Search NASA⌕ Search

SEARCH · Search NASA

Results for “scattering patterns”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
DOE OSTI2020

In situ high-temperature X-ray diffraction study of Sc-doped titanium oxide nanocrystallites

Titanium dioxide is an inexpensive wide-gap highly ionic semiconductor with striking photocatalytic capabilities in several heterogeneous photoredox reactions. A small crystal size is desirable to maximize the surface area, since photocatalytic reactions occur at the surface of a photocatalyst. Presented in this work are the synthesis and microstructural characterization of 4 at.% Sc-doped TiO 2 (4SDT) prepared by water-based co-precipitation. The crystal structure of 4SDT was examined via in situ high-temperature powder X-ray diffraction experiments from 25 to 1200°C. Rietveld analysis revealed single-phase anatase up to 875°C, while at 900°C the anatase-to-rutile phase transformation occurred and at higher temperatures additional reflections of Sc-rich phases (Sc 2 TiO 5 from 975°C and Ti 3 Sc 4 O 12 or Sc 2 O 3 at 1200°C) were observed. Debye function analysis (DFA) was applied to model the total scattering pattern directly in reciprocal space, allowing the reconstruction of Ti vacancies. Both Rietveld and DFA methods were applied to estimate the nanocrystallite size and shape with consistent growth in crystallite size with temperature: an ellipsoid shape with equatorial ~4.7 nm / axial (001) ~6.9 nm at 25°C to equatorial ~27.9 nm / axial (001) ~39.6 nm at 900°C refined by Rietveld analysis, versus a cylinder shape with D a , b = 4.3 nm and size dispersion σ ab = 1.5 nm, L c = 4.9 nm and σ c = 2.3 nm at 25°C to D a , b = 21.4 nm, σ ab = 8.3 nm, L c = 23.9 and σ c = 10.9 nm at 900°C estimated by DFA. The microstructural changes obtained by Rietveld and DFA methods were supported by high-resolution transmission electron microscopy image analysis, as well as by the less direct nitrogen sorption techniques that provide information on the size of non-agglomerated and dense particles. The Ti site-occupancy factor showed a linear increase from 0.6–0.8 at 25°C to unity at 900°C for anatase, and from ~0.7 at 900°C to unity at 1200°C for rutile, via Rietveld analysis and DFA.

36 MATERIALS SCIENCE↗
DOE OSTI2026

pySimpleMask

SF-26-118 pySimpleMask is a tool for creating masks and Q-partition maps for X-ray scattering patterns, supporting SAXS, WAXS, and XPCS data reduction. It ships both a desktop GUI and a headless Python API that can drive the full pipeline from scripts.

Chu, Miaoqi [Argonne National Laboratory (ANL), Ar↗
DOE OSTI2021

On the Crystal Structure of Colloidally Prepared Metastable Ag2Se Nanocrystals

Structural polymorphism is known for many bulk materials; however, on the nanoscale metastable polymorphs tend to form more readily than in the bulk, and with more structural variety. One such metastable polymorph observed for colloidal Ag2Se nanocrystals has traditionally been referred to as the “tetragonal” phase of Ag2Se. While there are reports on the chemistry and properties of this metastable polymorph, its crystal structure, and therefore electronic structure, has yet to be determined. We report that an anti-PbCl2-like structure type (space group P21/n) accurately describes the powder X-ray diffraction and X-ray total scattering patterns of colloidal Ag2Se nanocrystals prepared by several different methods. Density functional theory (DFT) calculations indicate that the anti-PbCl2-like Ag2Se polymorph is a dynamically stable, narrow-band gap semiconductor. DFT results reveal a dense theoretical Ag2Se phase space with many low-energy polymorphs, which helps explain the large number of polymorphs reported in the literature. Analysis and calculation data are stored in the zip archive. The `ag2se-calcs.aiida.` contains the provenance of the calculations and can be imported into an AiiDA database instance. The antiPbCl2like_Ag2Se_laboratory.cif file is the Reitveld refined Ag2Se structure starting from the PbCl2 structure.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS1974

Sinusoidal reaction formulation for radiation and scattering from conducting surfaces

A piecewise-sinusoidal reaction technique is developed for scattering and radiation from perfectly conducting bodies of arbitrary shape. The theory and numerical results for scattering patterns of rectangular plates and radiation patterns of corner-reflector antennas are presented. Experimental measurements are included for comparison with the calculated data.

