Search NASA⌕ Search

SEARCH · Search NASA

Results for “ROLLING MOMENTS - WINGS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Flight-Determined Stability and Control Derivatives for an Executive Jet Transport

A modified maximum likelihood estimation (MMLE) technique which included a provision for including a priori information about unknown parameters was used to determine the aerodynamic derivatives of the Lockheed JetStar airplane. Two hundred sixty-five maneuvers were performed with the JetStar airplane, which was modified to include direct lift controls, to obtain lateral-directional and longitudinal derivatives. Data were obtained at altitudes of 3048 meters, 6096 meters, and 9144 meters (10,000 feet, 20,000 feet, and 30,000 feet) and over an angle of attack range from approximately 3 deg to 13 deg and a Mach number range from 0.25 to 0.75. Side force generators were installed and tested in 87 maneuvers to determine their effectiveness and their effect on the other derivatives. Lateral-directional data for four flight conditions were analyzed without using a priori information to assess the effect of this feature on the results. The MMLE method generally gave consistent (repeatable) estimates of the derivatives, with the exception of the rolling moment due to yaw rate, which showed large variances.

Smith, H. J.↗
NASA NTRS1976

A study of the two-control operation of an airplane

The two control operation of a conventional airplane is treated by means of the theory of disturbed motions. The consequences of this method of control are studied with regard to the stability of the airplane in its unconstrained components of motion and the movements set up during turn maneuvers. It is found that the motion of a conventional airplane is more stable when an arbitrary kinematic constraint is imposed in banking than when such constraint is imposed in yawing. Several hypothetical assumptions of piloting procedure, each of which is considered to represent a component of the actual procedure, are studied. Different means of two control operation are also discussed and it is concluded that a reliable rolling moment control that does not give the usual adverse secondary yawing moment should be most satisfactory.

Jones, R. T.↗
NASA NTRS1976

Transonic wind-tunnel tests of a lifting parachute model

Wind-tunnel tests have been made in the Langley transonic dynamics tunnel on a 0.25-scale model of Sandia Laboratories' 3.96-meter (13-foot), slanted ribbon design, lifting parachute. The lifting parachute is the first stage of a proposed two-stage payload delivery system. The lifting parachute model was attached to a forebody representing the payload. The forebody was designed and installed in the test section in a manner which allowed rotational freedom about the pitch and yaw axes. Values of parachute axial force coefficient, rolling moment coefficient, and payload trim angles in pitch and yaw are presented through the transonic speed range. Data are presented for the parachute in both the reefed and full open conditions. Time history records of lifting parachute deployment and disreefing tests are included.

Foughner, J. T., Jr.↗
NASA NTRS1977

Merging of aircraft trailing vortices

A merging-distance criterion for equal-strength corotational vortices is derived from low-turbulence wind-tunnel flow-visualization data. The vortex separation distance is normalized by defining a vortex core diameter based on circulation defect and angular-momentum defect. Merging may take place for larger separation distances than predicted from earlier two-dimensional inviscid calculations, which indicates that viscosity and possibly three-dimensional effects are important factors in the merging phenomenon. Hot-wire velocity distributions and rolling-moment measurements show that attenuation of the vortex hazard is associated with vortex merging.

Brandt, S. A.↗
NASA NTRS1977

Inviscid modeling of aircraft trailing vortices

A survey is presented of inviscid theoretical methods that are useful in the study of lift-generated vortices. Concepts derived using these invisicid theories are cited which have helped to guide research directed at alleviating the velocities and rolling moments imposed on aircraft entering these wakes.

Rossow, V. J.↗
NASA NTRS1977

Thrust-augmented vortex attenuation

An experimental investigation was conducted to determine the vortex attenuating effect of engine thrust. Tests were made using a 0.03-scale model of the Boeing 747 transport aircraft as a vortex generating model. A Learjet-class probe model was used to measure the vortex induced rolling moment at a scale separation distance of 1.63 km. These tests were conducted at a lift coefficient of 1.4 at a model velocity of 30.48 m/s. The data presented indicate that engine thrust is effective as a vortex attenuating device when the engines are operated at high thrust levels and are positioned to direct the high energy engine wake into the core of the vortex. The greatest thrust vortex attenuation was obtained by operating the inboard engine thrust reversers at one-quarter thrust and the outboard engines at maximum forward thrust.

