Search NASA⌕ Search

SEARCH · Search NASA

Results for “Function Estimation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,117 records · Page 62

Atmospheric temperature profiles derived through the inversion of a system of first order differential equations

Generation of vertical temperatures profiles from remotely sensed atmospheric radiance data is described as an analogous communications system. The radiative transport characteristics of the atmosphere encodes the continuous temperature profile into an 'n' element vector where 'n' is the number of channels in the satellite instrument. The temperature profile is a message transmitted from station A to station B and the link is the satellite instrument. At station B the decoder reproduces a continuous function which is the best estimate of the message encoded at station A. It is shown that the decoder must operate in a tuned mode where the parameters used in the encoder precisely determine the decoder parameters, and that the characteristics of the total message block must be given by a set of decoder constraints

Gatlin, J. A.↗

Control-surface hinge-moment calculations for a high-aspect-ratio supercritical wing

The hinge moments, at selected flight conditions, resulting from deflecting two trailing edge control surfaces (one inboard and one midspan) on a high aspect ratio, swept, fuel conservative wing with a supercritical airfoil are estimated. Hinge moment results obtained from procedures which employ a recently developed transonic analysis are given. In this procedure a three dimensional inviscid transonic aerodynamics computer program is combined with a two dimensional turbulent boundary layer program in order to obtain an interacted solution. These results indicate that trends of the estimated hinge moment as a function of deflection angle are similar to those from experimental hinge moment measurements made on wind tunnel models with swept supercritical wings tested at similar values of free stream Mach number and angle of attack.

Perry, B., III↗

Manual control of yaw motion with combined visual and vestibular cues

Measurements are made of manual control performance in the closed-loop task of nulling perceived self-rotation velocity about an earth-vertical axis. Self-velocity estimation was modelled as a function of the simultaneous presentation of vestibular and peripheral visual field motion cues. Based on measured low-frequency operator behavior in three visual field environments, a parallel channel linear model is proposed which has separate visual and vestibular pathways summing in a complementary manner. A correction to the frequency responses is provided by a separate measurement of manual control performance in an analogous visual pursuit nulling task. The resulting dual-input describing function for motion perception dependence on combined cue presentation supports the complementary model, in which vestibular cues dominate sensation at frequencies above 0.05 Hz. The describing function model is extended by the proposal of a non-linear cue conflict model, in which cue weighting depends on the level of agreement between visual and vestibular cues.

Zacharias, G. L.↗

Space Shuttle utilization of TDRSS services

This paper provides a general description of how the tracking and data relay satellite system (TDRSS) will be utilized by the Space Shuttle. The design approaches which were necessitated for both the Shuttle S-band and Ku-band subsystems are functionally described, and current performance estimates are summarized for each communications link. The operational advantages and disadvantages of TDRSS to Shuttle are briefly considered, and both the technical and operational problem areas which have been identified to date are described.

Batson, B. H.↗

Subophitic basalts from Mare Crisium - Cooling rates

Subophitic basalt is the most common rock type at Mare Crisium. The cooling rate of a sample of this rock was determined by: (1) an olivine cooling speedometer and (2) Zr partitioning between ilmenite and ulvospinel. The kinetic modeling of the olivine cooling speedometer starts with a calculation of the compositional profile of olivine (the 'as-solidified profile') and proceeds to re-equilibration by diffusion as a function of cooling rate. The estimated cooling rate for subophitic basalts from the Luna 24 site is in the range of 2 C/day (about 0.1 C/hr), which is reasonably well corroborated by dynamic crystallization studies of Grove (1978).

Taylor, L. A.↗

Study of wrap-rib antenna design

The results of a parametric design study conducted to develop the significant characteristics and technology limitations of space deployable antenna systems with aperture sizes ranging from 50 up to 300 m and F/D ratios between 0.5 and 3.0 are presented. Wrap/rib type reflectors of both the prime and offset fed geometry and associated feed support structures were considered. The significant constraints investigated as limitations on achievable aperture were inherent manufacturability, orbit dynamic and thermal stability, antenna weight, and antenna stowed volume. A data base, resulting in the defined maximum achievable aperture size as a function of diameter, frequency and estimated cost, was formed.

