Search NASA⌕ Search

SEARCH · Search NASA

Results for “wind data”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,171 records · Page 65

Comparison of Wind-Tunnel Predictions with Flight Measurements of the Longitudinal-Stability and -Control Characteristics of a Douglas BTD-1 Airplane

Low Mach number longitudinal-stability and control characteristics as predicted by use of wind tunnel data from a powered 3/16-scale model are compared with flight test measurements of a Navy BTD-1 airplane. The accuracy of the wind tunnel data and the discrepancies involved in attempting to correlate with flight data are discussed and analyzed. The comparison showed that wind tunnel predictions were, in general, in good agreement with flight test data. The predicted values were for the most part sufficiently accurate to show the satisfactory and unsatisfactory characteristics in the preliminary design stage and to indicate possible methods of improvement. The discrepancies which did occur were attributed principally to physical dissimilarities between model and airplane and the instability to determine accurately the flight power conditions. The effect of Mach number was considered negligible since the maximum flight test value was about 0.5. In order to simulate more closely the flight conditions and hence obtain more accurate data for predictions, it appears desirable to perform large-scale tests of unorthodox control surfaces such as the sealed vaned elevators with which the airplane was equipped.

Bunnell, Mort V.↗

Meteor Wind Results at Durham (43 Deg N, 71 Deg W) During the ATMAP November 1981 and May 1982 Campaigns

Winds modeled from data measured with the University of New Hampshire Meteor Wind Radar System at Durham, New Hampshire, over the two 4-day periods November 20 to 23, 1981 and May 8 to 11, 1982 are presented. The raw meteor wind data was fit in a least square sense to a three dimensional model containing mean, 12-, 24-, and 48-h periods. The means winds for both periods are very close to the three year average values at Durham during May and November, respectively. The semidiurnal component for the November period had a normal amplitude and phase, and an estimated veritcal wavelength of 60 km. The May period results were essentially typical except that the Northward amplitude was 3 to 4 times smaller than normal. The diurnal amplitudes measured for both periods are typical for Durham and the diurnal phase is normally not very consistent. The 48-hour component amplitude is typical for these months. The intrinsic errors fo the radar are approximately + or - 2 km in position and + or - 4 m/s in radial velocity including quantization errors. These errors are random with zero mean and should not bias the wind results.

Clark, R. R.↗

Data acquisition for measuring the wind on Venus from Pioneer Venus

The data acquisition and processing technqiues used in the Pioneer Venus differential long baseline interferometry experiment are discribed. The experiment was designed to measure the motion in three dimensions of the Pioneer probes during their fall to the surface of Venus, using a combination of Doppler and long baseline ratio interferometric methods. The design of the experiment and the equipment and software techniques that were developed specially for this experiment are also described.

Smith, J. R.↗

Comparison of Wind-Tunnel and Flight Unsteady Pressure Environments for the Ares I-X Flight Test Vehicle

Wind-tunnel testing of highly-instrumented rigid models is the current standard for the estimation of unsteady environments acting on a launch vehicle during ascent. However, uncertainties are present in how well these constant condition wind-tunnel data model the unsteady environments for a full-scale launch vehicle during accelerating flight. The Ares I-X wind-tunnel and flight tests provided rich data sets for comparative analysis that have been used to develop answers to the question of tunnel-to-flight validity and uncertainty. In this paper, additional comparisons are presented for the unsteady pressure data acquired during wind-tunnel and flight testing to describe current methods that are used to evaluate preflight predictions. Utilizing these methods to generate ensembles of flight-comparable realizations from wind-tunnel data is shown to yield fluctuating magnitudes and spectra that compare well with flight data for the Ares I-X flight test vehicle throughout the transonic flight regime.

buffet↗

Comparison of Wind-Tunnel and Flight Unsteady Pressure Environments for the Ares I-X Flight Test Vehicle

Wind-tunnel testing of highly-instrumented rigid models is the current standard for the estimation of unsteady environments acting on a launch vehicle during ascent. However, uncertainties are present in how well these constant condition wind-tunnel data model the unsteady environments for a full-scale launch vehicle during accelerating flight. The Ares I-X wind-tunnel and flight tests provided rich data sets for comparative analysis that have been used to develop answers to the question of tunnel-to-flight validity and uncertainty. In this paper, additional comparisons are presented for the unsteady pressure data acquired during wind-tunnel and flight testing to describe current methods that are used to evaluate preflight predictions. Utilizing these methods to generate ensembles of flight-comparable realizations from wind-tunnel data is shown to yield fluctuating magnitudes and spectra that compare well with flight data for the Ares I-X flight test vehicle throughout the transonic flight regime.

buffet↗

Investigation of the turbulent wind field below 500 feet altitude at the Eastern Test Range, Florida

A detailed analysis of wind profiles and turbulence at the 150 m Cape Kennedy Meteorological Tower is presented. Various methods are explored for the estimation of wind profiles, wind variances, high-frequency spectra, and coherences between various levels, given roughness length and either low-level wind and temperature data, or geostrophic wind and insolation. The relationship between planetary Richardson number, insolation, and geostrophic wind is explored empirically. Techniques were devised which resulted in surface stresses reasonably well correlated with the surface stresses obtained from low-level data. Finally, practical methods are suggested for the estimation of wind profiles and wind statistics.

Blackadar, A. K.↗

Within-Tunnel Variations in Pressure Data for Three Transonic Wind Tunnels

This paper compares the results of pressure measurements made on the same test article with the same test matrix in three transonic wind tunnels. A comparison is presented of the unexplained variance associated with polar replicates acquired in each tunnel. The impact of a significance component of systematic (not random) unexplained variance is reviewed, and the results of analyses of variance are presented to assess the degree of significant systematic error in these representative wind tunnel tests. Total uncertainty estimates are reported for 140 samples of pressure data, quantifying the effects of within-polar random errors and between-polar systematic bias errors.

