Search NASA⌕ Search

SEARCH · Search NASA

Results for “Solar Modulation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,027 records · Page 57

Solar variability and quasi-stationary planetary wave behavior

A steady state analysis of winter winds shows that the speed of the upper atmospheric polar vortex approaches and occasionally exceeds the value required to reflect externally forced planetary wave 1 energy back towards the surface of the earth. Historical observations suggest that solar UV variability and geomagnetic disturbances are two primary forces which modulate the planetary wave trapping mechanism. Through the solar-terrestrial process described, small changes in the sun's behavior can be physically linked to both shortand long-term changes in tropospheric weather patterns.

Springer, B. D.↗

Intermediate load modules for test and evaluation

Photovoltaic modules were tested for qualification. Tests involved the following: (1) delivery of 20 solar cells for use as reference cells; (2) module documentation and inspection plans specifying the 10 Group I modules; (3) design review of module documentation from Group I modules; (4) revise module documentation to overcome any problems of deficiencies associated with the Group I modules; (5) delivery of 10 Group II modules built to revised specifications; (6) testing of Group II modules to the criteria as outlined in qualification specification. It is found that the solarvolt MSP43E40B satisfies the design criteria of qualification specification for intermediate load modules. Design changes were made in the Group I modules to overcome the deficiencies which allowed Group II modules to pass the qualification tests.

Source record↗

Simulation analysis of a novel high efficiency silicon solar cell

It is recognized that crystalline silicon photovoltaic module efficiency of 15 percent or more is required for cost-effective photovoltaic energy utilization. This level of module efficiency requires large-area encapsulated production cell efficiencies in the range of 18 to 20 percent. Though the theoretical maximum of silicon solar cell efficiency for an idealized case is estimated to be around 30 percent, practical performance of cells to-date are considerably below this limit. This is understood to be largely a consequence of minority carrier losses in the bulk as well as at all surfaces including those under the metal contacts. In this paper a novel device design with special features to reduce bulk and surface recombination losses is evaluated using numerical analysis technique. Details of the numerical model, cell design, and analysis results are presented.

Mokashi, Anant R.↗

A time-dependent diffusion convection model for the long term modulation of cosmic rays

A model is developed which incorporates to first order the direct effects of the time dependent diffusive propagation of interstellar cosmic rays in a slowly changing interplanetary medium. The model provides a physical explanation for observed rigidity-dependent phase lags in modulated spectra (cosmic ray hysteresis). The average distance to the modulating boundary during the last solar cycle is estimated.

Gallagher, J. J.↗

The Jovian relativistic electron distribution in interplanetary space from 1 to 11 AU - Evidence for a continuously emitting 'point' source

From observations of Jovian electrons with instrumentation on the Pioneer 10 spacecraft, it is concluded from both their spatial distribution and their modulation in interplanetary space by solar corotating interaction regions (CIRs) that, whatever the scale size of the Jovian magnetotail, the escape of relativistic electrons occurs within 1 AU of the planet. Thus, on the large scale of the heliosphere, Jupiter appears as a continuously emitting 'point source'. The close approach of the spacecraft at 9.6 AU to a possible extension of a magnetotail early in 1976 is discussed. From recurring intensity increases of approximately 1-MeV protons, it is concluded that CIRs have not dissipated even at about 11 AU.

Pyle, K. R.↗

An auroral effect on the fair weather electric field

Evidence is presented for coupling between the upper and lower atmosphere by means of the shorting out of the vertical mesospheric electric field by auroral radiation, which causes a transfer of mesospheric potential to the lower atmosphere. Measurements were made by an electric field antenna which was part of a parachute-borne payload, launched by rocket from near Fairbanks, Alaska. Data obtained from quiet time observations indicate the normal low altitude electric field pattern, with a greater field at high altitudes, while observations at disturbed times show a small field at high altitudes and a greater field at low altitudes. Means for observing this effect at lower latitudes are also suggested. While the data obtained support the proposed mechanism, it is noted that other mechanisms, such as direct modulation by large amounts of solar cosmic rays and aurorally produced charge separation, may also be important.

