Search NASA⌕ Search

SEARCH · Search NASA

Results for “Flow stability”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Transonic calculation of airfoil stability and response with active controls

Transonic aeroelastic stability and response analyses are performed for the MBB A-3 supercritical airfoil. Three degrees of freedom are considered: plunge, pitch, and aileron pitch. The objective of this study is to gain insight into the control of airfoil stability and response in transonic flow. Stability analyses are performed using a Padeaeroelastic model based on the use of the LTRAN2-NLR transonic small-disturbance finite-difference computer code. Response analyses are performed by coupling the structural equations of motion to the unsteady aerodynamic forces of LTRAN2-NLR. The focus of the present effort is on transonic time-marching transient response solutions using modal identification to determine stability. Frequency and damping of these modes are directly compared in the complex s-plane with Pademodel eigenvalues. Transonic stability and response characteristics of two-dimensional airfoils are discussed and comparisons are made. Application of the Padeaeroelastic model and time-marching analyses to flutter suppression using active controls is demonstrated.

Batina, J. T.↗
NASA NTRS1991

Stability of compressible Taylor-Couette flow

Compressible stability equations are solved using the spectral collocation method in an attempt to study the effects of temperature difference and compressibility on the stability of Taylor-Couette flow. It is found that the Chebyshev collocation spectral method yields highly accurate results using fewer grid points for solving stability problems. Comparisons are made between the result obtained by assuming small Mach number with a uniform temperature distribution and that based on fully incompressible analysis.

Kao, Kai-Hsiung↗
NASA NTRS1976

Influence of heat transfer on the stability of parallel flow between concentric cylinders

The stability of the parallel flow of water between concentric cylinders at different temperatures is investigated for infinitesimal velocity and pressure disturbances. Primary interest is in the effect of heat transfer and the radius ratio a/b on the critical point of the neutral stability curve. The results indicate a strong dependence of the critical eigenvalues on both the heat transfer and the radius ratio. The critical Reynolds number of the nonisothermal flow appears to approach a finite value as the inner radius approaches zero (pipe flow) by showing an inflection point on the curve of critical Reynolds number vs a/b.

Choo, Y. K.↗
NASA NTRS2012

Transient Side Load Analysis of Out-of-Round Film-Cooled Nozzle Extensions

There was interest in understanding the impact of out-of-round nozzle extension on the nozzle side load during transient startup operations. The out-of-round nozzle extension could be the result of asymmetric internal stresses, deformation induced by previous tests, and asymmetric loads induced by hardware attached to the nozzle. The objective of this study was therefore to computationally investigate the effect of out-of-round nozzle extension on the nozzle side loads during an engine startup transient. The rocket engine studied encompasses a regeneratively cooled chamber and nozzle, along with a film cooled nozzle extension. The computational methodology is based on an unstructured-grid, pressure-based computational fluid dynamics formulation, and transient inlet boundary flow properties derived from an engine system simulation. Six three-dimensional cases were performed with the out-of-roundness achieved by three different degrees of ovalization, elongated on lateral y and z axes: one slightly out-of-round, one more out-of-round, and one significantly out-of-round. The results show that the separation line jump was the primary source of the peak side loads. Comparing to the peak side load of the perfectly round nozzle, the peak side loads increased for the slightly and more ovalized nozzle extensions, and either increased or decreased for the two significantly ovalized nozzle extensions. A theory based on the counteraction of the flow destabilizing effect of an exacerbated asymmetrical flow caused by a lower degree of ovalization, and the flow stabilizing effect of a more symmetrical flow, created also by ovalization, is presented to explain the observations obtained in this effort.

Wang, Ten-See↗
NASA NTRSDate not supplied

The Plant Water Management Experiments: Hydroponics 3 & 4

As humans consider longer-duration missions in space, NASA has identified production of fresh vegetables aboard spacecraft as beneficial for crew nutrition, mental wellbeing, and enabling bioregenerative life support (i.e., air, water, and waste processing). Current low-g plant growth techniques have successfully grown a variety of leafy and flowering plants. However, unique microgravity fluidics challenges to maintain plant moisture levels persist which hamper overall system reliability. The Plant Water Management (PWM) experiments seek to demonstrate low-cost, low-mass, reusable plant growth systems that leverage recent advances in low-g capillary fluidics phenomena to provide routine, largely passive, water delivery to plants. This paper presents findings from a series of PWM-Hydroponics 3 & 4 experiments, which were collected during three ISS flight operations that occurred in March, May, and July of 2021. Open hydroponic capillary channel flows with synthetic evapo-transpiring plant models were used. Tests demonstrated flow stability for single and parallel channel flow configurations across a range of flow rates, plant types, and plant arrangements. Technology demonstrations of both passive aeration and bubble phase separation are reported. We provide details of the data reduction and archive. Insights from the successful flight demonstrations provide a foundation from which follow-on PWM-Hydroponics 5 & 6 experiments on ISS, potentially incorporate living plants, are being considered. Xx Summary of positives and negatives..

Marc B. Wasserman↗
NASA NTRS1991

On the stability of compressible flow past axisymmetric bodies

Compressible linear stability theory for axisymmetric flows is presented. The theory is applied to flow past a cylinder and a sharp cone at a Mach number of 5 with adiabatic wall conditions. The effect of transverse curvature and body divergence is studied. It is found that transverse curvature has a stabilizing influence on axisymmetric (first and second mode) disturbances while it has a destabilizing influence on the asymmetric (oblique first mode) disturbances. The body divergence effects are stabilizing for both symmetric and asymmetric disturbances. Comparisons made with the results of planar stability theory show that, for a cylinder, curvature effects become more pronounced with increasing distance along the cylinder. For a sharp cone, these effects become less significant further away from the cone tip since the body radius increases faster than the growth of the boundary layer. The effect of cone angle on stability is also studied.

