DOE OSTI2019
This report documents the results of sealed reactor tests to measure the hydrogen generation rate (HGR) from Tank 50 waste, which may be on the order of 3 x 10 -9 (ft 3 /h)/gal. Because the estimated HGR limit of detection (LOD) for an open, continuous flow system is approximately 6 x 10 -8 (ft 3 /h)/gal a more sensitive method was needed. By accumulating generated gases in a sealed system without a continuous purge gas, the resulting concentrations can increase the sensitivity of measurement, which is based on duration of heating. Prior sealed-reactor testing demonstrated measurements down to 7 x 10 -10 (ft 3 /h)/gal. In 2017, Savannah River Remediation, LLC (SRR) declared a Potential Inadequacy in the Safety Analysis (PISA) for the Saltstone Production Facility (SPF), among other facilities. The research for this report concerns waste from Tank 50 which is processed through SPF to produce saltstone. Previous studies examined the thermolysis of Tank 50 waste mixed with small individual amounts of saltstone grout premix additives, as well as glycolate. In contrast, the current study evaluated the impact of Tank 50 waste containing glycolate and stabilized within saltstone, on the generation of flammable gases, specifically hydrogen. The task included holding at target temperatures Tank 50 samples of salt solution in grout and spiked with 350 mg/L of glycolate to determine if the glycolate decomposes into H 2 . The measured hydrogen generation rates for radioactive saltstone monoliths over 28 days are: 2.0 x 10 -7 (ft 3 /h)/gal at 64-68°C, 1.4 x 10 -7 (ft 3 /h)/gal at 80-82°C, and 4.5 x 10 -7 (ft 3 /h)/gal at 112°C. Testing also included a non-radioactive salt simulant of Tank 50 waste, which was spiked with a concentration of glycolate expected in Savannah River Site (SRS) low-level waste, after the waste is solidified in grout. Included in the simulant tests was using grout made with two different surface areas, a monolith form with only the upper surface exposed and a pellet, or cube, form to increase the exposed surface area, to demonstrate the importance of exposed area in H 2 generation.