Search NASA⌕ Search

SEARCH · Search NASA

Results for “CONTROLS, LATERAL”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5

Wind modeling and lateral control for automatic landing

For the purposes of aircraft control system design and analysis, the wind can be characterized by a mean component which varies with height and by turbulent components which are described by the von Karman correlation model. The aircraft aero-dynamic forces and moments depend linearly on uniform and gradient gust components obtained by averaging over the aircraft's length and span. The correlations of the averaged components are then approximated by the outputs of linear shaping filters forced by white noise. The resulting model of the crosswind shear and turbulence effects is used in the design of a lateral control system for the automatic landing of a DC-8 aircraft.

Holley, W. E.↗

The Effect of Airfoil Thickness and Plan Form on Lateral Control

This investigation was carried out for the purpose of determining the effectiveness of ailerons and tests were made on six model airfoils in the no. 1 wind tunnel of the National Advisory Committee for Aeronautics. The method consisted in measuring the rolling moments and aileron moments in the ordinary way. In addition to this the wing was allowed to spin freely about an axis in the direction of the air flow and the angular velocity measured. The results show that the thickness of the airfoil has very little effect on either the rolling moment or the hinge moment, although the resulting efficiency is somewhat higher for the tapered wings. The airfoil tapered in plan form, however, shows practically no falling off in the rolling moment at the critical angle of attack, whereas the wings of rectangular plan form show a marked dropping off in the rolling moment at this point. This indicates that it is possible to obtain good lateral control with small ailerons at low speed if the plan form is tapered. The rotational speed of the different airfoils is practically the same for all of the sections tested.

Hoot, H I↗

Wind-tunnel of three lateral-control devices in combination with a full-span slotted flap on an NACA 23012 airfoil

A large-chord NACA 23012 airfoil was tested. The airfoil extended completely across the test section, and two-dimensional flow was approximated. The model was fitted with a full-span slotted flap having a chord 25.66 percent of the airfoil chord. The ailerons investigated extended over the entire span and each had a chord 10 percent of the airfoil chord. The types of ailerons tested were: retractable ailerons, slot-lip ailerons using the lip of the slot for ailerons, and plain ailerons on the trailing edge of the slotted flap. The data are presented in the form of curves of section lift, drag, and pitching-moment coefficients for the airfoil with flap deflected but with ailerons neutral, and of rolling-moment, yawing-moment, and hinge-moment coefficients calculated for a rectangular wing of aspect ratio 6 with a semi-span aileron and a full-span flap. For the ailerons investigated the data indicate that, from considerations of rolling and yawing moments produced and of stick forces desired, the retractable aileron is the most satisfactory means of lateral control for use with a full-span slotted flap.

Wenzinger, Carl J↗

A LEX blowing technique for post-stall lateral control of trapezoidal wings

An exploratory low-speed wind-tunnel investigation of a pneumatic technique for LEX-induced lift augmetation on a low-aspect-ratio trapezoidal wing near C sub L, MAX is reported. The technique involved lateral sheet ejection from LEX edge-slots, with emphasis on nonsymmetrical blowing to obtain incremental roll control at high angles of attack when the aileron power is declining. Preliminary experiments on a pressure instrumented semispan wing model followed by force/moment measurements on a full-span LEX-wing configuration confirmed the effectiveness of LEX blowing for lateral control improvement up to an angle of attack of 45 deg and with a momentum coefficient of less than 02.

Rao, Dhanvada M.↗

Evaluation of HiMAT aircraft landing approach lateral control gearing using simulation and a visual display

The utility of a visual display when studying the influence of changes in lateral stick gearing gains on the Highly Maneuverable Aircraft Technology (HiMAT) vehicle handling qualities during simulated approaches and landings is investigated. The visual display improved the validity of the simulation and provided improved roll response cues for the HiMAT aircraft landing approach. A range of acceptable constant lateral stick gearing gains is found that provides adequate maneuverability and allows for precision moments.

Sarrafian, S. K.↗

Adaptive State Predictor Based Human Operator Modeling on Longitudinal and Lateral Control

Control-theoretic modeling of the human operator dynamic behavior in manual control tasks has a long and rich history. In the last two decades, there has been a renewed interest in modeling the human operator. There has also been significant work on techniques used to identify the pilot model of a given structure. The purpose of this research is to attempt to go beyond pilot identification based on collected experimental data and to develop a predictor of pilot behavior. An experiment was conducted to categorize these interactions of the pilot with an adaptive controller compensating during control surface failures. A general linear in-parameter model structure is used to represent a pilot. Three different estimation methods are explored. A gradient descent estimator (GDE), a least squares estimator with exponential forgetting (LSEEF), and a least squares estimator with bounded gain forgetting (LSEBGF) used the experiment data to predict pilot stick input. Previous results have found that the GDE and LSEEF methods are fairly accurate in predicting longitudinal stick input from commanded pitch. This paper discusses the accuracy of each of the three methods - GDE, LSEEF, and LSEBGF - to predict both pilot longitudinal and lateral stick input from the flight director's commanded pitch and bank attitudes.

Trujillo, Anna C.↗