concepts, liquid crystal materials, stability tests, and the electronic system are described. It is concluded that a navigational aid of this type is technically feasible, but not at the projected low cost.

Matcovich, T. J.↗
NASA NTRS1974

Development and flight tests of a gyro-less wing leveler and directional autopilot

A gyro-less wing leveler and directional autopilot were developed and flight tested in a single-engine light airplane. The primary purpose of the project was to develop a simple, reliable, low-cost stability augmentation and autopilot system for light aircraft. The wing leveler used a fluidic inertial rate sensor, electronic signal processing circuitry, and vacuum operated servos. A strap-down magnetic heading reference of simple design provided the wing leveler with directional autopilot capability. Flight tests indicated that the performance of the gyro-less wing leveler was equal to that of a commercial wing leveler using a gyroscopic rate sensor. Drift-free, long-term, heading-hold capability of the magnetic heading reference was demonstrated.

Garner, H. D.↗
NASA NTRS1974

A survey of AFFDL parameter estimation efforts and future plans

An overview is presented of the applications of parameter estimation methods to the following areas of interest at the Air Force Flight Dynamics Laboratory (AFFDL): (1) conventional stability and control parameter estimation of rigid aircraft; (2) extension to elastic aircraft; (3) extension to stall/spin aerodynamics of rigid aircraft with a nonlinear model; (4) application to the pilot model identification; and (5) correlation of wind tunnel, drop model and flight test data. Only well-documented algorithms are used with modification to the model as required for the specific application. The genesis of each problem and other background information are discussed which enumerate the algorithms and explain how this information is used to improve existing operational aircraft characteristics as well as specify design criteria for future USAF aerospace vehicles.

Eckholdt, D. C.↗
NASA NTRS1974

Experimental and analytical studies in tilt-rotor aeroelasticity

An overview of an experimental and analytical research program underway for studying the aeroelastic and dynamic characteristics of tilt-rotor VTOL aircraft is presented. Selected results from several investigations of scaled models in the transonic dynamics tunnel, as well as some results from a test of a flight-worthy proprotor in the full-scale wind tunnel are shown and discussed with a view toward delineating various aspects of dynamic behavior peculiar to proprotor aircraft. Included are such items as proprotor/pylon stability, whirl flutter, gust response, and blade flapping. Theoretical predictions are shown to be in agreement with the measured stability and response behavior.

Kvaternik, R. G.↗
NASA NTRS1975

Results of a 0.03- scale aerodynamic characteristics investigation of Boeing 747 carrier (model no. AX 1319 I-1) mated with a space shuttle orbiter (model 45-0) conducted in the Boeing transonic wind tunnel (CA5), volume 1

The performance, stability, and control characteristics of various carrier aircraft configurations are presented. Aerodynamic characteristics of the carrier mated with the Orbiter, carrier alone, and Orbiter alone were investigated. Carrier support system tare and interference effects were determined. Six-component force and moment data were recorded for the carrier and Orbiter. Buffet onset characteristics of the carrier vertical tail and horizontal tail were recorded. Angles of attack from -3 deg through 26 deg and angles of slideslip between +12 deg and -12 deg were investigated at Mach numbers from 0.15 through 0.70. Photographs are included.

Sarver, D.↗
NASA NTRS1976

A review of some tilt-rotor aeroelastic research at NASA-Langley

An overview of an experimental and analytical research program conducted within the Aeroelasticity Branch of the NASA Langley Research Center for studying the aeroelastic and dynamic characteristics of tilt-rotor VTOL aircraft is presented. Selected results from several joint NASA/contractor investigations of scaled models in the Langley transonic dynamics tunnel are shown and discussed with a view toward delineating various aspects of dynamic behavior peculiar to proprotor aircraft. Included are such items as proprotor/pylon stability, whirl flutter, gust response, and blade flapping. Theoretical predictions, based on analyses developed at Langley, are shown to be in agreement with the measured stability and response behavior.

