SEARCH · Search NASA

Results for “Synchronization”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

All sources NASA NTRS DOE OSTI

NASA NTRS1973

Digital data detection and synchronization

The primary accomplishments have been in the analysis and simulation of receivers and bit synchronizers. It has been discovered that tracking rate effects play, a rather fundamental role in both receiver and synchronizer performance, but that data relating to recorder time-base-error, for the proper characterization of this phenomenon, is in rather short supply. It is possible to obtain operationally useful tape recorder time-base-error data from high signal-to-noise ratio tapes using synchronizers with relatively wideband tracking loops. Low signal-to-noise ratio tapes examined in the same way would not be synchronizable. Additional areas of interest covered are receiver false lock, cycle slipping, and other unusual phenomena, which have been described to some extent in this and earlier reports and simulated during the study.

Noack, T. L.↗

NASA NTRS1973

Maximum likelihood synchronizer for binary overlapping PCM/NRZ signals.

A maximum likelihood parameter estimation technique for the self bit synchronization problem is investigated. The input sequence to the bit synchronizer is a sequence of binary overlapping PCM/NRZ signal in the presence of white Gaussian noise with zero mean and known variance. The resulting synchronizer consists of matched filters, a transition device and a weighting function. Finally, the performance is examined by Monte Carlo simulations.

Wang, C. D.↗

NASA NTRS1972

An analysis and demonstration of clock synchronization by VLBI

A prototype of a semireal-time system for synchronizing the DSN station clocks by radio interferometry was successfully demonstrated. The system utilized an approximate maximum likelihood estimation procedure for processing the data, thereby achieving essentially optimum time synchronization estimates for a given amount of data, or equivalently, minimizing the amount of data required for reliable estimation. Synchronization accuracies as good as 100 nsec rms were achieved between DSS 11 and DSS 12, both at Goldstone, California. The accuracy can be improved by increasing the system bandwidth until the fundamental limitations due to position uncertainties of baseline and source and atmospheric effects are reached. These limitations are under ten nsec for transcontinental baselines.

Hurd, W. J.↗

NASA NTRS1974

Shuttle bit rate synchronizer

A shuttle bit rate synchronizer brassboard unit was designed, fabricated, and tested, which meets or exceeds the contractual specifications. The bit rate synchronizer operates at signal-to-noise ratios (in a bit rate bandwidth) down to -5 dB while exhibiting less than 0.6 dB bit error rate degradation. The mean acquisition time was measured to be less than 2 seconds. The synchronizer is designed around a digital data transition tracking loop whose phase and data detectors are integrate-and-dump filters matched to the Manchester encoded bits specified. It meets the reliability (no adjustments or tweaking) and versatility (multiple bit rates) of the shuttle S-band communication system through an implementation which is all digital after the initial stage of analog AGC and A/D conversion.

Huey, D. C.↗

NASA NTRS1974

Review of available synchronization and time distribution techniques

The methods of synchronizing precision clocks will be reviewed placing particular attention to the simpler techniques, their accuracies, and the approximate cost of equipment. The more exotic methods of synchronization are discussed in lesser detail. The synchronization techniques that will be covered will include satellite dissemination, communication and navigation transmissions via VLF, LF, HF, UHF and microwave as well as commercial and armed forces television. Portable clock trips will also be discussed.

Hall, R. G.↗

NASA NTRS1976

Substorm observations of magnetic perturbations and ULF waves at synchronous orbit by ATS-1 and ATS-6

In the empirical study of the geomagnetic cavity, the synchronous equatorial orbit has been shown to be a most advantageous site for scientific measurements. Satellites in this orbit are fixed in the earth's main magnetic field so that the records are not dominated by changes due to satellite motion through this field. Also, the satellites traverse the same geometric region of space daily, thus facilitating statistical studies of magnetospheric phenomena. Thirdly, the magnetic field lines leaving the earth's surface near the auroral zone cross the equatorial plane close to this orbit, thus subjecting the region to a number of such phenomena. Previous observations at synchronous orbit with the UCLA fluxgate magnetometers on ATS-1 and ATS-6 have revealed a variety of substorm-associated field variations. These effects may be divided tentatively into two classes, those resulting from instabilities (ULF waves) and those produced by changes in macroscopic current systems. The data and their interpretations will be reviewed in order to illustrate the potential importance of observations in the synchronous orbit during the International Magnetospheric Study.

