Search NASA⌕ Search

SEARCH · Search NASA

Results for “Pilot workload”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
NASA NTRS2012

Comparison of Procedures for Dual and Triple Closely Spaced Parallel Runways

A human-in-the-loop high fidelity flight simulation experiment was conducted, which investigated and compared breakout procedures for Very Closely Spaced Parallel Approaches (VCSPA) with two and three runways. To understand the feasibility, usability and human factors of two and three runway VCSPA, data were collected and analyzed on the dependent variables of breakout cross track error and pilot workload. Independent variables included number of runways, cause of breakout and location of breakout. Results indicated larger cross track error and higher workload using three runways as compared to 2-runway operations. Significant interaction effects involving breakout cause and breakout location were also observed. Across all conditions, cross track error values showed high levels of breakout trajectory accuracy and pilot workload remained manageable. Results suggest possible avenues of future adaptation for adopting these procedures (e.g., pilot training), while also showing potential promise of the concept.

triple approaches↗
NASA NTRS1990

An in-flight investigation of symbology drive law improvements to an operational attack helicopter

A display drive-law design technique developed at Ames Research Center was applied to the design of the pilot-controlled symbol on a display used in an operational helicopter. A comparison of the newly designed laws and of one documented version of the operational laws was then performed using an in-flight simulation of the helicopter on the NASA/Army CH-47B. Flight-test results indicated that the Ames-developed drive laws were superior to this version of the operational drive laws in terms of task performance and pilot workload. Subsequent postflight-test information suggested that the documentation of the operational drive laws may have been incomplete or in error, even though pilot opinion had corroborated the correctness of the documented operational display in flight. Accordingly, based on additional information, another version of the operational display laws was developed and analyzed, although not flight tested. The revised operational version was compared analytically with the two versions tested in flight. This analysis corroborated that the Ames-developed laws would be superior to this revised version of the operational laws also. A conclusion is that close attention should be paid to the future specification, analysis, and documentation of displayed command-element dynamics, since they have an important effect on task performance and pilot workload.

Schroeder, Jeffery A.↗
NASA NTRS1984

On the measurement of pilot perceptual workload - A comparison of assessment techniques addressing sensitivity and intrusion issues

A flight simulator-based study was conducted to examine fourteen distinct mental workload estimation measures, including opinion, secondary task, physiological, and primary task measures. Both the relative sensitivity of the measures to changes in mental workload and the differential intrusion of the changes on primary task performance were assessed. The flight task was varied in difficulty by manipulation of the presentation rate and complexity of a hazard-perception task that required each of 48 licensed pilots to rely heavily on their perceptual abilities. Three rating scales (Modified Cooper-Harper, Multi-descriptor, and Workload-Compensation-Interference/Technical Effectiveness), two secondary task measures (time estimation and tapping regularity), one physiological measure (respiration frequency), and one primary task measure (danger-condition response time) were reliable indicants of workload changes. Recommendations for applying the workload measures are presented.

Casali, J. G.↗
NASA NTRS1983

An overview of the demonstration advanced avionics system guest pilot evaluation conducted at Ames Research Center

The guest pilot flight evaluation of the Demonstration Advanced Avionics System (DAAS) is discussed. The results are based on the fifty-nine questionnaires that were completed by the participants. The primary purpose of the pilot evaluation was to expose the Demonstration Advanced Avionics System to the various segments of the general aviation community and solicit comments in order to determine the effectiveness of integrated avionics for general aviation. Segments of the community that were represented in the evaluation are listed. A total of sixty-four (64) flights were conducted in which one hundred and seventeen (117) pilots and observers participated. It was felt that the exposure each subject had with the DAAS was too short to adequately assess the training requirements, pilot workload, and the reconfiguration concept of the DAAS. It is recommended that an operational evaluation of the DAAS be made to assess: the training requirements or varying experience levels, the pilot workload in the ATC environment with unplanned route changes, and the viability of the reconfiguration concept for failures.

Callas, G. P.↗
NASA NTRS1975

Application of active control technology to aircraft ride smoothing

Prototype Ride Smoothing System (RSSs) were synthesized for flight testing aboard the National Aeronautics and Space Administration General Purpose Airborne Simulator (GPAS). The systems were designed to meet comprehensive criteria including passenger comfort and aircraft handling qualities considerations. System performance estimates based on analytic expressions were compared to estimates derived from digital calculations. The effect of RSSs on pilot workload during ILS approach in turbulence was examined in a fixed-base simulator. A limited number of flights were conducted to verify predicted RSS performance. Results of these experiments indicate that RSSs reduce pilot workload and increase passenger comfort while maintaining handling qualities.

Jacobson, I. D.↗
NASA NTRS1977

V/STOL hover stability impact on hover control task

Longitudinal static stability requirements for V/STOL aircraft are discussed in terms of vertical landing on a small ship at night, response of the aircraft to air turbulence, and hovering flight. The increased pilot workload encountered under these flight conditions is considered. Results of a flight simulation study performed to evaluate a specific hover control task, two control systems - attitude rate command and translational velocity command, and the pilots' performance with and without turbulence are reported. It is concluded that the translational velocity command system provides the control requirements for good spot hovering capability and reduced pilot workload.

