Search NASA⌕ Search

SEARCH · Search NASA

Results for “Random fields”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 901 records · Page 50

Computer modeling for a space power transmission system

The paper summarizes the development of a computer program that simulates the performance of a large phased array antenna composed of 7220 smaller subarrays, each made up of klystron modules which act as individual radiators. The purpose of this program is to: (1) study the far-field pattern near the rectenna, (2) calculate the beam efficiency, and (3) observe the grating lobe behavior. Attention is given to the computer program which consists of a main program and four subroutines, as well as to the system configurations. The effects of amplitude, phase and random subarray failures are examined and an error budget was specified for 10 to the 0 phase error, + or - 1 dB amplitude error, and a 2% random failure rate.

Rathjen, S. M.↗

Dynamics of an unsteady turbulent boundary layer

The present investigation is concerned with the response of a well-defined, steady, flatplate turbulent boundary layer subjected subsequently to two types of oscillations of the free-stream velocity in the test section. It is found that the mean velocity profile in the boundary layer is unaffected by imposed free-stream oscillations in the range of frequencies employed. It is the same as the one measured with a free-stream velocity distribution held steady at its mean value. The behavior of the mean velocity field is a consequence of two observations. The time-averaged Reynolds stress distribution across the boundry layer is unaffected by the imposed oscillations. The Reynolds stresses arising from the organized velocity fluctuations under imposed oscillatory conditions are negligible compared to Reynolds stress due to the random fluctuations.

Parikh, P. G.↗

Studies of coastal mesoscale winds using SIR-B

The variability of the mesoscale wind fields near coastlines which can be caused by mountains that shadow offshore wind and by valleys that enhance them. These wind, provide relatively fixed patterns that must be considered in the development of algorithms for future spaceborne scatterometer systems; mesoscale variability over the offshore regions is random and must be averaged out for forecasting yet nearshore fixed patterns are treated differently. Before the patterns of interest can be defined quantitatively, the scattering response of the ocean to winds at the L-band frequency and SIR-B angles of incidence must be developed from the SIR-B data. Patterns can be analyzed on the images both in regions selected for high probability of the occurrence of suitable patterns, and in other regions where the patterns are observed. The patterns are analyzed for topographic effects and the distance to sea over which these effects cause variations in the oceanic wind patterns. The results are interpreted in terms of quantitative description of the processes involved and in for need of modifications of future scatterometer algorithms.

Moore, R. K.↗

Growth process of gamma'-particles in a liquid-quenched Ni-15 at percent Al alloy

The growth of gamma-prime particles in a supersaturated Ni-15 at% Al alloy prepared by the liquid-quench method was studied using a magnetic mass balance, transmission electron microscopy, and field ion microscopy. Three stages in the precipitation and growth of these particles are demonstrated. In the first phase, the gamma-prime phase was produced by nucleation of spinodal decomposition of the alloy. In the second stage, spherical gamma-prime particles were arranged at random in the matrix with the size independent of aging time. Then, the Al concentration in the matrix decreased with the -1/3 power of the aging time. These results suggest that the degree of ordering increases with aging time. In the third stage, the particles were coarsened with aging time. They were arranged in the matrix (100) zone and were cubic, with the cube face lying on (100). The interfacial free energy was 28.4 mJ/sq m at 873 K and 22.4 mJ/sq m at 973 K.

Tachikake, A.↗

Wake shield

Progress on the modeling of the flow field around a wake shield using a recently obtained code based on the Monte Carlo method is discussed. The direct simulation Monte Carlo method is a method for solving the Boltzman Equation using an approximation to the collision integral term. The collision integrand is evaluated for randomly selected values of its arguments and the summation will approach the integral for large enough samples. The collision effects may be modeled for either hard sphere or various power law potentials. The convective side of the Boltzman equation is approximated over a time step using a simple trajectory calculation of molecules as they travel through the domain of interest.

Bannister, Tommy↗

Halo common proper motion stars - Subdwarf distance scale, halo binary fraction, and UBVRI colors

Common proper motion stars identified by Luyten (1979, 1980) were selected according to reduced proper motion and photometric criteria to produce a list of candidate halo objects. UBVRI photometry was obtained to identify genuine halo parts. About 20 percent of the stars with (Fe/H) less than -1.0 were found to have random errors not less than several x 0.1 mag in distance modulus, in addition to the photometric errors, thought to be due to the existence of close binary companions to some of the common proper motion stars. The implications of these errors for kinematic studies of field Population II stars are considered. Systematic errors of order 16 percent were also detected in distances derived from the U-B,B-V deblanketing technique. It is suggested that Population II field stars did not originate in globular clusters which subsequently disintegrated but formed in less dense environments. Several K subdwarfs were found with very high UV excesses, comparable with those predicted by some synthetic colors.

