Search NASA⌕ Search

SEARCH · Search NASA

Results for “FLAPPING FLIGHT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1934

Preliminary Wind-Tunnel and Flight Tests of a Balanced Split Flap, Special Report

One disadvantage that has been apparent in the operation of split flaps as used to date is the time and effort required to operate them. In this communication an investigation is being made of possible means for balancing them aerodynamically to make their operation easier. Several arrangements have been tested in the 7 by 210 foot wind tunnel, and the results of the wind-tunnel tests as well as preliminary flight tests on one of the more promising forms are given in this paper.

Weick, Fred E.↗
NASA NTRS1977

Aeroelastic stability of coupled flap-lag-torsional motion of helicopter rotor blades in forward flight

A set of coupled periodic nonlinear differential flap-lag-torsional equations of blade motion is described which can simulate a blade having a precone, twist, distributed torsion, root torsion, torque offset, blade-root offsets, and offsets among the elastic axis, the aerodynamic center, and the blade cross-sectional center of mass. It is noted that the aerodynamic loads derived for these equations are applicable to cases of both hover and forward flight. The aeroelastic stability of a hingeless helicopter blade is investigated by linearizing the nonlinear differential equations of motion about a time-dependent equilibrium position of the helicopter in forward flight, using propulsion and moment trim procedures. A comparison of the results with those obtained previously for coupled flap-lag-torsional boundaries in hover indicates that aeroelastic-stability margins are degraded due to forward flight.

Friedmann, P.↗
NASA NTRS1936

Flight Investigation of Lateral Control Devices for Use with Full-Span Flaps

This report presents the results of flight tests made on five different lateral control devices that appeared adaptable to wings fitted with full span flaps: controllable auxiliary airfoils (airfoils mounted above and forward of the leading edge of the wings), external ailerons (airfoils mounted above the wing and slightly forward of its maximum ordinate), upper-surface ailerons (similar to split trailing-edge flaps except that they constitute the upper surface of the wing), ailerons that retract into the wing when in neutral, and narrow-chord conventional ailerons in combination with a special type of split flap that retracts into the under surface of the wing forward of the ailerons. The devices were tested on a small parasol monoplane. Experienced gained in the use of flaps during these tests has indicated the desirability of a flap that can be operated quickly and easily.

Soule, H A↗
NASA NTRS1986

Lateral and longitudinal aerodynamic stability and control parameters of the basic vortex flap research aircraft as determined from flight test data

The aerodynamics of the basic F-106B were determined at selected points in the flight envelope. The test aircraft and flight procedures were presented. Aircraft instrumentation and the data system were discussed. The parameter extraction procedure was presented along with a discussion of the test flight results. The results were used to predict the aircraft motions for maneuvers that were not used to determine the vehicle aerodynamics. The control inputs used to maneuver the aircraft to get data for the determination of the aerodynamic parameters were discussed in the flight test procedures. The results from the current flight tests were compared with the results from wind tunnel test of the basic F-106B.

Suit, W. T.↗
NASA NTRS1989

Flap-lag stability data for a small-scale isolated hingeless rotor in forward flight

An isolated, hingeless rotor with discrete flap and lead-lag flexures and relatively rigid blades was tested in the Aeroflightdynamics Directorate's 7- by 10-Foot Wind Tunnel. The lead-lag stability of a structurally simple rotor configuration in forward flight was determined. The model tested had no cyclic pitch control, and was therefore operated untrimmed at several collective pitch angles, at shaft angles from 0 deg to -20 deg, and at advance ratios as high as 0.55. Two inplane natural frequencies, 0.61/rev and 0.72/rev, were tested for configuration both with and without structural flap lag coupling. Concomitant hover testing of the model was also conducted. Representative plots of the frequency and damping data are presented to show general trends, and complete tabular data and model properties information are included for use in detailed correlation exercises. The most prominent feature of the forward flight data is an abrupt increase in damping with advance ratio at certain high-speed, high shaft-angle conditions, with high flapping loads. The hover data are consistent with previous experimental and theoretical results for hingeless rotors without kinematic couplings. Overall, the data quality is very good and the data are expected to be useful in the development and validation of rotor aeroelastic stability analyses.

