Search NASA⌕ Search

SEARCH · Search NASA

Results for “emission reduction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Exhaust emission reduction for intermittent combustion aircraft engines

Three concepts for optimizing the performance, increasing the fuel economy, and reducing exhaust emission of the piston aircraft engine were investigated. High energy-multiple spark discharge and spark plug tip penetration, ultrasonic fuel vaporization, and variable valve timing were evaluated individually. Ultrasonic fuel vaporization did not demonstrate sufficient improvement in distribution to offset the performance loss caused by the additional manifold restriction. High energy ignition and revised spark plug tip location provided no change in performance or emissions. Variable valve timing provided some performance benefit; however, even greater performance improvement was obtained through induction system tuning which could be accomplished with far less complexity.

Moffett, R. N.↗
NASA NTRS1977

General aviation piston-engine exhaust emission reduction

To support the promulgation of aircraft regulations, two airports were examined, Van Nuys and Tamiami. It was determined that the carbon monoxide (CO) emissions from piston-engine aircraft have a significant influence on the CO levels in the ambient air in and around airports, where workers and travelers would be exposed. Emissions standards were set up for control of emissions from aircraft piston engines manufactured after December 31, 1979. The standards selected were based on a technologically feasible and economically reasonable control of carbon monoxide. It was concluded that substantial CO reductions could be realized if the range of typical fuel-air ratios could be narrowed. Thus, improvements in fuel management were determined as reasonable controls.

Kempke, E. E., Jr.↗
DOE OSTI2024

High-ambition climate action in all sectors can achieve a 65% greenhouse gas emissions reduction in the United States by 2035

Under the next cycle of target setting under the Paris Agreement, countries will be updating and submitting new nationally determined contributions (NDCs) over the coming year. To this end, there is a growing need for the United States to assess potential pathways toward a new, maximally ambitious 2035 NDC. In this study, we use an integrated assessment model with state-level detail to model existing policies from both federal and non-federal actors, including the Inflation Reduction Act, Bipartisan Infrastructure Law, and key state policies, across all sectors and gases. Additionally, we develop a high-ambition scenario, which includes new and enhanced policies from these actors. We find that existing policies can reduce net greenhouse gas (GHG) emissions by 44% (with a range of 37% to 52%) by 2035, relative to 2005 levels. The high-ambition scenario can deliver net GHG reductions up to 65% (with a range of 59% to 71%) by 2035 under accelerated implementation of federal regulations and investments, as well as state policies such as renewable portfolio standards, EV sales targets, and zero-emission appliance standards. This level of reductions would provide a basis for continued progress toward the country’s 2050 net-zero emissions goal.

54 ENVIRONMENTAL SCIENCES↗
DOE OSTI2022

Life-cycle greenhouse gas emissions reduction potential for corn ethanol refining in the USA

This study evaluates how low-carbon production technologies applicable to ethanol plants may reduce the life-cycle greenhouse gas emission (GHG) intensities of corn ethanol production in the USA. Results indicate that options focusing on incremental energy efficiency (e.g., combined heat and power) and yield improvements have a limited impact on GHG reductions. To achieve deep decarbonization (>50% GHG reduction compared to current corn ethanol production), a fuel switch from natural gas (NG) to alternative low-carbon fuels is needed. Replacing 50% of NG demand at ethanol plants with syngas from biomass through gasification or renewable natural gas from animal waste could achieve significant GHG reductions (11.7–23.5 g CO 2 e/MJ ethanol). Adding multiple technologies, including carbon capture and storage, to existing ethanol plants may further reduce GHG emissions to –18.4 g CO 2 e MJ –1 ethanol (including land-use change emissions), which is 120% lower than the carbon intensity of pure gasoline. These results could inform how the ethanol industry could move toward net-zero ethanol production.

09 BIOMASS FUELS↗
DOE OSTI2023

Cost and Life Cycle Analysis for Deep CO 2 Emissions Reduction for Steel Making: Direct Reduced Iron Technologies

Among heavy industrial sectors worldwide, the steel industry ranks first in carbon dioxide (CO 2 ) emissions. Technologies that produce direct reduced iron (DRI) enable the industry to reduce emissions or even approach net‐zero CO 2 emissions for steel production. Herein, comprehensive cradle‐to‐gate (CTG) life cycle analysis (LCA) and techno‐economic analysis (TEA) are used to evaluate the CO 2 emissions of three DRI technologies. Compared to the baseline of blast furnace and basic oxygen furnace (BF–BOF) technology for steel making, using natural gas (NG) to produce DRI has the potential to reduce CTG CO 2 emissions by 33%. When 83% or 100% renewable H 2 is used for DRI production, DRI technologies can potentially reduce CO 2 emissions by 57% and 67%, respectively, compared to baseline BF–BOF technology. However, the renewable H 2 application for DRI increases the levelized cost of steel (LCOS). When renewable natural gas (RNG) and clean electricity are used for steel production, the CTG CO 2 emissions of all the DRI technologies can potentially be reduced by more than 90% compared to the baseline BF–BOF technology, although the LCOS depends largely on the cost of RNG and clean electricity.

