Search NASA⌕ Search

SEARCH · Search NASA

Results for “Periodic Heating”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

Numerical simulation of boundary-layer excitation by surface heating/cooling

The concept of active control of growing disturbances in an unstable compressible flow by using time periodic, localized surface heating is studied numerically. The simulations are calculated by a fourth-order accurate solution of the compressible, laminar Navier-Stokes equations. Fourth-order accuracy is particularly important for this problem because the solution must be computed over many wavelengths. The numerical results demonstrate the growth of an initially small fluctuation into the nonlinear regime where a local breakdown into smaller scale disturbances can be observed. It is shown that periodic surface heating over a small strip can reduce the level of the fluctuation provided that the phase of the heating current is properly chosen.

Bayliss, A.↗

Measurement of heat and moisture fluxes at the top of the rain forest during ABLE

Observations are presented of turbulent heat, moisture, and momentum transport made at two levels, approximately 5 and 10 m above the Amazon rain forest canopy. Data acquired at 10 Hz included variances and some mixed third moments of vertical velocity, temperature, and humidity. Two features of the data appear to question the displacement height hypothesis: (1) The characteristic dissipation length scale in the near-canopy layer varied between 20 m in stable conditions to approximately 150 m during afternoon convective conditions, generally larger scales than would be expected; and (2) No appreciable difference in dissipation scales was seen at the two observed levels. Observed peaks in vertical velocity-temperature cospectra lead to similar length scale estimates for dominant eddies. Heat budgets on selected days show that frequent periods with negative heat flux concurrent with continuing positive moisture flux occur in early afternoon, and this is believed to indicate the patchy nature of canopy-atmosphere coupling. Vertical velocity skewness was observed to be negative on three successive days and exhibited a sharp positive gradient.

Fitzjarrald, David R.↗

Turbulent transport observed just above the Amazon forest

Observations of turbulent heat, moisture, and momentum transport made at two levels, approximately 5 and 10 m above the Amazon rain forest canopy, are presented. Data acquired at 10 Hz included variances and some mixed third moments of vertical velocity, temperature, and humidity. Two features of the data appear to question the displacement height hypothesis: (1) the characteristic dissipation length scale in the near-canopy layer varied between 20 m in stable conditions to approximately 150 m during afternoon convective conditions, generally larger scales than would be expected, and (2) no appreciable differences in dissipation scales was seen at two observed levels. Heat budgets on selected days show that frequent periods with negative heat flux concurrent with continuing positive moisture flux occur in early afternoon, and this is believed to indicate the patchy nature of canopy-atmosphere coupling. Vertical velocity skewness was observed to be negative on three successive days and exhibited a sharp positive gradient. Time series of some of the terms in the turbulence budgets of vertical velocity variance and kinematic heat flux are presented.

Fitzjarrald, David R.↗

A precise position and optical identification for 4U 2129+47 - X-ray heating and a 5.2 hour binary period

A precise (20 arcsec) position and an optical counterpart are presented for the weak X-ray source 4U 2129+47. The optical counterpart shows weak but distinct He II 4686-A and C III-N III 4640-4650-A emission. Both H-beta and Ca II H and K are sometimes visible in absorption. Numerous plates and spectrophotometric observations from the 1978 observing season show that the blue magnitude varies from 16.7 to 18.0 in a period of 5.2382 hours. The light curve is sinusoidal in appearance, but with sharply defined V-shaped minima. It is proposed that most of the optical emission from this system originates at the X-ray heated face of the normal star and hence that this system is analogous to HZ Her/Her X-1. This is one of the few intrinsically faint optical counterparts of X-ray sources that show clear evidence of binary nature. The observations suggest a distance of 1.2-1.6 kpc for the source, and a consequent X-ray luminosity of approximately 10 to the 34.8 ergs/s.

Thorstensen, J.↗

Heating of the high-latitude thermosphere during magnetically quiet periods

A persistent mid- to high-latitude heating phenomenon is observed in both hemispheres in data from the Ogo 6 quadrupole mass spectrometer. The phenomenon is evidenced by an increase in N2 density (indicative of a thermospheric temperature rise) and a depletion in helium (indicating an upwelling of air). The composition changes maximize near 0900 and 2100 UT, appear to corotate with the local magnetic pole, and are larger near equinox than near the summer solstice. The variation in latitude of the peak in the winter helium density (as a function of UT) is a specific manifestation of this general heating phenomenon.

