Search NASA⌕ Search

SEARCH · Search NASA

Results for “wave speed”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1965

Experimental Investigation of a Constant-Velocity Traveling Magnetic Wave Plasma Engine

The previously reported traveling magnetic wave plasma engine has been redesigned to reduce the high heat loss to the tube walls downstream of the last magnetic-field coil. The present configuration uses a 3-inch-diameter pyrex tube flared out to a 6-inch diameter immediately downstream of the last magnetic-field coil. This configuration has been studied to determine the effects of flared-tube geometry, molecular weight of the propellant, engine length, and use of a ferrite core on the engine performance. Argon and xenon gases were used as propellants. Two engine lengths were tested. One engine was nominally 1-magnetic-wavelength long (4 coils) and the other nominally 2 1/2-magnetic wavelengths long (10 coils). The magnetic wave speed for both of these lengths corresponds to a specific impulse of 4750 seconds. The maximum kinetic efficiency of the 4-coil engine was 10 percent at a specific impulse of 3200 seconds using argon gas and 22.5 percent at 4200 seconds using xenon gas as the propellant.

TRAVELING WAVE↗
NASA NTRS2004

Development of an Actuator for Flow Control Utilizing Detonation

Active flow control devices including mass injection systems and zero-net-mass flux actuators (synthetic jets) have been employed to delay flow separation. These devices are capable of interacting with low-speed, subsonic flows, but situations exist where a stronger crossflow interaction is needed. Small actuators that utilize detonation of premixed fuel and oxidizer should be capable of producing supersonic exit jet velocities. An actuator producing exit velocities of this magnitude should provide a more significant interaction with transonic and supersonic crossflows. This concept would be applicable to airfoils on high-speed aircraft as well as inlet and diffuser flow control. The present work consists of the development of a detonation actuator capable of producing a detonation in a single shot (one cycle). Multiple actuator configurations, initial fill pressures, oxidizers, equivalence ratios, ignition energies, and the addition of a turbulence generating device were considered experimentally and computationally. It was found that increased initial fill pressures and the addition of a turbulence generator aided in the detonation process. The actuators successfully produced Chapman-Jouguet detonations and wave speeds on the order of 3000 m/s.

Lonneman, Patrick J.↗
NASA NTRS1971

Wave growth in a strongly turbulent plasma

An equation is derived for the average nonlinear growth (damping) rate of an electrostatic mode with wave vector k for an ensemble of electrostatically turbulent, unmagnetized plasmas. Strong turbulence alters particle orbits during the course of wave growth and hence brings particles in and out of resonance with the wave. The wave growth rate in a strongly turbulent plasma therefore depends on the initial velocity distribution of particles not only at the wave speed, but in the vicinity of this speed as well. Two orbital effects are considered: turbulence modification of ensemble average orbits and turbulence-produced orbital dispersion about the average orbits. Both contribute to a resonance broadening.

Birmingham, T. J.↗
NASA NTRS1972

Application of various elastic thin shell theories to blood flow problems

Some existing theories, on elastic thin shells, are reviewed to ascertain their influence on the computation of phase velocities in fluid filled cylinders representing certain aspects of the behavior of arteries and veins in vivo. For physiologically meaningful parameters, including moderately large in plane prestrain that occurs in mammals, the results suggest that with one exception, the small differences in the formulations exercise little influence on the phase velocities. However, it is demonstrated that inclusion of the forces induced by the rotation of the hydrostatic pressure is essential or significantly erroneous torsional wave speeds result. Also the introduction of moderate implane prestrains that are present in living mammals is shown to lead to nonselfadjoint differential equations of motion, whose biorthogonal eigenvectors differ slightly from each other.

Source record↗
NASA NTRS1972

Viscous stability theory for thermally stratified flow - Discontinuous jets and shear layers.

