Search NASA⌕ Search

SEARCH · Search NASA

Results for “OPTICAL MODULATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46

Development of a Low-Cost Particulate Matter Monitor

We describe a small, inexpensive portable monitor for airborne particulates, composed of the following elements: a. A simple size-selective inlet (vertical elutriator) that permits only particles below a pre-set diameter to pass and enter the measurement section; b. A measurement section in which passing particles are deposited thermophoretically on a micro-fabricated resonant piezoelectric mass sensor; c. An optical characterization module co-located with the mass sensor module that directs infrared and ultraviolet beams through the deposit. The emergent optical beams are detected by a photodiode. The optical absorption of the deposit can be measured in order to characterize the deposit, and determine how much is due to diesel exhaust and/or environmental tobacco smoke; and d. A small pump that moves air through the device, which may also be operated in a passive mode. The component modules were designed by the project team, and fabricated at UCB andLBNL. Testing and validation were performed in a room-sized environmental chamber at LBNL in to which was added either environmental tobacco smoke (ETS, produced by a cigarette smoking machine) or diesel exhaust (from a conventional diesel engine). Two pilot field tests in a dwelling compared the monitor with existing aerosol instruments during exposure to infiltrated ambient air to which cigarette smoke, diesel exhaust, wood smoke and cooking fumes were added. The limit of detection (LOD) derived from statistical analysis of field data is 18 mu g m-3, at the 99percent confidence level. The monitor weighs less than 120 g and has a volume of roughly 250 cm3. Power consumption is approximately 100 milliwatts. During this study, the optical component of the device was not fully implemented and has been left for future efforts. Suggested improvements in the current prototype include use of integrated thermal correction, reconfiguration of the resonator for increased particle collection area, increased thermophoretic collection efficiency using an increased temperature gradient, and shielding the resonator electronics from deposition of ultrafine particles.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Coherent Optical Receiver for PPM Signals under Atmospheric Turbulence

Adaptive combining of experimentally obtained heterodyned pulse position modulated (PPM) signals with pulse-to-pulse coherence in the presence of simulated spatial distortions resembling atmospheric turbulence is demonstrated. The adaptively combined PPM signals are phased up via an LMS algorithm suitably optimized to operate with PPM in the presence of additive shot-noise. A convergence analysis of the algorithm is presented, and results with both, computer simulated and experimentally obtained PPM signals are analyzed.

coherent detection↗

Dynamical preparation of an atomic condensate in a Hofstadter band

The creation of a Hamiltonian in the quantum regime which has nontrivial topological features is a central goal of the cold-atom community, enabling widespread exploration of novel phases of quantum matter. A general scheme to synthesize such Hamiltonians is based on dynamical modulation of optical lattices which thereby generate vector potentials. At the same time, the modulation can lead to heating and serious difficulties with equilibration. Here we show that these challenges can be overcome by demonstrating how a Hofstadter Bose-Einstein condensate (BEC) can be dynamically realized, using experimental protocols. From Gross-Pitaevskii simulations our study reveals a complex, multistage evolution; this includes a chaotic intermediate "heating" stage followed by a spontaneous reentrance to the BEC. The observed behavior is reminiscent of evolution in cosmological models.

74 ATOMIC AND MOLECULAR PHYSICS↗

Referencing in fiber optic sensing systems

Different techniques to account for losses induced by the environment on signals in intensity modulation fiber optic sensing systems are described and analyzed.

Adamovsky, Grigory↗

Referencing in fiber optic sensing systems

Different techniques to account for losses induced by the environment on signals in intensity modulation fiber optic sensing systems are described and analyzed.

