Search NASA⌕ Search

SEARCH · Search NASA

Results for “shock wave experiments”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

Understanding the evolution of liquid and solid microjets from grooved Sn and Cu samples using radiography

Experiments were performed on grooved Sn and Cu samples to study the temporal evolution of microjets. Jets were generated by the impact of gun-launched flyer plates against the back of grooved targets made from either Cu or Sn (groove depth of ~250 μm). The Hugoniot states in the various Sn targets encompassed conditions where solid phases are maintained throughout (7 and 16 GPa) and also conditions where melting occurs upon the release of compression (25 and 34 GPa); the transition occurs near a Hugoniot pressure of 23 GPa. Cu targets at 27 and 56 GPa provide comparisons in which the jets move at similar speeds but remain solid. In all cases, the spatial distribution of mass within the microjets was measured using high-speed synchrotron radiography. The result is a time history of the jet thickness profile from which quantities like total jet mass and jet velocity can be derived. In both the solid and liquid states, we generally observe that an increase in the shock strength leads to an increase in jet mass. However, this trend breaks down for Hugoniot states near the transition from continuously solid to melted-on-release. This is evidenced by the observation that there was no difference in the rate of mass flow in Sn jets at 16 and 25 GPa, while similar pressure jumps on either side of this range caused substantial changes in the jet mass. This contrasts with the behavior of smaller polishing defects that were present on the same samples (~1 μm deep). From these, no ejecta mass was detected below the melt boundary, but obvious microjets were generated once melting occurred. This indicates that crossing the bulk melt-on-release threshold can alternately promote or inhibit the flow of mass into microjets based on the amplitude of the initial perturbation.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

X-ray diffraction from shock driven Sn microjets

Here, in situ x-ray diffraction was performed on shock-generated microjets composed of Sn and Sn–4Ag. Under low pressure drives (~21 GPa), a significant fraction of the jet volume was found to be in the β-Sn phase, and these crystallites were much smaller than the initial grain size of the material. Significant quantities of amorphous (molten) material were observed for higher drive pressures (~25–35 GPa). The extent of melting at these pressures was greater than would be predicted for uniaxial shock loading. Diffraction patterns from the Sn–4Ag alloy showed a peak that is consistent with the expected Ag 3 Sn intermetallic phase. This peak remained evident under drive conditions where the sample was otherwise fully amorphous. This indicates a slushy or a mixed phase of liquid Sn and solid Ag 3 Sn. Given the eutectic character of this alloy, this observation is attributed to a kinetic limitation on the dissolution of Ag 3 Sn. This implies that a much broader range of drive conditions will lead to mixed phase jets and ejecta than would be predicted from the equilibrium melt boundary of such alloys.

36 MATERIALS SCIENCE↗

Producing Refractory Microballoons

Metals, ceramics, and glasses just some of possible raw materials. Key components of equipment for new microballoon fabrication process nozzle, crucible assembly, and drop tube. Recessed, conical inner orifice aids in producing uniform, symmetrical microballoons. All-graphite crucible assembly resistant to misalinement and cracks. Drop tube ensures timely solidification of microballoons used in fluidized-bed heat exchangers; as containers for hazardous materials; catalysts in chemical and pharmaceutical processes; solid fuel for rockets; fuel containers for fusion power experiments; shock-wave dampers; and starting materials for high-strength, low-density sintered alloys and ceramics.

Lee, M. C.↗

High-pressure phase transition and equation of state of CsI

Stuructural properties of CsI at high pressure have been investigated by the use of synchrotron X-ray-diffraction techniques with the diamond-anvil cell at 300 K. The results indicate that the material undergoes a continuous distortion from B2 to an hcp-like phase, which is stable to at least 302 GPa. The intermediate orthorhombic phase is geometrically different from previous assignments and about 10 percent denser. With the new structure, the p-V results of static pressure experiments, shock-wave studies, and theoretical calculations are now in good agreement.

