Search NASA⌕ Search

SEARCH · Search NASA

Results for “ISENTROPIC PROCESSES”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5

Aerodynamic Improvement of a Compact Centrifugal Compressor

For the example of the JetCat P-200RX turbojet engine, optimization of the diffuser and straightening unit of a compact centrifugal compressor is considered, on the basis of a mathematical model of viscous turbulent air flow. The goal of optimization is to increase the isentropic (adiabatic) efficiency of the compressor.

42 ENGINEERING↗

Planetary Torque in 3D Isentropic Disks

Planetary migration is inherently a three-dimensional (3D) problem, because Earth-size planetary cores are deeply embedded in protoplanetary disks. Simulations of these 3D disks remain challenging due to the steep resolution requirements. Using two different hydrodynamics codes, FARGO3D and PEnGUIn, we simulate disk–planet interaction for a one to five Earth-mass planet embedded in an isentropic disk. We measure the torque on the planet and ensure that the measurements are converged both in resolution and between the two codes. We find that the torque is independent of the smoothing length of the planet’s potential ( r {sub s}), and that it has a weak dependence on the adiabatic index of the gaseous disk ( γ ). The torque values correspond to an inward migration rate qualitatively similar to previous linear calculations. We perform additional simulations with explicit radiative transfer using FARGOCA, and again find agreement between 3D simulations and existing torque formulae. We also present the flow pattern around the planets that show active flow is present within the planet’s Hill sphere, and meridional vortices are shed downstream. The vertical flow speed near the planet is faster for a smaller r {sub s} or γ , up to supersonic speeds for the smallest r {sub s} and γ in our study.

79 ASTRONOMY AND ASTROPHYSICS↗

Review of critical flow rate, propagation of pressure pulse, and sonic velocity in two-phase media

For single-phase media, the critical discharge velocity, the sonic velocity, and the pressure pulse propagation velocity can be expressed in the same form by assuming isentropic, equilibria processes. In two-phase mixtures, the same concept is not valid due to the existence of interfacial transports of momentum, heat, and mass. Thus, the three velocities should be treated differently and separately for each particular condition, taking into account the various transport processes involved under that condition. Various attempts are reviewed to predict the critical discharge rate or the propagation velocities by considering slip ratio (momentum change), evaporation (mass and heat transport), flow pattern, etc. Experimental data were compared with predictions based on various theorems. The importance is stressed of the time required to achieve equilibrium as compared with the time available during the process, for example, of passing a pressure pulse.

Hsu, Y.↗

Release adiabat measurements on minerals: The effect of viscosity

The current inversion of pressure-particle velocity data for release from a high pressure shock state to a pressure-density path is analyzed. It is assumed that the release process is isentropic. It was shown that for geological materials below stresses of 150 GPa, the effective viscosity must be 1000 kg/m/s in order that the viscous (irreversible) work carried out on the material in the shock state remains small compared to the mechanical work recovered upon adiabatic rarefaction. The available data pertaining to the offset of the Rayleigh line from the Hugoniot for minerals, the magnitude of the shear stress in the high pressure shock state for minerals, and the direct measurements of the viscosities of several engineering materials shocked to pressures below 150 GPa yield effective viscosities of 1000 kg/m/s or less. An inferance that this indicates that the conditions for isentropic release of minerals from shock states are achieved, and a conclusion that the application of the Riemann integral to obtain pressure-density states along the release adiabats of minerals in shock experiments is valid are made.

Jeanloz, R.↗

Release adiabat measurements on minerals - The effect of viscosity

The paper examines the effect of viscosity in the release adiabat measurements on minerals. The current inversion of pressure-particle velocity data for release from a high-pressure shock state to a pressure-density path usually depends critically upon the assumption that the release process is isentropic. It has been shown that the effective viscosity for geological materials below stresses of 150 GPa must be at least 1000 kg/m/s so that viscous work in the shock state remains small compared to mechanical work recovered upon adiabatic rarefaction. The magnitude of the shear stress in the shock state in minerals and viscosities of engineering materials shocked to pressures below 150 GPa show effective viscosities of about 1000 kg/m/s or less indicating that the conditions for isentropic release of materials from shock states are achieved and that the Riemann integral can be applied to obtain pressure-density states along the release adiabats of minerals.