Adamovsky, Grigory↗

X-ray bang-time and fusion reaction history at picosecond resolution using RadOptic detection

We report recent progress in the development of RadOptic detectors, radiation to optical converters, that rely upon x-ray absorption induced modulation of the optical refractive index of a semiconductor sensor medium to amplitude modulate an optical probe beam. The sensor temporal response is determined by the dynamics of the electron-hole pair creation and subsequent relaxation in the sensor medium. Response times of a few ps have been demonstrated in a series of experiments conducted at the LLNL Jupiter Laser Facility (JLF). This technology will enable x-ray bang-time and fusion burn-history measurements with {approx} ps resolution.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

X-ray bang-time and fusion reaction history at ~ps resolution using RadOptic detection

We report recent progress in the development of RadOptic detectors, radiation to optical converters, that rely upon x-ray absorption induced modulation of the optical refractive index of a semiconductor sensor medium to amplitude modulate an optical probe beam. The sensor temporal response is determined by the dynamics of the electron-hole pair creation and subsequent relaxation in the sensor medium. Response times of a few ps have been demonstrated in a series of experiments conducted at the LLNL Jupiter Laser Facility. This technology will enable x-ray bang-time and fusion burn-history measurements with {approx} ps resolution.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Demonstration of photonic micro-ring resonator based digital bit magnitude comparator

This paper details the novel design, simulation and analysis of the digital photonic single-bit magnitude comparator with the utilization of silicon micro-ring resonator as its core component. The micro-ring resonator uses electro-optic carrier injection modulation properties with its ring waveguide being structured in PIN diode. Five micro-ring resonators are used in the proposed design, with each corresponds to the specific logic mode operation. This work also presents the time varying simulation, where two predetermined 1-bit input stream is injected into the circuit at the data rate of 1 Gbps, where its output is observed via oscilloscope, where results are obtained at the sampling rate of 1.6 THz. The timing diagram for the entire simulation is also shown together with additional results obtained from the simulation.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Oscillatory instability development in extraction system of a negative ion source

Conditions of oscillatory instability development in the extraction system of a negative hydrogen ion source based on a volume-produced plasma are studied. Such an ion source is characterized by the presence of the parent gas in the extraction system due to the leakage from the gas-discharge chamber. The secondary electrons in the area of the ion-optical system become the reason of oscillation appearance and possible beam current modulation. Analytically the range of the stable beam propagation is found. The instability increment is shown to be rather small. Maximum increment of the oscillations corresponds to the beam velocity equal to the thermal velocity of plasma electrons. The group velocity of the oscillations is close to the beam velocity so the oscillations are convective. Simulation of the low energy beam propagation is performed in COMSOL Multiphysics, the beam current modulation being observed.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Slowing atoms using optical cavities pumped by phase-modulated light

We theoretically investigate the possibility of slowing and cooling a collisionless atomic gas using a phase-modulated pump field. We consider a single-pump ring cavity with asymmetric cavity losses containing a beam of N polarizable pointlike particles. We show using analytical and numerical analysis that different regimes of the atom-light interaction can be identified and for properly chosen parameters this can lead to effective slowing of the atomic ensemble.

74 ATOMIC AND MOLECULAR PHYSICS↗

Fast widefield imaging of neuronal structure and function with optical sectioning in vivo

Optical microscopy, owing to its noninvasiveness and subcellular resolution, enables in vivo visualization of neuronal structure and function in the physiological context. Optical-sectioning structured illumination microscopy (OS-SIM) is a widefield fluorescence imaging technique that uses structured illumination patterns to encode in-focus structures and optically sections 3D samples. However, its application to in vivo imaging has been limited. In this study, we optimized OS-SIM for in vivo neural imaging. We modified OS-SIM reconstruction algorithms to improve signal-to-noise ratio and correct motion-induced artifacts in live samples. Incorporating an adaptive optics (AO) module to OS-SIM, we found that correcting sample-induced optical aberrations was essential for achieving accurate structural and functional characterizations in vivo. With AO OS-SIM, we demonstrated fast, high-resolution in vivo imaging with optical sectioning for structural imaging of mouse cortical neurons and zebrafish larval motor neurons, and functional imaging of quantal synaptic transmission at Drosophila larval neuromuscular junctions.

