Search NASA⌕ Search

SEARCH · Search NASA

Results for “Vortex flows”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,189 records · Page 66
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Flow field over the wing of a delta-wing fighter model with vortex control devices at Mach 0.6 to 1.2

As part of a cooperative research program between NASA, McDonnell Douglas Corporation, and Wright Research and Development Center, a flow field investigation was conducted on a 7.52 percent scale windtunnel model of an advanced fighter aircraft design. The investigation was conducted in the Langley 16 ft Transonic Tunnel at Mach numbers of 0.6, 0.9, and 1.2. Angle of attack was varied from -4 degrees to 30 degrees and the model was tested at angles of sideslip of 0, 5, and -5 degrees. Data for the over the wing flow field were obtained at four axial survey stations by the use of six 5 hole conical probes mounted on a survey mechanism. The wing leading edge primary vortex exerted the greatest influence in terms of total pressure loss on the over the wing flow field in the area surveyed. A number of vortex control devices were also investigated. They included two different apex flaps, wing leading edge vortex flaps, and small large wing fences. The vortex flap and both apex flaps were beneficial in controlling the wing leading edge primary vortex.

Bare, E. Ann↗
DOE OSTI2023

Large Eddy Simulation of Rotationally Induced Ingress and Egress around an Axial Seal between Rotor and Stator Disks

In gas turbines, the hot gas exiting the combustor can have temperatures as high as 2000 °C, and some of this hot gas enter into the space between the stator and rotor disks (wheelspace). Since the entering hot gas could damage the disks, its ingestion must be minimized. This is carried out by rim seals and by introducing a cooler flow from the compressor (sealing flow) into the wheelspace. Ingress and egress into rim seals are driven by the stator vanes, the rotor and its rotation, and the rotor blades. This study focuses on the ingress and egress driven by the rotor and its rotation. This is carried out by performing wall-resolved large eddy simulation (LES) around an axial seal in a rotor–stator configuration without vanes and blades. Results obtained show the mechanisms by which the rotor and its rotation induce ingress, egress, and flow trajectories. Kelvin–Helmholtz instability was found to create a wavy shear layer and displacement thickness that produces alternating regions of high and low pressures around the rotor side of the seal. Vortex shedding on the backward-facing side of the seal and its impingement on the rotor side of the seal also produces alternating regions of high and low pressures. The locations of the alternating regions of high and low pressures were found to be statistically stationary and to cause ingress to start on the rotor side of the seal. Vortex shedding and recirculating flow in the seal clearance also cause ingress by entrainment. With the effects of the rotor and its rotation on ingress and egress isolated, this study enables the effects of stator vanes and rotor blades to be assessed.

42 ENGINEERING↗
NASA NTRS1976

An improved method for the prediction of completely three-dimensional aerodynamic load distributions of configurations with leading edge vortex separation

The application of a higher-order subsonic potential flow panel method to the solution of three-dimensional flow about wing and wing-body combinations with leading-edge vortex separation is presented. The governing equations are the linear flow differential equation and nonlinear boundary conditions which require that the flow be parallel to the wing and body surfaces and that the free vortex sheet, springing from the leading and trailing edges, be aligned with the local flow and support no pressure jump. The vortex core is modeled as a simple line vortex which receives vorticity from the free sheet through a connecting sheet. The Kutta condition is imposed on all appropriate edges of the wing. This set of nonlinear equations is solved by an iterative procedure. The Goethert rule accounts for compressibility. The method has been programmed for the CDC 6600. Delta wings, gothic wings, arrow wings, cambered wings, and wing with body have been analyzed. Initial studies involving variations of panel density, vortex sheet sizing, Jacobian update, and initial geometry demonstrate that the present method generally exhibits good convergence characteristics.

Rubbert, p. E.↗
NASA NTRS1978

Vortex Effects for Canard-wing Configurations at High Angles of Attack in Subsonic Flow

A fully three-dimensional subsonic panel method that can handle arbitrary shed vortex wakes is used to compute the nonlinear forces and moments on simple canard-wing configurations. The lifting surfaces and wakes are represented by doublet panels. The Mangler-Smith theory is used to provide an initial estimate for the vortex sheet shed from the leading edge. The trailing-edge wake and the leading-edge wake downstream of the trailing edge are assumed to be straight and leave the trailing edge at an angle of alpha/2. Results indicate good agreement with experimental data up to 40 degs angle of attack.