Reber, C. A.↗

An experimental investigation to determine the effect of window cooling by mass injection for the Shuttle Infrared Leeside Temperature Sensing (SILTS) experiment

The effect of mass injection on the shuttle infrared leeside temperature sensing (SILTS) pod window surfaces in reducing window heating and minimizing window lens radiation during the reentry data taking period is investigated. Heat transfer coefficients on and around the simulated windows and window cavities are determined. Heat transfer rates and window coolant flow rates are reported for the SILTS configuration. A comparison of two windows' geometries and their effects on the heat transfer rate is discussed and oil flow photographs are presented to indicate how mass injection affects the flow field near the SILTS window.

Bradley, P. F.↗

The generation of acoustic energy from stellar convection zones

The heating of stellar chromospheres and coronae by the dissipation of acoustic waves is an important heating mechanism. It is only in the lower solar chromosphere that short period acoustic wave heating seems undisputed. The arguments leading to the rejection of the so called acoustic heating theory are derived from comparisons of calculated acoustic energy fluxes with observational or theoretical requirements.

Bohn, H. U.↗

Orbiter windward surface entry Heating: Post-orbital flight test program update

Correlations of orbiter windward surface entry heating data from the first five flights are presented with emphasis on boundary layer transition and the effects of catalytic recombination. Results show that a single roughness boundary layer transition correlation developed for spherical element trips works well for the orbiter tile system. Also, an engineering approach for predicting heating in nonequilibrium flow conditions shows good agreement with the flight test data in the time period of significant heating. The results of these correlations, when used to predict orbiter heating for a high cross mission, indicate that the thermal protection system on the windward surface will perform successfully in such a mission.

Harthun, M. H.↗

Cool-down and frozen start-up behavior of a grooved water heat pipe

A grooved water heat pipe was tested to study its characteristics during the cool-down and start-up periods. The water heat pipe was cooled down from the ambient temperature to below the freezing temperature of water. During the cool-down, isothermal conditions were maintained at the evaporator and adiabatic sections until the working fluid was frozen. When water was frozen along the entire heat pipe, the heat pipe was rendered inactive. The start-up of the heat pipe from this state was studied under several different operating conditions. The results show the existence of large temperature gradients between the evaporator and the condenser, and the moving of the melting front of the working fluid along the heat pipe. Successful start-up was achieved for some test cases using partial gravity assist. The start-up behavior depended largely on the operating conditions.

Jang, Jong Hoon↗

A method for determining structural properties of RCC thermal protection material

A method was developed for evaluation and prediction of effects of oxidation of the graphitic substrate on structural properties of Reinforced Carbon-Carbon (RCC) thermal protection material. Test specimens of RCC material were exposed to successive periods of convective heating in a plasma-jet facility to simulate the chemical reactions of Shuttle atmospheric entry. After each period of testing, the test specimen mass loss and performance in a nondestructive flexure test were determined. A computational model of the RCC specimen was developed for the NASA Structural Analysis (NASTRAN) program and validated by comparison of calculated and experimental results of flexure tests. The elastic moduli and ultimate loads in tension and compression were then computed for various levels of substrate oxidation.

Wakefield, R. M.↗

The Application of Remote Sensing using NASA Earth Observations paired with Sociodemographic Indicators to Identify Communities Most Susceptible to Urban Heat Exposure in Austin, Texas

In recent years, Austin, Texas has experienced an increase in population and urban development. Additionally, the City’s climate—already characterized by periods of extreme heat and drought—continues to change. As temperatures and demand for utilities and cooling resources rise, the number of heat-related deaths and illnesses in socially vulnerable populations (e.g., older, lower-income populations) is expected to increase. The City of Austin, The University of Texas at Austin (UT Austin), and The University of Texas Health Science Center at Houston (UT Health) partnered with NASA DEVELOP to examine the distribution of urban heat throughout the City. This project used land surface temperature, greenness, plant water content, and urban surface material analysis parameters derived from NASA Earth observations from Landsat 8 Operational Land Imager (OLI), Landsat 8 Thermal Infrared Sensor (TIRS), and Aqua and Terra Moderate Resolution Imaging Spectroradiometer (MODIS). The project team produced three different indices to create a spatial analysis for the study area including a social vulnerability index (SoVI), heat exposure index (HEI), and an overall heat priority index (HPI) score. This overall score was determined with a weighted analysis of heat-related environmental variables from NASA Earth observations and socioeconomic data from the 2019 American Community Survey. Based on the HPI score, the project team identified 121 census block groups out of 605 total that are designated as being most at risk of adverse impacts from extreme heat events. To test the sensitivity of the HPI, the team used a Monte Carlo analysis using different approaches for geographic scale, variable inclusion, census uncertainty, and index aggregation. Based on the sensitivity analysis, the resulting HPI score showed the metric was consistent with the baseline HPI. This provided increased confidence the score can be used as a tool to make informed infrastructure improvement plans in targeted areas (e.g., siting of cooling centers) and ensure equitable sustainable development.