42 ENGINEERING↗

Overview of advanced components for fiber optic systems

The basic operating principles and potential performance of several state-of-the-art fiber-optic devices are illustrated with diagrams and briefly characterized. Technologies examined include high-birefringence polarization-maintaining fibers and directional couplers, single-mode fiber polarizers and cut-off polarizers, optical-fiber modulators with radially poled piezoactive polymer (PVF2) jackets, and piezoelectric-squeezer polarization modulators. The need for improved manufacturing techniques to make such fiber-optic devices cost-competitive with their thin-film integrated-optics analogs is indicated.

Depaula, Ramon P.↗

Nonlinear Fano-Resonant Dielectric Metasurfaces

Strong nonlinear light matter interaction is highly sought-after for a variety of applications including lasing and all-optical light modulation. Recently, resonant plasmonic structures have been considered promising candidates for enhancing nonlinear optical processes due to their ability to greatly enhance the optical near-field; however, their small mode volumes prevent the inherently large nonlinear susceptibility of the metal from being efficiently exploited. We present an alternative approach that utilizes a Fano-resonant silicon metasurface. The metasurface results in strong near-field enhancement within the volume of the silicon resonator while minimizing two photon absorption. Here, we measure a third harmonic generation enhancement factor of 1.5 105 with respect to an unpatterned silicon film and an absolute conversion efficiency of 1.2 10 6 with a peak pump intensity of 3.2 GW cm 2. The enhanced nonlinearity, combined with a sharp linear transmittance spectrum, results in transmission modulation with a modulation depth of 36%. Finally, the modulation mechanism is studied by pump probe experiments

36 MATERIALS SCIENCE↗

Fiber-optic temperature sensor using a spectrum-modulating semiconductor etalon

Described is a fiber-optic temperature sensor that uses a spectrum modulating SiC etalon. The spectral output of this type of sensor may be analyzed to obtain a temperature measurement which is largely independent of the transmission properties of the sensor's fiber-optic link. A highly precise laboratory spectrometer is described in detail, and this instrument is used to study the properties of this type of sensor. Also described are a number of different spectrum analyzers that are more suitable for use in a practical thermometer.

Beheim, Glenn↗

Fiber-optic temperature sensor using a spectrum-modulating semiconductor etalon

Described is a fiber-optic temperature sensor that uses a spectrum modulating SiC etalon. The spectral output of this type of sensor may be analyzed to obtain a temperature measurement which is largely independent of the transmission properties of the sensor's fiber-optic link. A highly precise laboratory spectrometer is described in detail, and this instrument is used to study the properties of this type of sensor. Also described are a number of different spectrum analyzers that are more suitable for use in a practical thermometer.

Beheim, Glenn↗

Possible Quasi-periodic Modulation in the z = 1.1 Gamma-Ray Blazar PKS 0426–380

We search for γ-ray and optical periodic modulations in distant flat-spectrum radio quasar (FSRQ) PKS 0426–380 (the redshift z = 1.1). Using two techniques (i.e., the maximum likelihood optimization and the exposure-weighted aperture photometry), we obtain γ-ray light curves from Fermi-LAT Pass 8 data covering from 2008 August to 2016 December. We then analyze the light curves with the Lomb–Scargle periodogram and the weighted wavelet Z-transform. A γ-ray quasi-periodicity with a period of 3.35 ± 0.68 yr is found at the significance level of ≃3.6 σ. The optical–UV flux covering from 2005 August to 2013 April provided by the ASI Science Data Center is also analyzed, but no significant quasi-periodicity is found. It should be pointed out that the result of the optical–UV data could be tentative because of the incompleteness of the data. Further long-term multiwavelength monitoring of this FSRQ is needed to confirm its quasi-periodicity.

79 ASTRONOMY AND ASTROPHYSICS↗