Hale, L. C.↗

Active heat exchange system development for latent heat thermal energy storage

Five tasks to select, design, fabricate, test and evaluate candidate active heat exchanger modules for future applications to solar and conventional utility power plants were discussed. Alternative mechanizations of active heat exchange concepts were analyzed for use with heat of fusion phase change materials (PCMs) in the temperature range of 250 to 350 C. Twenty-six heat exchange concepts were reviewed, and eight were selected for detailed assessment. Two candidates were selected for small-scale experimentation: a coated tube and shell heat exchanger and a direct contact reflux boiler. A dilute eutectic mixture of sodium nitrate and sodium hydroxide was selected as the PCM from over 50 candidate inorganic salt mixtures. Based on a salt screening process, eight major component salts were selected initially for further evaluation. The most attractive major components in the temperature range of 250 to 350 C appeared to be NaNO3, NaNO2, and NaOH. Sketches of the two active heat exchange concepts selected for test are given.

Lefrois, R. T.↗

The propagation of Jovian electrons to earth

An analysis of the Jovian electron flux increases observed by the earth-orbiting satellite Imp 8 throughout five 13 month Jovian synodic years during the period from launch of the satellite in 1973 to 1979 is presented. The analysis defines the characteristics of Jovian propagation to earth. Corotating interaction regions (CIR) that form at the leading edges of fast solar wind streams continue to modulate the propagation of MeV electrons from Jupiter to the orbit of the earth to produce approximately 27 day recurrent variations in the Jovian electron density. The new and significant result of this study is that these time-intensity profiles are more accurately described not by assumption that Jupiter is a constant source of electrons, but rather by assuming that electron emission is initiated with each passage of CIR by Jupiter with the emission continuing for only several days.

Chenette, D. L.↗

SEP BIMOD variable conductance heat pipes acceptance and characterization tests

A series of six heat pipes, similar in design to those flown on the Comunications Technology Satellite Hermes, for use in a prototype Solar Electric Propulsion BIMOD thrust module are evaluated. The results of acceptance and characterization tests performed on the heat pipe subassemble are reported. The performance of all the heat pipes met, or exceeded, design specifications.

Hemminger, J. A.↗

Effect of zinc impurity on silicon solar-cell efficiency

Zinc is a major residue impurity in the preparation of solar-grade silicon material by the zinc vapor reduction of silicon tetrachloride. This paper projects that in order to get a 17-percent AM1 cell efficiency for the Block IV module of the Low-Cost Solar Array Project, the concentration of the zinc recombination centers in the base region of silicon solar cells must be less than 4 x 10 to the 11th Zn/cu cm in the p-base n+/p/p+ cell and 7 x 10 to the 11th Zn/cu cm in the n-base p+/n/n+ cell for a base dopant impurity concentration of 5 x 10 to the 14 atoms/cu cm. If the base dopant impurity concentration is increased by a factor of 10 to 5 x 10 to the 15th atoms/cu cm, then the maximum allowable zinc concentration is increased by a factor of about two for a 17-percent AM1 efficiency. The thermal equilibrium electron and hole recombination and generation rates at the double-acceptor zinc centers are obtained from previous high-field measurements as well as new measurements at zero field described in this paper. These rates are used in the exact dc-circuit model to compute the projections.

Sah, C.-T.↗

Helium 10830 Angstrom Irradiance: 1975-1983

A fairly complete time series from late 1974 to mid-1983 is available of values of the equivalent width of the He I 10830A chromospheric spectrum line averaged over the visible solar disk. Variation from about 25 mA in 1975 to about 80 mA in late 1981 is the major component of the signal. The 10830 variation reaches minimum about a year before the sunspot minimum and reaches maximum about a year after sunspot maximum. Superposed on the solar cycle variation is a modulation of up to + or - 13 mAdu to the passage of active regions across the disk. Power spectral analysis of the time series shows a major peak at a synodic rotation period of 27.42 days and smaller peaks at 1/2, 1/4 and 1/6 of this period. The spectrum is well modeled by a basic fluctuating component with an exponentially decaying autocovariance function of scale time of 43 days. Analysis of the data indicates that the rotational modulation occurs in episodes that last from 4 to 10 rotations. These episodes arise when active regions tend to occur in a limited longitude range. The analysis also shows that the apparent rotation period increased from 1977 to 1981. The apparent rotation period since 1981 is markedly shorter.

