Search NASA⌕ Search

SEARCH · Search NASA

Results for “experimental data analysis”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Analytic and experimental evaluation of shadow shields and their support members for thermal control of space vehicles

The thermal performance of shadow shields, and their support struts, for the thermal protection of cryogenic propellants in a simulated deep-space environment was investigated analytically and experimentally. Very low overall heat-transfer rates were obtained when highly reflective aluminized Mylar shadow shields were used. The thermal interactions between the shields and support struts were investigated with fair to good agreement between the analysis and experimental data. The exterior surface of both fiberglass and titanium struts was coated to reduce the heat input into the test tank. The vacuum level inside the test facility strongly influenced the heat-transfer rates.

Boyle, R. J.↗
NASA NTRS1974

Analysis of experimental NRL radar altimeter data

An X-band radar capable of continuously variable transmitted pulse durations down to 1 nsec is being flown to investigate the interaction of radar altimeter signals with the sea surface. There is good agreement between the observed radar altimeter leading edge rise time for a 1-nsec transmitted pulse and the rise time predicted from the radar parameters and the sea state determined by a laser profilometer. Using a threshold tracker on 29-pulse averages for a transmitted pulse of 24 nsec, it was found that the range noise varied linearly with the power level of the threshold over a considerable range. The altimeter range quantization was 9.35 cm, and a minimum range noise of 3.9 cm was obtained. A comparison of pulse-to-pulse correlation observed in the radar data with that predicted by a Monte Carlo simulation is used to obtain a measure of sea surface scatterer motion.

Walsh, E. J.↗
NASA NTRS1975

Thermal desorption of metals from tungsten single crystal surfaces

After a short review of experimental methods used to determine desorption energies and frequencies the assumptions underlying the theoretical analysis of experimental data are discussed. Recent experimental results on the flash desorption of Cu, Ag, and Au from clean, well characterized W (110) and (100) surfaces are presented and analyzed in detail with respect to the coverage dependence. The results obtained clearly reveal the limitations of previous analytical methods and of the experimental technique per se (such as structure and phase changes below and in the temperature region in which desorption occurs).

Bauer, E.↗
NASA NTRS1976

New sidelobe envelopes for small aperture earth stations

The advent of domestic satellite systems and technological improvements in both space and ground equipment makes the use of small aperture earth stations economically feasible and attractive for broadcast satellite applications. With increasing use of the orbit spectrum, there is some concern that broadcast satellite systems may not be able to obtain satisfactory allocations of this orbit-spectrum resource because of interference considerations. Specifically, interference calculations based on the present envelope result in comparatively large orbit spacings for broadcast satellites. Theoretical and experimental investigations of simple sidelobe suppression techniques, plus an analysis of experimental data on small aperture antennas, indicate that much better sidelobe performance can be obtained with a very small cost or performance penalty.

Janky, J. M.↗
NASA NTRS1976

Residual stresses in polymer matrix composite laminates

Residual stresses in composites are induced during fabrication and by environmental exposure. The theory formulated can describe the shrinkage commonly observed after a thermal expansion test. Comparison between the analysis and experimental data for laminates of various material systems indicates that the residual stress-free temperature can be lower than the curing temperature, depending on the curing process. Effects of residual stresses on ply failure including the acoustic emission characteristics are discussed.

Hahn, H. T.↗
NASA NTRS1977

Model for premixed turbulent flames

Flame speed and mean degree of reaction profiles are determined for an ensemble mean one-dimensional premixed turbulent flame. Elementary closure models are employed to treat turbulence closure problems arising from the nonlinear convective and chemical reaction rate terms in the time-dependent fuel conservation equation; a constant eddy diffusivity is useed to model correlation terms derived from the convective term. An expression developed for fuel consumption is solved to obtain the turbulent flame speed and the variation of mean fuel mass fraction across the flame. Comparison of the numerical analysis with experimental data indicates the importance of the quenching of the combustion reaction in high-wavenumber eddies.

