Search NASA⌕ Search

SEARCH · Search NASA

Results for “real gas”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Hypersonic blunt body computations including real gas effects

The recently developed second-order explicit and implicit total variation diminishing (TVD) shock-capturing methods of the Harten and Yee, Yee, and van Leer types in conjunction with a generalized Roe's approximate Riemann solver of Vinokur and the generalized flux-vector splittings of Vinokur and Montagne for two-dimensional hypersonic real gas flows are studied. A previous study on one-dimensional unsteady problems indicated that these schemes produce good shock-capturing capability and that the state equation does not have a large effect on the general behavior of these methods for a wide range of flow conditions for equilibrium air. The objective of this paper is to investigate the applicability and shock resolution of these schemes for two-dimensional steady-state hypersonic blunt body flows. The main contribution of this paper is to identify some of the elements and parameters which can affect the convergence rate for high Mach numbers or real gases but have negligible effect for low Mach number cases for steady-state inviscid blunt body flows.

Montagne, J.-L.↗
NASA NTRS1980

Real-gas effects 1: Simulation of ideal gas flow by cryogenic nitrogen and other selected gases

The thermodynamic properties of nitrogen gas do not thermodynamically approximate an ideal, diatomic gas at cryogenic temperatures. Choice of a suitable equation of state to model its behavior is discussed and the equation of Beattie and Bridgeman is selected as best meeting the needs for cryogenic wind tunnel use. The real gas behavior of nitrogen gas is compared to an ideal, diatomic gas for the following flow processes: isentropic expansion; normal shocks; boundary layers; and shock wave boundary layer interactions. The only differences in predicted pressure ratio between nitrogen and an ideal gas that may limit the minimum operating temperatures of transonic cryogenic wind tunnels seem to occur at total pressures approaching 9atmospheres and total temperatures 10 K below the corresponding saturation temperature, where the differences approach 1 percent for both isentropic expansions and normal shocks. Several alternative cryogenic test gases - air, helium, and hydrogen - are also analyzed. Differences in air from an ideal, diatomic gas are similar in magnitude to those of nitrogen. Differences for helium and hydrogen are over an order of magnitude greater than those for nitrogen or air. Helium and hydrogen do not approximate the compressible flow of an ideal, diatomic gas.

Hall, R. M.↗
NASA NTRS1986

Real gas effects on the numerical simulation of a hypersonic inlet

The present use of a parabolized Navier-Stokes solver to accurately simulate the flowfield in a supersonic inlet yields good agreement between numerical analysis and experiment for a Mach 7.4 inlet under cruise conditions, with an internal compression ratio of 8. The significance of real gas effects on the performance calculation of a hypersonic inlet is demonstrated, with small changes in the ratio of specific heats resulting in a substantial change in the calculated pitot pressure ratio.

Ng, W.-F.↗
NASA NTRS2003

Real Gas Effects on the Performance of Hydrocarbon-fueled Pulse Detonation Engines

This paper presents results for a single-pulse detonation tube wherein the effects of high temperature dissociation and the subsequent recombination influence the sensible heat release available for providing propulsive thrust. The study involved the use of ethylene and air at equivalence ratios of 0.7 and 1.0. The real gas effects on the sensible heat release were found to be significantly large so as to have an impact on the thrust, impulse and fuel consumption of a PDE.

Povinelli, Louis A.↗
NASA NTRS1987

Simulation of real-gas effects on pressure distributions for a proposed Aeroassist Flight Experiment vehicle and comparison to prediction

Pressure distributions measured on a 60-deg elliptic cone, raked off at a 73-deg angle and having an ellipsoid nose (ellipticity equal to 2.0), are presented for a range of angle of attack from -10 to 15 deg. The high normal shock density ratio aspect of a real gas was simulated by testing in Mach-6 air (normal shock density ratio equal to 5.25) and Mach 6 CF4 (normal shock density ratio equal to 12.0). The effects of Reynolds number, angle of attack, and normal shock density ratio on these measurements are examined, and comparisons are made to an inviscid flowfield computer code known as HALIS. A significant effect of density ratio on pressure distributions on the cone section of the configuration was observed; the magnitude of this effect decreased with increased angle of attack. The effect of Reynolds number on pressures was negligible for forebody pressure distributions, but a measurable effect was noted on base pressures. In general, the HALIS code accurately predicted the measured pressure distributions in air and CF4.

