Search NASA⌕ Search

SEARCH · Search NASA

Results for “selenium doping”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

98 records · Page 6

Defect-mediated metastability and carrier lifetimes in polycrystalline (Ag,Cu)(In,Ga)Se 2 absorber materials

Using a combination of optical and electrical measurements, we develop a model for metastable defects in Ag-alloyed Cu(In,Ga)Se 2 , one of the leading thin film photovoltaic materials. By controlling the pre-selenization conditions of the back contact prior to the growth of polycrystalline (Ag,Cu)(In,Ga)Se 2 absorbers and subsequently exposing them to various stresses (light soaking and dark-heat), we explore in this paper the nature and role of metastable defects on the electro-optical and photovoltaic performance of high-efficiency solar cell materials and devices. Positron annihilation spectroscopy indicates that dark-heat exposure results in an increase in the concentration of the selenium–copper divacancy complex (V Se –V Cu ), attributed to depassivation of donor defects. Deep-level optical spectroscopy finds a corresponding increase of a defect at Ev+0.98 eV, and deep-level transient spectroscopy suggests that this increase is accompanied by a decrease in the concentration of mid-bandgap recombination centers. Time-resolved photoluminescence excitation spectroscopy data are consistent with the presence of the V Se –V Cu divacancy complex, which may act as a shallow trap for the minority carriers. Light-soaking experiments are consistent with the V Se –V Cu optical cycle proposed by Lany and Zunger, resulting in the conversion of shallow traps into recombination states that limit the effective minority carrier recombination time (and the associated carrier diffusion length) and an increase in the doping density that limits carrier extraction in photovoltaic devices.

14 SOLAR ENERGY↗

Identification of Recombination Losses in CdSe/CdTe Solar Cells from Spectroscopic and Microscopic Time-Resolved Photoluminescence

Due to the lowest-cost and best reliability, CdTe solar cells are the leading thin-film photovoltaic technology. Increasing open-circuit voltage by reducing recombination represents the most promising path toward further improvements. Analysis is needed to identify limitations that cause efficiency losses. To achieve this goal for Cu-doped CdSe/CdTe solar cells, time-resolved spectroscopy and microscopy are developed and applied. Recombination lifetimes and radiative efficiency identify that defect-mediated recombination is the dominant voltage loss mechanism. When carrier lifetimes are averaged over many crystalline grains, they increase from 180 to 430 ns when Al2O3 is applied to the back contact. The quasi-Fermi-level splitting correspondingly increases from 880–905 to 906–931 mV, indicating a pathway to overcome the long-standing 900 mV voltage limitation. However, the dominant recombination losses are attributed to the absorber bulk. From microscopic carrier lifetime measurements, it is identified that space charge fields due to charged grain boundaries (GBs) lead to recombination in the CdTe absorber bulk. At high injection, GB space charge fields are screened, but that occurs above 1 Sun excitation conditions. Alloying with selenium in the near-interface CdSeTe absorber region reduces GB losses and is identified as one of the factors leading to high radiative and power conversion efficiency.

14 SOLAR ENERGY↗

Structural and Electronic Properties of Indium-Doped n-type Cd-Se-Te Crystals

Here, we present a comprehensive investigation into the potential of n-type indium-doped cadmium selenide telluride (CST:In) as a high-performance candidate for solar cell applications, without the need for resource-intensive post-growth treatments that are required for CdTe:In. We compared undoped CST and CST:In crystals under different growth conditions, analyzing their structural and electronic properties using x-ray diffraction (XRD), electron probe microanalysis (EPMA), current-voltage (IV) and Hall effect measurements, time-resolved photoluminescence (TRPL), optical transmission, and photoluminescence (PL) mapping. The results reveal that as-grown CST:In crystals achieve nearly 100% carrier activation, yielding an electron concentration of 9.5x1018 cm -3 , mobility of 653 cm 2 /V.s and a 5 ns lifetime which approaches the radiative limit. Furthermore, comparison of PL maps from crystal growths having different cooling profiles suggests a strong effect of cooling rate on selenium segregation and cubic/hexagonal/polytype phase distribution. Slower cooling leads to a more homogeneous cubic structure with lower Se segregation, while a faster cooling rate results in increased Se segregation, and twin boundaries and stacking faults with polytypic and hexagonal character.