Desilva, B. M. E.↗
NASA NTRS1988

Transport into the south polar vortex in early spring

Estimates of the mean circulation and diffusive transport of ozone and other species into the Antarctic polar vortex during the spring of 1987 are made using data from the Airborne Antarctic Ozone Experiment. Measurements of long-lived tracers of tropospheric origin remained relatively constant at the levels of the maximum rate of decline of ozone during September. At lower levels in the stratosphere some evidence exists to support intrusions of tropospheric or low latitude air. Given the distribution in latitude and height of these tracers measured from the ER-2 aircraft, it can be inferred that the Lagrangian or diabatic mean circulation was zero or downward over Antarctica during the period of the ozone decline. The observation of a decline in ozone therefore requires a photochemical sink for ozone. The magnitude of the required photochemical sink must be sufficient to offset the transport of ozone into the polar region and produce the observed decline. Quasi-isentropic mixing and downward motion are coupled and are difficult to estimate from a single tracer. The full suite of measured tracers and auxiliary information are brought together to provide an estimate of the rate at which air is cycled through the polar vortex during spring. Estimates of large scale transport of potential vorticity and ozone from previous years are generally consistent with the data from the airborne experiment in suggesting a relatively slow rate of mass flow through the polar vortex in the lower stratosphere during September.

Hartmann, D.↗
NASA NTRS1982

A simple finite difference procedure for the vortex controlled diffuser

A simple prediction procedure for sudden expansion incompressible flows is developed and applied to the vortex controlled diffuser. Transient Navier-Stokes equations of an incompressible fluid are solved by means of their associated finite difference equations in terms of the primitive pressure velocity variables. A computer code is developed using a laminar flow simulation with free slip or no slip wall boundary conditions. In addition, predicted results confirm that effectiveness increases with increases in duct length and bleed flow rate

Busnaina, A. A.↗
NASA NTRS1988

Navier-Stokes simulation of unsteady three-dimensional blade-vortex interactions

The unsteady, viscous, three-dimensional flow field of a helicopter rotor blade encountering a passing vortex is calculated by solving the thin layer Navier-Stokes equations by a finite-difference numerical procedure. A prescribed vortex method is adopted to preserve the structure of the interacting concentrated vortex. The test cases considered correspond to the experimental model rotor test conditions of Caradonna et al.

Srinivasan, G. R.↗
NASA NTRS1983

A Numerical Investigation of the Multiple Vortex Phenomenon: Vortex Number and Structure as a Function of Swirl Ratio

A numerical investigation of the multiple vortex phenomenon (MVP) for tornado like flows is conducted to determine the conditions for when a vortex becomes unstable and divides into smaller subsidiary vortices, as well as to determine the structure of these vortices. A three dimensional numerical model developed by Rotunno (1983) is utilized which has been demonstrated to successfully simulate MVP with properties observed both in natural as well as laboratory tornado like vortices. The MVP is generated for several swirl ratio conditions in order to determine the number of vortices generated for those flow configurations. These results are then compared to experimental measurements to validate the numerical model. The number of vortices produced is consistent with observational results made in the Purdue tornado vortex chamber. Furthermore, horizontal and vertical cross sections are taken through the vortices to determine the structure of MVP. Preliminary results indicate that tangential velocities within these smaller asymmetric vortices increase by 20% over values observed in a single axisymmetric vortex at the same swirl ratio.

Smith, D. R.↗
NASA NTRS1993

On the secondary instability of the most dangerous Goertler vortex

Recent studies have demonstrated the most unstable Goertler vortex mode is found in flows, both two and three-dimensional, with regions of (moderately) large body curvature and these modes reside within a thin layer situated at the base of the conventional boundary layer. Further work concerning the nonlinear development of the most dangerous mode demonstrates that the flow results in a self induced flow reversal. However, prior to the point at which flow reversal is encountered, the total streamwise velocity profile is found to be highly inflectional in nature. Previous work then suggests that the nonlinear vortex state will become unstable to secondary, inviscid, Rayleigh wave instabilities prior to the point of flow reversal. Our concern is with the secondary instability of the nonlinear vortex states, which result from the streamwise evolution of the most unstable Goertler vortex mode, with the aim of determining whether such modes can induce a transition to a fully turbulent state before separation is encountered.