Gouldin, F. C.↗
NASA NTRS1983

Relating the radar backscattering coefficient to leaf-area index

The relationship between the radar backscattering coefficient of a vegetation canopy, sigma(0) sub can, and the canopy's leaf area index (LAI) is examined. The relationship is established through the development of a model for corn and sorghum and another for wheat. Both models are extensions of the cloud model of Attema and Ulaby (1978). Analysis of experimental data measured at 8.6, 13.0, 17.0, and 35.6 GHz indicates that most of the temporal variations of sigma(0) sub can can be accounted for through variations in green LAI alone, if the latter is greater than 0.5.

Ulaby, F. T.↗
NASA NTRS1983

Relative rate constants for the reactions of atomic oxygen with HO2 anad OH radicals

Relative rate constants for the reactions O + HO2 - OH + O2 (1) and O + OH - H + O2 (2) were obtained by using the discharge-flow resonance fluorescence technique at 2 torr total pressure and 299 K. HO2 radicals were generated by reacting atomic hydrogen with an excess of O2. Quasi-steady-state concentrations of OH and HO2 were established in the presence of excess atomic oxygen. Observed concentration ratios, namely the ratio of the OH concentration to the HO2 concentration, resulted in a value of 1.7 + or 0.2 for k1/k2. The error limits are twice the standard deviation obtained from the data analysis. Overall experimental error is estimated to be + or - 25 percent. This result confirms earlier direct measurements of k1 and k2 which required knowledge of absolute radical or atomic oxygen concentrations.

Keyser, L. F.↗
NASA NTRS1984

Relating the microwave backscattering coefficient to leaf area index

This paper examines the relationship between the microwave backscattering coefficient of a vegetation canopy, sigma (can, 0) and the canopy's leaf area index (LAI). The relationship is established through the development of one model for corn and sorghum and another for wheat. Both models are extensions of the cloud model of Attema and Ulaby (1978). Analysis of experimental data measured at 8.6, 13.0, 17.0, and 35.6 GHz indicates that most of the temporal variations of sigma (can, 0) can be accounted for through variations in green LAI alone, if the latter is greater than 0.5.

Ulaby, F. T.↗
NASA NTRS1984

Snowcover influence on backscattering from terrain

The effects of snowcover on the microwave backscattering from terrain in the 8-35 GHz region are examined through the analysis of experimental data and by application of a semiempirical model. The model accounts for surface backscattering contributions by the snow-air and snow-soil interfaces, and for volume backscattering contributions by the snow layer. Through comparisons of backscattering data for different terrain surfaces measured both with and without snowcover, the masking effects of snow are evaluated as a function of snow water equivalent and liquid water content. The results indicate that with dry snowcover it is not possible to discriminate between different types of ground surface (concrete, asphalt, grass, and bare ground) if the snow water equivalent is greater than about 20 cm (or a depth greater than 60 cm for a snow density of 0.3 g/cu cm). For the same density, however, if the snow is wet, a depth of 10 cm is sufficient to mask the underlying surface.

Ulaby, F. T.↗
NASA NTRS1984

Determination of near-surface plastic deformation in sliding contacts

It is pointed out that substantial plastic deformation occurs on and near the contact surfaces, when two solid bodies slide against each other without lubrication. It has been found that this deformation plays an important role in the tribological behavior of the sliding contact. The present investigation has the objective to develop an analytical model to predict the near-surface plastic deformation resulting from a single pass of one metallic surface over another. A finite element viscoplasticity program was written relating velocities to forces in a two-dimensional domain. The program was employed in the study of plastic deformation during a single pass of a hardened tool steel slider over a copper rub specimen. It was found that essentially the only material set in motion by the slider was directly under the contact zone. The agreement between values obtained in the analysis and experimental data is reasonably good.