Mcnulty, Michael J.↗
NASA NTRS2016

Aerodynamic Flight-Test Results for the Adaptive Compliant Trailing Edge

The aerodynamic effects of compliant flaps installed onto a modified Gulfstream III airplane were investigated. Analyses were performed prior to flight to predict the aerodynamic effects of the flap installation. Flight tests were conducted to gather both structural and aerodynamic data. The airplane was instrumented to collect vehicle aerodynamic data and wing pressure data. A leading-edge stagnation detection system was also installed. The data from these flights were analyzed and compared with predictions. The predictive tools compared well with flight data for small flap deflections, but differences between predictions and flight estimates were greater at larger deflections. This paper describes the methods used to examine the aerodynamics data from the flight tests and provides a discussion of the flight-test results in the areas of vehicle aerodynamics, wing sectional pressure coefficient profiles, and air data.

aerodynamics↗
NASA NTRS1982

Coupled flap-lag-torsional dynamics of hingeless rotor blades in forward flight

The aeroelastic stability and response problem of the coupled flap-lag-torsional dynamics of an isolated hingeless rotor blade in forward flight is considered. Linear, quasi-steady aerodynamics below stall is included. The spatial dependence of the partial differential nonliner equations of motion is discretized using a multimodal Galerkin method. The nonlinear time dependent equilibrium position (steady state response) about which the equations are linearized is obtained by solving a sequence of linear periodic response problems (quasilinearization). Results illustrating blade behavior in forward flight for both soft-in-plane and stiff-in-plane designs are presented. Quasilinearization provides a clear indication of the cases when nonlinear terms due to moderate deflections are important. The results indicate that nonlinearities affect system stability much more than system response. This implies that for obtaining blade vibrations and loads, approximate analytical models based on linearized formulations could be employed, whereas for determining blade stability a more accurate nonlinear analysis would be required.

Friedmann, P. P.↗
NASA NTRS1993

Flap-lag damping in hover and forward flight with a three-dimensional wake

Prediction of lag damping is difficult owing to the delicate balance of drag, induced drag and Coriolis forces in the in-plane direction. Moreover, induced drag is sensitive to dynamic wake, both shed and trailing components, and thus its prediction requires adequate unsteady-wake representation. Accordingly, rigid-blade flap-lag equations are coupled with a three-dimensional finite-state wake model; three isolated rotor configurations with three, four and five blades are treated over a range of thrust levels, Lock numbers, lag frequencies and advance ratios. The investigation includes convergence characteristics of damping with respect to the number of radial shape functions and harmonics of the wake model for multiblade modes of low frequency (less than 1/rev.) to high frequency (greater than 1/rev.). Predicted flap and lag damping levels are then compared with similar predictions with (1) rigid wake (no unsteady induced flow, (2) Loewy lift defficiency and (3) dynamic inflow. The coverage also includes correlations with the measured lag regressive-mode damping in hover and forward flight and comparisons with similar correlations with dynamic wake model are consistently higher than the predictions with the dynamic inflow model; even for the low frequency lag regressive mode, the number of wake harmonics should at least be equal to twice the number of blades.

Manjunath, A. R.↗
NASA NTRS1977

Flight test results for an advanced technology light airplane

A single-engine light airplane was modified by the installation of a wing with reduced area, Fowler flaps, Kruger flaps, and spoilers. Flight test results show that zero-lift drag was reduced 13.8% and a trimmed maximum lift coefficient of 2.73 was achieved. Gust response was significantly reduced and excellent roll control was achieved with spoilers. Several design features employed in the new wings have excellent potential for incorporation in future light airplanes.

Kohlman, D. L.↗
NASA NTRS1995

Analysis of in-flight boundary-layer state measurements on a subsonic transport wing in high-lift configuration

Flight experiments on NASA Langley's B737-100 (TSRV) airplane have been conducted to document flow characteristics in order to further the understanding of high-lift flow physics, and to correlate and validate computational predictions and wind-tunnel measurements. The project is a cooperative effort involving NASA, industry, and universities. In addition to focusing on in-flight measurements, the project includes extensive application of various computational techniques, and correlation of flight data with computational results and wind-tunnel measurements. Results obtained in the most recent phase of flight experiments are analyzed and presented in this paper. In-flight measurements include surface pressure distributions, measured using flush pressure taps and pressure belts on the slats, main element, and flap elements; surface shear stresses, measured using Preston tubes; off-surface velocity distributions, measured using shear-layer rakes; aeroelastic deformations of the flap elements, measured using an optical positioning system; and boundary-layer transition phenomena, measured using hot-film anemometers and an infrared imaging system. The analysis in this paper primarily focuses on changes in the boundary-layer state that occurred on the slats, main element, and fore flap as a result of changes in flap setting and/or flight condition. Following a detailed description of the experiment, the boundary-layer state phenomenon will be discussed based on data measured during these recent flight experiments.

vanDam, C. P.↗
NASA NTRS1992

Flap-lag damping in hover and forward flight with a three-dimensional wake

Prediction of lag damping is difficult owing to the delicate balance of drag, induced drag and Coriolis forces in the in-plane direction. Moreover, induced drag is sensitive to dynamic wake, both shed and trailing components, and thus its prediction requires adequate unsteady-wake representation. Accordingly, rigid-blade flap-lag equations are coupled with a three-dimensional finite-state wake model; three isolated rotor configurations with three, four and five blades are treated over a range of thrust levels, Lock numbers, lag frequencies and advance ratios. The investigation includes convergence characteristics of damping with respect to the number of shape functions and harmonics of the wake model for multiblade modes of low frequency (less than 1/rev.) to high frequency (greater than l/rev.). Predicted flap and lag damping levels are then compared with similar predictions with (1) rigid wake (no unsteady induced flow), (2) Loewy lift deficiency, and (3) dynamic inflow.