29 ENERGY PLANNING, POLICY, AND ECONOMY↗
NASA NTRS1992

Emissions reduction by varying the swirler airflow split in advanced gas turbine combustors

A rich burn/quick mix/lean burn (RQL) combustor concept for reducing pollutant emissions is currently under investigation at the NASA Lewis Research Center. The current study investigates the effect of varying the mass flow rate split between the swirler passages for an equivalance ratio of 2.0 on fuel distribution, temperature distribution, and emissions for the fuel nozzle/rich burn section of an RQL combustor. It is seen that optimizing these parameters can substantially improve combustor performance and reduce combustor emissions. The optimal mass flow rate split for reducing NO(x) emissions based on the numerical study was the same as found by experiment.

Micklow, Gerald J.↗
NASA NTRS1977

Stratospheric cruise emission reduction program

A recently implemented NASA effort specifically aimed at reducing cruise oxides of nitrogen from high-altitude aircraft is discussed. The desired emission levels and the combustor technology required to achieve them are discussed. A brief overview of the SCERP operating plan is given. Lean premixed-prevaporized combustion and some of the potential difficulties that are associated with applying this technique to gas turbine combustors are examined. Base technology was developed in several key areas. These fundamental studies are viewed as a requirement for successful implementation of the lean premixed combustion technique.

Diehl, L. A.↗
DOE OSTI2024

Analyzing Potential Greenhouse Gas Emissions Reductions from Plug-In Electric Vehicles: Report for CRC Project, "Carbon Return on Investment for Electrified Vehicles"

Investment in battery and electrification technologies has the potential to greatly reduce vehicular greenhouse gas (GHG) emissions, as a battery-electric vehicle (BEV) will have zero tailpipe emissions. However, there will be GHG emissions associated with production of the vehicle including its battery, and with any carbon-emitting electricity sources used to charge the vehicle. This study explores the GHG reduction benefits of different plug-in electric vehicle (PEV) designs in the context of factors such as electricity production mix, per-vehicle battery requirements, and varying battery market growth scenarios. The analyses focus on the U.S. light-duty vehicle (LDV) market, which accounts for nearly 60% of U.S. transportation sector GHG emissions - over twice as much as the next largest contributing transportation sub-sector.

29 ENERGY PLANNING, POLICY, AND ECONOMY↗
DOE OSTI2021

Anthropogenic–biogenic interaction amplifies warming from emission reduction over the southeastern US

A decline of surface biogenic secondary organic aerosols through the mediation of reduced anthropogenic aerosols has been recognized as an air quality co-benefit of anthropogenic emission control over the southeastern US. However, the climate impacts of this anthropogenic–biogenic interaction remain poorly understood. Here, we identified a substantial decline of summertime aerosol loading aloft over the southeastern US in recent decades through the interaction, which leads to a stronger decline in column-integrated aerosol optical depth and a greater increase in radiative fluxes over the southeastern than northeastern US, different from trends of anthropogenic emissions and near-surface aerosol loading. The anthropogenic–biogenic interaction is shown to explain more than 60% of the coherent increasing trend of 5.3 Wm -2 decade -1 in clear-sky surface downward radiative fluxes. We show that current climate models fail to represent this interaction. The interaction is further projected to amplify the positive radiative forcing from emission control by 42.3% regionally over the southeastern US and globally by 5.4% in 2050 under RCP4.5 compared to 2005. This amplification effect implies greater challenges to achieving the Paris Agreement temperature targets with continuous emission control in future.

54 ENVIRONMENTAL SCIENCES↗
DOE OSTI2025

Life-Cycle Analysis of Residential Windows Retrofits: Net GHG Emission Reduction and Payback Periods

Windows are a critical envelope component that plays an important role in the overall performance and environmental impact of a building life cycle. These implications can be embedded in the window lifecycle related to its design, manufacturing, raw materials and transportation, performance during the building’s use (operational), replacements, maintenance and end-of-life. Windows may impact 25% of the heating and cooling energy use, 10% of total building energy use and 45% of the envelope heat transfer (Harris 2022). The impacts of windows on the energy consumption of buildings have been extensively discussed, however, its embodied life-cycle impacts, such as greenhouse gas (GHG) emissions, and the trade-offs between the embodied and its operational emissions are less explored. Understanding the life cycle impacts of windows may subsidize decision making process and inform the development of emerging windows technologies. BTO’s Windows Program has played an important role to increase the adoption of emerging technologies as high-performance windows in the U.S. (Harris 2022) and to consider the GHG emission impacts of the those windows is an important aspect that can support the strategic objectives and the performance targets from the national blueprint for decarbonizing the buildings sector and to reduce the on-site emissions and embodied life cycle emissions from building materials and construction (US DOE 2024).

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