14 SOLAR ENERGY↗

Characterization of Lateral Amorphous Selenium Photodetectors for Low-Photon and VUV Detection at Cryogenic Temperatures

The performance of amorphous selenium (a-Se) as a cryogenic photodetector material is evaluated through a series of experiments using laterally structured devices operated in a custom optical test stand. These studies investigate the response of a-Se detectors to low-photon fluxes at high electric fields near avalanche conditions, the linearity of the photoconductive response over a wide dynamic range and the direct detection of narrowband 130 nm vacuum ultraviolet (VUV) illumination. At 87 K, matched-filter analysis shows reliable single-shot detection with efficiencies greater than or equal to 80 percent and area under the curve (AUC) greater than or equal to 0.85 using as few as approximately 6800 incident 401 nm photons, corresponding to approximately 3400 photons within field-active regions after accounting for geometric constraints. Measurements are performed at cryogenic temperatures using calibrated photon fluxes derived from a silicon photomultiplier reference and a characterized optical filter stack. Additional experiments using a tellurium-doped a-Se (a-SeTe) device explore the material's behavior under identical test conditions and demonstrate that avalanche is achievable in a-SeTe at cryogenic temperatures. The results demonstrate reproducible low-noise operation, VUV sensitivity and field-dependent gain behavior in a lateral a-Se architecture, representing the first reported observation of avalanche multiplication in laterally structured a-Se and a-SeTe devices at cryogenic temperatures. These findings support the potential integration of laterally structured a-Se devices into next-generation pixelated liquid-argon time projection chambers (TPCs) requiring scalable, high-field-compatible photon detection systems.

FOS: Physical sciences↗

Topological insulator Bi{sub 2}Se{sub 3} thin films grown on double-layer graphene by molecular beam epitaxy

Atomically flat thin films of topological insulator Bi{sub 2}Se{sub 3} have been grown on double-layer graphene formed on 6H-SiC(0001) substrate by molecular beam epitaxy. By a combined study of reflection high energy electron diffraction and scanning tunneling microscopy, we identified the Se-rich condition and temperature criterion for layer-by-layer growth of epitaxial Bi{sub 2}Se{sub 3} films. The as-grown films without doping exhibit a low defect density of 1.0{+-}0.2x10{sup 11}/cm{sup 2}, and become a bulk insulator at a thickness of ten quintuple layers, as revealed by in situ angle resolved photoemission spectroscopy measurement.

36 MATERIALS SCIENCE↗

Thermal stability and photoconductive properties of photosensors with an alternating multilayer structure of amorphous Se and As{sub x}Se{sub 1−x}

In this study, we fabricated a-Se based photosensors with an alternating multilayer structure of a-Se and As{sub x}Se{sub 1−x} by rotational thermal evaporation deposition. During the deposition of the amorphous As{sub x}Se{sub 1−x} layers, As diffuses into the underlying a-Se component layers, thereby improving the thermal stability of the multilayer photosensor and thus increasing the breakdown electric field. Although the As doping introduces carrier traps in the a-Se layers, the multilayer photosensors demonstrate an effective quantum efficiency comparable to the single-layered a-Se sensor under the blue light illumination but are with a lower dark current density by two orders of magnitude. In addition to the top As{sub x}Se{sub 1−x} layer being functioning as an electron blocking layer, carrier traps present in the multilayer structure may decrease the drift mobility of charge carriers and disturb electric field distribution in the photosensors, thereby suppressing the dark current.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Study of Some Physical Properties of Se{sub 30}Te{sub 70-x}Sn{sub x} Glasses

In the present work the effect of Sn doping on the physical properties of, tellurium rich, Se{sub 30}Te{sub 70-x}Sn{sub x} system is studied theoretically. The average coordination number, constraints, lone pair electrons and heat of atomization for Se{sub 30}Te{sub 70-x}Sn{sub x} system are calculated for x = 0,1.5,2.5,5.5 using the well defined relations. The present study shows that the values of lone pair electrons and average single bond energy goes on decreasing with increasing Sn content whereas the average coordination number, constraints and heat of atomization increases with increase in the Sn content.

36 MATERIALS SCIENCE↗

Experimental indication for band gap widening of chalcopyrite solar cell absorbers after potassium fluoride treatment

The implementation of potassium fluoride treatments as a doping and surface modification procedure in chalcopyrite absorber preparation has recently gained much interest since it led to new record efficiencies for this kind of solar cells. In the present work, Cu(In,Ga)Se{sub 2} absorbers have been evaporated on alkali containing Mo/soda-lime glass substrates. We report on compositional and electronic changes of the Cu(In,Ga)Se{sub 2} absorber surface as a result of a post deposition treatment with KF (KF PDT). In particular, by comparing standard X-ray photoelectron spectroscopy and synchrotron-based hard X-ray photoelectron spectroscopy (HAXPES), we are able to confirm a strong Cu depletion in the absorbers after the KF PDT which is limited to the very near surface region. As a result of the Cu depletion, we find a change of the valence band structure and a shift of the valence band onset by approximately 0.4 eV to lower binding energies which is tentatively explained by a band gap widening as expected for Cu deficient compounds. The KF PDT increased the open circuit voltage by 60–70 mV compared to the untreated absorbers, while the fill factor deteriorated.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