Mao, H. K.↗

Thermal expansivity, bulk modulus, and melting curve of H2O-ice VII to 20 GPa

Equation of state properties of ice VII and fluid H2O at high pressures and temperatures have been studied experimentally from 6 to 20 GPa and 300-700 K. The techniques involve direct measurements of the unit-cell volume of the solid using synchrotron X-ray diffraction with an externally heated diamond-anvil cell. The pressure dependencies of the volume and bulk modulus of ice VII at room temperature are in good agreement with previous synchrotron X-ray studies. The thermal expansivity was determined as a function of pressure and the results fit to a newly proposed phenomenological relation and to a Mie-Gruneisen equation of state formalism. The onset of melting of ice VII was determined directly by X-ray diffraction at a series of pressures and found to be in accord with previous volumetric determinations. Thermodynamic calculations based on the new data are performed to evaluate the range of validity of previously proposed equations of state for fluid water derived from static and shock-wave compression experiments and from simulations.

Fei, Yingwei↗

Hypersonic shock-wave turbulent-boundary-layer interaction flows - Experiment and computation

Solutions of the Reynolds-averaged Navier-Stokes equations are presented and compared with experimental surface data for a series of hypersonic shock-wave/turbulent-boundary-layer interaction flows. The turbulence models used include the standard k-epsilon two-equation eddy viscosity model, a two-layer modification to this model, and a third model with several modifications to account for compressibility effects. Both modified models gave significant improvements for all the test flows.

Horstman, C. C.↗

Simultaneous Raman and pyrometric temperature measurements in shock-wave-compressed toluene

We fielded experiments to compare temperatures measured simultaneously by pyrometry and Raman spectroscopy in toluene shocked to 9 GPa. A 0.5 mm thick toluene sample was compressed between sapphire windows by plate impact from a gas gun. As the shock wave reverberated between the windows, the pressure increased stepwise to about 9 GPa. While the sample was near its peak pressure, we measured the Raman spectrum and determined temperature from the ratio of the Stokes and anti-Stokes intensities. Simultaneously, we measured the sample thermal radiance from the C-H vibration bands that occur between 3.2 and 3.6 μm to determine temperature pyrometrically. The pyrometer used a biased indium antimonide detector paired with a custom transimpedance amplifier, a system capable of temperature measurements as low as about 400 K. The Raman measurements gave a temperature of 530 ± 25 K in the bulk volume of toluene. Pyrometry gave a temperature of 496 + 15/-20 K, which is in reasonable agreement with the Raman measurement. Comparisons of this type are necessary to validate pyrometry as a temperature diagnostic in dynamic experiments.

36 MATERIALS SCIENCE↗

Stratospheric-related research using the shock tube

The capabilities of shock tubes used in stratospheric-related research are considered, and the results of three independent shock tube research projects are reported. The studies are concerned with the evaluation of stratospheric ozone depletion. In the first experiment, photoabsorption cross sections of Freon 11 and 12 at stratospheric temperatures were measured using rarefaction waves. In the second experiment, reaction-rate coefficients were determined from measurements made behind reflected shock waves. In the third experiment, electronic-transition moments of the O2 Schumann-Runge system and the A2Pi-X2Pi system of ClO were deduced from intensity measurements made behind the incident shock.

Cooper, D. M.↗

Current shunting and formation of stationary shock waves during electric explosions of metal wires in air

Results of experiments on the generation of shock waves during electric explosions of fine copper and tungsten wires in air are analyzed. The generation mechanism of stationary shock wave by a plasma piston formed during the shunting breakdown of the electrode gap in the course of a wire explosion is investigated. The role of structural elements of such discharges, such as the core, corona, and wire environment, is analyzed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Reynolds Number Effects on the Richtmyer-Meshkov Instability

This presentation compares the results of two very different experimental studies of Richtmyer-Meshkov instability: shock tube experiments in which an air/SF6 interface is accelerated by a weak shock wave; and incompressible experiments in which a box containing two different density miscible liquids is impulsively accelerated by bouncing it off of a fixed coil spring. Both experiments are initiated with sinusoidal initial perturbations. The interface perturbation initially remains sinusoidal as it grows in amplitude, but eventually the interfacial vorticity concentrates into points, forming a row of line vortices of alternating sign. The Reynolds number based on vortex circulation ranges from 1,000 to 45,000 in these experiments. It is found that viscous effects have a large, quantifiable effect on the evolution of the individual vortices. The effects of viscosity on the overall perturbation amplitude, however, are small and will be compared to theory.