Micol, John R.↗
NASA NTRS1983

An experimental investigation of control surface effectiveness and real-gas simulation for biconics

Aerodynamic coefficients, pressure distributions, and oil-flow patterns measured on spherically blunted, 13 degrees/7 degrees on-axis and bent biconics at Mach 6 and 10 in air are compared. Angle of attack, referenced to the axis of the aft cone, was varied from zero to 40 degrees. The effect of deflection of base-mounted flaps on aerodynamic characteristics was examined at Mach 10. Real-gas effects on aerodynamic coefficients, pressure distributions and shock detachment distance were simulated by testing the biconic models in Mach 6 air and Mach 6 CF4 flows. (Density ratio equal to 5.3 for air and 12 for CF4.) The on-axis biconic is stable but cannot be trimmed at angles of attack above zero with the assumed center of gravity and flap configuration. Flaps on the bent biconic produced a stable and trim configuration for angles of attack from zero to 23 degrees. A significant effect of density ratio on aerodynamic coefficients, pressure distribution, and shock detachment distance was observed.

Miller, C. G.↗
NASA NTRS1992

Simulation of real-gas effects on pressure distributions for aeroassist flight experiment vehicle and comparison with prediction

Pressure distributions measured on a 60 degree half-angle elliptic cone, raked off at an angle of 73 degrees from the cone centerline and having an ellipsoid nose (ellipticity equal to 2.0 in the symmetry plane) are presented for angles of attack from -10 degrees to 10 degrees. The high normal shock density ratio aspect of a real gas was simulated by testing in Mach 6 air and CF sub 4 (density ratio equal to 5.25 and 12.0, respectively). The effects of Reynolds number, angle of attack, and normal shock density ratio on these measurements are examined, and comparisons with a three dimensional Euler code known as HALIS are made. A significant effect of density ratio on pressure distributions on the cone section of the configuration was observed; the magnitude of this effect decreased with increasing angle of attack. The effect of Reynolds number on pressure distributions was negligible for forebody pressure distributions, but a measurable effect was noted on base pressures. In general, the HALIS code accurately predicted the measured pressure distributions in air and CF sub 4.

Micol, John R.↗
NASA NTRS1991

A fine-wire thermocouple probe for measurement of stagnation temperatures in real gas hypersonic flows of nitrogen

A fine-wire thermocouple probe was used to determine freestream stagnation temperatures in hypersonic flows. Data were gathered in a N2 blowdown wind tunnel with runtimes of 1-5 s. Tests were made at supply pressures between 30 and 1400 atm and supply temperatures between 700 and 1900 K, with Mach numbers of 14 to 16. An iterative procedure requiring thermocouple data, pilot pressure measurements, and supply conditions was used to determine test cell stagnation temperatures. Probe conduction and radiation losses, as well as real gas behavior of N2, were accounted for during analysis. Temperature measurement error was found to be 5 to 10 percent. A correlation was drawn between thermocouple diameter Reynolds number and temperature recovery ratio. Transient probe behavior was studied and was found to be adequate in temperature gradients up to 1000 K/s.

Hollis, Brian R.↗
NASA NTRS1977

Investigation of real-gas and viscous effects on the aerodynamic characteristics of a 40 deg half-cone with suggested correlations for the shuttle orbiter

Parameters were evaluated that might be used to correlate shuttle orbiter aerodynamic data to be used in extrapolating from wind-tunnel to flight conditions. Preliminary calculations indicate that the lee-side forces will have an insignificant influence on the aerodynamic characteristics of the orbiter for moderate angle-of-attack entries; therefore, this work is focused on phenomena which have an overriding influence on windward forces, namely, real-gas (equilibrium and nonequilibrium) and viscous-interaction effects. Analytically determined flow fields previously obtained on 40 deg blunted cones were used as a data source to evaluate various correlation parameters. Inviscid effects were found to be the dominant contributor to the aerodynamic coefficients in the altitude range of 64 to 76.2 km. The most suitable correlation of the aerodynamic forces on these cones is based on local dynamic pressure and local Mach number.

Hunt, J. L.↗
NASA NTRS1972

Numerical computation of multishocked, three-dimensional supersonic flow fields with real gas effects.