Whitaker, A. B.↗
NASA NTRS2006

Preliminary Study Using Forward Reaction Control System Jets During Space Shuttle Entry

Failure or degradation of the flight control system, or hull damage, can lead to loss of vehicle control during entry. Possible failure scenarios are debris impact and wing damage that could result in a large aerodynamic asymmetry which cannot be trimmed out without additional yaw control. Currently the space shuttle uses aerodynamic control surfaces and Reaction Control System jets to control attitude. The forward jets are used for orbital maneuvering only, while the aft jets are used for yaw control during entry. This paper develops a controller for using the forward reaction control system jets as an additional control during entry, and assesses its value and feasibility during failure situations. Forward-aft jet blending logic is created, and implemented on a simplified model of the space shuttle entry flight control system. The model is validated and verified on the nonlinear, six degree-of-freedom Shuttle Engineering Simulator. A rudimentary human factors study was undertaken using the forward cockpit simulator at Johnson Space Center, to assess flying qualities of the new system and pilot workload. Results presented in the paper show that the combination of forward and aft jets provides useful additional yaw control, in addition to potential fuel savings and the ability to balance the use of the fuel in the forward and aft tanks to meet availability constraints of both forward and aft fuel tanks. Piloted simulation studies indicated that using both sets of jets while flying a damaged space shuttle reduces pilot workload, and makes the vehicle more responsive.

Restrepo, Carolina↗
NASA NTRS1998

Short Haul Civil Tiltrotor Study in MIDAS: Auto versus Manual Nacelle Procedures for Commanded Go-Around

Tiltrotor aircraft combine the speed and range of a turboprop performance with the ability to take off and land in a vertical mode like a helicopter. These aircraft will transport passengers from city center to city center and from satellite airports to major hub airports to make connections to long range travel. The Short Haul Civil Tiltrotor (SH(CT)) being studied by NASA is a concept 40 passenger civil tiltrotor (CTR) transport. The Man-machine Integration Design and Analysis System (MIDAS) was used to evaluate human performance in terms of crew procedures and pilot workload for a simulated 40 passenger Civil Tiltrotor Transport on a steep approach to a vertiport. The scenario for the simulation was a normal approach to the vertiport that is interrupted by a commanded go-around at the landing decision point. The simulation contrasted an automated discrete nacelle mode control with a fully manual nacelle control mode for the go-around. The MIDAS simulation showed that the pilot task loading during approach and for the commanded go-around is high and that pilot workload is near capacity throughout. The go-around in manual nacelle mode was most demanding, resulting in additional time requirements to complete necessary tasks.

Atencio, Adolph, Jr.↗
NASA NTRS1977

Flight investigation of a vertical-velocity command system for VTOL aircraft

A flight investigation was undertaken to assess the potential benefits afforded by a vertical-velocity command system (VVCS) for VTOL (vertical take-off and landing) aircraft. This augmentation system was conceived primarily as a means of lowering pilot workload during decelerating approaches to a hover and/or landing under category III instrument meteorological conditions. The scope of the investigation included a determination of acceptable system parameters, a visual flight evaluation, and an instrument flight evaluation which employed a 10 deg, decelerating, simulated instrument approach task. The results indicated that the VVCS, which decouples the pitch and vertical degrees of freedom, provides more accurate glide-path tracking and a lower pilot workload than does the unaugmented system.

Kelly, J. R.↗
NASA NTRS2004

Autonomous Propulsion System Technology Being Developed to Optimize Engine Performance Throughout the Lifecycle

The goal of the Autonomous Propulsion System Technology (APST) project is to reduce pilot workload under both normal and anomalous conditions. Ongoing work under APST develops and leverages technologies that provide autonomous engine monitoring, diagnosing, and controller adaptation functions, resulting in an integrated suite of algorithms that maintain the propulsion system's performance and safety throughout its life. Engine-to-engine performance variation occurs among new engines because of manufacturing tolerances and assembly practices. As an engine wears, the performance changes as operability limits are reached. In addition to these normal phenomena, other unanticipated events such as sensor failures, bird ingestion, or component faults may occur, affecting pilot workload as well as compromising safety. APST will adapt the controller as necessary to achieve optimal performance for a normal aging engine, and the safety net of APST algorithms will examine and interpret data from a variety of onboard sources to detect, isolate, and if possible, accommodate faults. Situations that cannot be accommodated within the faulted engine itself will be referred to a higher level vehicle management system. This system will have the authority to redistribute the faulted engine's functionality among other engines, or to replan the mission based on this new engine health information. Work is currently underway in the areas of adaptive control to compensate for engine degradation due to aging, data fusion for diagnostics and prognostics of specific sensor and component faults, and foreign object ingestion detection. In addition, a framework is being defined for integrating all the components of APST into a unified system. A multivariable, adaptive, multimode control algorithm has been developed that accommodates degradation-induced thrust disturbances during throttle transients. The baseline controller of the engine model currently being investigated has multiple control modes that are selected according to some performance or operational criteria. As the engine degrades, parameters shift from their nominal values. Thus, when a new control mode is swapped in, a variable that is being brought under control might have an excessive initial error. The new adaptive algorithm adjusts the controller gains on the basis of the level of degradation to minimize the disruptive influence of the large error on other variables and to recover the desired thrust response.

