Search NASA⌕ Search

SEARCH · Search NASA

Results for “AIRPLANES - DESIGN & THEORY”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
NASA NTRS1997

Dynamic Ground Effect for a Cranked Arrow Wing Airplane

Flight-determined ground effect characteristics for an F-16XL airplane are presented and correlated with wind tunnel predictions and similar flight results from other aircraft. Maneuvers were conducted at a variety of flightpath angles. Conventional ground effect flight test methods were used, with the exception that space positioning data were obtained using the differential global positioning system (DGPS). Accuracy of the DGPS was similar to that of optical tracking methods, but it was operationally more attractive. The dynamic flight determined lift and drag coefficient increments were measurably lower than steady-state wind-tunnel predictions. This relationship is consistent with the results of other aircraft for which similar data are available. Trends in the flight measured lift increments caused by ground effect as a function of flightpath angle were evident but weakly correlated. An engineering model of dynamic ground effect was developed based on linear aerodynamic theory and super-positioning of flows. This model was applied to the F-16XL data set and to previously published data for an F-15 airplane. In both cases, the model provided an engineering estimate of the ratio between the steady-state and dynamic data sets.

Curry, Robert E.↗
NASA NTRS1976

Flight test evaluation of a method to determine the level flight performance propeller-driven aircraft

A procedure is developed for deriving the level flight drag and propulsive efficiency of propeller-driven aircraft. This is a method in which the overall drag of the aircraft is expressed in terms of the measured increment of power required to overcome a corresponding known increment of drag. The aircraft is flown in unaccelerated, straight and level flight, and thus includes the effects of the propeller drag and slipstream. Propeller efficiency and airplane drag are computed on the basis of data obtained during flight test and do not rely on the analytical calculations of inadequate theory.

Cross, E. J., Jr.↗
NASA NTRS1937

Wind-tunnel interference with particular reference to off-center positions of the wing and to the downwash at the tail

The theory of wind tunnel boundary influence on the downwash from a wing has been extended to provide more complete corrections for application to airplane test data. The first section of the report gives the corrections of the lifting line for wing positions above or below the tunnel center line; the second section shows the manner in which the induced boundary influence changes with distance aft of the lifting line. Values of the boundary corrections are given for off-center positions of the wing in circular, square, 2:1 rectangular, and 2:1 elliptical tunnels. Aft of the wing the corrections are presented for only the square and the 2:1 rectangular tunnels, but it is believed that these may be applied to jets of circular and 2:1 elliptical cross sections. In all cases results are included for both open and closed tunnels.

Silverstein, Abe↗
NASA NTRS1990

A gravitational test of wave reinforcement versus fluid density models

Spermatozoa, protozoa, and algae form macroscopic patterns somewhat analogous to thermally driven convection cells. These bioconvective patterns have attracted interest in the fluid dynamics community, but whether in all cases these waves were gravity driven was unknown. There are two conflicting theories, one gravity dependent (fluid density model), the other gravity independent (wave reinforcement theory). The primary objectives of the summer faculty fellows were to: (1) assist in sample collection (spermatozoa) and preparation for the KC-135 research airplane experiment; and (2) to collaborate on ground testing of bioconvective variables such as motility, concentration, morphology, etc., in relation to their macroscopic patterns. Results are very briefly given.

Johnson, Jacqueline Umstead↗
NASA NTRS1989

Wave drag due to lift for transonic airplanes

Lift dominated pointed aircraft configurations are considered in the transonic range. These are treated as lifting wings of zero thickness with an aspect ratio of order one. An inner expansion which starts as Jones' theory is matched to a nonlinear outer transonic theory as in Barnwell's earlier work. Expressions for the wave drag due to the equivalent body are derived. Some examples of numerical calculations for different configurations are presented.

Cole, Julian D.↗
NASA NTRS1986

On the flight dynamics of aeroelastic vehicles

The nonlinear equations of motion for an elasic airplane are developed from first principles. Lagrange's Equation and the Principle of Virtual Work are used to generate the equations of motion and strip theory is then employed to obtain closed form integral expressions for the generalized forces. The inertial coupling is minimized by appropriate choice of the body reference axes and by making use of free vibration modes of the body. In addition, particular attention is paid to the simplifying assumptions used during the development of the equations of motion. A unique aspect of this modeling process is that since the generalized aerodynamic forces are determined from closed form, analytic expressions, this method can be used to gain insight into the effects of parameter variations not easily obtained from numerical models. A numerical example is also presented in which the modeling method is applied to a representative elastic aircraft. The model is used to address the effects of aerodynamic coupling which occurs between the rigid body degrees of freedom and the elastic degrees of freedom. Finally, model simplification is addressed and two methods are evaluated. The resulting frequency responses are compared.

