Search NASA⌕ Search

SEARCH · Search NASA

Results for “simulator motion”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 109 records · Page 6

Compensation based on linearized analysis for a six degree of freedom motion simulator

The inertial response characteristics of a synergistic, six-degree-of-freedom motion base are presented in terms of amplitude ratio and phase lag as functions of frequency data for the frequency range of interest (0 to 2 Hz) in real time, digital, flight simulators. The notch filters which smooth the digital-drive signals to continuous drive signals are presented, and appropriate compensation, based on the inertial response data, is suggested. The existence of an inverse transformation that converts actuator extensions into inertial positions makes it possible to gather the response data in the inertial axis system.

Parrish, R. V.↗

Man-systems evaluation of moving base vehicle simulation motion cues

A motion cue investigation program is reported that deals with human factor aspects of high fidelity vehicle simulation. General data on non-visual motion thresholds and specific threshold values are established for use as washout parameters in vehicle simulation. A general purpose similator is used to test the contradictory cue hypothesis that acceleration sensitivity is reduced during a vehicle control task involving visual feedback. The simulator provides varying acceleration levels. The method of forced choice is based on the theory of signal detect ability.

Kirkpatrick, M.↗

A visual motion simulator for general aviation compensated within the nonlinear adaptive washout for actuator lag

A description is presented of the general aviation aircraft simulator recently acquired by the Langley Research Center, summarizing the complement of instruments, radio/navigation equipment, control loading, and other features. Emphasis is placed mainly on the two-degree-of-freedom motion drives developed for this simulator and the presentation of the dynamic response of the motion system (without washout) in terms of amplitude ratio and phase lag as a function of frequency. The nonlinear adaptive washout based on continuous steepest descent optimization presents cues in pitch rate, surge, roll rate, and sway, and allows for actuator lag compensation.

Ashworth, B. R.↗

Collaborative study on Earthquake Ground Motion Simulation Using Rupture Dynamics

The objective of this multi-year project between the LLNL and Kyoto University, is the investigation of effects of rupture dynamics on near-fault ground motion amplitude for strike slip earthquakes through rupture dynamics simulations. The work presented in this report was in part performed by Jikai Sun, a graduate student from Kyoto university, during his visit to the LLNL as a summer student. He was trained by Dr. Pitarka in using computer programs for generating rupture models and performing rupture dynamics simulations.

58 GEOSCIENCES↗

A study of moving base simulation motion cues utilizing washout technique

The present study was conducted to derive data on non-visual motion thresholds utilizing washout technique, and to develop specific threshold values for use as washout parameters. It describes the results of acceleration detection studies carried out using the NASA MSFC General Purpose Simulator which provides six degree-of-freedom cab motion. A series of experiments was performed to test the hypothesis that constant velocity visual cues might suppress non-visual deceleration sensitivity. The psychophysical method employed was the forced-choice procedure which theoretically yields a pure sensitivity measure. The MSFC General Purpose Simulator was programmed to provide velocity ramps in three axes - pitch, fore-aft translation, and vertical translation. Data were collected with and without a constant velocity visual input. Comparison of the current results with classical data suggested significantly greater sensitivity of the human observer to fore-aft accelerations than has generally been reported, sensitivity tending to depend on motion direction and sign of velocity change.

Kirkpatrick, M., III↗

A dynamic motion simulator for future European docking systems

Europe's first confrontation with docking in space will require extensive testing to verify design and performance and to qualify hardware. For this purpose, a Docking Dynamics Test Facility (DDTF) was developed. It allows reproduction on the ground of the same impact loads and relative motion dynamics which would occur in space during docking. It uses a 9 degree of freedom, servo-motion system, controlled by a real time computer, which simulates the docking spacecraft in a zero-g environment. The test technique involves and active loop based on six axis force and torque detection, a mathematical simulation of individual spacecraft dynamics, and a 9 degree of freedom servomotion of which 3 DOFs allow extension of the kinematic range to 5 m. The configuration was checked out by closed loop tests involving spacecraft control models and real sensor hardware. The test facility at present has an extensive configuration that allows evaluation of both proximity control and docking systems. It provides a versatile tool to verify system design, hardware items and performance capabilities in the ongoing HERMES and COLUMBUS programs. The test system is described and its capabilities are summarized.

Brondino, G.↗

TH-EF-BRA-11: Feasibility of Super-Resolution Time-Resolved 4DMRI for Multi-Breath Volumetric Motion Simulation in Radiotherapy Planning

