Search NASA⌕ Search

SEARCH · Search NASA

Results for “vortex flow”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Investigation of aerodynamic characteristics of wings having vortex flow using different numerical codes

The aerodynamic characteristics of highly sweptback wings having separation-induced vortex flow were investigated by employing different numerical codes with a view to determining some of the capabilities and limitations of these codes. Flat wings of various configurations-strake wing models, cropped, diamond, arrow and double delta wings, were studied. Cambered and cranked planforms have also been tested. The theoretical results predicted by the codes were compared with the experimental data, wherever possible, and found to agree favorably for most of the configurations investigated. However, large cambered wings could not be successfully modeled by the codes. It appears that the final solution in the free vortex sheet method is affected by the selection of the initial solution. Accumulated span loadings estimated for delta and diamond wings were found to be unusual in comparison with attached flow results in that the slopes of these load curves near the leading edge do not tend to infinity as they do in the case of attached flow.

Reddy, C. S.↗
NASA NTRS1998

Numerical Study of Tip Vortex Flows

This paper presents an overview and summary of the many different research work related to tip vortex flows and wake/trailing vortices as applied to practical engineering problems. As a literature survey paper, it outlines relevant analytical, theoretical, experimental and computational study found in literature. It also discusses in brief some of the fundamental aspects of the physics and its complexities. An appendix is also included. The topics included in this paper are: 1) Analytical Vortices; 2) Experimental Studies; 3) Computational Studies; 4) Wake Vortex Control and Management; 5) Wake Modeling; 6) High-Lift Systems; 7) Issues in Numerical Studies; 8) Instabilities; 9) Related Topics; 10) Visualization Tools for Vertical Flows; 11) Further Work Needed; 12) Acknowledgements; 13) References; and 14) Appendix.

Dacles-Mariani, Jennifer↗
NASA NTRS1988

The mean flow structure around and within a turbulent junction or horseshoe vortex. II - The separated and junction vortex flow

Five-hole probe measurements of the flow through the separation region and in the vortex system of an incompressible subsonic flow around and within a turbulent junction or horseshoe vortex are reported. Mean velocity, static pressure, and total pressure results are presented. The streamwise vorticity field is obtained from the measured velocity field. Flow visualization results for the floor and cylinder surface agree well with the flow field data.

Pierce, F. J.↗
NASA NTRS1985

Low-speed experimental study of the vortex flow effects of a fighter forebody having unconventional cross-section

A low speed wind tunnel investigation is conducted for the vortex flow characteristics of a tailless fighter configuration that features full length, fuselage-blended forebody strakes. Static pressure distributions were obtained on the forebody upper surface, and six-component forces and moments were measured on the complete, 60-deg cropped delta wing-fuselage-centerline vertical fin model at angles of attack and sideslip respectively reaching 50 deg and + or - 20 deg. The surface pressure data reveal that development of concentrated vortices from the sharp edged forebody strakes occurred at moderate and high angles of attack. The blended forebody was effective in capturing the windward vortical flow up to high incidence and sideslip angles. The direct suction effect of the windward vortex on the forebody sidewall was the primary contributor to static directional stability at high angles of attack. These improvements are potentially offset, however, by reduced or unstable roll and yaw damping.

Erickson, G. E.↗
NASA NTRS2003

Control of Interacting Vortex Flows at Subsonic and Transonic Speeds Using Passive Porosity

A wind tunnel experiment was conducted in the NASA Langley Research Center (LaRC) 8-foot Transonic Pressure Tunnel (TPT) to determine the effects of passive surface porosity on vortex flow interactions about a general research fighter configuration at subsonic and transonic speeds. Flow- through porosity was applied to a wind leading-edge extension (LEX) mounted to a 65 deg cropped delta wind model to promote large nose-down pitching moment increments at high angles of attack. Porosity decreased the vorticity shed from the LEX, which weakened the LEX vortex and altered the global interactions of the LEX and wing vortices at high angles of attack. Six-component forces and moments and wing upper surface static pressure distributions were obtained at free- stream Mach numbers of 0.50, 0.85, and 1.20, Reynolds number of 2.5(10(exp-6) per foot, angles of attack up to 30 deg and angles of sideslip to plus or minus 8 deg. The off-surface flow field was visualized in selected cross-planes using a laser vapor screen flow visualization technique. Test data were obtained with a centerline vertical tail and with alternate twin, wing-mounted vertical fins having 0 deg and 30 deg cant angles. In addition, the porosity of the LEX was compartmentalized to determine the sensitivity of the vortex- dominated aerodynamics to the location and level of porosity applied to the LEX.