Kennedy, F. E., Jr.↗
NASA NTRS1986

A numerical and experimental investigation of electrochemical aircraft deicing

This study was composed of three parts. The first part involved the extension of an existing transient two dimensional numerical code for an electrothermal deicer so that it would simulate the situation where a variable thickness ice layer existed at the outer surface. The Enthalpy Method was used to simulate the phase change, and Gauss-Seidel iteration was used to solve the resulting system of finite difference equations. A set of criteria were developed for determining when a variable thickness ice layer had an effect on deicer performance. The second part was the acquisition and analysis of experimental data. The test model was a section of a Bell UH-1H helicopter blade equipped with an electrothermal deicer. A total of fifty-two thermocouples were utilized to document the thermal response of the blade and decier assembly. In the deicing runs, the experimental temperature response data clearly showed when melting, shedding or refreezing occurred. The tests illustrated that the criterion for shedding in the three cases where it did occur was that the abrasion shield interface temperature was 32 to 34 F. The third part concerned the validation of a one dimensional transient thermal model of an electrothermal deicer by comparison of the predictions with the experimental data. The Enthalpy Method was found to effectively model the phase change which occurred, and the ice shedding algorithm employed in the simulation was also evaluated.

Leffel, K. L.↗
NASA NTRS1985

Evaluation of EHD film thickness for cryogenic fluids

Some aerospace rocket engine applications require that bearings operate at high speeds with cryogenic rocket fuel as the only liquid lubricant. Analyses and field data on these bearings indicate that life would be limited to a few minutes if they operated unlubricated. The extent to which cryogenic fluids are capable of generating elastohydrodynamic films is, therefore, an area of concern and is investigated in this paper. Results from experimental and analytical work at the authors' laboratories indicate sufficient films are not generated to lubricate the bearing reliably. This conclusion is supported by experimental data and analysis which show liquid nitrogen, the cryogenic fluid tested, to be isoviscous.

Merriman, T. L.↗
NASA NTRS1987

EXAFS: New tool for study of battery and fuel cell materials

Extended X ray absorption fine structure (EXAFS) is a powerful technique for probing the local atomic structure of battery and fuel cell materials. The major advantages of EXAFS are that both the probe and the signal are X rays and the technique is element selective and applicable to all states of matter. This permits in situ studies of electrodes and determination of the structure of single components in composite electrodes, or even complete cells. EXAFS specifically probes short range order and yields coordination numbers, bond distances, and chemical identity of nearest neighbors. Thus, it is ideal for structural studies of ions in solution and the poorly crystallized materials that are often the active materials or catalysts in batteries and fuel cells. Studies on typical battery and fuel cell components are used to describe the technique and the capability of EXAFS as a structural tool in these applications. Typical experimental and data analysis procedures are outlined. The advantages and limitations of the technique are also briefly discussed.

Mcbreen, James↗
NASA NTRS1986

An analysis of refractory silicate nucleation via the theory of the physical spinodal

An analysis of experimental data has been conducted using the theory of the spinodal, as a test of its applicability to refractory vapors. A promising aspect of this approach is its prediction of a temperature and supersaturation at which there no longer exists a barrier to nucleation; such a phenomenon has been observed in both the SiO-H2 and MgSiO-H2 systems, where a small change in ambient temperature yielded 5-10 orders of magnitude increases in the nucleation rate within a few seconds.

Nuth, Joseph A., III↗
NASA NTRS1986

Full-scale ground effects of twin impinging jets beneath a subsonic tactical V/STOL aircraft

This paper presents a summary of an analysis of flow field characteristics about a large scale twin-tilt-nacelle V/STOL aircraft in close proximity to the ground. The analysis uses experimental data in the form of measurements of pressure distributions on the ground beneath the aircraft and on the undersurface of the aircraft's fuselage. The integrals of these distributions are compared with forces measured directly, for both the total model and isolated nacelles, (i.e., net thrust). The handling qualities of the vehicle were found to be influenced by flow field characteristic features, not present in simpler models. Lift increases and significant degradation in roll control occur at low heights for fuselage strake deflections of 30 degrees or more. Reductions in control effectiveness about the other axes were also observed.

Dudley, Michael R.↗
NASA NTRS1988

Temperature, Humidity, And Polymer Aging

Report presents analysis of experimental data on electrical resistivity of polymer (polyvinyl butyral) as function of temperature and relative humidity. Resulting theoretical expression for electrical resistivity resembles generally accepted empirical law for the corrosion rate.

Cuddihy, Edward F.↗