Search NASA⌕ Search

SEARCH · Search NASA

Results for “WIND EFFECT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,045 records · Page 58

Kelvin waves in total column ozone

Tropical Kelvin waves have been observed previously in ozone mixing ratio data from the SBUV (Solar Backscatter Ultraviolet) and LIMS (Limb Infrared Monitor of the Stratosphere) instruments on board the Nimbus-7 satellite. Kelvin wave features in total column ozone, using version 6 data from the Total Ozone Mapping Spectrometer (TOMS) instrument (also on board Nimbus-7) are investigated. Results show eastward-propagating zonal waves 1-2 with periods approximately 5-15 days, amplitudes approximately 3-5 DU, and latitudinal symmetry typical of Kelvin waves. A simplified model calculation suggests that the primary source for the perturbations is slow Kelvin waves in the lower-to-middle stratosphere. Maximum Kelvin wave signatures occur in conjunction with westward lower-to-middle stratospheric equatorial zonal winds (a quasi-biennial oscillation (QBO) wind modulation effect).

Ziemke, J. R.↗

The adaptive wall test section for the NASA Langley 0.3-m Transonic Cryogenic Tunnel

The effect of wind tunnel wall interference on transonic aerodynamic data obtained in a ventilated test section is difficult to predict. The magnitude of the interference can be reduced and the prediction of the level of interference can be simplified by testing in a test section with solid, adaptive walls. An adaptive wall test section configured for two dimensional testing has been installed in the circuit of the Langley 0.3-m Transonic Cryogenic Tunnel. The unique features of the tunnel and the new test section are described. An overview of computer software to configure the walls along streamsurfaces is presented along with a description of the of the experiments planned to assess the capabilities of the new test section.

Mineck, Raymond E.↗

Model supports and their effects on the results of wind tunnel tests

The airflow about a model while being tested is often sufficiently affected by the model support to lead to erroneous conclusions unless appropriate corrections are used. In this paper some new material on the subject is presented, together with a review of the airfoil support corrections used in several other laboratories.

Bacon, David L↗

The effect of trim angle on the take-off performance

Data obtained at the N.A.C.A. tank from tests on the models of three flying-boat hulls - N.A.C.A. models 11-A, 16, and 22 - are used to demonstrate the effect of trim angle on water resistance. A specific example is taken, and data from Model 11-A are used to show that the trim angle giving the minimum water resistance will give minimum total air-plus-water resistance. Total-resistance curves for best trimmed angles and other angles are compared for the same example. The effect of wind on best trim angles and upon the take-off and run is shown by the working of an example. The possibility of using tank data on trim angles as aid in piloting is discussed, and an instrument for use in determining the trim angle of seaplanes is described. The importance of maintaining the best trim angle throughout the take-off is indicated.

Shoemaker, James M↗

Wind-tunnel investigation of the effect of power and flaps on the static lateral characteristics of a single-engine low-wing airplane model

Tests were made in the Langley 7- by 10-foot tunnel to determine the lateral-stability characteristics with and without power of a model of a typical low-wing single-engine airplane with flaps neutral, with a full-span single slotted flap, and with a full-span double slotted flap. Power decreased the dihedral effect regardless of flap condition, and the double-slotted flap configuration showed the most marked decrease. The usual effect of power in increasing the directional stability was also shown. Deflection of the single slotted flap produced negative dihedral effect, but increased the directional stability. The effects of deflecting the double slotted flap were erratic and marked changes in both effective dihedral and directional stability occurred. The addition of the tail surfaces always contributed directional stability and generally produced positive dihedral effect.

Tamburello, Vito↗

Wind-tunnel investigation of the effects of horizontal-tail position on the low-speed longitudinal stability characteristics of an airplane model with a 35 degrees sweptback wing equipped with chordwise fences

An experimental investigation was made in the Langley stability tunnel to determine whether the low-speed longitudinal stability characteristics of a model with a 35 degree sweptback wing could be improved appreciably by lowering the horizontal tail. The investigation included tests of several components of the model and of various model configurations with chordwise fences on the wing.

Queijo, M J↗