Richmond, J. H.↗
NASA NTRS1975

Interactions of satellite-speed helium atoms with satellite-surfaces. 1: Spatial distributions of reflected helium atoms

Interactions of satellite-speed helium atoms with practical satellite surfaces were investigated experimentally, and spatial distributions of satellite-speed helium beams scattered from four different engineering surfaces were measured. The 7000 m/sec helium beams were produced using an arc-heated supersonic molecular beam source. The test surfaces included cleaned 6061-T6 aluminum plate, anodized aluminum foil, white paint, and quartz surfaces. Both in-plane (in the plane containing the incident beam and the surface normal) and out-of-plane spatial distributions of reflected helium atoms were measured for six different incidence angles (0, 15, 30, 45, 60, and 75 deg from the surface normal). It was found that a large fraction of the incident helium atoms were scattered back in the vicinity of the incoming beam, particularly in the case of glancing incidence angles. This unexpected scattering feature results perhaps from the gross roughness of these test surfaces. This prominent backscattering could yield drag coefficients which are higher than for surfaces with either forward-lobed or diffusive (cosine) scattering patterns.

Liu, S. M.↗
NASA NTRS1975

Sinusoidal reaction formulation for radiation and scattering from conducting surfaces

A piecewise-sinusoidal reaction technique is proposed for the study of scattering and radiation from perfectly conducting bodies of arbitrary shape. The reaction technique described is a moment method based on the integral equation of an electric field. A theory of sinusoidal reaction formulation for radiation and scattering problems is outlined, in which the scattered field is obtained by integrating the surface currents. Numerical results are presented for the scattering patterns of rectangular plates and corner reflectors and the radiation patterns of corner-reflector antennas.

Wang, N. N.↗
NASA NTRS1980

Light scattering by randomly oriented spheroidal particles

A study of the light scattering properties of randomly oriented, identical spheroidal particles is presented. A computation method was developed to integrate the Asano and Yamomoto solution (1975) for scattering from a homogeneous spheroid over all particle orientations; the extinction and scattering cross-sections, the asymmetry factor, and scattering matrix elements are calculated for randomly oriented prolate and oblate spheroids and compared with the calculations for spheres and laboratory measurements. The angular scattering behavior of spheroids is found to be different from that of the spheres for side scattering to backscattering directions, and prolate and oblate spheroids of the same shape parameter have similar angular scattering patterns.

Asano, S.↗
NASA NTRS1983

Quasi-relativistic electron precipitation due to interactions with coherent VLF waves in the magnetosphere

The equations of motion for the cyclotron resonance interaction between coherent whistler mode waves and energetic particles are rederived with the inclusion of relativistic effects. The pitch angle scattering of the near-loss-cone quasi-relativistic electrons trapped in the magnetosphere is studied using a test particle method employing these relativistic equations, and the precipitated energy spectrum due to the wave-induced perturbations of a full distribution of particles is computed. Results show that the full width at half maximum peak width of the rms scattering pattern of the near-loss-cone particles would give an upper bound to the peak width of the associated precipitated energy spectrum under the conditions of moderate wave intensities in the low L shell region. In addition, it is found that the peak widths are within the upper limit values measured by recent satellite experiments. It is concluded that interactions of inner radiation belt particles with monochromatic waves could produce precipitated fluxes with relatively sharp spectral widths, and that therefore the L-dependent narrow peaks observed by low altitude satellite particle detectors could be caused by such interactions.

Chang, H. C.↗
NASA NTRS1984

An experimental investigation of the angular scattering and backscattering behaviors of the simulated clouds of the outer planets

A cryogenic, 50 liter volume Planetary Cloud Simulation Chamber has been constructed to permit the laboratory study of the cloud compositions which are likely to be found in the atmospheres of the outer planets. On the basis of available data, clouds composed of water ice, carbon dioxide, and liquid and solid ammonia and methane, both pure and in various mixtures, have been generated. Cloud microphysical observations have been permitted through the use of a cloud particle slide injector and photomicrography. Viewports in the lower chamber have enabled the collection of cloud backscattering data using 633 and 838 nm laser light, including linear depolarization ratios and complete Stokes parameterization. The considerable technological difficulties associated with the collection of angular scattering patterns within the chamber, however, could not be completely overcome.