Jeanloz, R.↗

Thermodynamic and fluid mechanic analysis of rapid pressurization in a dead-end tube

Three models have been applied to very rapid compression of oxygen in a dead-ended tube. Pressures as high as 41 MPa (6000 psi) leading to peak temperatures of 1400 K are predicted. These temperatures are well in excess of the autoignition temperature (750 K) of teflon, a frequently used material for lining hoses employed in oxygen service. These findings are in accord with experiments that have resulted in ignition and combustion of the teflon, leading to the combustion of the stainless steel braiding and catastrophic failure. The system analyzed was representative of a capped off-high-pressure oxygen line, which could be part of a larger system. Pressurization of the larger system would lead to compression in the dead-end line, and possible ignition of the teflon liner. The model consists of a large plenum containing oxygen at the desired pressure (500 to 6000 psi). The plenum is connected via a fast acting valve to a stainless steel tube 2 cm inside diameter. Opening times are on the order of 15 ms. Downstream of the valve is an orifice sized to increase filling times to around 100 ms. The total length from the valve to the dead-end is 150 cm. The distance from the valve to the orifice is 95 cm. The models describe the fluid mechanics and thermodynamics of the flow, and do not include any combustion phenomena. A purely thermodynamic model assumes filling to be complete upstream of the orifice before any gas passes through the orifice. This simplification is reasonable based on experiment and computer modeling. Results show that peak temperatures as high as 4800 K can result from recompression of the gas after expanding through the orifice. An approximate transient model without an orifice was developed assuming an isentropic compression process. An analytical solution was obtained. Results indicated that fill times can be considerably shorter than valve opening times. The third model was a finite difference, 1-D transient compressible flow model. Results from the code show the recompression effect but predict much lower peak temperatures than the thermodynamic model.

Leslie, Ian H.↗

Validation of parameterization scheme for eddy diffusion from satellite data

The eddy diffusion coefficient K(yy) has been calculated usign LIMS for the months of December 1978 and January and February 1979. Two methods have been used. The first implements the suggestion made by Tung (1987) to parameterize the eddy transport as a diffusive process along isentropes. The second method integrates the equation relating the parcel displacements to the eddy velocity fields. The latter method uses a filtering on both space and time domains to isolate transients and is referred to as the 'spectral method'. Results from the first method are shown to be reliable only for quiescent periods, breaking down when the meridional gradient of potential vorticity is negligible. Results from the two methods are in agreement only for very disturbed conditions, when transience is readily isolated. It is concluded that the parameterizations suggested for eddy transport and calculated in this paper may be meaningful for quiet periods, but are not reliable for unsteady and very large amplitude disturbances.