Patterson, J. C., Jr.↗
NASA NTRS1978

The role of atmospheric shear, turbulence and a ground plane on the dissipation of aircraft vortex wakes

Enhanced dispersion of two-dimensional trailed vortex pairs within simplified neutral atmospheric backgrounds is studied numerically for three conditions: when the pair is imbedded in a constant turbulent bath (constant dissipation); when the pair is subjected to a mean cross-wind shear; and when the pair is near the ground. Turbulent transport is modeled using second-order closure turbulent transport theory. The turbulent background fields are constructed using a superequilibrium approximation. The computed results allow several general conclusions to be drawn with regard to the reduction in circulation of the vortex pair and the rolling moment induced on a following aircraft: (1) the rate of decay of a vortex pair increases with increasing background dissipation rate; (2) cross-wind shear disperses the vortex whose vorticity is opposite to the background; and (3) the proximity of a ground plane reduces the hazard of the pair by scrubbing. The phenomenon of vortex bounce is explained in terms of secondary vorticity produced at the ground plane. Qualitative comparisons are made with available experimental data, and inferences of these results upon the persistence of aircraft trailing vortices are discussed.

Bilanin, A. J.↗
NASA NTRS1979

Effect of spanwise gust variations

The spanwise, vertical force, and rolling moment effects of random gusts encountered by aircraft are analyzed. Mathematical models are given for approximating atmospheric turbulence.

Houbolt, J. C.↗
NASA NTRS1979

Results of two tests in the MSFC 14 by 14-inch trisonic wind tunnel, FA 27 (TWT-655) and FA 28 (TWT-656)

Wind tunnel tests were conducted in a 14- inch wind tunnel with a 0.004 scale model of the space shuttle launch vehicle in order to (1) determine the cause and possible aerodynamic alterations required to eliminate the Orbiter rolling moment couple; (2) determine configuration alterations to alleviate the forward Orbiter external tank loads; and (3) provide data to verify previous data.

Braddock, W. F.↗
NASA NTRS1982

Water tunnel flow visualization and wind tunnel data analysis of the F/A-18

Six degree of freedom studies were utilized to extract a band of yawing and rolling moment coefficients from the F/A-18 aircraft flight records. These were compared with 0.06 scale model data obtained in a 16T wind tunnel facility. The results, indicate the flight test yawing moment data exhibit an improvement over the wind tunnel data to near neutral stability and a significant reduction in lateral stability (again to anear neutral level). These data are consistent with the flight test results since the motion was characterized by a relatively slo departure. Flight tests repeated the slow yaw departure at M 0.3. Only 0.16 scale model wind tunnel data showed levels of lateral stability similar to the flight test results. Accordingly, geometric modifications were investigated on the 0.16 scale model in the 30x60 foot wind tunnel to improve high angle of attack lateral stability.

Erickson, G. E.↗
NASA NTRS1982

Shuttle entry performance and stability and control derivatives extraction from flight measurement data

Flight data taken from three Shuttle Space Transportation System flights (STS-1, 2, and 3) during entry are analyzed to determine the shuttle performance and aerodynamic characteristics. Correlations of the performance coefficients and the stability and control derivatives with preflight predictions are presented over the hypersonic speed range from Mach 2 to 25. In addition, an evaluation of the effectiveness of the onboard Reaction Control System (RCS) is given and an effort is made to independently quantify the combined impingement and flow-field interaction effects on the spacecraft rolling moment. Comparisons of stability and control derivatives extracted for the same flight conditions, but using data from different onboard sensors are also made. Results obtained using the same flight data, but different computer software are also shown.