Kvaternik, R. G.↗
NASA NTRS1977

Lift enhancement by an externally trapped vortex

A theoretical study is made of the performance capabilities of a lift concept that utilizes a spanwise vortex over the upper surface of the wing. The vortex is generated by a vertical flap near the leading edge of the wing and maintained by suction through orifices in endplates at the wingtip. The analysis approximates the three-dimensional flow field with a two-dimensional configuration that is mapped by conformal transformation into the flow about a circle. Theoretical solutions for a range of flap and orifice configurations predict that section lift coefficients up to around 10 can be achieved. It is concluded that such a lift concept is applicable to STOL aircraft if the vortex can be adequately stabilized and if the endplate suction can be generated efficiently.

Rossow, V. J.↗
NASA NTRS1977

Improvement of maneuver aerodynamics by spanwise blowing

Spanwise blowing was used to test a generalized wind-tunnel model to investigate component concepts in order to provide improved maneuver characteristics for advanced fighter aircraft. Primary emphasis was placed on performance, stability, and control at high angles of attack and subsonic speeds. Test data were obtained in the Langley high speed 7 by 10 foot tunnel at free stream Mach numbers up to 0.50 for a range of model angles of attack, jet momentum coefficients, and leading and trailing edge flap deflection angles. Spanwise blowing on a 44 deg swept trapezoidal wing resulted in leading edge vortex enhancement with subsequent large vortex induced lift increments and drag polar improvements at the higher angles of attack. Small deflections of a leading edge flap delayed these lift and drag benefits to higher angles of attack. In addition, blowing was more effective at higher Mach numbers. Spanwise blowing in conjunction with a deflected trailing edge flap resulted in lift and drag benefits that exceeded the summation of the effects of each high lift device acting alone. Asymmetric blowing was an effective lateral control device at the higher angles of attack.

Erickson, G. E.↗
NASA NTRS1977

A summary of ship deck motion dynamics as applied to VSTOL aircraft

Ship deck motions are considered in terms of the landing/takeoff of V/STOL aircraft from small ships. Fluctuations in the air turbulence shed by the ship's superstructures, wind direction and velocity, and wind turbulence loads on the aircraft are among the factors discussed. Roll stabilization using antiroll tanks, fins, and rudders is covered.

Baitis, A. E.↗
NASA NTRS1978

Supersonic transport

An aircraft of supersonic transport configuration is described, featuring thrust vectoring in conjunction with wing apex segments used as canard surfaces during takeoff, landing, and low-speed flight. The angle of incidence of the wing apex segments, when the segments were functioning as canard surfaces, was variable with respect to the aircraft angle of attack. The wing apex segments furthermore formed a portion of the main wing panel swept leading edge when not functioning as canard surfaces. The combination of thrust vectoring and deployable wing apex segments resulted in increased aircraft range and improved low speed longitudinal stability while providing acceptable takeoff length capabilities.

Coe, P. L., Jr.↗
NASA NTRS1978

Utilization of the wing-body aerodynamic analysis program

The analysis program was used to investigate several aircraft characteristics. The studies performed included vehicle stability analysis, determination of upwash angle, identification of nonpotential flow, launch dynamics, and wake vortex upset loads. The techniques and are discussed. When possible, computed results are compared with experimental data.

Curry, R. E.↗
NASA NTRS1980

A piloted simulator investigation of static stability and stability/control augmentation effects on helicopter handling qualities for instrument approach

A ground simulator experiment was conducted on the Flight Simulator for Advanced Aircraft at Ames Research Center to investigate the influence of several static stability and stability/control augmentation design parameters on helicopter flying qualities during terminal area operations in instrument conditions. Effects of light turbulence were included. Two levels of static stability in each rotational axis (pitch, roll, yaw) were examined for a hingeless rotor configuration. The variations in pitch and roll were: (1) stable and (2) neutral static stability; in yaw there were two stable levels. Four types of stability/control augmentation were also examined for the lower level of static stability in each axis. This latter investigation covered three helicopter rotor types: hingeless, articulated, and teetering. Four pilots performed a total of 105 evaluations of these parameters for a representative VOR instrument approach task. Pilot rating results indicate the acceptability of neutral static stability longitudinally and laterally and the need for pitch-roll attitude augmentation to achieve a satisfactory system.