A computational procedure is presented which is capable of determining the supersonic flow field surrounding three-dimensional wing-body configurations such as a delta-wing space shuttle. The governing equations in conservation-law form are solved by a finite difference method using a second-order noncentered algorithm between the body and the outermost shock wave, which is treated as a sharp discontinuity. Secondary shocks which form between these boundaries are captured automatically, and the intersection of these shocks with the bow shock posed no difficulty. Resulting flow fields about typical blunt nose shuttle-like configurations at angle of attack are presented. The differences between perfect and real gas effects for high Mach number flows are shown.

Kutler, P.↗
NASA NTRS1990

On the Goertler instability in hypersonic flows: Sutherland law fluids and real gas effects

The Goertler vortex instability mechanism in a hypersonic boundary layer on a curved wall is investigated. The precise roles of the effects of boundary layer growth, wall cooling, and gas dissociation is clarified in the determination of stability properties. It is first assumed that the fluid is an ideal gas with viscosity given by Sutherland's law. It is shown that when the free stream Mach number M is large, the boundary layer divides into two sublayers: a wall layer of O(M sup 3/2) thickness over which the basic state temperature is O(M squared) and a temperature adjustment layer of O(1) thickness over which the basic state temperature decreases monotonically to its free stream value. Goertler vortices which have wavelengths comparable with the boundary layer thickness are referred to as wall modes. It is shown that their downstream evolution is governed by a set of parabolic partial differential equations and that they have the usual features of Goertler vortices in incompressible boundary layers. As the local wavenumber increases, the neutral Goertler number decreases and the center of vortex activity moves towards the temperature adjustment layer. Goertler vortices with wavenumbers of order one or larger must necessarily be trapped in the temperature adjustment layer and it is this mode which is most dangerous. For this mode, it was found that the leading order term in the Goertler number expansion is independent of the wavenumber and is due to the curvature of the basic state. This term is also the asymptotic limit of the neutral Goertler numbers of the wall mode. To determine the higher order corrections terms in the Goertler number expansion, two wall curvature cases are distinguished. Real gas effects were investigated by assuming that the fluid is an ideal dissociating gas. It was found that both gas dissociation and wall cooling are destabilizing for the mode trapped in the temperature adjustment layer, but for the wall mode trapped near the wall the effect of gas dissociation can be either destabilizing or stabilizing.

Fu, Yibin B.↗
NASA NTRS1996

Real-Gas Flow Properties for NASA Langley Research Center Aerothermodynamic Facilities Complex Wind Tunnels

A computational algorithm has been developed which can be employed to determine the flow properties of an arbitrary real (virial) gas in a wind tunnel. A multiple-coefficient virial gas equation of state and the assumption of isentropic flow are used to model the gas and to compute flow properties throughout the wind tunnel. This algorithm has been used to calculate flow properties for the wind tunnels of the Aerothermodynamics Facilities Complex at the NASA Langley Research Center, in which air, CF4. He, and N2 are employed as test gases. The algorithm is detailed in this paper and sample results are presented for each of the Aerothermodynamic Facilities Complex wind tunnels.

Hollis, Brian R.↗
NASA NTRS1972

A program for calculating expansion-tube flow quantities for real-gas mixtures and comparison with experimental results

A computer program written in FORTRAN 4 language is presented which determines expansion-tube flow quantities for real test gases CO2 N2, O2, Ar, He, and H2, or mixtures of these gases, in thermochemical equilibrium. The effects of dissociation and first and second ionization are included. Flow quantities behind the incident shock into the quiescent test gas are determined from the pressure and temperature of the quiescent test gas in conjunction with: (1) incident-shock velocity, (2) static pressure immediately behind the incident shock, or (3) pressure and temperature of the driver gas (imperfect hydrogen or helium). The effect of the possible existence of a shock reflection at the secondary diaphragm of the expansion tube is included. Expansion-tube test-section flow conditions are obtained by performing an isentropic unsteady expansion from the conditions behind the incident shock or reflected shock to either the test-region velocity or the static pressure. Both a thermochemical-equilibrium expansion and a frozen expansion are included. Flow conditions immediately behind the bow shock of a model positioned at the test section are also determined. Results from the program are compared with preliminary experimental data obtained in the Langley 6-inch expansion tube.

Miller, C. G., III↗
NASA NTRS1969

High pressure real gas effects for helium and nitrogen

Critical flow factor is calculated that permits the isentropic mass-flow rate of the gases through critical flow nozzles to be calculated from plenum conditions. Results include nozzle throat velocity, compressibility factor, entropy, enthalpy, specific heat, and ratios of throat to plenum pressure, density, and temperature.

Johnson, R. C.↗