NATO FURNISHED↗
NASA NTRS1984

An investigation of aerodynamic characteristics of wings having vortex flow using different numerical codes

Three different numerical codes are employed to determine the aerodynamic characteristics of wings with separation induced vortex flows. Both flat as well as cambered wings of various planform shapes are studied. The effects of wing thickness, fuselage, notch ratio and multiple vortex modeling on aerodynamic performance of the wing are also examined. The theoretically predicted results are compared with experimental results to validate the various computer codes used in this study. An analytical procedure for designing aerodynamically effective leading edge extension (LEE) for a thick delta wing is also presented.

Sushil K Chaturvedi↗
NASA NTRS1977

Interaction with and production of sound by vortex flows

A description is presented of an improved version of a comprehensive theory of aeroacoustics which, in its original form, had first been reported by Yates and Sandri (1976). The new theory departs in several basic aspects from the concepts provided by Lighthill (1952), Ribner (1964), and Lilley et al. (1974). A detailed derivation of the theory is given for the case of constant entropy flows, taking into account the production of sound by a 'primary' fluid flow, the processing of sound by a flow, and the effects of sound on a primary flow. An investigation is conducted regarding the processing and the production of sound by vortex flow. Questions related to the excitation of a fluid flow by sound are also considered.

Yates, J. E.↗
NASA NTRS1992

X-29 vortex flow control tests

A joint Air Force/NASA X-29 aircraft program to improve yaw control at high angle of attack using vortex flow control (VFC) is described. Directional VFC blowing proved to a be a powerful yaw moment generator and was very effective in overriding natural asymmetries, but was essentially ineffective in suppressing wing rock. Symmetric aft blowing also had little effect on suppressing wing rock.

Hancock, Regis↗
NASA NTRS1978

Performance characteristics of two annular dump diffusers using suction-stabilized vortex flow control

The two diffusers employed in the investigation had the same overall area ratio but different prediffuser area ratios and suction slot geometries. Velocity profile and diffuser pressure recovery performance data were obtained at ambient pressure and temperature, with inlet Mach numbers ranging from 0.18 to 0.41 and suction rate varying from zero to 18% of total inlet mass flow rate. On the basis of the reported investigation it is concluded that suction stabilized vortex flow diffusers show promise for application in combustors because of relatively high static pressure recovery and low total pressure loss obtained in a short length. Performance obtained using a narrow angle (7 degree) prediffuser was superior to that obtained with a prediffuser having a 14 degree included angle.

Juhasz, A. J.↗
NASA NTRS1985

VORSTAB: A computer program for calculating lateral-directional stability derivatives with vortex flow effect

A computer program based on the Quasi-Vortex-Lattice Method of Lan is presented for calculating longitudinal and lateral-directional aerodynamic characteristics of nonplanar wing-body combination. The method is based on the assumption of inviscid subsonic flow. Both attached and vortex-separated flows are treated. For the vortex-separated flow, the calculation is based on the method of suction analogy. The effect of vortex breakdown is accounted for by an empirical method. A summary of the theoretical method, program capabilities, input format, output variables and program job control set-up are described. Three test cases are presented as guides for potential users of the code.