Schmidt, D. K.↗
NASA NTRS1937

Stability of Castering Wheels for Aircraft Landing Gears, Special Report

In many installations of castering rubber-tired wheels there is a tendency for the wheel to oscillate violently about the spindle axis. This phenomenon, popularly called 'shimmy,' has occurred in some airplane tail wheels and has been corrected in two ways: first by the application of friction in the spindles of the tail wheels; and, second, by locking the wheels while taxiing at high speeds. Shimmy is common with the large wheels used as nose wheels in tricycle landing gears and, since it is impossible to lock the wheels, friction in the nose-wheel spindle has been the sole means of correction. Because the nose wheel is larger than the conventional tail wheel and usually carries a greater load, the larger amounts of spindle friction necessary to prevent shimmy are objectionable. the present paper presents a theoretical and experimental study of the problem of the stability of castering wheels for airplane landing gears. On the basis of simplified assumptions induced from experimental observations, a theoretical study has been made of the shimmy of castering wheels. The theory is based on the discovery of a phenomenon called 'kinematic shimmy' and is compared quantitatively with the results of model experiments. Experimental checks, using a model having low-pressure tires, are reported and the applicability of the results to full scale is discussed. Theoretical methods of estimating the spindle viscous damping and spindle solid friction necessary to avoid shimmy - lateral freedom - is introduced.

Kantrowitz, Arthur↗
NASA NTRS1922

Location of Center of Pressure of Airplane Wings

Data obtained in the Gottingen Aerodynamic Laboratory give considerable detail on the resulting air force moment exerted on various wing sections at different angles of attack. The Gottingen data can serve well to test the hydrodynamic theory, which (on the assumption of uniform motion and hence of infinitely wide wings) renders it possible to compute this moment as a function of the angle of attack. The Gottigen data can well serve to test the theory and it may be noted that experiment and computation compare favorably.

WINGS↗
NASA NTRS1984

An experimental investigation of the effect of boundary layer refraction on the noise from a high-speed propeller

Models of supersonic propellers were previously tested for acoustics in the Lewis 8- by 6-Foot Wind Tunnel using pressure transducers mounted in the tunnel ceiling. The boundary layer on the tunnel ceiling is believed to refract some of the propeller noise away from the measurement transducers. Measurements were made on a plate installed in the wind tunnel which had a thinner boundary layer than the ceiling boundary layer. The plate was installed in two locations for comparison with tunnel ceiling noise data and with fuselage data taken on the NASA Dryden Jetstar airplane. Analysis of the data indicates that the refraction increases with: increasing boundary layer thickness; increasing free stream Mach number; increasing frequency; and decreasing sound radiation angle (toward the inlet axis). At aft radiation angles greater than about 100 deg there was little or no refraction. Comparisons with the airplane data indicated that not only is the boundary layer thickness important but also the shape of the velocity profile. Comparisons with an existing two-dimensional theory, using an idealized shear layer to approximate the boundary layer, showed that the theory and data had the same trends. Analysis of the data taken in the tunnel at two different distances from the propeller indicates a decay with distance in the wind tunnel at high Mach numbers but the decay at low Mach numbers is not as clear.

Dittmar, J. H.↗
NASA NTRS1924

Nomogram for correcting drag and angle of attack of an airfoil model in an air stream of finite diameter

In experimenting with airfoil models in a wind tunnel, the magnitude of the forces acting on the model is affected by the fact that the air stream in which the model is suspended, has a restricted cross-section. In order to utilize the results for an airplane in an unlimited quantity of air, a correction must be made. The magnitude of this correction was determined by Prandtl by the application of his wing theory.

MATHEMATICS↗
NASA NTRS2002

Flight Test Techniques Used to Evaluate Performance Benefits During Formation Flight

The Autonomous Formation Flight research project has been implemented at the NASA Dryden Flight Research Center to demonstrate the benefits of formation flight and develop advanced technologies to facilitate exploiting these benefits. Two F/A-18 aircraft have been modified to precisely control and monitor relative position, and to determine performance of the trailing airplane. Flight test maneuvers and analysis techniques have been developed to determine the performance advantages, including drag and fuel flow reductions and improvements in range factor. By flying the trailing airplane through a matrix of lateral, longitudinal, and vertical offset positions, a detailed map of the performance benefits has been obtained at two flight conditions. Significant performance benefits have been obtained during this flight test phase. Drag reductions of more than 20 percent and fuel flow reductions of more than 18 percent have been measured at flight conditions of Mach 0.56 and an altitude of 25,000 ft. The results show favorable agreement with published theory and generic predictions. An F/A-18 long-range cruise mission at Mach 0.8 and an altitude of 40,000 ft has been simulated in the optimum formation position and has demonstrated a 14-percent fuel reduction when compared with a controlled chase airplane of similar configuration.

Ray, Ronald J.↗
NASA NTRS1982

NASA aerial applications wake interaction research

A computer code has been developed for predicting trajectories of particles released in the wakes of airplanes or helicopters. The code accounts for effects of turbulence, crosswind, propeller slipstream, terrain variations, and plant canopy density on particle trajectories. Comparisons are given between experiments and theory. Applications of the code for spray pattern improvement are illustrated.

