Search NASA⌕ Search

SEARCH · Search NASA

Results for “Module”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 901 records · Page 50
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

A novel approach to a PPM-modulated frequency-doubled electro-optic cavity-dumped Nd:YAG laser

A technique which can provide frequency doubling, with high efficiency, while cavity dumping a laser for pulse position M-ary modulation while being used for an optical communication link is discussed. This approach uses a secondary cavity that provides feedback of the undoubled fundamental light, which is normally lost, into the primary cavity to be recirculated and frequency doubled. Specific operations of the electrooptic modulator and frequency-doubling crystal are described along with the overall modulation scheme and experimental setup.

Robinson, D. L.↗
NASA NTRS1989

Optically controlled absorption modulator based on state filling of In(x)Ga(1-x)As/GaAs quantum wells

The first demonstration of an optically controlled absorption modulator based on state filling in a periodically doped In(x)Ga(1-x)As/GaAs multiple quantum well structure is reported. Differential absorption of approximately 10,000/cm is observed in the quantum wells of the test structure at saturation pump powers. Photoluminescence and time-resolved modulation measurements confirm the predicted behavior of carrier recombination and give a measure of enhanced carrier lifetime of approximately 1 ms. These initial results show the potential for developing these structures into optically addressed spatial light modulators.

Iannelli, J. M.↗
NASA NTRS1989

Optically controlled reflection modulator using GaAs-AlGaAs n-i-p-i/multiple-quantum-well structures

An optically controlled reflection modulator has been demonstrated that consists of a combination of a GaAs-AlGaAs n-i-p-i doping structure with a multiple-quantum-well structures on top of a distributed Bragg reflector, all grown by MBE. A modulation of approximately 60 percent is obtained on the test structure, corresponding to a differential change of absorption coefficient in the quantum wells of approximately 7500/cm. Changes in reflectance can be observed with a control beam power as low as 1.5 microW. This device structure has the potential of being developed as an optically addressed spatial light modulator for optical information processing.

Law, K.-K.↗
NASA NTRS1989

Flow-induced morphological instabilities due to temporally-modulated stagnation-point flow

The influence of periodically-modulated planar stagnation-point flow on the morphological stability of a directionally-solidifying interface is presently considered with a view to the effect of unsteady nonparallel flows on single-crystal growth. The modeling of the system assumes that the viscous boundary layer thickness is much greater than that of the solute boundary layer, and that the modulation frequency is much smaller than the strength of plane stagnation-point flow. The solidifying interface is either stabilized or destabilized depending on the ratio of the period of modulation to the solute-diffusion time.

Merchant, G. J.↗
NASA NTRS1988

A review of test results on parabolic dish solar thermal power modules with dish-mounted Rankine engines and for production of process steam

This paper presents results of development testing of various solar thermal parabolic dish modules and assemblies. Most of the tests were at modules and assemblies that used a dish-mounted, organic Rankine cycle turbine for production of electric power. Some tests were also run on equipment for production of process steam or for production of electricity using dish-mounted reciprocating steam engines. These tests indicate that early modules achieve efficiencies of about 18 percent in converting sunlight to electricity (excluding the inverter but including parasitics). A number of malfunctions occurred. The performance measurements, as well as the malfunctions and other operating experience, provided information that should be of value in developing systems with improved performance and reduced maintenance.

Jaffe, Leonard D.↗
NASA NTRS1989

Pulse modulated control synthesis for a flexible spacecraft

The describing function method is employed for the nonlinear control analysis and design of a flexible spacecraft equipped with pulse modulated reaction jets. The method provides a means of characterizing the pulse modulator in terms of its gain and phase for structural mode limit cycle analysis. Although the describing function method is inherently inexact and is not widely used in practice, a new way of utilizing it for practical control design problems is presented. It is shown that the approximations inherent in the method can be accounted as a modeling uncertainty for the nonlinear control robustness analysis. The pulse modulated control system of the Intelsat 5 spacecraft is used as an example to illustrate the concept and methodology developed in the paper. The nonlinear stability margins predicted by the describing function analysis are verified from nonlinear simulations.

Anthony, Tobin C.↗
NASA NTRS1990

GaAIAs Traveling-Wave Electro-optical Modulators

Microwave signals modulate optical signals in unit integrable with GaAs and GaAIAs devices. Experimental GaAIAs electro-optical modulators designed and built for operation at wavelength of 0.82 micrometers. Easily integrable with GaAs monolithic microwave integrated circuits. Integrated optical and microwave waveguides in electro-optical materials constitute traveling-wave electro-optical modulator in configuration of Mach-Zehnder interferometer. Because characteristic impedance of waveguide 50 ohms - standard value - no impedance-matching network required.

