Search NASA⌕ Search

SEARCH · Search NASA

Results for “AIRPLANES, LIGHT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Dynamic wind-tunnel tests of an aeromechanical gust-alleviation system using several different combinations of control surfaces

Some experimental results are presented from wind tunnel studies of a dynamic model equipped with an aeromechanical gust alleviation system for reducing the normal acceleration response of light airplanes. The gust alleviation system consists of two auxiliary aerodynamic surfaces that deflect the wing flaps through mechanical linkages when a gust is encountered to maintain nearly constant airplane lift. The gust alleviation system was implemented on a 1/6-scale, rod mounted, free flying model that is geometrically and dynamically representative of small, four place, high wing, single engine, light airplanes. The effects of flaps with different spans, two size of auxiliary aerodynamic surfaces, plain and double hinged flaps, and a flap elevator interconnection were studied. The model test results are presented in terms of predicted root mean square response of the full scale airplane to atmospheric turbulence. The results show that the gust alleviation system reduces the root mean square normal acceleration response by 30 percent in comparison with the response in the flaps locked condition. Small reductions in pitch-rate response were also obtained. It is believed that substantially larger reductions in normal acceleration can be achieved by reducing the rather high levels of mechanical friction which were extant in the alleviation system of the present model.

Stewart, E. C.↗
NASA NTRS1987

Measurements of propeller noise in a light turboprop airplane

In-flight acoustic measurements have been made on the exterior and interior of a twin-engined turboprop airplane under controlled conditions to study data repeatability. It is found that the variability of the harmonic sound pressure levels in the cabin is greater than that for the exterior sound pressure levels, typical values for the standard deviation being +2.0 dB and -4.2 dB for the interior, versus +1.4 dB and -2.3 dB for the exterior. When insertion losses are determined for acoustic treatments in the cabin, the standard deviations of the data are typically + or - 6.5 dB. It is concluded that additional factors, such as accurate and repeatable selection of relative phase between propellers, controlled cabin-air-temperatures, installation of baseline acoustic absorption, and measurement of aircraft attitude, should be considered in order to reduce uncertainty in the measured data.

Wilby, J. F.↗
NASA NTRS1986

Development of spin resistance criteria for light general aviation airplanes

A brief history of stall/spin technology for light general aviation airplanes is presented. Criteria needed to describe desirable characteristics of a spin-resistant airplane and means to evaluate airplanes for compliance with the criteria have been developed. Initial results from limited flight tests of an experimental high-wing airplane indicated that the basic configuration would not meet the spin resistance criteria. Further tests with the airplane modified to enhance its spin resistance are planned.

Dicarlo, D. J.↗
NASA NTRS1972

Flight evaluations of the effect of advanced control systems and displays on the handling qualities of a general aviation airplane.

Flight tests have shown that, by means of improved displays and advanced control systems, it is possible to transform a typical light airplane into a flying machine that borders on being perfect from a handling-qualities standpoint. A flight-director display and an attitude-command control system used in combination transformed a vehicle with poor handling qualities during ILS approaches in turbulent air into a vehicle with extremely good handling qualities. The attitude-command control system also improved the ride qualities of the airplane. A rate-command control system was less beneficial than an attitude-command control system. Although this paper deals primarily with general aviation aircraft, the results presented pertain to other types of aircraft. Short-takeoff-and-landing (STOL) aircraft would be a natural application of the control systems because, as a result of their low speeds, they encounter many of the handling-qualities problems noted on light aircraft. The improved ride qualities should be of interest to all airline operations, and for STOL aircraft in particular, because of their prolonged exposure to low-altitude turbulence.

Loschke, P. C.↗
NASA NTRS1987

Flight investigation of the effect of tail configuration on stall, spin, and recovery characteristics of a low-wing general aviation research airplane

Flight tests were performed to investigate the stall, spin, and recovery characteristics of a low-wing, single-engine, light airplane with four interchangeable tail configurations. The four tail configurations were evaluated for effects of varying mass distribution, center-of-gravity position, and control inputs. The airplane tended to roll-off at the stall. Variations in tail configuration produced spins ranging from 40 deg to 60 deg angle of attack and turn rates of about 145 to 208 deg/sec. Some unrecoverable flat spins were encountered which required use of the airplane spin chute for recovery. For recoverable spins, antispin rudder followed by forward wheel with ailerons centered provided the quickest spin recovery. The moderate spin modes agreed very well with those predicted from spin-tunnel model tests, however, the flat spin was at a lower angle of attack and a slower rotation rate than indicated by the model tests.

