Search NASA⌕ Search

SEARCH · Search NASA

Results for “Intermittent”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,081 records · Page 60
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Improvement of the mechanical and thermal properties of the metallized polycarbonate capacitor

Changes were studied which enable polycarbonate metallized film capacitors to withstand 500 thermal shock cycles while maintaining electrical characteristic integrity without becoming intermittent, and without losing hermeticity. The task was for metallized polycarbonate film capacitors designed to meet MIL-C-39022/9 and MIL-C-83421/1. The capacitor design improvements implemented were the insertion of a rubber washer between spray cap and end seal and the utilization of a flexible lead assembly. One hundred fifty capacitors incorporating the design improvements were manufactured and subsequently underwent 500 thermal shock cycles. One hundred forty nine capacitors survived the test. Failure analysis revealed that the lone failure was due to a poor solder joint, initially detected in pre-screening tests as having poor dissipation factor and equivalent series resistance measurement readings.

Kellerman, H. J.↗
NASA NTRS1978

First measurements of mesospheric vertical velocities by VHF radar at temperate latitudes

A program of ground-based VHF measurements of turbulence and of wave and tidal motions in the mesosphere has been initiated by the University of Illinois using a high-power radar facility located at Urbana, Illinois. Observations show scattering occurring intermittently during the daytime throughout the mesosphere. Vertical velocities exhibit the presence of gravity waves with dominant periods near 10 min and amplitudes ranging from less than 1 m/s to approximately 5 m/s.

Miller, K. L.↗
NASA NTRS1978

Radio tracking of a fin whale /Balaenoptera physalus/

Tracking of a fin whale tagged with an implantable beacon transmitter (IBT) is described. The IBT, which was fired from a modified 12-gauge shotgun, weighs 517 g and is 70 cm long, including a 46-cm antenna. Data on whale movement and breathing are presented. Contact was lost after 27.8 hours of intermittent tracking, presumably as a result of battery leakage. Potential range and duration of IBT transmission are considered, and the significance of transmitter location and orientation in the whale blubber is considered.

Ray, G. C.↗
NASA NTRS1978

Flow and temperature fields following injection of a jet normal to a cross stream

The interaction of a jet entering into a freestream normal to the main flow direction has been studied with particular attention directed to visualization of the large-scale flow interactions and to measurement of the film-cooling performance. Large eddies are apparent downstream of the entering jet even at moderate blowing rate (defined as the ratio of the mass velocity of the jet to the mass velocity of the freestream). At higher blowing rate, there is only intermittent contact between the mass from the jet and the downstream wall. The film cooling downstream from a single normal jet yields a lower centerline effectiveness compared to an inclined jet through a greater lateral spreading. The greater spreading provides a more uniform effectiveness across the span of the downstream wall, in particular at large blowing rate.

Goldstein, R. J.↗
NASA NTRS1979

A structural model of the adaptive human pilot

A compensatory tracking model of the human pilot is offered which attempts to provide a more realistic representation of the human's signal processing structure than that which is exhibited by pilot models currently in use. Two features of the model distinguish it from other representations of the human pilot. First, proprioceptive information from the control stick or manipulator constitutes one of the major feedback paths in the model, providing feedback of vehicle output rate due to control activity. Implicit in this feedback loop is a model of the vehicle dynamics which is valid in and beyond the region of crossover. Second, error-rate information is continuously derived and independently but intermittently controlled. An output injected remnant model is offered and qualitatively justified on the basis of providing a measure of the effect of inaccuracies such as time variations in the pilot's internal model of the controlled element dynamics. The data from experimental tracking tasks involving five different controlled element dynamics and one nonideal viewing condition were matched with model generated describing functions and remnant power spectral densities.

Hess, R. A.↗
NASA NTRS1979

Evidence for earth magnetospheric tail associated phenomena at 3100 R sub E

Examination of Pioneer 7 NASA Ames Research Center plasma analyzer data obtained in February 1977 at about 3100 earth radii, downstream from earth in the vicinity of the expected extended geomagnetic tail indicate that tail-related phenomena may have been observed. These observations are characterized by intermittent intervals of extremely low levels of plasma ion flux. Corresponding Prognoz 5 Space Research Institute plasma ion data obtained in the vicinity of earth indicate typical solar-wind flux levels and a relatively steady character of the solar wind during this time. These recent Pioneer 7 observations in the vicinity of the expected geomagnetic tail at about 3100 earth radii are consistent with earlier Pioneer 7 observations in September 1966 at about 1000 earth radii and Pioneer 8 observations in January 1968 at about 500 earth radii and represent the most extended positive observational information of the extended nature of the geomagnetic tail. These measurements suggest that at times Jupiter's magnetosphere may have tail-associated phenomena extending to distances of about 10 AU downstream from the planet. These measurements also raise the possibility that at times comets may have tail-associated phenomena extending downstream from the visible tail.