Compton, H. R.↗
NASA NTRS1982

Shuttle entry GN&C performance during STS-1 and STS-2

Data obtained during the entry segment of the descent phase of the flights are analyzed. The nominal entry profile is defined and a description is given of the guidance, navigation, and control subsystem. Emphasis is placed on the stability and control problems encountered during STS-1 and to the changes made in response to these anomalies. These are: (1) the first roll maneuver was done manually at a reduced roll rate; (2) the nominal elevator position was changed from one degree up to one degree down for Mach numbers greater than 12 to reduce the heat load on the body flap; (3) the pilot was directed to execute small roll maneuvers at dynamic pressures of 4, 8, and 18 psf to help determine the roll moment from the aft yaw jets; (4) the planned test inputs in the transonic region were reduced in magnitude; and (5) the targeted touchdown point was moved 500 feet closer to the runway threshold.

Mcwhorter, L. B.↗
NASA NTRS1984

Optimum design of rotor blades for vibration reduction in forward flight

Modern structural optimization techniques are applied to vibration reduction of helicopter rotor blades in forward flight. The objective function minimized consists of the oscillatory vertical hub shears or the hub rolling moments at one particular advance ratio. The behavior constraints are the frequency placements of the blade and the requirement that aeroelastic stability margins, in hover, remain unaffected by the optimization process. The aeroelastic stability and response analysis is based on a fully coupled flap-lag-torsional analysis of the blade. Numerical results are presented for some typical soft-in-plane hingeless rotor configurations indicating a 15-40 percent reduction in vibration levels, as well as a blade which is 20 percent lighter than the initial design. These results imply that structural optimization techniques can yield substantial practical benefits in the design process of rotor systems.

Friedmann, P. P.↗
NASA NTRS1985

On the wake hazard alleviation associated with roll oscillations of wake-generating aircraft

An explanation is provided for the difference in wake vortex alleviation achieved by roll oscillations in flight tests with B-747 and L-1011 transport aircraft. Both aircraft had their landing flaps extended and several spoilers deployed. Numerical analysis shows that the growth in amplitude of the initial waves in the vortex filament is brought about by the sinusoidal instability. In the case of the B-747, growth is enhanced by a vortex whose strength is about the same as the tip vortex which is shed near the fuselage by the inboard end of the flaps. Conversely, the L-1011 is estimated to shed a negligible fuselage vortex and to have a relatively strong wingtip vortex. These characteristics bring about a rotation and amplification of the initial waves in the vortex filaments in the wake of the B-747 but not in the L-1011 vortex wake. An aircraft following the B-747 would then experience only intermittent encounters with the intense parts of the wake vortices so that the time-averaged wake-induced rolling moment is substantially reduced.

Rossow, V. J.↗
NASA NTRS1986

Aerodynamic Prediction for Supersonic Canard-Tail Missiles

LRCDM2 computer program developed to calculate pressure distribution at points on surfaces of complete supersonic missile. Missile comprises up to two finned sections attached to axisymmetric body of circular cross section. Includes effects of vortex shedding due to forebody and forward fins, providing more accurate rolling moments. LRCDM2 written in FORTRAN IV.

Dillenius, M. F.↗
NASA NTRS1987

Example on how to model and simulate turbulence for flight simulators

Analytical developments relative to gust response are discussed. Turbulence length scale, spectral functions, zero crossing values, gust loads analysis, power spectral techniques for analyzing the response of aircraft in turbulence, the spectrum of the rolling moment coefficient, and the spectrum correction factor are among the issues considered.

Houbolt, John C.↗
NASA NTRS1987

Implementation of turbulence models into simulators

Simulation of turbulence as it relates to the flight training environment is discussed in general terms. Simulators that put random white noise into the system and simulators that put random motion into the equations of motion are discussed, as are simulators that incorporate pitch and roll moments into vertical turbulence. Wind shear models and simplified models of microburst phenomena are covered.

Ireland, Robert L.↗