The method used by Drazin to investigate the stability of unbounded, viscous, homogeneous, parallel shear flow to small wavenumber disturbances is extended to study the effect of thermal stratification on the stability of unbounded jets and shear layers. By this method the stability characteristics of continuous profiles are inferred from the stability characteristics of discontinuous profiles. The characteristic value problem for discontinuous jet and shear layers is posed by the requirement that the solutions of the governing differential equation satisfy the matching conditions and boundedness conditions for layers that extend to infinity. The analysis leads to a characteristic determinant which is required to vanish for the characteristic values of the parameters: the Reynolds number, the wavenumber, and the wave speed. The stabilizing effect of the thermal stratification as parameterized by the Richardson number was found to be most stabilizing for small wavenumber (large-scale) disturbances.

Gage, K. S.↗
NASA NTRS1974

A remote sensing study of Pacific hurricane Ava

Aircraft, Skylab, NOAA-2, ATS-3, and NIMBUS-5 recently obtained a variety of measurements of Pacific hurricane Ava. These measurements are unusually broad in scope and include satellite observed passive microwave emissivities at 13.9 and 19.5 GHz, active microwave scattering cross-sections at 13.9 GHz, and near infrared and visible images. Essentially simultaneous aircraft measurements of wind speed, waves, whitecaps, 1.4 and 13-15 GHz passive microwave emissivities, 1.4 GHz active microwave images, sea surface temperatures, pressure fields, and aerosol size distributions were also obtained. A brief description of sensors and platforms is presented along with some in-depth details of results obtained.

Ross, D.↗
NASA NTRS1976

An Experimental Investigation of Fluid Flow and Heating in Various Resonance Tube Modes

Experiments have been performed to study resonance phenomena in tubes excited by underexpanded jet flows. This investigation comprised the following: Study of the various resonance tube modes under a wide range of nozzle pressure, spacing between nozzle and tube mouth, and different tube length; the effects of these modes on the endwall pressure and gas temperature; flow visualization of both jet and tube flows by spark shadowgraph technique; and measurement of wave speed inside the tube by the laser-schlieren techniques. An extensive study of the free-jet flow was undertaken to explain important aspects of various modes of operation of resonance tube flows.

Sarohia, V.↗
NASA NTRS1975

Flow processes in electric discharge drivers

The performance of an electric discharge shock tube is discussed from the point of view that the conditions at the sonic station are the primary controlling variables (likewise in comparing designs), and that the analysis of the flow on either side of the sonic station should be done separately. The importance of considering mass-flow rate in matching a given driver design to the downstream flow required for a particular shock-wave speed is stressed. It is shown that a driver based on the principle of liquid injection (of H2) is superior to one based on the Ludwieg tube, because of the greater mass-flow rate and the absence of a massive diaphragm.

Baganoff, D.↗
NASA NTRS1977

Dynamic response of some tentative compliant wall structures to convected turbulence fields

Some tentative compliant wall structures designed for possible skin friction drag reduction are investigated. Among the structural models considered is a ribbed membrane backed by polyurethane or PVS plastisol. This model is simplified as a beam placed on a viscoelastic foundation as well as on a set of evenly spaced supports. The total length of the beam may be either finite or infinite, and the supports may be either rigid or elastic. Another structural model considered is a membrane mounted over a series of pretensioned wires, also evenly spaced, and the entire membrane is backed by an air cavity. The forcing pressure field is idealized as a frozen random pattern convected downstream at a characteristic velocity. The results are given in terms of the frequency response functions of the system, the spectral density of the structural motion, and the spectral density of the boundary layer pressure including the effect of structural motion. These results are used in a parametric study of structural configurations capable of generating favorable wave lengths, wave amplitudes, and wave speeds in the structural motion for potential drag reduction.

Nijim, H. H.↗
NASA NTRS1977

On the theory of solitary Rossby waves

The evolution of long, finite amplitude Rossby waves in a horizontally sheared zonal current is studied. The wave evolution is described by the Korteweg-de Vries equation or the modified Korteweg-de Vries equation depending on the atmospheric stratification. In either case, the cross-stream modal structure of these waves is given by the long-wave limit of the neutral eigensolutions of the barotropic stability equation. Both non-singular and singular eigensolutions are considered and the appropriate analysis is developed to yield a uniformly valid description of the motion in the critical-layer region where the wave speed matches the flow velocity. The analysis demonstrates that coherent, propagating, eddy structures can exist in stable shear flows and that these eddies have peculiar interaction properties quite distinct from the traditional views of turbulent motion.