Stough, H. Paul, III↗
NASA NTRS1985

Leading-edge design for improved spin resistance of wings incorporating conventional and advanced airfoils

Discontinuous wing leading-edge droop designs have been evaluated as a means of modifying wing autorotative characteristics and thus improving airplane spin resistance. Addition of a discontinuous outboard wing leading-edge droop to three typical light airplanes having NACA 6-series wing sections produced significant improvements in stall characteristics and spin resistance. Wind tunnel tests of two wings having advanced natural laminar flow airfoil sections indicated that a discontinuous leading-edge droop can delay the onset of autorotation at high angles of attack without adversely affecting the development of laminar flow at cruise angles of attack.

Stough, H. P., III↗
NASA NTRS1974

Development and flight tests of a gyro-less wing leveler and directional autopilot

A gyro-less wing leveler and directional autopilot were developed and flight tested in a single-engine light airplane. The primary purpose of the project was to develop a simple, reliable, low-cost stability augmentation and autopilot system for light aircraft. The wing leveler used a fluidic inertial rate sensor, electronic signal processing circuitry, and vacuum operated servos. A strap-down magnetic heading reference of simple design provided the wing leveler with directional autopilot capability. Flight tests indicated that the performance of the gyro-less wing leveler was equal to that of a commercial wing leveler using a gyroscopic rate sensor. Drift-free, long-term, heading-hold capability of the magnetic heading reference was demonstrated.

Garner, H. D.↗
NASA NTRS1984

Airborne measurements of launch vehicle effluent of STS-2 launch on November 12, 1981 at Cape Canaveral, Florida

The second Space Shuttle (STS-2) was launched from the John F. Kennedy Space Center at 1010 EST on November 12, 1981. An instrumented light airplane was used to measure the emitted concentration of Shuttle exhaust products produced during launch. The airplane accomplished 31 passes through and under the exhaust cloud in the 1 hr 45 min immediately following the launch. Measurements included the following: (1) particulate data in the form of a light scattering coefficient obtained from an integrating nephelometer, (2) particulate concentrations and mass concentrations obtained from a spectrometer probe, (3) gaseous HCl and total HCl concentrations obtained from a gas-filter-correlation instrument and a chemiluminescent instrument, respectively, and (4) outside-air temperature and dew-point temperature. These data are presented along with time, altitude, and position for each cloud pass. These data are within the range of values observed during similar measurements made during the first Space Shuttle launch on April 12, 1981.

Maddrea, G. L., Jr.↗
NASA NTRS1972

Effect of limited amplitude and rate of flap motion on vane-controlled gust alleviation system

An airplane (light transport type) is assumed to be in level flight (no pitching) through atmospheric turbulence which has a mean-square vertical gust intensity of 9.3 (m/sec)sq. The power spectral density of the vertical acceleration due to gusts is examined with and without a gust-alleviation system in operation. The gust-alleviation system consisted of wing flaps that were used in conjunction with a vane mounted ahead of the airplane to sense the vertical gust velocity. The primary purpose of this study was to examine the change in the effectiveness of the gust-alleviation system when the flap motion is limited in amplitude and rate. The alleviation system was very effective if no restrictions were placed on flap motion (rate and amplitude). Restricting the flap amplitude to 0.5 radian did not appreciably change the effectiveness. However, restricting the flap rate did reduce the gust alleviation, and restricting the flap rate to 0.25 rad/sec actually caused the alleviation system to increase the vertical acceleration above that for the no-alleviation situation. Based upon this analysis, rate limiting appears to be rather significant in gust-alleviation systems designed for passenger comfort.