Manjunath, A. R.↗
NASA NTRS1976

An experimental investigation of the flap-lag stability of a hingeless rotor with comparable levels of hub and blade stiffness in hovering flight

An experimental investigation of the flap-lag stability of a hingeless rotor in hovering flight is presented and discussed. The rotor blade and hub configuration were selected such that the hub and blade had comparable levels of bending stiffness. Experimental measurements of the lag damping were made for various values of rotor rotational speed and blade pitch angle. Specifically at a blade pitch angle of 8 deg at three-quarters radius, the lag damping was determined over a range of rotational speeds from 200 RPM to 320 RPM and also over a range of blade pitch angles from 0 deg to 8 deg.

Curtiss, H. C., Jr.↗
NASA NTRS1979

The size and performance effects of high lift system technology on a modern twin engine jet transport

The energy and economic benefits of low-speed aerodynamic system technology applied to a modern 200-passenger, 2000-nmi range, twin engine jet transport are reviewed. Results of a new method to design flap systems at flight Reynolds number are summarized. The study contains the airplane high lift configuration drag characteristics and design selection charts showing the effect of flap technology on the airplane size and performance. The study areas include: wing and flap geometry, climb and descent speed schedules with partial flap deflection, flap system technology, and augmented stability. The results compare the improvements in payload from a hot, high elevation airport.

Sullivan, R. L.↗
NASA NTRS1947

High-Speed Wind-Tunnel Tests of a Model of the Lockheed YP-80A Airplane Including Correlation with Flight Tests and Tests of Dive-Recovery Flaps

This report contains the results of tests of a 1/3-scale model of the Lockheed YP-90A "Shooting Star" airplane and a comparison of drag, maximum lift coefficient, and elevator angle required for level flight as measured in the wind tunnel and in flight. Included in the report are the general aerodynamic characteristics of the model and of two types of dive-recovery flaps, one at several positions along the chord on the lower surface of the wing and the other on the lower surface of the fuselage. The results show good agreement between the flight and wind-tunnel measurements at all Mach numbers. The results indicate that the YP-80A is controllable in pitch by the elevators to a Mach number of at least 0.85. The fuselage dive-recovery flaps are effective for producing a climbing moment and increasing the drag at Mach numbers up to at least 0.8. The wing dive-recovery flaps are most effective for producing a climbing moment at 0.75 Mach number. At 0.85 Mach number, their effectiveness is approximately 50 percent of the maximum. The optimum position for the wing dive-recovery flaps to produce a climbing moment is at approximately 35 percent of the chord.

Cleary, Joseph W.↗
NASA NTRS1975

Comparison of model and flight test data for an augmented jet flap STOL research aircraft

Aerodynamic design data for the Augmented Jet Flap STOL Research Aircraft or commonly known as the Augmentor-Wing Jet-STOL Research Aircraft was based on results of tests carried out on a large scale research model in the NASA Ames 40- by 80-Foot Wind Tunnel. Since the model differs in some respects from the aircraft, precise correlation between tunnel and flight test is not expected, however the major areas of confidence derived from the wind tunnel tests are delineated, and for the most part, tunnel results compare favorably with flight experience. In some areas the model tests were known to be nonrepresentative so that a degree of uncertainty remained: these areas of greater uncertainty are identified, and discussed in the light of subsequent flight tests.

Cook, W. L.↗
NASA NTRS1973

Non-linear flap-lag dynamics of hingeless helicopter blades in hover and in forward flight.

The aeroelastic instability of the coupled nonlinear flap-lag motion of a torsionally rigid helicopter blade is treated by using the perturbation method in multiple time scales. The nonlinearities present in the equations are those arising from the inclusion of moderately large deflections in the inertia and aerodynamic loading terms. The stability boundaries, amplitudes of nonlinear response, and conditions for existence of limit cycles are obtained analytically. Thus the different roles played by the forcing, parametric excitation, and nonlinear coupling in affecting the solution can be easily identified. Numerical results illustrating the behavior of the blade are presented.

Friedmann, P.↗