SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Logarithmic transfer response circuit applied to recording mass spectra, especially peaks from metastable ions
Polarized helium 3 negative ion beam production utilizing differential metastability of hyperfine and fine structure levels
Time-resolved spectroscopic measurement of absolute intensity, spectral profiles and self- absorption for He I lines in early helium afterglow
Detection by coincidence counting techniques of two-photon decay of metastable state of singly ionized helium
Gravitation research - experimental test of Freundlich red-shift hypothesis and measurement of metastable vs ground-state electron exchange cross sections for helium and neon
Microwave and optical measurements of decay of neutral metastable and charged species in flowing He afterglow
Molecular metastables produced in positive column of helium discharge by electron excitation
Gamma decay of Se 73 and Se 81 isomeric pairs with half-lives, energies and decay schemes
Direct excitation in argon gas from metastable state to upper laser state compared with two-step excitation
Spontaneous annealing models of lithium- diffused Si solar cells, discussing defect compensation and metastable defect formation
Metastable helium atom addition to hydrogen plasma for ion cyclotron mode enhancement
Elastic scattering cross section for low energy electrons on metastable He atoms, using polarized orbital method
Experimental characteristics of a continuously pulsed copper halide laser with a cable-capacitor Blumlein discharge circuit are reported. Quartz laser tubes 1 m in length and 1.5 and 2.5 cm in diameter were employed to study the effects of the electrical circuit, lasant, and buffer gas on laser performance. Measured properties of the Blumlein circuit are compared with an analytic solution for an idealized circuit. Both CuCl and CuBr with neon and helium buffer gas were studied. A maximum average power of 12.5 W was obtained with a 1.5 nF capacitor charged to 8 kV and discharged at 31 kHz with CuCl and neon buffer gas at 0.7 kPa in a 2.5-cm-diam tube. A maximum efficiency of 0.72 percent was obtained at 9 W average power. Measurements of the radial distribution of the power in the laser beam and the variation of laser power at 510.6 and 578.2 nm with halide vapor density are also reported. Double and continuously pulsed laser characteristics are compared, and the role of copper metastable level atoms in limiting the laser pulse energy density is discussed.
The two-population model of Schmitt, Abreu and Hays (1981) is used to calculate the line shape of the atomic oxygen metastable state, nonthermal O(1D) 6300 A emission, in order to simulate observations made from a space platform at different zenith angles and altitudes. The Addition theorem, for spherical harmonics of a Legendre polynomial expansion of the nonthermal population distribution function, is used to obtain nonthermal line shapes observed at zenith angles other than the local vertical one.
The possibility of using an IBr laser as a solar-energy converter is examined theoretically, and reasons for its choice are given. Broadband absorption results in dissociation with the formation of excited metastable Br atoms, some of which then lase to the ground state Br. The ground state is depopulated by three-body recombination and, more importantly, by exchange reactions which more than compensate for the high quenching in heteronuclear halogen systems. Kinetic modeling indicates lasing is possible in the pulsed mode and possibly in the steady state with a cooled gas flow system. Temperature effects are discussed. The efficiency of the laser approaches 1.2 percent at optical thicknesses large enough for complete absorption of the photons.
Extended x-ray absorption fine structure (EXAFS) measurements of single-crystal Ge/GeSn radial heterostructure nanowires are used to examine the effects of composition on both short-range order (SRO) and longer-range disorder in GeSn alloys. GeSn has prompted significant interest because it can achieve a direct band gap for sufficient Sn concentrations beyond the equilibrium solid solubility limit in an all-group IV system. Short-range order in this material is particularly interesting as it has been predicted to affect the band gap independent of average composition or strain effects. By independently controlling the Sn composition and GeSn thickness during chemical vapor deposition of misfitting GeSn shells around ultrathin, elastically compliant, Ge core nanowires, the elastic misfit strain in the GeSn is minimized for Sn compositions over the studied range ≈Ge 0.96 Sn 0.04 to Ge 0.88 Sn 0.12 . The degree of SRO was found to decrease with increasing Sn composition. Additionally, damping of the EXAFS signal was observed as the Sn content increased, particularly for increasingly distant atomic shells about the absorbing atom, even for scattering paths not involving Sn atoms. This result is quantified as an increase in the mean-squared relative displacement parameters of the shells. These measurements reveal the accommodation of local strain due to the presence of the highly size-mismatched Sn atoms in the Ge diamond cubic lattice (≈14%), which may have effects on the band structure of the material in addition to the influence of short-range atomic order. Comparison among the nanowire samples allows for calculation of the topological rigidity parameter, a ∗∗ , for the first-neighbor bond lengths. Furthermore, these exhibit chemically distinct values for Ge-Ge, Ge-Sn, and Sn-Sn, and they are consistent with the value a ∗∗ = 0.75 ± 0.07 confirming the general applicability of the model to alloys with both large amounts of natural misfit strain and the potential for short-range order.
Here we generate an atomic beam of titanium (Ti) using a “Ti-ball” Ti-sublimation pump, which is a common getter pump used in ultrahigh vacuum systems. We show that the sublimated atomic beam can be optically pumped into the metastable 3d 3 ( 4 F)4s a 5 F 5 state, which is the lower energy level in a cycling optical transition that can be used for laser cooling. We measure the atomic density and transverse and longitudinal velocity distributions of the beam through laser fluorescence spectroscopy. We find a metastable atomic flux density of 4.3(2) × 10 9 s -1 cm -2 with a mean forward velocity of 773(8) m/s at 2.55 cm directly downstream of the center of the Ti-ball. Owing to the details of optical pumping, the beam is highly collimated along the transverse axis parallel to the optical pumping beam and the flux density falls off as 1/r. We discuss how this source can be used to load atoms into a magneto-optical trap.
The dynamics of reactive atoms at surfaces are centrally important to areas such as heterogeneous catalysis, corrosion, materials degradation in extreme environments, and plasma etching. Remarkably detailed understanding of dynamical processes at surfaces has been extracted from scattering molecules and inert atoms under well-defined conditions. However, traditional techniques for generating beams of reactive atoms often result in impure mixtures, broad energy distributions, and poorly defined contributions of metastable electronically excited atoms. In this perspective article, we review the state-of-the-art in reactive atom surface scattering with a focus on experiments performed under controlled conditions on well-defined surfaces. We highlight a new technique for controlled state-to-state scattering of polyelectronic atoms from surfaces, based on vacuum ultraviolet photolysis and state-selective ion imaging. The new capabilities provide an avenue for research into the underexplored area of excited state and spin selective chemical dynamics at surfaces.