Barker, L. K.↗
NASA NTRS1981

Analytical techniques for the analysis of stall/spin flight test data

Analytical techniques for the analysis of stall/spin flight test data are reviewed by discussing (1) certain special flight instrumentation issues, (2) the mathematical modeling techniques, and (3) the analysis of post stall and spinning flight of general aviation airplanes. The angles of attack, sideslip, roll, pitch, and yaw are derived from measurements of angular velocity and linear acceleration. The key to the success of this approach is to simultaneously estimate both the biases in the instrumentation and the initial conditions. Techniques for determining stability derivatives from flight data are applied to angles of attack too high for stabilized flight. This practice greatly expands the range over which aerodynamic characteristics can be determined from flight test. Nonlinear terms in certain aerodynamic functions are shown to be valid by comparing them with the trends of results at different angles of attack. A very old technique of studying spins is extended and applied to some modern light airplanes. Airplanes for which the wing provides the dominant moments during spins, offer the possibility of linking spin characteristics to longitudinal data.

Taylor, L. W., Jr.↗
NASA NTRS1970

Aircraft vortex wakes

Aircraft generated vortex wakes and core air motions hazards for encountering light airplane

Boswinkle, R. W., Jr.↗
NASA NTRS1972

Determination of stability derivatives from flight data using a Newton-Raphson minimization technique

A modified Newton-Raphson or quasilinearization minimization technique for determining stability derivatives from flight data was developed and compared with simple-equations, analog-matching, least-squares, and Shinbrot methods of analysis. For the data analyzed, the solutions computed by using the estimates obtained from the Newton-Raphson technique fit the data and determined coefficients adequately. A further modification to include a priori information was found to be useful. A model statistically similar to the flight data was analyzed using the same methods (excluding analog matching), and the Newton-Raphson technique was found to yield superior estimates. An approximate Cramer-Rao bound was compared with the error covariance matrix of the model and was found to provide information about the reliability of the individual estimates obtained. The technique was successfully applied to data obtained from a light airplane, a large supersonic airplane, and a lifting body vehicle. It was shown that the reliability of the estimates of a given coefficient obtained from these vehicles depends upon the data analyzed.

Iliff, K. W.↗
NASA NTRS1973

An analytical study of the response of a constant-attitude aircraft to atmospheric turbulence

A light airplane equipped with an automatic control system which drives large wing flaps and the stabilator so as to produce a constant pitch attitude in all flight modes was analyzed for its response to a specific gust. The aircraft was also equipped with a bank-angle steering, zero sideslip automatic control system which was studied for its effectiveness in suppressing a specific lateral gust. The gusts were assumed to be comprised of 200 lateral and 400 vertical sinusoids. Each was used to excite the controlled aircraft and the time response to the sum of all sinusoids was plotted. The assumption was that the gust may be treated as stationary in space but variable in time rather than the reverse. Results indicate that such a control system can suppress vertical gusts up to the limit of control authority. Either the lateral accelerations or the yawing velocity response to lateral gusts can be suppressed with this system but not both simultaneously.

Smetana, F. O.↗
NASA NTRS1978

The influence of unsteady aerodynamics on extracted aircraft parameters

The effect of accounting for unsteady aerodynamics on the parameters extracted from flight data is examined. Longitudinal equations of motion have been modified, and a parameter-extraction program developed to include the effects of unsteady aerodynamics. The approach used was to generate pseudo data using the unsteady-aerodynamics model and to use that data in two parameter-extraction programs, one including and the other neglecting unsteady effects to see if the parameters were significantly different. Flight data for a light airplane also was used with the two extraction programs for the same purpose. Results showed that, for the cases considered, including unsteady aerodynamics in the parameter-extraction program did affect the extracted quantities, particularly the damping in pitch. In addition, the parameter variances were lower when unsteady aerodynamics were included in the extraction program than when the effects were neglected.

Queijo, M. J.↗
NASA NTRS1979

Summary of noise reduction characteristics of typical general aviation materials

The paper presents the results of a large number of systematic tests to determine noise reduction characteristics of general aviation materials. Effects of material type (metallic and composite), thickness, panel stiffening, vibration damping materials, sound absorption materials and pressurization on noise reduction are included. Several promising methods for reducing cabin interior noise in light airplanes are discussed based on the results.

Roskam, J.↗