SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Practical design curves for axial compression, and pure bending factors of eccentrically stiffened circular cylinders
Buckling of conical shells under axial compression and effects of axially symmetric defects
Nongray radiation effects on compressible turbulent free jet mixing of nonsimilar gases, using stepwise spectral absorption coefficient and Beer law
Axial compression force effects in welded rails on critical velocity for high speed train
The tilt rotor underwent a hover performance test on the Aero Propulsion Laboratory whirl stand at Wright-Patterson Air Force Base. The maximum thrust over density ratio measured at the design tip speed of 740 feet per second was 10,016 pounds. This occurred when the power over density ratio was 1721 horsepower. At the hover overspeed rpm, the thrust and power, over density ratio, were 11,008 pounds and 1866 horsepower. During the test, the maximum measured thrust coefficient was 0.177, and the rotor figure of merit exceeded 0.81. Measured lifting efficiency was 8.35 pounds per horsepower at the thrust a 13,000-pound aircraft would require for hover at sea level on a standard day. No effect of compressibility on performance is discernible in the test results (the range of tip Mach numbers tested was 0.55 to 0.71).
Analytical expressions for the effects of compressibility and heat transfer on laminar and turbulent shape factors H have been developed. Solving the turbulent equation for the power law velocity profile exponent N has resulted in a simple technique by which the N values of experimental turbulent profiles can be calculated directly from the integral parameters. Thus the data plotting, curve fitting, and slope measuring, which is the normal technique of obtaining experimental N values, is eliminated. The N values obtained by this method should be within the accuracy with which they could be measured.
Sound propagation through a turbulent flow field with nonvanishing mean-flow velocity has been studied. The effects of compressibility on sound scattering are discussed. Using an analysis describing moving sources in a fixed frame, particular results are obtained for the far-field scattered sound intensity due to uniformly moving scattering turbulence. A formula is obtained showing the factor by which the scattered sound intensity is amplified due to the motion of the turbulence. In addition, this analysis was extended to include wave propagating through mean flow with constant gradient.
The items discussed are: (1) a recently proposed correction formula for the effect of compressibility in two dimensional subsonic flow; (2) the equivalence rule and the area rule for transonic speeds; (3) reciprocal relations in linearized wing theory; and (4) some general results connected with the problem of minimum wave resistance. The paper concludes with an example showing indentation of the fuselage to obtain favorable interference with the wing at supersonic speeds.
Results on the numerical simulation of jet flow fields were used to study the radiated sound field, and in addition, to extend and test the capabilities of the turbulent jet simulation codes. The principal result of the investigation was the computation of the radiated sound field from a turbulent jet. In addition, the computer codes were extended to account for the effects of compressibility and eddy viscosity, and the treatment of the nonlinear terms of the Navier-Stokes equations was modified so that they can be computed in a semi-implicit way. A summary of the flow model and a description of the numerical methods used for its solution are presented. Calculations of the radiated sound field are reported. In addition, the extensions that were made to the fundamental dynamical codes are described. Finally, the current state-of-the-art for computer simulation of turbulent jet noise is summarized.
Quantitative measurements of the turbulence fluctuations in velocity and mass flux have been obtained in Mach 0.6 and 0.8 turbulent boundary layer and free-shear layer flows by laser velocimetry and hot-wire anemometry techniques. To evaluate the effects of compressibility, these transonic data are compared to available incompressible and supersonic results. Based on some simplifying assumptions, estimates of the rms density fluctuations are made for which error bounds are given. In addition to these fluctuation data, the compressible mean velocity data obtained with the laser velocimeter are presented and compared to pitot tube results. The investigation was conducted in the Ames 6- by 6-Foot Supersonic Wind Tunnel at free-stream Mach numbers of 0.6 and 0.8 for a unit Reynolds number of about 10,000,000 per meter.
A 1/4 scale model of the Bell XS-1 transonic aircraft was tested in the Langley 300 mile-per-hour 7 by 10 foot tunnel to determine its low speed longitudinal stability and control characteristics. Pertinent longitudinal flying qualities expected of the XS-1 research airplane were estimated from the results of these tests including the effects of compressibility likely to be encountered at speeds below the force break. It appears that the static longitudinal stability and elevator control power will be adequate, but that the elevator control force gradient in steady flight will be undesirably low for all configurations. It is suggested that a centering spring be incorporated in the elevator control system of the airplane in order to increase the control force gradient in steady flight and in maneuvers.
The hydrogen-oxygen plasma was generated at combustion chamber pressures ranging from 0.5 to 2.0 megapascals and for various seed ratios (1 to 10 percent). The plasma was observed as the atmospheric exhaust from a Mach 2 rocket test facility. Transverse profiles of the absolute integrated intensity were measured with the optically thin CsI lines (0.5664 and 0.5636 microns) at a range of axial positions downstream of the 5-cm-diameter combustor nozzle exit. Radial profiles of the emission coefficient were obtained from the measured transverse profiles of intensity by Abel inversion. Temperatures were then determined from the emission coefficients for conditions of local thermodynamic equilibrium using particle densities generated by a two-dimensional free jet computer program. Temperature results show the inherent effects of compression and expansion pressure waves characteristic of a free jet exiting from a supersonic nozzle.
The effect of compression loads on positive nickel hydroxide electrodes is reported. Results show the electrodes could be compressed up to 20,000 kilograms without any change in capacity.
A mathematical anaysis predict the unsteady aerodynamic utilizing semi actuator theory environment for a cascade of airfoils harmonically oscillating in choked flow was developed. A normal shock is located in the blade passage, its position depending on the time dependent geometry, and pressure perturbations of the system. In addition to shock dynamics, the model includes the effect of compressibility, interblade phase lag, and an unsteady flow field upstream and downstream of the cascade. Calculated unsteady aerodynamics were compared with isolated airfoil wind tunnel data, and choke flutter onset boundaries were compared with data from testing of an F100 high pressure compressor stage.
A rapid technique for solving the blade-to-blade turbomachinery flow problem was developed. Approximate governing flow equations, which include the effects of compressibility, radius change, rotation, and variable stream sheet thickness are solved using a panel method. The development and solution of these equations are described. Sample calculations are presented to illustrate the method's capabilities and accuracy.
An introduction to the system concepts: TELEDEMO and TELEDIMS is provided. TELEDEMO is derived primarily from computer graphics and, via incorporation of sophisticated image data compression, enables effective low cost teleconferencing at data rates as low as 1K bit/second using dial-up phone lines. Combining TELEDEMO's powerful capabilities for the development of presentation material with microprocessor-based Information Management Systems (IMS) yields a truly all electronic IMS called TELEDIMS.
An optical systems design approach for a parallel optical processor that has an information throughput capacity in excess of one petabit per second is discussed. This system enables predetection processing of white light, passively illuminated scenes. Integrated with a programmable Van der Lugt filter, this system is an effective data compression method. A program to implement this parallel optical processing by interferometry system is discussed.
A rapid technique for solving the blade-to-blade turbomachinery flow problem was developed. Approximate governing flow equations, which include the effects of compressibility, radius change, rotation, and variable stream sheet thickness are solved using a panel method. The development and solution of these equations are described. Sample calculations are presented to illustrate the method's capabilities and accuracy. Previously announced in STAR as N83-13077