Bhasin, Kul B.↗
NASA NTRS1988

The 30-GHz monolithic receive module

The fourth year progress is described on a program to develop a 27.5 to 30 GHz GaAs monolithic receive module for spaceborne-communication antenna feed array applications, and to deliver submodules for experimental evaluation. Program goals include an overall receive module noise figure of 5 dB, a 30 dB RF to IF gain with six levels of intermediate gain control, a five bit phase shifter, and a maximum power consumption of 250 mW. Submicron gate length single and dual gate FETs are described and applied in the development of monolithic gain control amplifiers and low noise amplifiers. A two-stage monolithic gain control amplifier based on ion implanted dual gate MESFETs was designed and fabricated. The gain control amplifier has a gain of 12 dB at 29 GHz with a gain control range of over 13 dB. A two-stage monolithic low noise amplifier based on ion implanted MESFETs which provides 7 dB gain with 6.2 dB noise figure at 29 GHz was also developed. An interconnected receive module containing LNA, gain control, and phase shifter submodules was built using the LNA and gain control ICs as well as a monolithic phase shifter developed previously under this program. The design, fabrication, and evaluation of this interconnected receiver is presented. Progress in the development of an RF/IF submodule containing a unique ion implanted diode mixer diode and a broadband balanced mixer monolithic IC with on-chip IF amplifier and the initial design of circuits for the RF portion of a two submodule receiver are also discussed.

Bauhahn, P.↗
NASA NTRS1990

Automation in the Space Station module power management and distribution Breadboard

The Space Station Module Power Management and Distribution (SSM/PMAD) Breadboard, located at NASA's Marshall Space Flight Center (MSFC) in Huntsville, Alabama, models the power distribution within a Space Station Freedom Habitation or Laboratory module. Originally designed for 20 kHz ac power, the system is now being converted to high voltage dc power with power levels on a par with those expected for a space station module. In addition to the power distribution hardware, the system includes computer control through a hierarchy of processes. The lowest level process consists of fast, simple (from a computing standpoint) switchgear, capable of quickly safing the system. The next level consists of local load center processors called Lowest Level Processors (LLP's). These LLP's execute load scheduling, perform redundant switching, and shed loads which use more than scheduled power. The level above the LLP's contains a Communication and Algorithmic Controller (CAC) which coordinates communications with the highest level. Finally, at this highest level, three cooperating Artificial Intelligence (AI) systems manage load prioritization, load scheduling, load shedding, and fault recovery and management. The system provides an excellent venue for developing and examining advanced automation techniques. The current system and the plans for its future are examined.

Walls, Bryan↗
NASA NTRS1990

A computer module used to calculate the horizontal control surface size of a conceptual aircraft design

The creation of a computer module used to calculate the size of the horizontal control surfaces of a conceptual aircraft design is discussed. The control surface size is determined by first calculating the size needed to rotate the aircraft during takeoff, and, second, by determining if the calculated size is large enough to maintain stability of the aircraft throughout any specified mission. The tail size needed to rotate during takeoff is calculated from a summation of forces about the main landing gear of the aircraft. The stability of the aircraft is determined from a summation of forces about the center of gravity during different phases of the aircraft's flight. Included in the horizontal control surface analysis are: downwash effects on an aft tail, upwash effects on a forward canard, and effects due to flight in close proximity to the ground. Comparisons of production aircraft with numerical models show good accuracy for control surface sizing. A modified canard design verified the accuracy of the module for canard configurations. Added to this stability and control module is a subroutine that determines one of the three design variables, for a stable vectored thrust aircraft. These include forward thrust nozzle position, aft thrust nozzle angle, and forward thrust split.

Sandlin, Doral R.↗
NASA NTRS1989

High frequency GaAlAs modulator and photodetector for phased array antenna applications

A waveguide Mach-Zehnder electro-optic modulator and an interdigitated photoconductive detector designed to operate at 820 nm, fabricated on different GaAlAs/GaAs heterostructure materials, are being investigated for use in optical interconnects in phased array antenna systems. Measured optical attenuation effects in the modulator are discussed and the observed modulation performance up to 1 GHz is presented. Measurements of detector frequency response are described and results presented.

Claspy, P. C.↗
NASA NTRS1988

Proposed acceptance, qualification, and characterization tests for thin-film PV modules

Details of a proposed test program for PV thin-film modules which the Department of Energy has directed the Solar Energy Research Institute (SERI) to prepare are presented. Results of one of the characterization tests that SERI has performed are also presented. The objective is to establish a common approach to testing modules that will be acceptable to both users and manufacturers. The tests include acceptance, qualification, and characterization tests. Acceptance tests verify that randomly selected modules have similar characteristics. Qualification tests are based on accelerated test methods designed to simulate adverse conditions. Characterization tests provide data on performance in a predefined environment.

