Search NASA⌕ Search

SEARCH · Search NASA

Results for “AIRSHIPS - RIGID”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS2004

Paschen Considerations for High Altitude Airships

Recently, there have been several proposals submitted to funding agencies for long-lived high altitude (about 70,000 feet) airships for communications, surveillance, etc. In order for these airships to remain at altitude, high power, high efficiency, lightweight solar arrays must be used, and high efficiency power management and distribution systems must be employed. The needs for high power and high efficiency imply high voltage systems. However, the air pressure at these extreme altitudes is such that electrical power systems will be near the Paschen discharge minimum over a wide range of electrode separations. In this paper, preliminary calculations are made for acceptable high voltage design practices under ambient, hydrogen and helium gas atmospheres.

Ferguson, D. C.↗
NASA NTRS1946

An Analytical Investigation of the Heat Losses from a U.S. Navy K-Type Airship

The heat losses from the envelope surface of a U.S. Navy K-type airship are evaluated to determine if the use of heat is a feasible means of preventing ice and snow accumulations on lighter-than-air craft during flight and when moored uncovered. Consideration is given to heat losses in clear air (no liquid water present in the atmosphere) and in probable conditions of icing and snow. The results of the analysis indicate that the amount of heat required in flight to raise the surface temperature of the entire envelope to the extent considered adequate for ice protection, based on experience with tests of heavier-than-air craft, is very large. Existing types of heating equipment which could be used to supply this quantity of heat would probably be too bulky and heavy to provide a practical flight installation. The heat requirements to provide protection for the nose and stern regions in assumed mild to moderate icing conditions appear to be within the range of the capacity of current types of heating equipment suitable for flight use. The amount of heat necessary to prevent snow accumulations on the upper surface of the airship envelope when moored uncovered under all conditions appear to be excessive for the heating equipment presently available for flight use, but could possibly be achieved with auxiliary ground heating equipment.

Hillendahl, Wesley H.↗
NASA NTRS2012

Airships 101: Rediscovering the Potential of Lighter-Than-Air (LTA)

An overview of airships past, present, and future is provided in a Powerpoint-formatted presentation. This presentation was requested for transfer to the British MOD by Paul Espinosa of NASA Ames, Code PX. The presentation provides general information about airships divided into four main categories: the legacy of NASA Ames in LTA (Lighter-Than-Air), LTA taxonomy and theory, LTA revival and missions, and LTA research and technology.

Melton, John E.↗
NASA NTRS2017

General Nobile and the Airship Italia: No Second-In-Command

The airship Italia, commanded by General Umberto Nobile, crashed during its return flight from the North Pole in 1928. Prior work has demonstrated the possibility that this crash was fatigue-related, due to significant sleep-deprivation on the part of its Commander, and to resulting errors in cognition and judgment. However, the underlying cause of the fatigue was likely due to the fact that the Commander did not have a Second-In-Command on board to take over duties while the Commander was allowed to rest. At that time the Second-In-Command was a formally designated position, and according to Nobiles previous writings was considered to be a necessary crew member on an airship.

Second-In-Command↗
NASA NTRS2019

Discrete Lattice Material Vacuum Airship

Vacuum airships fueled by renewable energy would reduce reliance on fossil fuel-based modes of transport, lessen the need for limited and non-renewable lifting gases, and can be achieved using novel manufacturing techniques for ultra-light, discrete lattice material systems.The Discrete Lattice Material Vacuum Airships (DLMVA) system combines novel material science and manufacturing technologies for new modes of mass transportation, resulting in a disruptive approach to reduce national resource consumption and emissions. Through the use of high performance building block elements, modular, scalable and extensible aircraft can be rapidly assembled into positive net-buoyancy systems utilizing a vacuum instead of a lifting gas. By using architected lattice material principles, show that lattice materials can overcome stability limitations of previous vacuum balloon designs. Additionally, we show that lattice vacuum balloons are strength limited, rather than stability limited. As a result,airborne infrastructure can be developed to support the proliferation of modern systems such as e-commerce and distributed communications, while simultaneously reducing dependence on finite, non-renewable, emission-heavy resources.

Jenett, Benjamin E.↗
NASA NTRS2022

Towards Finding Energy Efficient Paths for Hybrid Airships in the Atmosphere of Venus

This paper presents a solution to the motion planning problem for an autonomous airship under superrotation winds of the Venusian atmosphere. The airship uses both buoyancy and aerodynamic lift to control its altitude. In addition, solar panels distributed over the aircraft provide energy to the propellers and allow for battery recharging. Our approach uses a sampling-based planner that relies on Dubins’ Airplane paths deformed under the influence of the winds to create a tree of kinematically feasible trajectories. We use the battery state to prune energetically unfeasible trajectories and we propose a cost function that accounts for the energy expenditure of the propulsive system and that considers battery charging by using the Economics notion of opportunity cost. The method is illustrated through a series of simulations that show how the vehicle takes longer and high-altitude paths to minimize the use of energy and favor battery recharge. Our results also show that naive trajectories are not feasible in terms of energy, justifying the need for more efficient solutions.

