Search NASA⌕ Search

SEARCH · Search NASA

Results for “vortex”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 883 records · Page 49

Probing the Cold Dust Emission in the AB Aur Disk: A Dust Trap in a Decaying Vortex?

One serious challenge for planet formation is the rapid inward drift of pebble-sized dust particles in protoplanetary disks. Dust trapping at local maxima in the disk gas pressure has received much theoretical attention but still lacks observational support. The cold dust emission in the AB Aur disk forms an asymmetric ring at a radius of about 120 au, which is suggestive of dust trapping in a gas vortex. We present high spatial resolution (0.″58 × 0.″78 ≈ 80 × 110 au) NOEMA observations of the 1.12 mm and 2.22 mm dust continuum emission from the AB Aur disk. Significant azimuthal variations of the flux ratio at both wavelengths indicate a size segregation of the large dust particles along the ring. Our continuum images also show that the intensity variations along the ring are smaller at 2.22 mm than at 1.12 mm, contrary to what dust trapping models with a gas vortex have predicted. Our two-fluid (gas+dust) hydrodynamical simulations demonstrate that this feature is well explained if the gas vortex has started to decay due to turbulent diffusion, and dust particles are thus losing the azimuthal trapping on different timescales depending on their size. The comparison between our observations and simulations allows us to constrain the size distribution and the total mass of solid particles in the ring, which we find to be of the order of 30 Earth masses, enough to form future rocky planets.

79 ASTRONOMY AND ASTROPHYSICS↗

Investigation of rotor blade tip-vortex aerodynamics

Several aspects of the aerodynamics of rotor blade tip vortices are examined. Two particular categories are dealt with; (1) dynamic loads on a blade passing close to or intersecting a trailing vortex, and (2) the response of the trailing vortex core to changes in the flow. Results for both categories are in reasonable agreement with existing data, although lower pressure gradients were obtained than anticipated for category one. A correlation between trailing edge sweep angle at the tip and vortex core size was noted for category two.

Lewellen, W. S.↗

Exploratory flight investigation of aircraft response to the wing vortex wake generated by jet transport aircraft

The effect of intercepting wing tip vortices generated by large jet transports, including jumbo jets, over separation distances from 1 nautical mile to 15 nautical miles is evaluated on the basis of the response of a vortex probe airplane in the roil mode. The vortex probe test aircraft included a representative general aviation airplane, an executive jet, a fighter, and light and medium weight jet transports. The test conditions and airplane configurations were comparable to those normally used during takeoff, landing, or holding pattern operations. For flight safety the tests were performed at altitudes from 9500 feet to 12,500 feet. In addition to an evaluation of the probe airplane response, a flight test technique is suggested for determining minimum separation distance, using as variable the ratio of vortex-induced roll acceleration to maximum lateral control acceleration and the gross weight of the generating aircraft.

Andrews, W. H.↗

Avoidance of Trailing Vortex Hazard by Airport Warning System

In an effort to improve airport traffic operation near jumbo jets, an airport trailing vortex warning system (ATVWS) was developed to predict trailing vortex turbulence. The ATVWS consists of a computer simulator which is compatible with a vortex sensor such as a laser Doppler velocimeter or an acoustic radar. A study of the traffic in one of the ten busiest airports, Atlanta Municipal Airport, provided information on traffic patterns of a statistical nature. With this information, airport traffic patterns can be studied and hazard statistics developed. Based on a careful study of this simulation model, requirements for the development and testing of an ATVWS can be accurately specified.

Rudland, R. S.↗

Study of the far wake vortex field generated by a rectangular airfoil in a water tank

Underwater towing experiments were carried out with a rectangular airfoil of aspect ratio 5.3 at 4 and 8 deg angles of attack and at chord-based Reynolds numbers between 2 x 100,000 and 7.5 x 100,000. Quantitative measurements by means of the hydrogen bubble technique indicated lower peak swirl velocities in the range of 100 to 1000 lenghts downstream than have been measured in wind tunnel of flight tests. The maximum circumferential velocity decayed whereas the turbulent eddy viscosity increased. This behavior and other known rates of vortex decay are explained in terms of an analytical solution for the vortex problem with time varying eddy viscosity. It is shown that this case corresponds to nonequilibrium turbulent vortex flow.