Waddington, D.↗
NASA NTRS1990

Intensity modulation of HF heater-induced plasma lines

The Arecibo HF heater is normally composed of two separate sets of antenna array, transmitting waves vertically at the same frequency and polarization. However, when these two sets of antenna array radiate at slightly different frequencies, the intensities of HF heater-induced plasma lines (HFPLs) can be drastically modulated. In recent Duncan et al.'s (1989) experiments the 100 percent intensity modulation of HFPLs was seen to persist even when the secondary set of antenna array radiated at a few percent of the power transmitted by the primary set of antenna array. An explanation is offered, and it is shown that there exists a minimum power, Pmin, and if the secondary set of antenna array radiates at a power lower than Pmin, the 100-percent intensity modulation of HFPLs will not be observed. The functional dependence of Pmin on the difference frequency of the two sets of antenna array is also predicted for future experiments to corroborate.

Kuo, S. P.↗
NASA NTRS1990

Shielding requirements for the Space Station habitability modules

The design, analysis, development, and tests of the total meteoroid/debris protection system for the Space Station Freedom habitability modules, such as the habitation module, the laboratory module, and the node structures, are described. Design requirements are discussed along with development efforts, including a combination of hypervelocity testing and analyses. Computer hydrocode analysis of hypervelocity impact phenomena associated with Space Station habitability structures is covered and the use of optimization techniques, engineering models, and parametric analyses is assessed. Explosive rail gun development efforts and protective capability and damage tolerance of multilayer insulation due to meteoroid/debris impact are considered. It is concluded that anticipated changes in the debris environment definition and requirements will require rescoping the tests and analysis required to develop a protection system.

Avans, Sherman L.↗
NASA NTRS1990

Numerical simulation of 3-D Benard convection with gravitational modulation

In this numerical study, randomly and sinusoidally modulated gravitational fields imposed on three-dimensional Rayleigh-Benard convection are investigated in an effort to understand the effects of vibration (G-Jitter) on fluid systems. The time-dependent, Navier-Stokes equations and the energy equation with Boussinesq approximations are solved by a semi-implicit, pseudospectral procedure. An analysis of energy balances indicates that with increasing modulation amplitude, transition from synchronous to relaxation oscillation goes through the subharmonic response. Random modulations are found to be less stabilizing than sinusoidal and are shown to impose three-dimensionality on the flow for some parameter ranges both at terrestrial and zero base gravity conditions.

Biringen, S.↗
NASA NTRS1989

Space Station Freedom photovoltaic power module design status

Electric power generation for the Space Station Freedom will be provided by four photovoltaic (PV) power modules using silicon solar cells during phase I operation. Each PV power module requires two solar arrays with 32,800 solar cells generating 18.75 kW of dc power for a total of 75 kW. A portion of this power will be stored in nickel-hydrogen batteries for use during eclipse, and the balance will be processed and converted to 20 kHz ac power for distribution to end users through the power management and distribution system. The design incorporates an optimized thermal control system, pointing and tracking provision with the application of gimbals, and the use of orbital replacement units to achieve modularization. The design status of the PV power module, as derived from major trade studies, is discussed at hardware levels ranging from component to system. Details of the design are presented where appropriate.

Jimenez, Amador P.↗
NASA NTRS1990

Turbulence modulation effect on evaporating spray characterization

The effects of turbulence modulation on the evaporating spray characteristics of a liquid fuel jet are numerically investigated. Two modulation models are implemented into the k-epsilon two-equation model. The gas phase is solved by a pressure-based method on a Eulerian frame and droplets are solved by a stochastic discrete particle technique based on Lagrangian formulation. The k-epsilon models are used to characterize the time and length scales of the gas phase turbulence for droplet dispersions and droplet/turbulence interactions. The modulation models are found to have significant effects on gas phase dynamics, and are less important for the droplet dynamics. Numerical predictions are compared with the experimental data of Drallemier and Peters (1990).

Shang, H. M.↗
NASA NTRS1990

The modulation of a radar signal from the ocean surface due to slope and hydrodynamic effects

The modulation of the signal level of a tower-based radar scatterometer illuminating a small area of the ocean surface is predicted from direct measurements of the hydrodynamic conditions of the ocean surface and compared with X band radar measurements taken simultaneously. The radar backscatter is assumed to be due to Bragg resonance between the signal and the ripple waves. The effects of the slope of the ocean surface due to passing long waves are modeled by converting a measured wave height series into a slope time series. Laser-slope-gauge measurements of the spectrum of the ripple waves that ride upon the long ocean waves are used to predict the hydrodynamic effects. Comparisons with the measured radar signal show that the slope modulation alone gives a poor prediction of the modulation. Inclusion of the hydrodynamic effects in the simulation appears more promising, although it also is not entirely successful with this data set.

West, James C.↗