Search NASA⌕ Search

SEARCH · Search NASA

Results for “MICROPHONE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

Hearing carrier-envelope offset frequency and phase in air with a microphone

Attosecond science and frequency metrology rely on the precise measurement and control of the laser pulse waveform, a feat traditionally achieved using optoelectronic techniques. In this study, we conducted a laser-induced acoustic experiment in air ionized by carrier-envelope phase (CEP)-stabilized sub-4 fs pulses. Our results reveal that the acoustic signal exhibits CEP dependence in few-cycle pulses, primarily through amplitude modulation from laser-driven ionization. This optoacoustic phenomenon is, to the best of our knowledge, a novel phenomenon that enables not only the measurement of the carrier-envelope offset frequency but also the direct characterization of the waveform of optical pulses through a microphone. Our study highlights the potential of laser-induced acoustic waves for advancing ultrafast science.

Han, Meng [Kansas State University, Manhattan, KS ↗
DOE OSTI2026

A reactive ferroelectric tuner for microphonics compensation

Jefferson Lab (JLab) is actively pursuing an extensive research program focused on developing advanced Nb₃Sn superconducting technology for particle accel-eration. Due to the brittle nature of Nb₃Sn coatings, a Ferroelectric Tuner (FRT) currently represents the most viable approach for microphonics compensation in these next-generation cavities. We suggest a novel, fast-responding FRT integrated directly into the main coupler, eliminating the need for an additional RF port. Leveraging a unique RF design based on a magic-T configuration, this advanced FRT will enable micro-phonics compensation in the ±30 Hz range without undesirable changes to the external quality factor.

Accelerator Physics↗
DOE OSTI2025

A reactive ferroelectric tuner for microphonics compensation

Jefferson Lab (JLab) is actively pursuing an extensive research program focused on developing advanced Nb₃Sn superconducting technology for particle accel-eration. Due to the brittle nature of Nb₃Sn coatings, a Ferroelectric Tuner (FRT) currently represents the most viable approach for microphonics compensation in these next-generation cavities. We suggest a novel, fast-responding FRT integrated directly into the main coupler, eliminating the need for an additional RF port. Leveraging a unique RF design based on a magic-T configuration, this advanced FRT will enable micro-phonics compensation in the ±30 Hz range without undesirable changes to the external quality factor.

Accelerator Physics↗
NASA NTRS1966

Phonocardiograph microphone is rugged and moistureproof

Microphone used as a phonocardiograph transducer monitors small amplitude audio signals in the presence of large shock loads and high humidity. It contains a lead zirconate-lead titanate piezoelectric plate encapsulated in a flexible polyurethane resin. The resin is contained in a sealed nylon case having a diameter of less than one inch.

Young, W. J.↗
NASA NTRS1972

Microphone density gage experiment for OGO-F

A description is given of the fabrication, installation, and operation of the microphone density gage instrument. An analysis of the resulting problems and minor failures is also given. The approach to the data analysis is discussed and the significant results obtained are presented.

Source record↗
NASA NTRS1972

Neutral density measurements near 400 kilometers by a microphone density gage on Ogo 6 during July 12-15, 1969.

Analysis of persistent density peaks (maxima) measured near 400 km during daytime (1425 LT) by a microphone density gauge on Ogo 6 during July 12 to 15, 1969. Most of the density peaks occurred between geomagnetic latitudes 50 and 61 N and L values 2.3 and 4.7. The average density change in the peaks was 27%. Most of the peaks appeared in the longitude sector from 150 to 350 E. No density peaks were measured in the 50 to 130 E sector during the 3-1/2 day observation period. A persistent pair of density peaks was present on seven successive orbits during July 13 and July 14 (both geomagnetically disturbed days) near geomagnetic latitudes 53 and 61 N, respectively.

Anderson, A. D.↗
NASA NTRS1975

Portable headset microphone checker

Simple and reliable test system gives go/no-go indication of output level of headset microphones. Portable system has its own internal battery power supply and can be used in field or in laboratory with wide variety of headset types.

Davenport, J.↗
NASA NTRS1975

Analysis of ground reflection of jet noise obtained with various microphone arrays over an asphalt surface

Ground reflection effects on the propagation of jet noise over an asphalt surface are discussed for data obtained using a 33.02-cm diameter nozzle with microphones at several heights and distances from the nozzle axis. Ground reflection effects are analyzed using the concept of a reflected signal transfer function which represents the influence of both the reflecting surface and the atmosphere on the propagation of the reflected signal in a mathematical model. The mathematical model used as a basis for the computer program was successful in significantly reducing the ground reflection effects. The range of values of the single complex number used to define the reflected signal transfer function was larger than expected when determined only by the asphalt surface. This may indicate that the atmosphere is affecting the propagation of the reflected signal more than the asphalt surface. The selective placement of the reinforcements and cancellations in the design of an experiment to minimize ground reflection effects is also discussed.