Litt, Jonathan S.↗
NASA NTRS1979

LED instrument approach instruction display

A display employing light emitting diodes (LED's) was developed to demonstrate the feasibility of such displays for presenting landing and navigation information to reduce the workload of general aviation pilots during IFR flight. The display consists of a paper tape reader, digital memory, control electronics, digital latches, and LED alphanumeric displays. A presentable digital countdown clock-timer is included as part of the system to provide a convenient means of monitoring time intervals for precise flight navigation. The system is a limited capability prototype assembled to test pilot reaction to such a device under simulated IFR operation. Pilot opinion indicates that the display is helpful in reducing the IFR pilots workload when used with a runway approach plate. However, the development of a compact, low power second generation display was recommended which could present several instructions simultaneously and provide information update capability. A microprocessor-based display could fulfill these requirements.

Meredith, B. D.↗
NASA NTRS1988

Timesharing performance as an indicator of pilot mental workload

The research was performed in two simultaneous phases, each intended to identify and manipulate factors related to operator mental workload. The first phase concerned evaluation of attentional deficits (workloads) in a timesharing task. Work in the second phase involved incorporating the results from these and other experiments into an expert system designed to provide workload metric selection advice to nonexperts in the field interested in operator workload. The results of the experiments conducted are summarized.

Casper, Patricia A.↗
NASA NTRS1988

Timesharing performance as an indicator of pilot mental workload

Attentional deficits (workloads) were evaluated in a timesharing task. The results from this and other experiments were incorporated into an expert system designed to provide workload metric selection advice to non-experts in the field interested in operator workload.

Casper, Patricia A.↗
NASA NTRS2013

Experiment Description and Results for Arrival Operations Using Interval Management with Spacing to Parallel Dependent Runways (IMSPiDR)

The predicted increase in the number of commercial aircraft operations creates a need for improved operational efficiency. Two areas believed to offer increases in aircraft efficiency are optimized profile descents and dependent parallel runway operations. Using Flight deck Interval Management (FIM) software and procedures during these operations, flight crews can achieve by the runway threshold an interval assigned by air traffic control (ATC) behind the preceding aircraft that maximizes runway throughput while minimizing additional fuel consumption and pilot workload. This document describes an experiment where 24 pilots flew arrivals into the Dallas Fort-Worth terminal environment using one of three simulators at NASA?s Langley Research Center. Results indicate that pilots delivered their aircraft to the runway threshold within +/- 3.5 seconds of their assigned time interval, and reported low workload levels. In general, pilots found the FIM concept, procedures, speeds, and interface acceptable. Analysis of the time error and FIM speed changes as a function of arrival stream position suggest the spacing algorithm generates stable behavior while in the presence of continuous (wind) or impulse (offset) error. Concerns reported included multiple speed changes within a short time period, and an airspeed increase followed shortly by an airspeed decrease.

Baxley, Brian T.↗
NASA NTRS1975

Simulation and flight studies of an approach profile indicator for VTOL aircraft

Simulation and flight investigations were conducted by using a method of providing supplementary information to the pilot in conjunction with a closed-circuit-television display during a VTOL instrument final approach including deceleration and hover. The supplementary information included range, cross range, ground speed, altitude, and rate-of-climb error and was displayed on an instrument called an approach profile indicator. The display was arranged to provide both quasi-command and situation information. Pilot comments indicated that the approach-profile-indicator display concept in conjunction with the closed-circuit television resulted in a decreased pilot workload and an increase in pilot confidence. Also, the results indicated that the approach profile repeatability was significantly improved because of the ground-speed and altitude information provided on the approach profile indicator.

Moen, G. C.↗
NASA NTRS1984

Allowable response delay for large aircraft

The degree of permissible time delay in an airliner flight control system is presently sought by means of a pilot-in-the-loop moving base flight simulator, assuming the characteristics of an advanced L-1011 aircraft variant. Test pilots and engineers from the U.S. Navy, the airliner manufacturer, and NASA Langley were used in a task which encompassed approach and landing after recovery from offsets in localizer and glide slope, during calm, turbulent, and cross-wind conditions. The data obtained in the course of 279 runs included statistics on pilot workload and performance as well as pilot opinion. Preliminary results indicate that requirements for a 0.1-sec maximum delay in aircraft response are excessively conservative for large aircraft, where an offset landing maneuver is the critical design task. Lateral axis delays appear to be more critical than longitudinal ones.

Meyer, R. T.↗