Sassi, F.↗

Adaptation of existing facilities to isentropic compression experiments

We demonstrate that the established pulsed power infrastructure at the National High Magnetic Field Laboratory - Pulsed Field Facility (NHMFL-PFF) at the Los Alamos National Laboratory can be adapted to obtain high quality isentropic compression experiment (ICE) data on materials in extreme conditions of dynamic high pressure. Experiments utilized a single-turn magnet pulsed power system at the NHMFL-PFF that was originally designed to measure actinide samples in extremes of high magnetic field (to 300 Tesla). A simple modification to the single-turn magnet has converted it to a fast turnaround dynamic high pressure measurement system. This paper details the work done including important background details that indicate that much more can be accomplished with optimization of the load characteristics in terms of ultimate peak pressures. To match the rise time of the NHMFL capacitor bank ({approx}2 {mu}s versus {approx}0.5 {mu}s for the Sandia Z-machine) the sample dimensions can be relatively large, i.e., up to 5 mm thickness. The maximum stresses are {approx}50GPa (0.5 Mbar) at the maximum bank voltage (60 kV) and higher pressures may be possible if the sample is tamped. For the design and predictions of performance of the NHMFL-ICE experiment it is important to have good predictive models. A SPICE code simulation was chosen to model all aspects of the experiment, electrical and physical. To this end, accurate dynamic load models were developed to simulate the compression and expansion of the dynamic load at high pressures using shock physics principles. A series experiments have been performed which demonstrated the feasibility of the NHMFL-ICE technique. The results will be shown and discussed. The NHMFL-ICE technique is an excellent method for measuring equations of state (EOS) at megabar pressures. Because a complete EOS can be obtained in one experiment from zero to the peak pressure, and because many shots can be fired in one day, the technique promises to provide high quality EOS data at relatively low cost.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Variational particle scheme for the porous medium equation and for the system of isentropic Euler equations

We introduce variational particle schemes for the porous medium equation and the system of isentropic Euler equations in one space dimension. The methods are motivated by the interpretation of each of these partial differential equations as a 'steepest descent' on a suitable abstract manifold. We show that our methods capture very well the nonlinear features of the flows.

97 MATHEMATICS AND COMPUTING↗

The Life Cycle of Stratospheric Aerosol Particles

This paper describes the life cycle of the background (nonvolcanic) stratospheric sulfate aerosol. The authors assume the particles are formed by homogeneous nucleation near the tropical tropopause and are carried aloft into the stratosphere. The particles remain in the Tropics for most of their life, and during this period of time a size distribution is developed by a combination of coagulation, growth by heteromolecular condensation, and mixing with air parcels containing preexisting sulfate particles. The aerosol eventually migrates to higher latitudes and descends across isentropic surfaces to the lower stratosphere. The aerosol is removed from the stratosphere primarily at mid- and high latitudes through various processes, mainly by isentropic transport across the tropopause from the stratosphere into the troposphere.

Hamill, Patrick↗

The evolution of Ertel's potential vorticity during stratospheric sudden warmings

In the winter stratosphere of the Northern Hemisphere, the disruption of the westerly vortex and associated warming of polar latitudes is a well known phenomenon. It has become apparent that some important dynamical processes in the stratosphere are highly nonlinear and are best thought of locally rather than in terms of the interaction between the zonal-mean flow and harmonic waves around latitude circles. The importance of nonlinear processes was suggested by McIntyre and Palmer (1983, 1984) who used isentropic maps of Ertel's Potential Vorticity to show that during disturbed episodes material lines may become strongly and irreversibly deformed in certain places. They adopted the term planetary wave breaking to describe this process. Isentropic maps of Q are used to follow the evolution of a Canadian warming in November - December 1981 and a particularly strong warming in January 1982. The advection of Q over large distances on isentropic surfaces was a striking feature of the flow during each event. This could be identified because of our ability to follow the movement of material lines due to the approximate conservation of Q over several days. The advection of Q was a nonlinear process because its changing distribution affected the advecting wind field. The Canadian warming did not lead to a permanent change in the structure of the westerly vortex, as defined by the coarse-grain field of Q, whereas the January event was accompanied by a substantial loss of resolved Q which was never fully recovered.

Fairlie, T. D. A.↗

Studies of magnetocaloric effect on spin-1/2 J{sub 1}-J{sub 2} Heisenberg hexagons

Magnetocaloric effect of four different spin-1/2 J{sub 1}-J{sub 2} Heisenberg hexagons has been studied in terms of adiabatic demagnetization. Four hexagons with different combinations of antiferromagnetic and ferromagnetic Heisenberg exchange interactions are considered. Level of frustration on those models is different. Studies on the magnetization process, nature of isentrops and properties of magnetocaloric effect have been carried out. Comparison of results on those models has been discussed.

36 MATERIALS SCIENCE↗