Search NASA⌕ Search

SEARCH · Search NASA

Results for “Resonance structures”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Inflight dynamics testing of the Apollo spacecraft

Response of the Apollo command module, service and lunar module airframe while in a docked configuration in the flight environment was measured in a frequency band encompassing the first two bending modes. Transfer characteristics from thrust-application point to control-system sensor were examined. The frequency and the stability margins of the first two predominant structural resonances were verified by the test. This report describes the flight test that was performed and the postflight data analysis.

Peters, W. H.↗
NASA NTRS1973

Photoionization from excited states of helium

The cross sections for photoionization from the 2 1S, 2 3S, 2 1P and 2 3P excited states of helium are calculated for photoelectron energies below the n = 2 threshold of He(+) using Hylleraas bound state wave functions and 1s-2s-2p close coupling final state wave functions. The resonant structures associated with the lowest-lying 1S, 1P, 3P, and 1D autoionizing states of helium are found to be characterized by large values of the line profile parameter q. The cross sections and the photoelectron angular distribution asymmetry parameters for the P-states are calculated for various polarization states of the target atom and the incident photon. Experiments which would lead to the separate determinations of the S- and D- wave partial photoionization cross sections are discussed.

Jacobs, V. L.↗
NASA NTRS1973

Design and development of a momentum wheel with magnetic bearings

An engineering model momentum wheel with radial magnetic bearings has been designed and developed and successfully operated to a speed of approximately 500 rad/sec. This speed corresponds to a maximum angular momentum of 83 Nm-sec which is 83% of the design value. The maximum momentum achieved was limited by the suspension servo bandwidth and this, in turn, was limited by the lowest structural resonance of the rotor.

Veillette, L. J.↗
NASA NTRS1975

Functional and dynamics testing of the flexible solar array for the communications technology satellite

The test objectives, test methods, thermal environmental simulations, and test results are described, for a series of combined dynamic, thermal, and vacuum environmental tests on a Deployable Solar Array for the Communications Technology Satellite. Six major resonant structural modes were observed over an excitation range of 0.1-1.0 Hz. Corresponding modal damping factors were found to be between 0.001 and 0.01. Variation of temperature environments between -125 C and 42 C did not significantly affect the characteristics of the fundamental modes, but did influence some of the higher modes. Superharmonic response behavior was observed. The tests also verified functional mechanical performance of the solar array under thermal and vacuum conditions.

Harrison, T. D.↗
NASA NTRS1977

Effects of damping on mode shapes, volume 1

Displacement, velocity, and acceleration admittances were calculated for a realistic NASTRAN structural model of space shuttle for three conditions: liftoff, maximum dynamic pressure and end of solid rocket booster burn. The realistic model of the orbiter, external tank, and solid rocket motors included the representation of structural joint transmissibilities by finite stiffness and damping elements. Methods developed to incorporate structural joints and their damping characteristics into a finite element model of the space shuttle, to determine the point damping parameters required to produce realistic damping in the primary modes, and to calculate the effect of distributed damping on structural resonances through the calculation of admittances.

Gates, R. M.↗
NASA NTRS1976

Frequency domain approach for evaluation of stochastic control of elastic spacecraft

An attempt is made to develop a reduced-order filter for an elastic spacecraft. The frequency-domain approach is resorted to both for arriving at an appropriate ROF and for evaluating the resulting stochastic flight controller. The frequency-domain approach employed is contrasted to the time-domain approach previously utilized by the authors. A linearized deterministic dynamical model of a solar electric propulsion spacecraft is analyzed. Flexibility modes were incorporated profitably into the ROF model, and the stochastic controllers exhibit notching of structural resonances reminiscent of classical notch filters. Accurate estimates of modal parameters (damping, natural frequency) are deemed crucial, and use of worst-case values in the ROF design is recommended.