Intriligator, D. S.↗
NASA NTRS1979

Turbine sizing of a solar thermal power plant

Since the insolation is intermittent, thermal energy storage is necessary to extend the time of power generation with solar heat past sunset. There are two approaches to specifying the size of turbine-generator units depending on the system operation. In the first approach, the turbine operates at its full capacity when operating on direct solar heat, and at reduced capacity when operating on collected heat out of energy storage. In the second approach, the turbine will always operate at a uniform level either on derated energy from the receiver or from energy storage. Both of these approaches have certain advantages and disadvantages. In this paper, a simple analysis is outlined and exercised to compare the performance and economics of these two approaches.

Manvi, R.↗
NASA NTRS1979

A global geochemical model for the evolution of the mantle

It is proposed that the upper mantle transition region, 220 to 670 km, is composed of eclogite which has been derived from primitive mantle by about 20 percent partial melting and that this is the source and sink of oceanic crust. The remainder of the upper mantle is garnet peridotite which is the source of continental basalts and hotspot magmas. This region is enriched in incompatible elements by hydrous and CO2 rich metasomatic fluids which have depleted the underlying layers in the L.I.L. elements and L.R.E.E. The volatiles make this a low-velocity, high attenuation, low viscosity region. The eclogite layer is internally heated and its controls the convection pattern in the upper mantle. Plate tectonics is intermittent. The continental thermal anomaly at a depth of 150-220 km triggers kimberlite and carbonatite activity, alkali and flood basalt volcanism, vertical tectonics and continental breakup. Hot spots remain active after the continents leave and build the oceanic islands. Mantle plumes rise from a depth of about 220 km. Midocean ridge basalts rise from the depleted layer below this depth. Material from this layer can also be displaced upwards by subducted oceanic lithosphere to form back-arc basins.

Anderson, D. L.↗
NASA NTRS1980

Stress wave attenuation in thin structures by ultrasonic through-transmission

The steady state amplitude of the output of an ultrasonic through transmission measurement is analyzed and the result is given in closed form. Provided that the product of the input and output transduction ratios; the specimen-transducer reflection coefficient; the specimen-transducer phase shift parameter; and the material phase velocity are known, this analysis gives a means for determining the through-thickness attenuation of an individual thin sample. Multiple stress wave reflections are taken into account and so signal echoes do not represent a difficulty. An example is presented for a graphite fiber epoxy composite (Hercules AS/3501-6). A direct method for continuous or intermittent monitoring of through thickness attenuation of plate structures which may be subject to service structural degradation is provided.

Lee, S. S.↗
NASA NTRS1980

Manufacture of fiber-epoxy test specimens: Including associated jigs and instrumentation

Experimental work on the manufacture and strength of graphite-epoxy composites is considered. The correct data and thus a true assessment of the strength properties based on a proper and scientifically modeled test specimen with engineered design, construction, and manufacture has led to claims of a very broad spread in optimized values. Such behavior is in the main due to inadequate control during manufacture of test specimen, improper curing, and uneven scatter in the fiber orientation. The graphite fibers are strong but brittle. Even with various epoxy matrices and volume fraction, the fracture toughness is still relatively low. Graphite-epoxy prepreg tape was investigated as a sandwich construction with intermittent interlaminar bonding between the laminates in order to produce high strength, high fracture toughness composites. The quality and control of manufacture of the multilaminate test specimen blanks was emphasized. The dimensions, orientation and cure must be meticulous in order to produce the desired mix.

Mathur, S. B.↗
NASA NTRS1980

Head-up transition behavior of pilots during simulated low-visibility approaches

Each of 13 commercial pilots from four airlines flew a total of 108 manual flight director approaches in a moving base simulation of a medium-sized turbojet (95,000 lb gross weight) which had a day and night Redifon external scene. Three levels of runway visual range (RVR) (1,600; 2,400; and greater than 8,000 ft), three wind-shear profiles, nine ceiling heights, and continuous and intermittent visibility after initial breakout were tested. The results indicated that: (1) mean decision time ranged from 2 to 4.6 sec for ceilings under 380 ft across the three RVR conditions; (2) mean vertical distance traveled during the visual-cue assessment period was a relatively constant proportion below the existing ceiling; (3) a significant three way interaction in mean decision time between wind shear, day-night, and ceiling RVR variables occurred; (4) mean number of head-up transitions to VFR conditions after breakout ranged from 4.6 to 13.4 and increased as a function of ceiling and severity of wind shear; the typical duration of fixation out the window was 1.5 sec; and (5) subjective pilot ratings of controllability and precision of control as well as amount of skill, attention, or effort required to make the landing were influenced significantly by the wind shear, night conditions, and low breakout ceiling conditions.