Coleman, P. J., Jr.↗

NASA NTRS1977

A statistical study of Pc 3 magnetic pulsations at synchronous orbit, ATS 6

Results are reported for a study designed to determine statistically the nature and variation of the polarization parameters of Pc3 magnetic pulsations at synchronous orbit. Data obtained with a triaxial flux gate magnetometer on the geosynchronous satellite ATS 6 are subjected to routine power spectral and polarization analyses, and the events examined are identified as peaks in the spectra. Coherence analysis of spectral matrices for these events indicates that Pc3 are very common at synchronous orbit and are primarily a local morning phenomenon with an occurrence peak around 1000 LT; that the pulsations occur at all frequencies in the Pc3 band, with the most common frequency at about 0.35 Hz; that the Pc3 at synchronous orbit are most often linear and generally transverse, but some have significant compressional components; and that based on azimuth angle, there are two distinct classes of Pc3 (azimuthal and radial) with different characteristics. These statistical results are compared with model predictions and ground-based observations.

Arthur, C. W.↗

NASA NTRS1977

Synchronization of the ERDA-NASA 100 kW wind turbine generator with large utility networks

The synchronizing of a wind turbine generator against an infinite bus under random conditions is studied for the first time. With a digital computer, complete solutions for rotor speed, generator power angle, electromagnetic torque, wind turbine torque, wind turbine blade pitch angle, and armature current are obtained and presented by graphs. Experiments have been recently performed on the ERDA-NASA 100 kW wind turbine. Experimental results matched computer study results very closely and confirmed that the synchronization can be accomplished by means of the existing speed control system and an automatic synchronizer.

Hwang, H. H.↗

NASA NTRS1980

Critique of a Hughes shuttle Ku-band data sampler/bit synchronizer

An alternative bit synchronizer proposed for shuttle was analyzed in a noise-free environment by considering the basic operation of the loop via timing diagrams and by linearizing the bit synchronizer as an equivalent, continuous, phased-lock loop (PLL). The loop is composed of a high-frequency phase-frequency detector which is capable of detecting both phase and frequency errors and is used to track the clock, and a bit transition detector which attempts to track the transitions of the data bits. It was determined that the basic approach was a good design which, with proper implementation of the accumulator, up/down counter and logic should provide accurate mid-bit sampling with symmetric bits. However, when bit asymmetry occurs, the bit synchronizer can lock up with a large timing error, yet be quasi-stable (timing will not change unless the clock and bit sequence drift). This will result in incorrectly detecting some bits.

Holmes, J. K.↗

NASA NTRS1981

Two-way sequential time synchronization: Preliminary results from the SIRIO-1 experiment

A two-way time synchronization experiment performed in the spring of 1979 and 1980 via the Italian SIRIO-1 experimental telecommunications satellite is described. The experiment was designed and implemented to precisely monitor the satellite motion and to evaluate the possibility of performing a high precision, two-way time synchronization using a single communication channel, time-shared between the participating sites. Results show that the precision of the time synchronization is between 1 and 5 ns, while the evaluation and correction of the satellite motion effect was performed with an accuracy of a few nanoseconds or better over a time interval from 1 up to 20 seconds.

Detoma, E.↗

NASA NTRS1982

Plasma injection events at synchronous orbit related to positive Dst

AST 6 spacecraft synchronous orbit measurements are compared with space and ground data in a study of plasma effects related to SI and SC magnetic perturbations. It is found that synchronous orbit plasma injections related to the sudden phenomena are similar to those associated with substorms, although the former occur at all local times. The synchronous orbit plasma injections are interpreted as the co-location of particle boundaries on an inward propagating front and the compression magnetic pulse associated with SI and SC events is seen as responsible for the co-location of the boundaries and their inward propagation. The positive Dst magnetic pulse plays a role similar to that of the magnetic tail reconfiguration pulse associated with substorms, and evidence is shown that positive Dst enhances magnetospheric convection independently of interplanetary magnetic field direction

Arnoldy, R. L.↗

NASA NTRS1981

Time synchronization of a frequency-hopped MFSK communication system

In a frequency-hopped (FH) multiple-frequency-shift-keyed (MFSK) communication system, frequency hopping causes the necessary frequency transitions for time synchronization estimation rather than the data sequence as in the conventional (nonfrequency-hopped) system. Making use of this observation, this paper presents a fine synchronization (i.e., time errors of less than a hop duration) technique for estimation of FH timing. The performance degradation due to imperfect FH time synchronization is found in terms of the effect on bit error probability as a function of full-band or partial-band noise jamming levels and of the number of hops used in the FH timing estimate.