Larson, V.↗
NASA NTRS1978

A high speed pointing system

A laser ranging system for use with the Space Shuttle, and applied to a precise determination of the distance between points arrayed on different tectonic plates, i.e., along the San Andreas fault, spaced at distances of 25, 50, and 100 km, is discussed with attention to the orbiting pointing system. The mount carrying the system contains a single elliptical mirror which directs ten laser firings per second (15-18 firings to each target), and receives the light reflected from the target. The mirror and all moving structural parts are constructed of Be. The axes are equipped with 19-bit shaft angle encoders and brushless torque motors. Care is taken to avoid structural resonances, and to ensure a minimum of servo settling time. A Kalman filter is used with the microprocessor system to interpolate low data rate commands to the higher data rates required by the pointing system.

Winston, G. C.↗
NASA NTRS1979

The use of coherence functions to determine dynamic excitation sources on launch vehicle payloads

The problem of determining the relative contribution of simultaneous acoustic and mechanical inputs to the response of structures under combined dynamic loads was studied. An analytical technique developed by Bendat for calculating ordinary, partial, and multiple coherence functions, using an iterative nonmatrix approach was applied to data obtained from laboratory tests on a complex structural assembly. Testing was performed in an acoustically 'live' room. Up to three random inputs, having similar spectral content and varying degrees of mutual coherence, and a single output were used. Stationary and nonstationary inputs were used. It was concluded that the technique provided an effective method of identifying sources of dynamic excitation and evaluating their relative contributions to the measured output at structural resonances, for stationary random inputs. An attempt to apply the technique to nonstationary inputs did not yield consistent results.

Barrett, S.↗
NASA NTRS1979

Melting of Io by tidal dissipation

The resonant structure of Io leads to forced eccentricities that are considerably larger than the free values. Although still modest by all standards, these forced eccentricities coupled with the enormous tides induced by Jupiter lead to magnitudes of tidal dissipation that are large enough to completely dominate the thermal history of Io. In the present paper, the forced eccentricities are calculated and then substituted into an expression for the total tidal dissipation. The results point to the possibility that the dissipation of tidal energy in Io may have melted a major fraction of Io's mass.

Peale, S. J.↗
NASA NTRS1981

Experimental study of noise reduction for an unstiffened cylindrical model of an airplane fuselage

Noise reduction measurements were made for a simplified model of an airplane fuselage consisting of an unstiffened aluminum cylinder 0.5 m in diameter by 1.2 m long with a 1.6-mm-thick wall. Noise reduction was first measured with a reverberant field pink-noise load on the cylinder exterior. Next, noise reduction was measured by using a propeller to provide a more realistic noise load on the cylinder. Structural resonance frequencies and acoustic reverberation times for the cylinder interior volume were also measured. Comparison of data from the relatively simple test using reverberant-field noise with data from the more complex propeller-noise tests indicates some similarity in both the overall noise reduction and the spectral distribution. However, all of the test parameters investigated (propeller speed, blade pitch, and tip clearance) had some effect on the noise-reduction spectra. Thus, the amount of noise reduction achieved appears to be somewhat dependent upon the spectral and spatial characteristics of the flight conditions. Information is also presented on cyclinder resonance frequencies, damping, and characteristics of propeller-noise loads.

Willis, C. M.↗
NASA NTRS1982

The origin of the Kirkwood gaps - A mapping for asteroidal motion near the 3/1 commensurability

A mapping of the phase space onto itself with the same low-order resonance structure as the 3/1 commensurability in the planar-elliptic restricted three-body problem is obtained. This mapping is about 1,000 times faster than the usual method of numerically integrating the averaged equations of motion. It exhibits some surprising behavior that might provide a key to the origin of the Kirkwood gaps. It is noted that a test asteroid placed in the gap may evolve for a million years with low eccentricity (less than 0.05) and then suddenly jump to large eccentricity (greater than 0.3), becoming a Mars crosser. The removal of the asteroid by a close encounter with Mars would then be possible. As a first test of this hypothesis, a distribution of 300 test asteroids in the area of the 3/1 commensurability was evolved for two million years. When the Mars crossers are removed, the distribution of initial conditions reveals a gap at the location of the 3/1 Kirkwood gap.

Wisdom, J.↗