Purpose: To develop a novel super-resolution time-resolved 4DMRI technique to evaluate multi-breath, irregular and complex organ motion without respiratory surrogate for radiotherapy planning. Methods: The super-resolution time-resolved (TR) 4DMRI approach combines a series of low-resolution 3D cine MRI images acquired during free breathing (FB) with a high-resolution breath-hold (BH) 3DMRI via deformable image registration (DIR). Five volunteers participated in the study under an IRB-approved protocol. The 3D cine images with voxel size of 5×5×5 mm{sup 3} at two volumes per second (2Hz) were acquired coronally using a T1 fast field echo sequence, half-scan (0.8) acceleration, and SENSE (3) parallel imaging. Phase-encoding was set in the lateral direction to minimize motion artifacts. The BH image with voxel size of 2×2×2 mm{sup 3} was acquired using the same sequence within 10 seconds. A demons-based DIR program was employed to produce super-resolution 2Hz 4DMRI. Registration quality was visually assessed using difference images between TR 4DMRI and 3D cine and quantitatively assessed using average voxel correlation. The fidelity of the 3D cine images was assessed using a gel phantom and a 1D motion platform by comparing mobile and static images. Results: Owing to voxel intensity similarity using the same MRI scanning sequence, accurate DIR between FB and BH images is achieved. The voxel correlations between 3D cine and TR 4DMRI are greater than 0.92 in all cases and the difference images illustrate minimal residual error with little systematic patterns. The 3D cine images of the mobile gel phantom preserve object geometry with minimal scanning artifacts. Conclusion: The super-resolution time-resolved 4DMRI technique has been achieved via DIR, providing a potential solution for multi-breath motion assessment. Accurate DIR mapping has been achieved to map high-resolution BH images to low-resolution FB images, producing 2Hz volumetric high-resolution 4DMRI. Further validation and improvement are still required prior to clinical applications. This study is in part supported by the NIH (U54CA137788/U54CA132378).

60 APPLIED LIFE SCIENCES↗

Earthquake Ground Motion Simulation Using Irikura Recipe

The primary objective of our study is to investigate the transportability of the IM2011 rupture generation process to broadband simulation methods used by the SCEC BBP. Here we test it using the Graves and Pitarka hybrid simulation method. At longer periods (> 1 s), the simulation approach of Graves and Pitarka is very similar to IM2011; that is, the full kinematic rupture description is convolved with full waveform Green’s functions to obtain the ground motion response. However, at shorter periods, the Graves and Pitarka approach uses a semi-stochastic procedure to generate the response, in contrast to the empirical Green’s function approach used in IM2011. Therefore, part of our analysis includes formulating the IM2011 rupture such that it can be inserted into the Graves and Pitarka method at shorter periods. This process is relatively straightforward, but does require some care to insure that all parameters, and in particular the rupture speed, are properly represented.

58 GEOSCIENCES↗

Destabilizing effects of visual environment motions simulating eye movements or head movements

In the present paper, we explore effects on the human of exposure to a visual virtual environment which has been enslaved to simulate the human user's head movements or eye movements. Specifically, we have studied the capacity of our experimental subjects to maintain stable spatial orientation in the context of moving their entire visible surroundings by using the parameters of the subjects' natural movements. Our index of the subjects' spatial orientation was the extent of involuntary sways of the body while attempting to stand still, as measured by translations and rotations of the head. We also observed, informally, their symptoms of motion sickness.

White, Keith D.↗

Collaborative study on "Earthquake Ground Motion Simulation Using Rupture Dynamics"

California (LLNL) and Disaster Prevention Research Institute, Kyoto University, Japan (DPRI) on rupture dynamics for crustal earthquakes, we carried out analyses of effects of several dynamic rupture parameters, such as stress drop, slip weakening distance and stress excess on fault rupture slip, slip velocity, and rupture velocity. In addition, we examined potential relationships between the assumed initial stress conditions, including asperities location, and rupture initiation and the final slip and slip velocity obtained from the spontaneous rupture modeling.

58 GEOSCIENCES↗

Motion simulator study of longitudinal stability requirements for large delta wing transport airplanes during approach and landing with stability augmentation systems failed

A ground-based simulator investigation was conducted in preparation for and correlation with an-flight simulator program. The objective of these studies was to define minimum acceptable levels of static longitudinal stability for landing approach following stability augmentation systems failures. The airworthiness authorities are presently attempting to establish the requirements for civil transports with only the backup flight control system operating. Using a baseline configuration representative of a large delta wing transport, 20 different configurations, many representing negative static margins, were assessed by three research test pilots in 33 hours of piloted operation. Verification of the baseline model to be used in the TIFS experiment was provided by computed and piloted comparisons with a well-validated reference airplane simulation. Pilot comments and ratings are included, as well as preliminary tracking performance and workload data.

Snyder, C. T.↗

Human dynamic orientation model applied to motion simulation

The Ormsby model of dynamic orientation, in the form of a discrete time computer program was used to predict non-visually induced sensations during an idealized coordinated aircraft turn. To predict simulation fidelity, the Ormsby model was used to assign penalties for incorrect attitude and angular rate perceptions. It was determined that a three rotational degree of freedom simulation should remain faithful to attitude perception even at the expense of incorrect angular rate sensations. Implementing this strategy, a simulation profile for the idealized turn was designed for a Link GAT-1 trainer. A simple optokinetic display was added to improve the fidelity of roll rate sensations.

Borah, J. D.↗

A method motion simulator design based on modeling characteristics of the human operator

A design criteria is obtained to compare two simulators and evaluate their equivalence or credibility. In the subsequent analysis the comparison of two simulators can be considered as the same problem as the comparison of a real world situation and a simulation's representation of this real world situation. The design criteria developed involves modeling of the human operator and defining simple parameters to describe his behavior in the simulator and in the real world situation. In the process of obtaining human operator parameters to define characteristics to evaluate simulators, measures are also obtained on these human operator characteristics which can be used to describe the human as an information processor and controller. First, a study is conducted on the simulator design problem in such a manner that this modeling approach can be used to develop a criteria for the comparison of two simulators.

Repperger, D. W.↗