Harvey, J. W.↗

Qualification tests and electrical measurements: Practice and problems

As part of the Flat-Plate Solar Array Project, 138 different module designs were subjected to qualification tests. Electrical measurements were subjected on well over a thousand modules representing more than 150 designs. From this experience, conclusions are drawn regarding results and problems, with discussion of the need for change or improvement. The qualification test sequence incuded application of environmental and electrical stresses to the module. With few exceptions, the tests have revealed defects necessitation of environmental and electrical stresses to the module. With few exceptions, the tests have revealed defects necessitating module design or process changes. However, the continued need for these tests may be questioned on the basis of technical and logistical factors. Technically, the current test sequence does not cover all design characteristics, does not include all field conditions and is not known to represent the desired 30-year module life. Logistically, the tests are time-consuming and costly, and there is a lack of, fully qualified independent test organizations. Alternatives to the current test program include simplification based on design specification and site environment, and/or the use of warranties or other commercial practices.

Smokler, M. I.↗

Development of design criteria and qualification tests for bypass diodes in photovoltaic applications

Design criteria have been developed for bypass diodes in p-n and Schottky barrier in photovoltaic applications. A test method for assessing conformity to the design criteria is described. Junction temperatures are defined in terms of expected worst-case field conditions, including ambient temperature and solar irradiance on the photovoltaic module. The rating criteria address the maximum allowable current and heat-sink characteristics of diodes mounted inside or outside the photovoltaic module. The method establishes worst-case module-to-diode thermal interfaces and may be adapted for laboratory or field-site experiments. A list of the design criteria is given.

Otth, D. H.↗

Patterns of discoloration and oxidation by direct and scattered fluxes on LDEF, including oxygen on silicon

A number of interesting discoloration patterns are clearly evident on MOOO2-1 which resides on the three faces of the Long Duration Exposure Facility (LDEF). Most interesting is the pattern of blue oxidation on polished single crystal silicon apparently produced by scattered or direct ram oxygen atoms along the earth face. A complete explanation for the patterns has not yet been obtained. All honeycomb outgassing holes have a small discoloration ring around them that varies in color. The shadow cast by a suspended wire on the earth face surface is not easily explained by either solar photons or by ram flux. The shadows and the dark/light regions cannot be explained consistently by the process of solar ultraviolet paint-darkening modulated by ram flux oxygen bleaching of the paint.

Frederickson, A. R.↗

Frequency variations of the earth's obliquity and the 100-kyr ice-age cycles

Changes in the earth's climate are induced by variations in the earth's orbital parameters which modulate the seasonal distribution of solar radiation. Periodicities in the geological climate record with cycles of 100, 41, and 23 kyr have been linked with changes in obliquity, eccentricity, and precession of the equinoxes. The effect of variations of eccentricity during a 100 kyr period is weak relative to the signals from obliquity and precession variations and it may therefore be expected that the 100 kyr signal in the climate record would be of low intensity. However, this signal dominates the climate record and internal nonlinear processes within the climate system have previously been proposed to account for this fact. The author shows that variations in the frequency of the obliquity cycle can give rise to strong 100-kyr forcing of climate.

Liu, Han-Shou↗

Use of Taguchi design of experiments to optimize and increase robustness of preliminary designs

The research performed this summer includes the completion of work begun last summer in support of the Air Launched Personnel Launch System parametric study, providing support on the development of the test matrices for the plume experiments in the Plume Model Investigation Team Project, and aiding in the conceptual design of a lunar habitat. After the conclusion of last years Summer Program, the Systems Definition Branch continued with the Air Launched Personnel Launch System (ALPLS) study by running three experiments defined by L27 Orthogonal Arrays. Although the data was evaluated during the academic year, the analysis of variance and the final project review were completed this summer. The Plume Model Investigation Team (PLUMMIT) was formed by the Engineering Directorate to develop a consensus position on plume impingement loads and to validate plume flowfield models. In order to obtain a large number of individual correlated data sets for model validation, a series of plume experiments was planned. A preliminary 'full factorial' test matrix indicated that 73,024 jet firings would be necessary to obtain all of the information requested. As this was approximately 100 times more firings than the scheduled use of Vacuum Chamber A would permit, considerable effort was needed to reduce the test matrix and optimize it with respect to the specific objectives of the program. Part of the First Lunar Outpost Project deals with Lunar Habitat. Requirements for the habitat include radiation protection, a safe haven for occasional solar flare storms, an airlock module as well as consumables to support 34 extra vehicular activities during a 45 day mission. The objective for the proposed work was to collaborate with the Habitat Team on the development and reusability of the Logistics Modules.

Carrasco, Hector R.↗