DeLoach, Richard↗

Comparison of polar cap potential drops estimated from solar wind and ground magnetometer data - CDAW 6

It is pointed out that the maximum electrostatic potential difference across the polar cap, Phi, is a fundamental measure of the coupling between the solar wind and the earth's magnetosphere/ionosphere sytem. During the Coordinated Data Analysis Workshop (CDAW) 6 intervals, no suitably instrumented spacecraft was in an appropriate orbit to determine the polar-cap potential drop directly. However, two recently developed independent techniques make it possible to estimate the polar-cap potential drop for times when direct spacecraft data are not available. The present investigation is concerned with a comparison of cross-polar-cap potential drop estimates calculated for the two CDAW 6 intervals on the basis of these two techniques. In the case of one interval, the agreement between the potential drops and Joule heating rates is relatively good. In the second interval, however, the agreement is not very good. Explanations for this discrepancy are discussed.

Reiff, P. H.↗

Integration time required to extract accurate static and dynamic data from transonic wind-tunnel tests

Because the forces and pressures on wind-tunnel models tested at transonic speeds are not steady, even for 'static' aerodynamic tests, integration time is required to obtain data of acceptable accuracy. The integration time required for both static and dynamic tests is evaluated analytically and confirmed by experimental measurements. It is shown that, for static and dynamic tests, the accuracy obtained is a function of integration time, frequency content of the signal, and the ratio of the dynamic amplitude to the full signal of interest. In addition, for the dynamic case, the frequency band width used in analysis is important. Results of this study indicate that, for typical data accuracy desired from models in a large transonic wind tunnel (11- by 11-ft), up to the following integration times are required: static force and moment tests, 0.5 sec; static pressure tests, 0.1 sec; flutter tests, 30 to 60 sec; and random-dynamic tests, 10 sec.

Muhlstein, L., Jr.↗

Integration Time Required to Extract Accurate Data from Transonic Wind-Tunnel Tests

Because the forces and pressures on wind-tunnel models tested at transonic speeds are not steady, even for static aerodynamic tests, integration time is required to obtain data of acceptable accuracy. The integration time required for both static and dynamic tests is evaluated analytically and confirmed by experimental measurements. It is shown that, for static and dynamic tests, the accuracy obtained is a function of integration time, frequency of the signal, and the ratio of the dynamic amplitude to the full signal of interest. In addition, for the dynamic case, the frequency bandwidth used in analysis is important. Results of this study indicate that, for typical data accuracy desired from models in a large transonic wind tunnel (11- by 11-ft), up to the following integration times are required: static force and moment tests, 0.5 s; static pressure tests, 1 s; flutter tests, 30 to 60 s; and random-dynamic tests, 10 s.

Muhlstein, Lado, Jr.↗

Performance and load data from Mod-0A and Mod-1 wind turbine generators

Experimental data, together with supporting analysis, are presented on the power conversion performance and blade loading of large, horizontal-axis wind turbines tested at electric utility sites in the U.S. Four turbine rotor configurations, from 28 to 61 meters in diameter, and data from five test sites are included. Performance data are presented in the form of graphs of power and system efficiency versus free-stream wind speed. Deviations from theoretical performance are analyzed statistically. Power conversion efficiency averaged 0.34 for all tests combined, compared with 0.31 predicted. Round blade tips appeared to improve performance significantly. Cyclic blade loads were normalized to develop load factors which can be used in the design of rotors with rigid hubs.

Spera, D. A.↗

New considerations on scale extrapolation of wing pressure distributions affected by transonic shock-induced separations

Use of this analytical parameter, it is shown, highlights the distinction between cases which are dominated by trailing-edge separation, and those for which separation at the shock foot is dominant. Use of the analytical parameter and the distinction noted above greatly improves the correlation of separation data and the extrapolation of wind tunnel data to flight conditions.

Kahn, M. M. S.↗

Measured and predicted pressure distributions on the AFTI/F-111 mission adaptive wing

Flight tests have been conducted using an F-111 aircraft modified with a mission adaptive wing (MAW). The MAW has variable-camber leading and trailing edge surfaces that can change the wing camber in flight, while preserving smooth upper surface contours. This paper contains wing surface pressure measurements obtained during flight tests at Dryden Flight Research Facility of NASA Ames Research Center. Upper and lower surface steady pressure distributions were measured along four streamwise rows of static pressure orifices on the right wing for a leading-edge sweep angle of 26 deg. The airplane, wing, instrumentation, and test conditions are discussed. Steady pressure results are presented for selected wing camber deflections flown at subsonic Mach numbers up to 0.90 and an angle-of-attack range of 5 to 12 deg. The Reynolds number was 26 million, based on the mean aerodynamic chord. The MAW flight data are compared to MAW wind tunnel data, transonic aircraft technology (TACT) flight data, and predicted pressure distributions. The results provide a unique database for a smooth, variable-camber, advanced supercritical wing.

Webb, Lannie D.↗

Aeroassisted Flight Experiment aerodynamic characteristics at flight conditions

The success of NASA's Aeroassisted Flight Experiment project depends on the suitable placement of instrumentation on the vehicle surface and the ability of the vehicle to fly the maximum science payload. The initial aerodynamic data base was established using wind tunnel data and CFD analyses, where the influence of real-gas effects precluded the use of ground-facility data. More recently, a viscous thermochemical nonequilibrium flow analysis about the complete vehicle, including the wake, has updated the vehicle aerodynamic data base.

Weilmuenster, K. James↗