Lan, C. Edward↗
NASA NTRS1989

A multi-domain spectral computation of three-dimensional laminar horseshoe vortex flow using incompressible Navier-Stokes equations

Multidomain spectral methods are presently used to numerically simulate a strut-wall intersection's laminar horseshoe vortex flow through direct solution of the three-dimensional, incompressible, time-dependent Navier-Stokes equations. Direct expansion in Chebyshev polynomials and spectral element method spatial discretization of flow dependence are used to achieve high-order accuracy, and minimal dispersion errors. Low and moderate Reynolds number results are presented to illustrate the method application.

Tan, C. S.↗
NASA NTRS1975

Prediction of vortex flow characteristics of wings at subsonic and supersonic speeds

The leading-edge-suction analogy of Polhamus, which has been successful in the prediction of vortex lift characteristics on wings with pointed tips at subsonic and supersonic speeds, has recently been extended to account for the vortex flow characteristics for wings with side edges. Comparisons of experimental data and other currently used methods with the extended method are made for wings having side edges at subsonic and supersonic speeds. Recent data obtained for a low-aspect-ratio cropped-delta wing with various amounts of asymmetrical tip rake, simulating a roll control device, are also presented.

Lamar, J. E.↗
NASA NTRS1986

An implicit flux-difference splitting scheme for three-dimensional, incompressible Navier-Stokes solutions to leading edge vortex flows

A new, implicit finite-difference scheme designed to solve the conservative, flux-difference split Navier-Stokes equations is used to compute incompressible vortex flows around delta wings. The completely vectorizable hybrid algorithm is constructed in delta form for steady state solutions independent of the time-step sizes. The scheme combines approximate factorization in crossflow planes with a symmetric planar Gauss-Seidel relaxation in the remaining spatial direction. The governing equations are solved in curvilinear, body-fitted coordinates for treating complex geometries. The computed flow field results are compared with other theoretical and experimental data.

Hartwich, P.-M.↗
NASA NTRS1988

An airborne system for vortex flow visualization on the F-18 high-alpha research vehicle

A flow visualization system for the F-18 high-alpha research vehicle is described which allows direct observation of the separated vortex flows over a wide range of flight conditions. The system consists of a smoke generator system, on-board photographic and video systems, and instrumentation. In the present concept, smoke is entrained into the low-pressure vortex core, and vortice breakdown is indicated by a rapid diffusion of the smoke. The resulting pattern is observed using photographic and video images and is correlated with measured flight conditions.

Curry, Robert E.↗
NASA NTRS1989

Upwind Navier-Stokes solutions for leading-edge vortex flows

An incompressible Navier-Stokes solver using an upwind finite-difference algorithm is employed to investigate low-speed, three-dimensional, laminar, leading-edge vortex flows over three round-edged low-aspect-ratio wings. The effects of grid density, Reynolds number, and wing planform on the flowfield structures and integral values are studied. Computed results show good qualitative and quantitative agreement with the available experimental data.

Hsu, C.-H.↗
NASA NTRS1999

Implementation of Parallel Computing Technology to Vortex Flow

Mainframe supercomputers such as the Cray C90 was invaluable in obtaining large scale computations using several millions of grid points to resolve salient features of a tip vortex flow over a lifting wing. However, real flight configurations require tracking not only of the flow over several lifting wings but its growth and decay in the near- and intermediate- wake regions, not to mention the interaction of these vortices with each other. Resolving and tracking the evolution and interaction of these vortices shed from complex bodies is computationally intensive. Parallel computing technology is an attractive option in solving these flows. In planetary science vortical flows are also important in studying how planets and protoplanets form when cosmic dust and gases become gravitationally unstable and eventually form planets or protoplanets. The current paradigm for the formation of planetary systems maintains that the planets accreted from the nebula of gas and dust left over from the formation of the Sun. Traditional theory also indicate that such a preplanetary nebula took the form of flattened disk. The coagulation of dust led to the settling of aggregates toward the midplane of the disk, where they grew further into asteroid-like planetesimals. Some of the issues still remaining in this process are the onset of gravitational instability, the role of turbulence in the damping of particles and radial effects. In this study the focus will be with the role of turbulence and the radial effects.

Dacles-Mariani, Jennifer↗