Wade, W. D.↗

Turbine blade structural dynamic analysis

The paper presents structural dynamic analysis and test results for the Space Shuttle Main Engine turbine blades. Athough these blades are designed to avoid coincidence of natural frequencies with harmonic excitation forces, the complexity of the turbine hardware, its nonlinearities and lack of information regarding the forcing function have led to fatigue failures. A comparison of single-blade analysis and test modal frequencies, shapes, and stresses is given; analysis techniques to describe the forcing function, compute dynamic responses, and incorporate the nonlinearities of Coulomb-friction dampers are presented. Recommendations are made for new research to improve forcing function computations and structural damping estimates used in the analysis.

Dickerson, E. O.↗

Electromagnetic deep-probing (100-1000 kms) of the Earth's interior from artificial satellites: Constraints on the regional emplacement of crustal resources

Efforts continue in the development of a computer program for looking at the coupling of finite dimensioned source fields with a laterally heterogeneous Earth. An algorithm for calculating a time-varying reference field using ground-based magnetic observatory data is also under development as part of the production of noise-free estimates of global electromagnetic response functions using Magsat data.

Hermance, J. F.↗

Satellite services system analysis study. Volume 2, part 2: Study results

The development of an effective satellite services system was investigated. Satek Satellite user market, design reference missions, satellite service functions, service equipment, and cost estimates are discussed. Extensive program plans for a satellite service system implementation are included.

Source record↗

Influence of combined visual and vestibular cues on human perception and control of horizontal rotation

Measurements are made of manual control performance in the closed-loop task of nulling perceived self-rotation velocity about an earth-vertical axis. Self-velocity estimation is modeled as a function of the simultaneous presentation of vestibular and peripheral visual field motion cues. Based on measured low-frequency operator behavior in three visual field environments, a parallel channel linear model is proposed which has separate visual and vestibular pathways summing in a complementary manner. A dual-input describing function analysis supports the complementary model; vestibular cues dominate sensation at higher frequencies. The describing function model is extended by the proposal of a nonlinear cue conflict model, in which cue weighting depends on the level of agreement between visual and vestibular cues.

Zacharias, G. L.↗

GPS aiding of ocean current determination

The navigational accuracy of an oceangoing vessel using conventional GPS p-code data is examined. The GPS signal is transmitted over two carrier frequencies in the L-band at 1575.42 and 1227.6 MHz. Achievable navigational uncertainties of differenced positional estimates are presented as a function of the parameters of the problem, with particular attention given to the effect of sea-state, user equivalent range error, uncompensated antenna motion, varying delay intervals, and reduced data rate examined in the unaided mode. The unmodeled errors resulting from satellite ephemeris uncertainties are shown to be negligible for the GPS-NDS (Navigation Development) satellites. Requirements are met in relatively calm seas, but accuracy degradation by a factor of at least 2 must be anticipated in heavier sea states. The aided mode of operation is examined, and it is shown that requirements can be met by using an inertial measurement unit (IMU) to aid the GPS receiver operation. Since the use of an IMU would mean higher costs, direct Doppler from the GPS satellites is presented as a viable alternative.

Mohan, S. N.↗

Microwave scatterometer measurements of oceanic wind vector

Results from Seasat-A scatterometer (SASS) remote sensing of oceanic wind vectors are reviewed, together with the theory of radar backscattering. The SASS was designed to measure the surface wind stress and neutral stability wind vector at 19.5 m altitude. Requirements included windspeeds from 4-24 m/sec to within 2 m/sec or 10%, a 1000 km swath, directions from 0-360 deg to within 20 deg, a 50 km resolution cell, and cross-track and along-track spacing between resolution cells of 100 km. The method was based on Bragg scattering of microwaves from cm-length capillary ocean waves. The strength of the backscatter is proportional to the capillary wave amplitude, which is in equilibrium with the ocean surface wind speed. The measurement grouping, least-squares estimator, and dB deviation model function table for the SASS geophysical algorithm are discussed. Comparisons of SASS, GOASEX, and ground truth wind data are made, and a 0.92 correlation between SASS and ground truth data is determined from regression analysis.