Otto, S. R.↗
NASA NTRS1984

Experimental and analytical studies in fluids

The first objective was to analyze and design a true airspeed sensor which will replace the conventional pitot-static pressure transducer for small commercial aircraft. The second objective was to obtain a numerical solution and predict the frequency response which is generated by the vortex whistle at a certain airspeed. It was concluded flow rate measurements indicate that the vortex tube sound frequency is linearly proportional to the frequency response. The vortex tube whistle frequency is dependent upon geometrical parameters to such an extent that: an increase in vortex tube length produces a decrease in frequency response and that an increase in the exhaust nozzle length produces an increase in the frequency precession. An increase in the vortex tube diameter produces a decrease in frequency precession. An increase in swirler diameter produces a decrease in frequency. An increase in the location distance of the microphone pickup signal point from the inside edge of the exit nozzle produces an increase in frequency response. The experimental results indicate that those parameters most significantly effecting frequency are in descending order of importance microphone location, vortex tube diameter, exit nozzle length, vortex tube length, and swirler diameter.

Goglia, Gene L.↗
NASA NTRS1988

Three-dimensional viscous flow computations of a circular jet in subsonic and supersonic cross flow

Three-dimensional viscous flow computations are presented for 90 deg injection angle jets in subsonic and supersonic cross flow. Comparisons with experimental data include jet centerline and vortex trajectories for the subsonic cross flow, and surface pressure measurement for the supersonic crossflow case. The vortices induced in the jet/freestream interaction are computed and illustrated. The vortices persist in subsonic flow and die out quickly in supersonic flow. The structure of the shocks in the unconfined supersonic flow is illustrated.

Harloff, G. J.↗
NASA NTRS1992

The use of interferometry in the study of rotorcraft aerodynamics

The application of interferometry techniques to analysis of aerodynamic flows on rotorcraft is reviewed, with emphasis on those studies which give insight into the character of the complex flows on helicopter rotor blades. In particular, blade-vortex interaction, dynamic stall, and transonic flow on rotor blades are reviewed, showing how interferometry offers new insight into the basic flow characteristics of these flows and presenting some of the correlations that have been made with the results of computational analysis.

Carr, Lawrence W.↗
NASA NTRS1986

Viscous analyses for flow through subsonic and supersonic intakes

A parabolized Navier-Stokes code was used to analyze a number of diffusers typical of a modern inlet design. The effect of curvature of the diffuser centerline and transitioning cross sections was evaluated to determine the primary cause of the flow distortion in the duct. Results are presented for S-shaped intakes with circular and transitioning cross sections. Special emphasis is placed on verification of the analysis to accurately predict distorted flow fields resulting from pressure-driven secondary flows. The effect of vortex generators on reducing the distortion of intakes is presented. Comparisons of the experimental and analytical total pressure contours at the exit of the intake exhibit good agreement. In the case of supersonic inlets, computations of the inlet flow field reveal that large secondary flow regions may be generated just inside of the intake. These strong flows may lead to separated flow regions and cause pronounced distortions upstream of the compressor.

Povinelli, Louis A.↗
NASA NTRS1987

Viscous analyses for flow through subsonic and supersonic intakes

A parabolized Navier-Stokes code was used to analyze a number of diffusers typical of a modern inlet design. The effect of curvature of the diffuser centerline and transitioning cross sections was evaluated to determine the primary cause of the flow distortion in the duct. Results are presented for S-shaped intakes with circular and transitioning cross sections. Special emphasis is placed on verification of the analysis to accurately predict distorted flow fields resulting from pressure-driven secondary flows. The effect of vortex generators on reducing the distortion of intakes is presented. Comparisons of the experimental and analytical total pressure contours at the exit of the intake exhibit good agreement. In the case of supersonic inlets, computations of the inlet flow field reveal that large secondary flow regions may be generated just inside of the intake. These strong flows may lead to separated flow regions and cause pronounced distortions upstream of the compressor.

Povinelli, Louis A.↗
NASA NTRS1985

A Method for Computing the Core Flow in Three-Dimensional Leading-Edge Vortices

A theory is presented for calculating the flow in the core of a separation-induced leading-edge vortex. The method is based on matching inner and outer representations of the vortex. The inner model of the vortex is based on the quasicylindrical Navier-Stokes equations; the flow is assumed to be steady, axially symmetric, and incompressible and in addition, gradients in the radial direction are assumed to be much larger then gradients in the axial direction. The outer model is based on the three-dimensional free-vortex-sheet theory, a higher-order panel method which solves the Prandtl-Glauert equation including nonlinear boundary conditions pertinent to the concentrated vorticity representation of the leading edge vortex. The resultant flow is evaluated a posteriori for evidence of incipient vortex breakdown and the critical helix angle concept, in conjunction with an adverse longitudinal pressure gradient, is found to correlate well with the occurrence of vortex breakdown at the trailing edge of delta, arrow, and diamond wings.

Luckring, J. M.↗