Malik, M. R.↗
NASA NTRS1983

Complex eigenvalues for the stability of Couette flow

The eigenvalue problem for the linear stability of Couette flow between rotating concentric cylinders to axisymmetric disturbances is considered. It is shown by numerical calculations and by formal perturbation methods that when the outer cylinder is at rest there exist complex eigenvalues corresponding to oscillatory damped disturbances. The structure of the first few eigenvalues in the spectrum is discussed. The results do not contradict the principle of exchange of stabilities, namely, for a fixed axial wavenumber the first mode to become unstable as the speed of the inner cylinder is increased is nonoscillatory as the stability boundary is crossed.

Diprima, R. C.↗
NASA NTRS1988

A spectral collocation solution to the compressible stability eigenvalue problem

A newly developed spectral compressible linear stability code (SPECLS) (staggered pressure mesh) is presented for analysis of shear flow stability, and applied to high speed boundary layers and free shear flows. The formulation utilizes the first application of a staggered mesh for a compressible flow analysis by a spectral technique. An order of magnitude less number of points is needed for equivalent accuracy of growth rates compared to those calculated by a finite difference formulation. Supersonic disturbances which are found to have oscillatory structures were resolved by a spectral multi-domain discretization, which requires a factor of three fewer points than the single domain spectral stability code. It is indicated, as expected, that stability of mixing layers is enhanced by viscosity and increasing Mach number. The mean flow involves a jet being injected into a quiescent gas. Higher temperatures of the injected gas is also found to enhance stability characteristics of the free shear layer.

Macaraeg, Michele G.↗
NASA NTRS1993

Stability of oscillatory two phase Couette flow

We investigate the stability of two phase Couette flow of different liquids bounded between plane parallel plates. One of the plates has a time dependent velocity in its own plane, which is composed of a constant steady part and a time harmonic component. In the absence of time harmonic modulations, the flow can be unstable to an interfacial instability if the viscosities are different and the more viscous fluid occupies the thinner of the two layers. Using Floquet theory, we show analytically in the limit of long waves, that time periodic modulations in the basic flow can have a significant influence on flow stability. In particular, flows which are otherwise unstable for extensive ranges of viscosity ratios, can be stabilized completely by the inclusion of background modulations, a finding that can have useful consequences in many practical applications.

Coward, Adrian V.↗
NASA NTRS1982

Steady thermocapillary flows and their stability

Thermocapillarity can drive steady flows in float-zone configurations. These flows can become unstable and exhibit time-periodic oscillations. In order to obtain insight into such phenomena, studies are made of a simplified system consisting of liquid in a two-dimensional slot. Steady flows and their instabilities are examined.

Sen, A. K.↗
NASA NTRS1976

Stability of laser heated flows

A local stability analysis is utilized to determine the stability of disturbances generated at each point along a nozzle of variable area ratio for a one-dimensional flow heated by laser radiation entering from the upstream direction. The governing equations for the quasi-one-dimensional flow without viscous dissipation, diffusion, and thermal conduction but including radiative heat transfer are given. The governing equations are combined to yield a relationship which governs the Mach number variation through the nozzle. The complete steady-state solution can be calculated from knowledge of the Mach number profile, the inlet conditions, and the laser power. The local stability analysis permits obtaining contour (or contours) of neutral stability. Solutions have been obtained for various nozzle configurations, but only one set of example calculations is presented. The results obtained indicate that the analysis serves as an important indicator as to where potential absorption wave phenomena may be initiated.

Wu, P. K. S.↗
NASA NTRS1983

Morphological and convective instabilities during solidification

Linear stability theory is employed in the present analysis of flow stability between two vertical, infinite, rigid coaxial cylinders at different temperatures. These calculations have been prompted by, and are found to be in general agreement with, experiments on succinonitrile. A long, vertical cylinder sample of this material was heated so that a vertical melt annulus formed between the coaxial heater and the surrounding crystal/melt interface. Above a critical Grashof number of about 200, a helical crystal/melt interface formed which steadily rotated about the cylinder axis and whose wave speed was several orders of magnitude lower than the base flow velocity.

Coriell, S. R.↗
NASA NTRS1992

A different view of plasma flow inside P/Halley

The Giotto spacecraft carried two different instruments - the JPA and the IMS - for the observation of hot ions in the coma of P/Halley. Although there are many similarities in the time and distance profiles of the plasma flow parameters (bulk velocity, number density, and temperature) computed from the two data sets, there are also some significant differences, especially at cometocentric distances less than 500,000 km. The principal discrepancies between the JPA results presented by Formisano et al. (1990) and the IMS observations are: (1) the IMS did not detect the levelling off of the speed and temperature profiles that Formisano et al. interpreted as flow stabilization; (2) the IMS detected differential north-south flow between the solar wind and cometary ions for only a brief interval when the magnetic field was oriented nearly southward, whereas Formisano et al. reported more extensive differential north-south flow that was independent of the direction of the field; (3) the JPA ion densities were factors of 2 to 4 higher than the IMS ion densities which, in turn, were an order of magnitude greater than theoretical values.

Neugebauer, M.↗