Morris, D. J.↗
NASA NTRS1999

A Whitham-Theory Sonic-Boom Analysis of the TU-144 Aircraft at a Mach Number of 2.2

NASA became interested in the Tu- 144 aircraft when it was offered for use as a "flying testbed" to study operating characteristics of a supersonic-cruise commercial airplane. In addition to the other operational tests being conducted on the Tu- 144 aircraft, it was proposed that two sets of sonic-boom pressure signature measurements be made. One set of tests would consist of ground-level pressure measurements. The second set would be measurements of pressures under the Tu- 144 aircraft in cruise. Pressure gages would be required for this second set of tests: measuring ambient and differential pressures in the flow field of a Tu-144 cruising at supersonic speeds. The range of these gages had to be determined well in advance of the scheduled flights so that they could be installed and calibrated.

Robert J Mack↗
NASA NTRS1957

Ground Effects on the Longitudinal Characteristics of Two Models with Wings Having Low Aspect Ratio and Pointed Tips

Wind-tunnel tests were conducted to determine the ground effects on a tailless model with a wing of aspect ratio 2 and infinite taper, and on a tailed model with a triangular wing of aspect ratio 3, with flaps. Control-surface hinge moments were measured on the tailless model. The results are compared with the predictions of the theory of Tani, et al.

CONTROLS, FLAP-TYPE - COMPLETE WINGS↗
NASA NTRS1960

Ground Measurements of Airplane Shock-Wave Noise at Mach Numbers to 2.0 and at Altitudes to 60,000 Feet

The intensity of shock-wave noise at the ground resulting from flights at Mach numbers to 2.0 and altitudes to 60,000 feet was measured. Meagurements near the ground track for flights of a supersonic fighter and one flight of a supersonic bomber are presented. Level cruising flight at an altitude of 60,000 feet and a Mach number of 2.0 produced sonic booms which were considered to be tolerable, and it is reasonable t o expect that cruising flight at higher altitudes will produce booms of tolerable intensity for airplanes of the size and weight of the test airplanes. The measured variation of sonic-boom intensity with altitude was in good agreement with the variation calculated by an equation given in NASA Technical Note D-48. The effect of Mach number on the ground overpressure is small between Mach numbers of 1.4 and 2.0, a result in agreement with the theory. No amplification of the shock-wave overpressures due to refraction effects was apparent near the cutoff Mach number. A method for estimating the effect of fligh-path angle on cutoff Mach number is shown. Experimental results indicate agreement with the method, since a climb maneuver produced booms of a much decreased intensity as compared with the intensity of those measured in level flight at about the same altitude and Mach number. Comparison of sound pressure levels for the fighter and bomber airp lanes indicated little effect of either airplane size or weight at an altitude of 40,000 feet.

Lina, Lindsay J.↗
NASA NTRS1955

Error in Airspeed Measurement Due to the Static-Pressure Field Ahead of an Airplane at Transonic Speeds

The magnitude and variation of the static-pressure error for various distances ahead of sharp-nose bodies and open-nose air inlets and for a distance of 1 chord ahead of the wing tip of a swept wing are defined by a combination of experiment and theory. The mechanism of the error is discussed in some detail to show the contributing factors that make up the error. The information presented provides a useful means for choosing a proper location for measurement of static pressure for most purposes.

O'Bryan, Thomas C↗
NASA NTRS2000

A Method for Calculating Transient Surface Temperatures and Surface Heating Rates for High-Speed Aircraft

This report describes a method that can calculate transient aerodynamic heating and transient surface temperatures at supersonic and hypersonic speeds. This method can rapidly calculate temperature and heating rate time-histories for complete flight trajectories. Semi-empirical theories are used to calculate laminar and turbulent heat transfer coefficients and a procedure for estimating boundary-layer transition is included. Results from this method are compared with flight data from the X-15 research vehicle, YF-12 airplane, and the Space Shuttle Orbiter. These comparisons show that the calculated values are in good agreement with the measured flight data.

Quinn, Robert D.↗
NASA NTRS1957

Comparison of Experimental and Theoretical Zero-Lift Wave-Drag Results for Various Wing-Body-Tail Combinations at Mach Numbers up to 1.9

Comparisons are made of experimental and theoretical zero-lift wave drag for several nose shapes, wing-body combinations, and models of current airplanes at Mach numbers up to 1.0. The experimental data were obtained from tests in the Ames 6- by6-foot supersonic wind tunnel and at the NACA Wallops Island facility. The theoretical drag was found by use of linear theory utilizing model area distributions. The agreement between theoretical and experimental zero-lift wave-drag coefficients was generally very good, especially for a fuselage or for fuselage-wing combinations that were vertically symmetrical. For other models that had rapid changes in body shape and/or were not vertically symmetrical, the agreement of theory with experiment ranged from fair to poor, depending on the severity of the change in shape.

DRAG COEFFICIENT↗