Lezius, D. K.↗

Preliminary results of flight tests of vortex attenuating splines

Flight tests have been conducted to evaluate the effectiveness of a wingtip vortex attenuating device, referred to as a spline. Vortex penetrations were made with a PA-28 behind a C-54 aircraft with and without wingtip splines attached and the resultant rolling acceleration was measured and related to the roll acceleration capability of the PA-28. Tests were conducted over a range of separation distances from about 5 nautical miles (n. mi.) to less than 1 n. mi. Preliminary results indicate that, with the splines installed, there was a significant reduction in the vortex induced roll acceleration experienced by the PA-28 probe aircraft, and the distance at which the PA-28 roll control became ineffective was reduced from 2.5 n. mi. to 0.6 n. mi., or less. There was a slight increase in approach noise (approximately 4 db) with the splines installed due primarily to the higher engine power used during approach. Although splines significantly reduced the C-54 rate of climb, the rates available with four engines were acceptable for this test program. Splines did not introduce any noticeable change in the handling qualities of the C-54.

Hastings, E. C., Jr.↗

Effect of inlet ingestion of a wing tip vortex on turbojet stall margin

A two-dimensional inlet and a turbojet engine were investigated in a Mach 0.4 stream so as to ingest the tip vortex of a forward mounted wing. Results show that ingestion of a wing tip vortex by a turbojet engine can cause a large reduction in engine stall margin. The loss in stall compressor pressure ratio was primarily dependent on vortex location and rotational direction and not on total-pressure variations across the compressor face.

Mitchell, G. A.↗

A vortex entrainment model applied to slender delta wings

A mathematical model of the vortex flow over a slender sharp-edged delta wing is proposed, and is shown to provide good agreement with the experiment. Although the technique requires experimental data in the form of the vortex core locations, it does account for the previously ignored mass entrainment of the vortex core.

Coe, P. L., Jr.↗

Vortex age as a wake turbulence scaling parameter

Tests were conducted in the Virginia Tech Stability Wind Tunnel to determine the significance of vortex age as a scaling parameter in wake turbulence development and dissipation. Vortex structure was measured over a range of three angles of attack, three free-stream speeds, and seven downstream positions from 2 to 30 chordlengths using an NACA 0012 wing and a five hole yawhead probe. The resulting data indicates that vortex age is not a self-sufficient scaling parameter but a free-stream velocity influence also exists at higher angles of attack which cannot be explained in terms of Re or M.

Marchman, J. F., III↗

Vortex-induced heating to a cone-cylinder body at Mach 6

Presented data on vortex-induced heating in a cone-cylinder body at Mach 6 show that the most severe heating need not occur as a result of the interaction of the primary vortices with the lee surface, even though this interaction produces a large, well-defined featherline oil smear. It is pointed out that the severity of vortex-induced heating is extremely sensitive to Reynolds number and geometry and that there exists a 'threshold Reynolds number' below which vortex-induced heating decreases abruptly.

Hefner, J. N.↗

Results of full-scale vortex attenuation flight experiments

Flight tests have been conducted to evaluate the effectiveness of a wing-tip vortex attenuating device, referred to as a spline. Vortex penetrations were made with a PA-28 behind a C-54 aircraft with and without wing-tip splines attached, and the resultant rolling acceleration was measured and related to the roll acceleration capability of the PA-28. Tests were conducted over a range of separation distances from about 5 n mi to less than 1 n mi. Preliminary results indicate that, with the splines installed, there was a significant reduction in the vortex-induced roll acceleration experienced by the PA-28 probe aircraft, and the distance at which the PA-28 roll control became ineffective was reduced from 2.5 n mi to less than 1 n mi. Although splines significantly reduced the C-54 rate of climb, the rates available with four engines were acceptable for this test program.

Hastings, E. C., Jr.↗

Acoustic scattering from a turbulent vortex

With the aid of the Born approximation, the time autocorrelation and power spectral density are calculated for the received acoustic signal scattered from velocity fluctuations in a turbulent aircraft trailing vortex. The turbulence is required to be globally stationary, but only locally homogeneous. The treatment includes the effects of spectral broadening due to convection of the scattering eddies by a spatially varying mean flow and by macroeddies. The 3 db bandwidth of the received signal is related to the scattering angle and the core Mach number of the vortex. A primary feature of the analysis is that it provides a method for inferring the radial intensity distribution of turbulence in a vortex. The analysis technique is also applicable to scattering from other turbulent flows where significant variations of turbulence level occur over distances on the order of the macroeddy size.