Ryan Hammock↗

Orthostatic fluid-electrolyte and endocrine responses in fainters and nonfainters

The responses to orthostasis of fluid-electrolyte and endocrine indicators in persons subject and not subject to fainting during tilting are investigated, along with the effects of heat acclimatization and physical training on those responses. Plasma volume and electrolytes and plasma vasopressin and renin activity were determined in tilt-table tests conducted before and after an eight-day period of daily heat acclimation during exercise at 50% maximal oxygen uptake at 40 C, or a control period of exercise at 24 C. Half of the 10 subjects in the study, regardless of exercise regime, showed improved orthostatic reactions in the second tilting test, related to increases in post-tilt plasma volume and potassium concentration, particularly in the nonfainters. In the first test, plasma renin activity is observed to increase fivefold and plasma vasopressin 50 times after the transition from the supine to the orthostatic positions; the respective increases were reduced by 50 and 75% in the second test. The fainters also exhibit a greater increase in vasopressin and a lower increase in renin activity upon tilting than the nonfainters. Results indicate the orthostatic-induced vasopressin increase to be related to volume control independent of renin activity.

Shvartz, E.↗

Active thermal control systems for lunar and Martian exploration

Several ATCS options including heat pumps, radiator shading devices, and single-phase flow loops were considered. The ATCS chosen for both lunar and Martian habitats consists of a heat pump integral with a nontoxic fluid acquisition and transport loop, and vertically oriented modular reflux-boiler radiators. The heat pump operates only during the lunar day. The lunar and Martian transfer vehicles have an internal single-phase water-acquisition loop and an external two-phase ammonia rejection system with rotating inflatable radiators. The lunar and Martian excursion vehicles incorporate internal single-phase water acquisition, which is connected via heat exchangers to external body-mounted single-phase radiators. A water evaporation system is used for the transfer vehicles during periods of high heating.

Ewert, Michael K.↗

Calculation of convective and radiative heating on the forebody heatshield of the aeroassist flight experiment vehicle

The total (convective and radiative) heating is calculated over the entire forebody heatshield of the Aeroassist Flight Experiment (AFE) vehicle. The convective heating is calculated using a three-dimensional Navier-Stokes code (LAURA) which includes both chemical and thermal nonequilibrium effects. The flowfield solution is then used to provide inputs to a nonequilibrium air radiation code (NEQAIR) to calculate the nonequilibrium radiative heating. Results are presented at two points on the current Baseline 5A trajectory corresponding to the start of the primary data taking period and peak heating.

Hamilton, H. Harris, II↗

Replication of the Apparent Excess Heat Effect in a Light Water-Potassium Carbonate-Nickel Electrolytic Cell

Replication of experiments claiming to demonstrate excess heat production in light water-Ni-K2CO3 electrolytic cells was found to produce an apparent excess heat of 11 W maximum, for 60 W electrical power into the cell. Power gains range from 1.06 to 1.68. The cell was operated at four different dc current levels plus one pulsed current run at 1 Hz, 10% duty cycle. The 28 liter cell used in these verification tests was on loan from a private corporation whose own tests with similar cells are documented to produce 50 W steady excess heat for a continuous period exceeding hundreds of days. The apparent excess heat can not be readily explained either in terms of nonlinearity of the cell's thermal conductance at a low temperature differential or by thermoelectric heat pumping. However, the present data do admit efficient recombination of dissolved hydrogen-oxygen as an ordinary explanation. Calorimetry methods and heat balance calculations for the verification tests are described. Considering the large magnitude of benefit if this effect is found to be a genuine new energy source, a more thorough investigation of evolved heat in the nickel-hydrogen system in both electrolytic and gaseous loading cells remains warranted.

Niedra, Janis M.↗