Lebacqz, J. V.↗
NASA NTRS1981

A real time Pegasus propulsion system model for VSTOL piloted simulation evaluation

A real time propulsion system modeling technique suitable for use in man-in-the-loop simulator studies was developd. This technique provides the system accuracy, stability, and transient response required for integrated aircraft and propulsion control system studies. A Pegasus-Harrier propulsion system was selected as a baseline for developing mathematical modeling and simulation techniques for VSTOL. Initially, static and dynamic propulsion system characteristics were modeled in detail to form a nonlinear aerothermodynamic digital computer simulation of a Pegasus engine. From this high fidelity simulation, a real time propulsion model was formulated by applying a piece-wise linear state variable methodology. A hydromechanical and water injection control system was also simulated. The real time dynamic model includes the detail and flexibility required for the evaluation of critical control parameters and propulsion component limits over a limited flight envelope. The model was programmed for interfacing with a Harrier aircraft simulation. Typical propulsion system simulation results are presented.

Mihaloew, J. R.↗
NASA NTRS1981

Annular wing

An annular wing particularly suited for use in supporting in flight an aircraft characterized by the absence of directional stabilizing surfaces is described. The wing comprises a rigid annular body of a substantially uniformly symmetrical configuration characterized by an annular positive lifting surface and cord line coincident with the segment of a line radiating along the surface of an inverted truncated cone. A decalage is established for the leading and trailing semicircular portions of the body, relative to instantaneous line of flight, and a dihedral for the laterally opposed semicircular portions of the body, relative to the line of flight. The direction of flight and climb angle or glide slope angle are established by selectively positioning the center of gravity of the wing ahead of the aerodynamic center along the radius coincident with an axis for a selected line of flight.

Walker, H. J.↗
NASA NTRS1986

Directional handling qualities requirements for nap-of-the-earth tasks

A piloted similator experiment designed to investigate directional axis handling qualities requirements for low-speed and hover tasks conducted by a scout/attack helicopter is described. Included were the directional characteristics of various candidate light helicopter family (LHX) configurations. The test also focused on conventional single main/tail rotor configurations where the first-order effects that contribute to the loss of tail rotor control experienced by the OH-58 series aircraft were modeled. Two types of yaw stability and control augmentation systems were implemented: washed-out yaw rate feedback and shaped control input, and a yaw rate command, heading-hold system. The results of the experiment indicate that rotorcraft configurations with high directional gust sensitivity require more yaw damping to maintain satisfactory handling qualities during nap-of-the-earth (NOE) flying tasks. It was also determined that both yaw damping and control response are critical handling qualities parameters in performing the air-to-air target acquisition and tracking task. The lack of substantial yaw damping and larger values of gust sensitivity increased the possibility of loss of directional control at low airspeeds for the tail rotor configurations.

Bivens, C. C.↗
NASA NTRS1986

High-angle-of-attack aerodynamics - Lessons learned

Recently, the military and civil technical communities have undertaken numerous studies of the high angle-of-attack aerodynamic characteristics of advanced airplane and missile configurations. The method of approach and the design methodology employed have necessarily been experimental and exploratory in nature, due to the complex nature of separated flows. However, despite the relatively poor definition of many of the key aerodynamic phenomena involved for high-alpha conditions, some generic guidelines for design consideration have been identified. The present paper summarizes some of the more important lessons learned in the area of high angle-of-attack aerodynamics with examples of a number of key concepts and with particular emphasis on high-alpha stability and control characteristics of high performance aircraft. Topics covered in the discussion include the impact of design evolution, forebody flows, control of separated flows, configuration effects, aerodynamic controls, wind-tunnel flight correlation, and recent NASA research activities.

Chambers, J. R.↗
NASA NTRS1988

Investigation of air transportation technology at Princeton University, 1986

The Air Transportation Technology Program at Princeton proceeded along four avenues: Guidance and control strategies for penetration of microbursts and wind shear; Application of artificial intelligence in flight control systems; Computer aided control system design; and Effects of control saturation on closed loop stability and response of open loop unstable aircraft. Areas of investigation relate to guidance and control of commercial transports as well as general aviation aircraft. Interaction between the flight crew and automatic systems is a subject of prime concern.

Stengel, Robert F.↗