Bernardo Martinez R. Jr↗
NASA NTRS2016

Modeling and Simulation Tools for Heavy Lift Airships

For conventional fixed wing and rotary wing aircraft a variety of modeling and simulation tools have been developed to provide designers the means to thoroughly investigate proposed designs and operational concepts. However, lighter-than-air (LTA) airships, hybrid air vehicles, and aerostats have some important aspects that are different from heavier-than-air (HTA) vehicles. In order to account for these differences, modifications are required to the standard design tools to fully characterize the LTA vehicle design and performance parameters.. To address these LTA design and operational factors, LTA development organizations have created unique proprietary modeling tools, often at their own expense. An expansion of this limited LTA tool set could be accomplished by leveraging existing modeling and simulation capabilities available in the National laboratories and public research centers. Development of an expanded set of publicly available LTA modeling and simulation tools for LTA developers would mitigate the reliance on proprietary LTA design tools in use today. A set of well researched, open source, high fidelity LTA design modeling and simulation tools would advance LTA vehicle development and also provide the analytical basis for accurate LTA operational cost assessments. This paper will present the modeling and analysis tool capabilities required for LTA vehicle design, analysis of operations, and full life-cycle support. A survey of the tools currently available will be assessed to identify the gaps between their capabilities and the LTA industry's needs. Options for development of new modeling and analysis capabilities to supplement contemporary tools will also be presented.

airship design and analysis↗
NASA NTRS1923

The effect of bow stiffeners in nonrigid airships

It is now well known that all nonrigid airships constructed at the present time have bow stiffeners consisting of battens curved to the form of the envelope and designed to hold the nose of the ship in its true form despite the very large pressure which exists at the extreme forward point. The effect of the stiffeners is to reduce considerably the apparent pressure which has to be maintained inside the envelope in order to prevent the nose from caving in.

AIRSHIP NOSES - STIFFENING↗
NASA NTRS1922

The choice of the speed of an airship

The favorable speed of an airship is chiefly determined by the condition of the consumption of the least amount of fuel per unit of traveled distance, although other conditions come into play. The resulting rules depend on the character of the wind and on the variability of the efficiency of the engine propeller units. This investigation resulted in the following rules. 1) Always keep the absolute course and steer at such an angle with reference to it as to neutralize the side wind. 2) In a strong contrary wind, take a speed one and one half times the velocity of the wind. 3) As a general rule, take the velocity of the wind and the velocity of the course component of the wind. Add them together if the wind has a contrary component, but subtract them from each other if the wind has a favorable component.

AIRSHIPS - SPEED↗
NASA NTRS1922

The future of the airship

The author discusses the safety record of airships in light of the accidents with the Roma and the ZR2.

AIRSHIPS↗
NASA NTRS1922

Causes of failure of airship sheds

Different causes of airship shed collapse are discussed, with suction and human carelessness being the prime causes.

AIRSHIPS SHEDS - GERMANY↗
NASA NTRS1923

Replacing the weight of materials consumed on airships

Two methods to replace the weight of gas lost on long airship flights are discussed: condensing the water of combustion and thermic sustentation. In the present article we will discuss the first method, leaving the second to be examined in a subsequent article.

AIRSHIPS↗
NASA NTRS1924

Mooring airships

The purpose of this paper is to summarize the present status of the problem of mooring airships. Mooring with one, two and even three cables are all discussed.

HANGERS, LAUNCHING & LANDING DEVICES↗
NASA NTRS1975

Feasibility study of modern airships, phase 1. Volume 1: Summary and mission analysis (tasks 2 and 4)

The histroy, potential mission application, and designs of lighter-than-air (LTA) vehicles are researched and evaluated. Missions are identified to which airship vehicles are potentially suited. Results of the mission analysis are combined with the findings of a parametric analysis to formulate the mission/vehicle combinations recommended for further study. Current transportation systems are surveyed and potential areas of competition are identified as well as potential missions resulting from limitations of these systems. Potential areas of military usage are included.

Bloetscher, F.↗
NASA NTRS1975

Potential missions for advanced airships

The freight commodity transport and the intercity passenger travel markets in the U.S. for 1967 and 1972 are analyzed, along with 1985 estimates, in order to establish the size, speed and cost enabling use of the airship in these markets. Items examined include frozen meat, confectionary, drugs, electrical equipment, mechanical parts, clothing and plastic products. A 50 ton/500 passenger payload capacity, a cruise speed of 100 kt and a VTOL capability or at minimum short take-off and vertical landing capability are needed to make an LTA vehicle viable in the transport market if it had a direct operating cost of $500 to $800 per hour for freight carrying and $1100 to $2700 an hour in passenger service with utilizations between 2000 hours and 4000 hours a year.

Grant, D. T.↗
NASA NTRS1975

Comparative airship economics

As future LTA vehicles will be doomed right from the start if they do not fill a real need, some differences in transport philosophy between design engineers on the one hand and freight forwarders on the other are discussed. Watching rising costs of energy necessary to transport our cargo from A to B, and realizing that this price of energy is always included in the product's selling price at B, the apparent correlation between installed specific tractive force per unit of cargo weight and pure freighting cost are contemplated. Very speedy and progressive Airship designs are mistrusted, because the key to any low cost transport tool is to design it for its given task only, without any unnecessary sophistication.

Harthoorn, R.↗