Ryan, Sean G.↗

The structure of supersonic jet flow and its radiated sound

Large-eddy simulation of a supersonic jet is presented with emphasis on capturing the unsteady features of the flow pertinent to sound emission. A high-accuracy numerical scheme is used to solve the filtered, unsteady, compressible Navier-Stokes equations while modelling the subgrid-scale turbulence. For random inflow disturbance, the wave-like feature of the large-scale structure is demonstrated. The large-scale structure was then enhanced by imposing harmonic disturbances to the inflow. The limitation of using the full Navier-Stokes equation to calculate the far-field sound is discussed. Application of Lighthill's acoustic analogy is given with the objective of highlighting the difficulties that arise from the non-compactness of the source term.

Mankbadi, Reda R.↗

Evaluation of Magnetoresistive RAM for Space Applications

Magnetoresistive random-access memory (MRAM) is a non-volatile memory that exploits electronic spin, rather than charge, to store data. Instead of moving charge on and off a floating gate to alter the threshold voltage of a CMOS transistor (creating different bit states), MRAM uses magnetic fields to flip the polarization of a ferromagnetic material thus switching its resistance and bit state. These polarized states are immune to radiation-induced upset, thus making MRAM very attractive for space application. These magnetic memory elements also have infinite data retention and erase/program endurance. Presented here are results of reliability testing of two space-qualified MRAM products from Aeroflex and Honeywell.

Heidecker, Jason↗

Estimating errors in least-squares fitting

While least-squares fitting procedures are commonly used in data analysis and are extensively discussed in the literature devoted to this subject, the proper assessment of errors resulting from such fits has received relatively little attention. The present work considers statistical errors in the fitted parameters, as well as in the values of the fitted function itself, resulting from random errors in the data. Expressions are derived for the standard error of the fit, as a function of the independent variable, for the general nonlinear and linear fitting problems. Additionally, closed-form expressions are derived for some examples commonly encountered in the scientific and engineering fields, namely ordinary polynomial and Gaussian fitting functions. These results have direct application to the assessment of the antenna gain and system temperature characteristics, in addition to a broad range of problems in data analysis. The effects of the nature of the data and the choice of fitting function on the ability to accurately model the system under study are discussed, and some general rules are deduced to assist workers intent on maximizing the amount of information obtained form a given set of measurements.

Richter, P. H.↗

Analysis of GPS Data Collected on the Greenland Ice Sheet

For several years, GPS observations have been made year round at the Swiss Camp, Greenland. The GPS data are recorded for 12 hours every 10-15 days; data are stored in memory and downloaded during the annual field season. Traditional GPS analysis techniques, where the receiver is assumed not to move within a 24 hour period, is not appropriate at the Swiss Camp, where horizontal velocities are on the order of 30 cm/day. Comparison of analysis strategies for these GPS data indicate that a random walk parameterization, with a constraint of 1-2 x 10(exp -7) km/sqrt(sec) minimizes noise due to satellite outages without corrupting the estimated ice velocity. Low elevation angle observations should be included in the analysis in order to increase the number of satellites viewed at each data epoch. Carrier phase ambiguity resolution is important for improving the accuracy of receiver coordinates.

Larson, K.↗

Design and Development of Modules to Support Live Microscopic Imaging on Ground-Based Microgravity Simulators

In space, astronauts are exposed to environmental stressors that often result in physiological changes. One prominent stressor in spaceflight is microgravity, and research has shown that long term microgravity exposure causes muscle atrophy, bone loss, cardiovascular concerns, and vision impairment. It is critical to understand how altered gravity affects physiology on the cellular, molecular, and gene level in order to accurately assess health risks and to develop effective countermeasures. Ground-based microgravity simulators such as random positioning machines (RPMs) are used to produce some of the biological effects of altered gravity on different cell types and organisms. Real-time imaging during simulations are of particular interest as we can study how basic cell functions such as cell division, cell migration, and proliferation progress under microgravity conditions. However, design limitations of present microgravity simulators such as susceptibility to parasitic vibration and displacement of the sample from the center of rotation challenge the accuracy of experiment results and live images. We have developed a cell culture sample holder module suitable for live microscopic imaging on an RPM. CAD modeling and 3D printing technology were used to implement modifications to the sample holder and to install a digital microscope to perform live bright-field and fluorescent imaging. Vibration damping materials were also investigated to allow for stable imaging while the microgravity simulator was within a cell culture incubator. Novel methods and hardware modifications for improving live cell imaging on ground-based microgravity simulators were proposed and discussed.