Jones, W. L.↗

Multivariate Density Estimation and Remote Sensing

Current efforts to develop methods and computer algorithms to effectively represent multivariate data commonly encountered in remote sensing applications are described. While this may involve scatter diagrams, multivariate representations of nonparametric probability density estimates are emphasized. The density function provides a useful graphical tool for looking at data and a useful theoretical tool for classification. This approach is called a thunderstorm data analysis.

Scott, D. W.↗

Three-dimensional analysis of magnetometer array data

A technique is developed for mapping magnetic variation fields in three dimensions using data from an array of magnetometers, based on the theory of optimal linear estimation. The technique is applied to data from the Scandinavian Magnetometer Array. Estimates of the spatial power spectra for the internal and external magnetic variations are derived, which in turn provide estimates of the spatial autocorrelation functions of the three magnetic variation components. Statistical errors involved in mapping the external and internal fields are quantified and displayed over the mapping region. Examples of field mapping and of separation into external and internal components are presented. A comparison between the three-dimensional field separation and a two-dimensional separation from a single chain of stations shows that significant differences can arise in the inferred internal component.

Richmond, A. D.↗

Creep-rupture behavior of six candidate Stirling engine superalloys tested in air

The creep-rupture behavior of six candidate Stirling engine iron-base superalloys was determined in air. The alloys included four wrought alloys (A-286, Alloy 800H, N-155, and 19-9DL) and two cast alloys (CRM-6D and XF-818). The specimens were tested to rupture for times up to 3000 h at 650 to 925 C. Rupture life, t(r) minimum creep rate, and time to 1-percent creep strain t(0.01) were statistically analyzed as a function of stress and temperature. Estimated stress levels at different temperatures to obtain 3500 h t(r) and t(0.01) lives were determined. These data will be compared with similar data being obtained under 15 MPa hydrogen.

Bhattacharyya, S.↗

Compensator development and examination of performance and robustness

This research focuses on the development of compensators to control the mean square surface error of a wraprib antenna. The methodology is as follows: A model of appropriate size and structure is developed by looking at the convergence of functional gains for control and estimation. Then an LQG compensator is designed using this model. Finally, the compensator is simplified using balanced realization theory. In the conventional approach for compensator design, there is no mechanism for ensuring that the model is adequate for designing a compensator which will achieve the desired level of performance. It is shown here that both the model order and compensator order are directly related to the closed loop performance requirements for the system.

Source record↗

Deriving Two-Dimensional Ocean Wave Spectra and Surface Height Maps from the Shuttle Imaging Radar (SIR-B)

Directional ocean wave spectra were derived from Shuttle Imaging Radar (SIR-B) imagery in regions where nearly simultaneous aircraft-based measurements of the wave spectra were also available as part of the NASA Shuttle Mission 41G experiments. The SIR-B response to a coherently speckled scene is used to estimate the stationary system transfer function in the 15 even terms of an eighth-order two-dimensional polynomial. Surface elevation contours are assigned to SIR-B ocean scenes Fourier filtered using a empirical model of the modulation transfer function calibrated with independent measurements of wave height. The empirical measurements of the wave height distribution are illustrated for a variety of sea states.

Tilley, D. G.↗

Satellite sensing of aerosol absorption

A method is developed for remote sensing of aerosol absorption from satellite images of the earth's surface. The method is based on the measurement of the change in the upward radiances between a clear and a hazy day over a varying surface reflectance. For a zero change balance between brightening due to scattering and darkening due to absorption and scattering is reached. This balance is utilized via a radiative transfer model to derive the aerosol single-scattering albedo. A sensitivity study is performed, and the method is tested against laboratory measurements. It is suggested that for the case of haze introduced on top of an existing background aerosol and with a fair estimate of the scattering phase function, the error in the remotely sensed single-scattering albedo is in the range of 0.03-0.05. The main errors in the method arise from variations in the surface reflectance between the clear and the hazy days, uncertainty in the scattering phase function, and variation of the aerosol and gaseous absorption between these two days. If the satellite calibration varies with time, the measurements of single-scattering albedo can be substantially affected.

Kaufman, Yoram J.↗