Haines, R. F.↗
NASA NTRS1980

RAMP: A fault tolerant distributed microcomputer structure for aircraft navigation and control

RAMP consists of distributed sets of parallel computers partioned on the basis of software and packaging constraints. To minimize hardware and software complexity, the processors operate asynchronously. It was shown that through the design of asymptotically stable control laws, data errors due to the asynchronism were minimized. It was further shown that by designing control laws with this property and making minor hardware modifications to the RAMP modules, the system became inherently tolerant to intermittent faults. A laboratory version of RAMP was constructed and is described in the paper along with the experimental results.

Dunn, W. R.↗
NASA NTRS1979

SERT II 1979 extended flight thruster system performance

The SERT II spacecraft, launched in 1970, has been maintained in an operational, but intermittently active status since 1971. Periodic thruster status has been reported while waiting for normal orbit precession to return the spacecraft to continuous sunlight in 1979. Now, the thruster has been operated for 600 hours in the first quarter of 1979. Thruster startup and operation in 1979 is unchanged after 9 years in space. The ion thruster was gimbaled and used to maintain spin stabilization of the spacecraft. Minor components of the spacecraft have failed, but have not interfered with the functional status of the spacecraft.

Kerslake, W. R.↗
NASA NTRS1981

The effects of trace impurities in coal-derived liquid fuels on deposition and accelerated high temperature corrosion of cast superalloys

The effects of trace metal impurities in coal-derived liquids on deposition, high temperature corrosion and fouling were examined. Alloys were burner rig tested from 800 to 1100 C and corrosion was evaluated as a function of potential impurities. Actual and doped fuel test were used to define an empirical life prediction equation. An evaluation of inhibitors to reduce or eliminate accelerated corrosion was made. Barium and strontium were found to limit attack. Intermittent application of the inhibitors or silicon additions were found to be effective techniques for controlling deposition without losing the inhibitor benefits. A computer program was used to predict the dew points and compositions of deposits. These predictions were confirmed in deposition test. The potential for such deposits to plug cooling holes of turbine airfoils was evaluated. Tests indicated that, while a potential problem exists, it strongly depended on minor impurity variations.

Lowell, C. E.↗
NASA NTRS1980

Structure of the low latitude boundary layer

Observations at high temporal resolution of the frontside magnetopause and plasma boundary layer, made with the LASL/MPE fast plasma analyzer onboard the ISEE 1 and 2 spacecraft, revealed a complex quasiperiodic structure of some of the observed boundary layers. A cool tailward streaming boundary layer plasma was seen intermittently, with intervening periods of hot tenuous plasma which has properties similar to the magnetospheric population. While individual encounters with the boundary layer plasma last only a few minutes, the total observation time may extend over one hour or more.

Sckopke, N.↗
NASA NTRS1981

Li/SO2 cell performance

The development of a Li/SO2 cell exhibiting intermittent storage capability at 98 C and instantaneous voltage response is discussed. Results of short circuit, cell puncture, and forced discharge testing are presented along with elevated temperature storage and temperature cycling responses.

Cloyd, J. S.↗
NASA NTRS1981

High temperature cyclic oxidation furnace testing at NASA Lewis Research Center

A standardized method of testing the cyclic oxidation resistance of various alloys in static air to 1200 C was developed and is routinely used at NASA Lewis Research Center. Test samples are automatically raised and lowered into a resistance wound furnace for a series of fixed interval heating and cooling cycles. Spall catchers collect the accumulated spall from each sample. The samples are weighed intermittently to generate specific weight change/time data. At various test times the samples and the accumulated spall are analyzed by X-ray diffraction. A computer program uses this gravimetric and X-ray data as input to print out the oxidation curves and specific weight change/time and X-ray results in a published format, organizes, and indexes the data. So far, several hundred Fe, Ni, and Co base alloys were tested using this same basic procedure and results form the basis of a series of cyclic oxidation handbooks to be published by NASA. Such specific weight change/time data were used to estimate the oxidative metal consumption by several computer modeling techniques to rank alloys and for use in life testing estimates.

Barrett, C. A.↗
NASA NTRS1981

The influence of a local wall deformation on the development of natural instabilities in a laminar boundary layer

The natural instabilities which propagate in the laminar boundary layer of a flat plate composed of intermittent wave trains are described. A spectral analysis determines the frequency range and gives a frequency and the harmonic 2 only if there is a wall deformation. This analysis provides the amplitude modulation spectrum of the instabilities. Plots of the evolution of power spectral density are compared with the numerical results obtained from the resolve of the Orr-Sommerfeld equation, while the harmonic is related to a micro-recirculating flow near the wall deformation.

Burnel, S.↗