Ramsey, V. W.↗

Effect of symmetrical vortex shedding on the longitudinal aerodynamic characteristics of wing-body-tail combinations

An engineering prediction method for determining the longitudinal aerodynamic characteristics of wing-body-tail combinations is developed. The method includes the effects of nonlinear aerodynamics of components and the interference between components. Nonlinearities associated with symmetrical vortex shedding from the nose of the body are considered as well as the nonlinearities associated with the separation vortices from the leading edges and side edges of the lifting surfaces. The wing and tail characteristics are calculated using lifting surface theories which include effects of incidence, camber, twist, and induced velocities from external sources of disturbance such as bodies and vortices. The lifting surface theories calculate the distribution of leading edge and side edge suction which is converted to vortex lift using the Polhamus suction analogy. Correlation curves are developed to determine the fraction of the theoretical suction force which is converted into vortex lift. The prediction method is compared with experimental data on a variety of aircraft configurations to assess the accuracy and limitations of the method.

Mendenhall, M. R.↗

A Model for the Vortex Pair Associated with a Jet in a Cross Flow

A model is presented for the contrarotating vortex pair that is formed by a round, turbulent, subsonic jet directed normally into a uniform, subsonic cross flow. The model consists of a set of algebraic equations that describe the properties of the vortex pair as a function of their location in the jet plume. The parameters of the model are physical characteristics of the vortices such as the vortex strength, spacing, and core size. These parameters are determined by velocity measurements at selective points in the jet plume.

Sellers, William L.↗

Performance of vortex generators in a Mach 2.5 low-bleed full scale 45-percent-internal-contraction axisymmetric inlet

Steady-state and dynamic flow characteristics associated with two sets of vortex generators having different mixing criteria were determined. The inlet performance with and without these vortex generators is presented. The vortex generators were successful in eliminating separation, increasing area-weighted total pressure recovery, and decreasing distortion. Transmission times obtained from cross-correlations of the wall static pressures and the diffuser exit total pressure showed no effect of the upstream flow characteristics on the diffuser exit pressures when generators were used. Without generators, separation occurred and the upstream pressure characteristics had immediate effects on the diffuser exit pressure characteristics.

Neumann, H. E.↗

Flow visualization of leading-edge vortex enhancement by spanwise blowing

Flow visualization studies were conducted in a small pilot wind tunnel to determine qualitative effects of blowing a discrete jet essentially parallel to the leading edge of a 45 deg-swept trapezoidal wing featuring leading- and trailing-edge flaps. Test parameters included wing angle-of-attack, jet momentum coefficient, leading- and trailing-edge flap deflections, and nozzle chordwise displacement. Results of this study indicate that blowing from a reflection plane over the wing enhances the leading-edge vortex and delays vortex bursting to higher angles-of-attack and greater span distances. Increased blowing rates decrease vortex size, growth rate, and vertical displacement above the wing surface at a given span station and also extend the spanwise effectiveness of lateral blowing. Deflection of a leading-edge flap delays the beneficial effects of spanwise blowing to higher angles-of-attack. Nozzle chordwise locations investigated for the wing with and without leading-edge flap deflection appear equally effective in enhancing the separated leading-edge flow.

Erickson, G. E.↗

Subsonic aerodynamic characteristics of interacting lifting surfaces with separated flow around sharp edges predicted by a vortex-lattice method

Because the potential flow suction along the leading and side edges of a planform can be used to determine both leading- and side-edge vortex lift, the present investigation was undertaken to apply the vortex-lattice method to computing side-edge suction force for isolated or interacting planforms. Although there is a small effect of bound vortex sweep on the computation of the side-edge suction force, the results obtained for a number of different isolated planforms produced acceptable agreement with results obtained from a method employing continuous induced-velocity distributions. By using the method outlined, better agreement between theory and experiment was noted for a wing in the presence of a canard than was previously obtained.

Lamar, J. E.↗