Simon, M. K.↗

NASA NTRS1982

A comparison of frame synchronization methods

Different methods are considered for frame synchronization of a concatenated block code/Viterbi link. Synchronization after Viterbi decoding, synchronization before Viterbi decoding based on hard-quantized channel symbols are all compared. For each scheme, the probability under certain conditions of true detection of sync within four 10,000 bit frames is tabulated.

Swanson, L.↗

NASA NTRS1983

Symbol synchronization for the TDRSS decoder

Each 8 bits out of the Viterbi decoder correspond to one symbol of the R/S code. Synchronization must be maintained here so that each 8-bit symbol delivered to the R/S decoder corresponds to an 8-bit symbol from the R/S encoder. Lack of synchronization, would cause an error in almost every R/S symbol since even a - 1-bit sync slip shifts every bit in each 8-bit symbol by one position, therby confusing the mapping betweeen 8-bit sequences and symbols. The error correcting capability of the R/S code would be exceeded. Possible ways to correcting this condition include: (1) designing the R/S decoder to recognize the overload and shifting the output sequence of the inner decoder to establish a different sync state; (2) using the characteristics of the inner decoder to establish symbol synchronization for the outer code, with or without a deinterleaver and an interleaver; and (3) modifying the encoder to alternate periodically between two sets of generators.

Costello, D. J., Jr.↗

NASA NTRS1984

A validation methodology for fault-tolerant clock synchronization

A validation method for the synchronization subsystem of a fault-tolerant computer system is presented. The high reliability requirement of flight crucial systems precludes the use of most traditional validation methods. The method presented utilizes formal design proof to uncover design and coding errors and experimentation to validate the assumptions of the design proof. The experimental method is described and illustrated by validating an experimental implementation of the Software Implemented Fault Tolerance (SIFT) clock synchronization algorithm. The design proof of the algorithm defines the maximum skew between any two nonfaulty clocks in the system in terms of theoretical upper bounds on certain system parameters. The quantile to which each parameter must be estimated is determined by a combinatorial analysis of the system reliability. The parameters are measured by direct and indirect means, and upper bounds are estimated. A nonparametric method based on an asymptotic property of the tail of a distribution is used to estimate the upper bound of a critical system parameter. Although the proof process is very costly, it is extremely valuable when validating the crucial synchronization subsystem.

Johnson, S. C.↗

NASA NTRS1986

Frame-Synchronization-Assisting Module

Auxiliary data processor does computations related to synchronization of frames of telemetry data, relieving main processor of task. Called frame-synchronization-assisting module (FSAM), sorts through large amounts of data to determine whether valid and how configured. Module connected to main processor of computer through direct-memory-access (interface) module. Examines data in computer memory to find frame-synchronizing codes.

Desilveira, C.↗

NASA NTRS1985

Bit synchronization of differentially detected MSK and GMSK

The filter-square bit synchronizer has been previously proposed and shown to give near optimum performance for coherent PSK systems. In this paper, the same bit synchronization scheme is analyzed for a differentially detected GMSK system. It is shown that the filter-square bit synchronizer can successfully work in a differential phase detection receiver. By making linear approximations appropriate for high loop signal-to-noise ratio operation (the usual case of interest in tracking), it is demonstrated that the mean-square bit sync jitter of differentially detected GMSK system reveals striking similarities both qualitatively and quantitatively in comparison with that of a coherent PSK system.

Simon, M. K.↗

NASA NTRS1987

CMOS Clock Synchronizer

Circuit synchronizes clock and gate signals within one-quarter of clock cycle. Clock synchronizer with one-quarter-cycle skew constructed from three flip-flops, three NAND gates, and inverter. In addition gate signal to which clock synchronized, circuit requires square-wave input at twice desired clock frequency.

Kepp, R. B.↗