Miles, J. H.↗
NASA NTRS1975

Development, fabrication and calibration of a porous surface microphone in an aerofoil

The development of a porous surface microphone in an airfoil intended to measure acoustic signals in a turbulent airflow and to minimize the flow noise is described. The sensor because of its airfoil operates over a wide range of yaw angles and flow velocities without excessive flow noise. The acoustic properties of the porous materials used in the airfoil sensor and their effects on the frequency response of the sensor were analyzed and tested. An accurate airfoil was selected, having a smaller thickness-to-chord ratio and an airfoil sensor was designed. The sensor was calibrated acoustically and its flow noise evaluated in the quiet BBN wind tunnel at flow velocities up to 70 m/sec. Results are presented.

Noiseux, D. U.↗
NASA NTRS1975

Analysis of ground reflection of jet noise obtained with various microphone arrays over an asphalt surface

Ground reflection effects on the propagation of jet noise over an asphalt surface are discussed for data obtained using a 33.02 cm (13-in.) diameter nozzle with microphones at several heights and distances from the nozzle axis. Analysis of ground reflection effects is accomplished using the concept of a reflected signal transfer function which represents the influence of both the reflecting surface and the atmosphere on the propagation of the reflected signal in a mathematical model. The mathematical model used as a basis for the computer program was successful in significantly reducing the ground reflection effects. The range of values of the single complex number used to define the reflected signal transfer function was larger than expected when determined only by the asphalt surface. This may indicate that the atmosphere is affecting the propagation of the reflected signal more than the asphalt surface. Also discussed is the selective placement of the reinforcements and cancellations in the design of an experiment to minimize ground reflection effects.

Miles, J. H.↗
NASA NTRS1979

High-temperature microphone system

Microphone system that measures pressure fluctuations in air or other gases is not unduly effected by temperature or rate-of-change of temperature. Easily fabricated system has proved operable at temperatures up to 430 C.

Zuckerwar, A. J.↗
NASA NTRS1977

Shape optimization of pressure gradient microphones

Recently developed finite element computer programs were utilized to investigate the influence of the shape of a body on its scattering field with the aim of determining the optimal shape for a Pressure Gradient Microphone (PGM). Circular cylinders of various aspect ratios were evaluated to choose the length to diameter ratio best suited for a dual element PGM application. Alterations of the basic cylindrical shape by rounding the edges and recessing at the centerline were also studied. It was found that for a + or - 1 db deviation from a linear pressure gradient response, a circular cylinder of aspect ratio near 0.5 was most suitable, yielding a useful upper frequency corresponding to ka = 1.8. The maximum increase in this upper frequency limit obtained through a number of shape alterations was only about 20 percent. An initial experimental evaluation of a single element cylindrical PGM of aspect ratio 0.18 utilizing a piezoresistive type sensor was also performed and is compared to the analytical results.

Norum, T. D.↗
NASA NTRS1985

Microphone Detects Boiler-Tube Leaks

Unit simple, sensitive, rugged, and reliable. Diaphragmless microphone detects leaks from small boiler tubes. Porous plug retains carbon granules in tube while allowing pressure changes to penetrate to granules. Has greater life expectancy than previous controllers and used in variety of hot corrosive atmospheres.

Parthasarathy, S. P.↗
NASA NTRS1990

Microphone Detects Waves In Laminar Boundary-Layer Flow

Simple noninvasive acoustical technique effective in measurement of instability waves, which precede onset of turbulence in laminar boundary layer flows. Microphone mounted below surface detects pressure waves indicative of instabilities in laminar flow. Relatively insensitive to long-wavelength background noise. Such measurements important in research on aerodynamic flows and potential applications in control of turbulence (with consequent reduction of drag) on aircraft.

Kendall, James M.↗
NASA NTRS1994

High-Temperature Microphone With Fiber-Optic Output

Acoustic-pressure transducer (microphone) with fiber-optic output designed to withstand hot, loud, structurally vibrating environment like that of jet engine. Features flat frequency response out to frequencies well beyond several-kilohertz range needed to test for acoustic-pressure loads on engine structures.

Hellbaum, Richard F.↗
NASA NTRS1994

System Measures Thermal Noise In A Microphone

Vacuum provides acoustic isolation from environment. System for measuring thermal noise of microphone and its preamplifier eliminates some sources of error found in older systems. Includes isolation vessel and exterior suspension, acting together, enables measurement of thermal noise under realistic conditions while providing superior vibrational and accoustical isolation. System yields more accurate measurements of thermal noise.

Zuckerwar, Allan J.↗