3D printing↗

Martian doublet craters.

A large number of Mars craters are nearly tangential to other craters. They occur in clusters or as isolated crater doublets. Results of probability calculations and a Monte Carlo cratering simulation model show conclusively that many of the Mars craters could not have resulted from random single-body impact. The possibility that these craters are calderas is considered possible only if calderas on Mars form by mechanisms different from those on earth. However, clusters and doublets could be caused by meteoroid breakup resulting from stresses induced in the meteoroid by the gravitational field of Mars. It is concluded that, under certain conditions, doublets should be produced on Mars as a direct result of breakup of an impacting meteoroid. The impact process can yield nonrandom crater distributions that should be observed in different degrees of development on different planetary surfaces.

Oberbeck, V. R.↗

Characteristics of corona impulses from insulated wires subjected to high ac voltages

Corona discharges arise due to ionization of air or gas subject to high electric fields. The free electrons and ions contained in these discharges interact with molecules of insulating materials, resulting in chemical changes and destroying the electrical insulating properties. The paper describes some results of measurements aimed at determining corona pulse waveforms, their repetition rate, and amplitude distribution during various randomly-sampled identical time periods of a 60-Hz high-voltage wave. Described are properties of positive and negative corona impulses generated from typical conductors at various test high voltages. A possible method for calculating the energies, densities, and electromagnetic interferences by making use of these results is suggested.

Doreswamy, C. V.↗

Depolarization effects in the active remote sensing of random media

Backscattering cross sections for depolarization are derived for the active remote sensing of a two-layer random medium. It is shown that the depolarization effects arise as a second-order term in albedo under the Born approximation. The results of the backscattering cross sections are illustrated as functions of frequency and incident angles and used to match experimental data collected from a vegetation field.

Zuniga, M.↗

Photometric theory for wide-angle phenomena

An examination is made of the problem posed by wide-angle photographic photometry, in order to extract a photometric-morphological history of Comet P/Halley. Photometric solutions are presently achieved over wide angles through a generalization of an assumption-free moment-sum method. Standard stars in the field allow a complete solution to be obtained for extinction, sky brightness, and the characteristic curve. After formulating Newton's method for the solution of the general nonlinear least-square problem, an implementation is undertaken for a canonical data set. Attention is given to the problem of random and systematic photometric errors.

Usher, Peter D.↗

Three-dimensional random vibration testing definition and simulation

An approach is presented for the definition of 3D random vibration test requirements for multiaxial shaker systems. In particular, it is shown that, by utilizing coherence functions for cross-correlation effects, test requirements can be defined in a simple way and provide a more realistic environmental simulation. The method is applicable to the simulation of all field environments and can be similarly employed to develop laboratory test requirements based on field data. Example problems are presented to demonstrate the approach.

Chang, Kurng Y.↗

The behavior of elastic anisotropic laminated composite flat structures subjected to deterministic and random loadings

Within this research project, the following topics were studied: (1) foundation of the refined theory of flat cross-ply laminated composite flat and curved panels as well as their static and dynamic response analysis; (2) foundation of a geometrically-nonlinear shear-deformable theory of composite laminated flat panels including the effect of initial geometric imperfections and its application in the postbuckling analysis; (3) the study of the dynamic response of shear deformable elastic laminated composite panels to deterministic time-dependent external excitations as the sonic boom and explosive blast type-loadings; (4) the study of the dynamic response of shear deformable elastic laminated composite panels to random excitation as e.g. the one produced by a jet noise or by any time-dependent external excitation whose characteristics are expressed in a statistical sense; and (5) the dynamic stability of fiber-reinforced composite flat panels whose materials (due to e.g. an ambient high temperature field) exhibit a time-dependent physical behavior.

Librescu, Liviu↗

Simulation of wave propagation in three-dimensional random media

Quantitative error analysis for simulation of wave propagation in three dimensional random media assuming narrow angular scattering are presented for the plane wave and spherical wave geometry. This includes the errors resulting from finite grid size, finite simulation dimensions, and the separation of the two-dimensional screens along the propagation direction. Simple error scalings are determined for power-law spectra of the random refractive index of the media. The effects of a finite inner scale are also considered. The spatial spectra of the intensity errors are calculated and compared to the spatial spectra of intensity. The numerical requirements for a simulation of given accuracy are determined for realizations of the field. The numerical requirements for accurate estimation of higher moments of the field are less stringent.

Coles, William A.↗