Sassen, K.↗
NASA NTRS1987

Measuring and modeling the backscattering cross section of a leaf

Leaves are a significant feature of any vegetation canopy, and for remote sensing purposes it is important to develop an effective model for predicting the scattering from a leaf. From measurements of the X band backscattering cross section of a coleus leaf in varying stages of dryness, it is shown that a uniform resistive sheet constitutes such a model for a planar leaf. The scattering is determined by the (complex) resistivity which is, in turn, entirely specified by the gravimetric moisture content of the leaf. Using an available asymptotic expression for the scattering from a rectangular resistive plate which includes, as a special case, a metallic plate whose resistivity is zero, the computed backscattering cross sections for both principal polarizations are found to be in excellent agreement with data measured for rectangular sections of leaves with different moisture contents. If the resistivity is sufficiently large, the asymptotic expressions do not differ significantly from the physical optics ones, and for naturally shaped leaves as well as rectangular sections, the physical optics approximation in conjunction with the resistive sheet model faithfully reproduces the dominant feataures of the scattering patterns under all moisture conditions.

Senior, T. B. A.↗
NASA NTRS1989

A new technique for simulating composite material. Task 2: Analytical solutions with Generalized Impedance Boundary Conditions (GIBCs)

The diffraction problem associated with a multilayer material slab recessed in a perfectly conducting ground plane is formulated and solved via the Generalized Scattering Matrix Formulation (GSMF) in conjunction with the dual integral equation approach. The multilayer slab is replaced by a surface obeying a generalized impedance boundary condition (GIBC) to facilitate the computation of the pertinent Wiener Hopf split functions and their zeros. Both E(sub z) and H(sub z) polarizations are considered and a number of scattering patterns are presented, some of which are compared to exact results available for a homogeneous recessed slab.

Ricoy, M. A.↗
NASA NTRS1991

Diffraction by a multilayer slab recessed in a ground plane via generalized impedance boundary conditions

The diffraction problem associated with a multilayer material slab recessed in a perfectly conducting ground plane is formulated and solved via the generalized scattering matrix formulation in conjunction with the dual integral equation approach. The multilayer slab is replaced by a surface obeying a generalized impedance boundary condition to facilitate the computation of the pertinent Wiener Hopf split functions and their zeros. Both Ez and Hz polarizations are considered, and a number of scattering patterns are presented, some of which are compared to exact results available for a homogeneous recessed slab.

Ricoy, M. A.↗
NASA NTRS1992

Advanced electromagnetic methods for aerospace vehicles

The Advanced Helicopter Electromagnetics (AHE) Industrial Associates Program continues its research on variety of main topics identified and recommended by the Advisory Task Force of the program. The research activities center on issues that advance technology related to helicopter electromagnetics. While most of the topics are a continuation of previous works, special effort has been focused on some of the areas due to recommendations from the last annual conference. The main topics addressed in this report are: composite materials, and antenna technology. The area of composite materials continues getting special attention in this period. The research has focused on: (1) measurements of the electrical properties of low-conductivity materials; (2) modeling of material discontinuity and their effects on the scattering patterns; (3) preliminary analysis on interaction of electromagnetic fields with multi-layered graphite fiberglass plates; and (4) finite difference time domain (FDTD) modeling of fields penetration through composite panels of a helicopter.

Balanis, Constantine A.↗
NASA NTRS1994

Revolving-Pinhole Calibrator

Revolving-pinhole calibrator used to calibrate instrument called "Forward Scattering Spectrometer Probe" (FSSP). This instrument measures light scattered from water droplets in icing clouds. Scattering patterns used to determine sizes and distribution of sizes of droplets in connection with safety-oriented studies of icing on aircraft. Pinhole serves as diffraction standard for measuring small particles and drops.

Hovenac, Edward A.↗
NASA NTRS1997

Physical Vapor Transport of Mercurous Chloride Crystals: Design of a Microgravity Experiment

Flow field characteristics predicted from a computational model show that the dynamical state of the flow, for practical crystal growth conditions of mercurous chloride, can range from steady to unsteady. Evidence that the flow field can be strongly dominated by convection for ground-based conditions is provided by the prediction of asymmetric velocity profiles bv the model which show reasonable agreement with laser Doppler velocimetry experiments in both magnitude and planform. Unsteady flow is shown to be correlated with a degradation of crystal quality as quantified by light scattering pattern measurements, A microgravity experiment is designed to show that an experiment performed with parameters which yield an unsteady flow becomes steady (diffusive-advective) in a microgravity environment of 10(exp -3) g(sub 0) as predicted by the model, and hence yields crystals with optimal quality.

Duval, W, M. B.↗