Redekopp, L. G.↗
NASA NTRS1978

Whistler mode noise in Jupiter's inner magnetosphere

A study is made of the amplitude and spectral extent of whistler mode noise in the inner magnetosphere of Jupiter. It is found that the 'hat-shaped' pitch angle distributions of energetic electrons (21 and 31 MeV at L=3) are consistent with those predicted in the presence of a band-limited spectrum of whistler mode noise. The equatorial maximum linear growth rate of parallel propagating whistlers are consistent with those necessary to limit the energetic electron intensities by the whistler mode instability. It is noted that the wave phase speeds before wave reflection can occur at high latitudes and that wave growth is limited to a disk-like region centered around the magnetic equator. The frequency extent of the whistler mode noise spectrum may be estimated by the range of frequencies maximally unstable to equatorial linear growth. A value is found for the spectral density of the broadband whistler mode noise necessary to balance radial diffusion of energetic electrons above the critical range, and an expression is derived for the energetic electron system response to fluctuations about the limiting flux value.

Sentman, D. D.↗
NASA NTRS1980

'GAIM' - Gas-addition, impedance-matched arc driver

A conceptual view for a GAIM energy/driver system to maximize shock-tube performance through efficient interfacing of the energy source with the gas dynamics of the arc driver is presented. Electrical and arc-chamber requirements are evaluated utilizing two new computer codes. One code calculates the shock wave generated for a selected time rate and magnitude of arc-energy input; the other computes the values of external circuit elements required to produce the selected energy input, with the driver represented as the load element of the electrical discharge circuit. Results indicate that the energy-storage capability and the driver arrangement needed to produce the highest shock Mach number can be achieved by means of driver gas addition and by impedance matching (GAIM). Design criteria are presented for arc energy requirements necessary to produce given shock-wave speeds. Shock velocities as high as the 70 km/sec required for simulating Jovian entry now seem possible in shock-tube operation. Practical implementation of a GAIM system is discussed.

Dannenberg, R. E.↗
NASA NTRS1983

Implicit upwind methods for the compressible Navier-Stokes equations

A class of implicit upwind differencing methods for the compressible Navier-Stokes equations is described and applied. The methods are based on the use of local eigenvalues or wave speeds to control spatial differencing of inviscid terms and are aimed at increasing the level of accuracy and stability achievable in computation. Techniques for accelerating the rate of convergence to a steady state solution are also used. Applications to inviscid and viscous transonic flows are discussed and compared with other methods and experimental measurements. It is shown that accurate and efficient transonic airfoil calculations can be made on the Cray-l computer in less than 2 min.

Coakley, T. J.↗
NASA NTRS1983

Convection effects at solid-liquid interfaces: Influence of gravity

The stability of the flow between two vertical, infinite, rigid, coaxial cylinders held at different temperatures is analyzed by linear stability theory. For a Prandtl number of 22.8 and a radius ratio of 0.02, the flow is unstable to an axisymmetric perturbation at a critical Grashof number of 2150; the wave speed of the instability is comparable to the maximum velocity of the unperturbed flow. When the rigid outer cylinder-fluid interface is replaced by a crystal-melt interface which can change shape, two new modes of instability occur at lower Grashof numbers.

Glicksman, M. E.↗
NASA NTRS1983

Implicit upwind methods for the compressible Navier-Stokes equations

A class of implicit upwind-differencing methods for the compressible Navier-Stokes equations is described and applied. The methods are based on the use of local eigenvalues or wave speeds to control spatial differencing of inviscid terms and are aimed at increasing the level of accuracy and stability achievable in computation. Techniques for accelerating the rate of convergence to a steady-state solution are also used. Applications to inviscid and viscous transonic flows are discussed and compared with other methods and experimental measurements. It is shown that accurate and efficient transonic airfoil calculations can be made on the Cray-1 coomputer in less than 2 min.

Coakley, T. J.↗