Niederhaus, Charles↗

High Resolution Experiments of Compressible Turbulence Interacting With Shock Waves

Most of the second year of our research program focused on exploring the potentially favorable the effects of expansion waves on homogeneous and isotropic turbulence, which is formed downstream of a grid. Expansion waves are associated with compressible flows and may reduce the drag over airfoils by suppressing turbulence. In the very few previous investigations of interactions of turbulence with expansion waves the effects due to stabilizing streamline curvature substantially masked the effects of turbulence suppression due to flow expansion though the waves. In the present flow configuration planar expansion waves interact with grid generated turbulence in our high-resolution shock tube research facility. This approach will assess directly the effects of the interaction on turbulence. The first objective of our study was to identify the nature of expansion waves present in our shock tube facility. Our time-dependent numerical simulations of the flow in our facility indicated the existence of two regions of traveling expansion waves. The system of expansion waves utilized in this investigation is generated by the exiting shock wave and the induced flow behind it at the end of the driver. Several new measuring techniques are being developed which are capable of providing velocity-gradient-related quantities in compressible flows for the first time.

Agui, Juan↗

Modeling Hydrodynamic Instabilities, Shocks, and Radiation Waves in High Energy Density Experiments [Dissertation]

This thesis presents the computational design, modeling, and analysis of three experiments in high-energy density physics (HEDP), all of them concerning fundamental radiation flows. The first experiment is a laboratory astrophysics experiment to investigate the role of the Kelvin-Helmholtz instability (KHI) in the process of galactic filaments supplying gas to galactic halos. The achieved goal was to provide a first study in which the role of the instability is maximal and predict behavior in future iterations of an experiment accessing a more radiative regime where the role of the instability is stifled. This experiment would help answer how certain galaxies are able to grow so rapidly and produce many stars as the KHI limits this process. The second experiment, COAX, is a radiation flow experiment with a novel spectroscopy diagnostic configuration, designed to spatially measure the temperature of a radiation wave as it travels down a doped foam. A key result of this work was the development of a synthetic spectroscopy application and application of modern spectroscopy comparison techniques to provide our first temperature reconstructions from the experimental data. This experimental platform serves as the launching ground for a number of new experiments that vary the basic premise and thus is foundational to our ongoing research. The final experiment is a full integration of modeling, design, and theoretical development for the Radishock experiment. This experimental platform studies the head-on collision of a radiation wave with a counter-propagating shock, and like COAX, uses spectroscopy to diagnose and detect the interaction. My research analyzes the successful shots, indicating aspects of successful detections and suggests improvements to future iterations of the design.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Generation of laser plasma bunches with a high efficiency of energy concentration for laboratory simulation of collisionless shock waves in magnetised cosmic plasma

We present the results of first experiments on the formation of collisionless shock waves (CSWs) in background plasma by injecting laser plasma bunches transverse to the magnetic field (as a piston) with a maximum energy up to 100 J per unit of solid angle and with a high enough degree of ion magnetisation. With this aim in view, on a unique KI-1 facility at the Institute of Laser Physics, Siberian Branch of the Russian Academy of Sciences (ILP), a plastic (polyethylene) target irradiated by a CO{sub 2} laser in the most energy-efficient regime (near the plasma formation threshold) and a highly ionised hydrogen plasma with a high concentration in a large volume (not less than 1 m{sup 3}) have been employed. As a result of model experiments performed on the basis of a model of collisionless interaction of plasma flows, developed at the VNIIEF and being adequate to the problem under consideration, not only an intensive, background-induced, deceleration of a super-Alfven laser plasma flow, but also the formation in that flow of a strong perturbation having the properties of a subcritical CSW and propagating transverse to the magnetic field, have been first registered in the laboratory conditions. (extreme laser radiation: physics and fundamental applications)

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