Search NASA⌕ Search

SEARCH · Search NASA

Results for “ENGINES - PERFORMANCE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,225 records · Page 68
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

A Quiet Engine for stilling complaints.

Two experimental Quiet Engines using derated CF6 cores are discussed. One engine has a low-speed fan running at a tip speed of 1160 fps; the other engine has a fan running at the high speed of 1550 fps. The two engines are expected to show the relative advantages of fans operating at low tip speeds with high lift coefficients in comparison with fans operating at high tip speeds with low lift coefficients. Test results obtained with full-scale (6-ft diameter) fans are examined.

Sanders, N. D.↗
NASA NTRS1972

Mariner Venus/Mercury 1973 rocket engine assembly

The fabrication and test of rocket engine assemblies (REA) for Mariner Venus/Mercury 1973 are reported. The fabrication, assembly and flight acceptance test of seven REA's including the type approval test of one engine and fabrication of one additional kit consisting of detail parts for an engine ready for catalyst loading are presented. The MV/M '73 REA which is a nominal 51 lbs thrust monopropellant engine is described. Under steady state operation the specific impulse is not less than 228 lb-sec at 55 lb and 218.5 lb-sec at 10 lb thrust varying linearly between these limits. The characteristic velocity is not less than 4100 ft/sec at any thrust level.

Snoke, D. R.↗
NASA NTRS1974

A simplified life-cycle cost comparison of various engines for small helicopter use

A ten-year, life-cycle cost comparison is made of the following engines for small helicopter use: (1) simple turboshaft; (2) regenerative turboshaft; (3) compression-ignition reciprocator; (4) spark-ignited rotary; and (5) spark-ignited reciprocator. Based on a simplified analysis and somewhat approximate data, the simple turboshaft engine apparently has the lowest costs for mission times up to just under 2 hours. At 2 hours and above, the regenerative turboshaft appears promising. The reciprocating and rotary engines are less attractive, requiring from 10 percent to 80 percent more aircraft to have the same total payload capability as a given number of turbine powered craft. A nomogram was developed for estimating total costs of engines not covered in this study.

Civinskas, K. C.↗
NASA NTRS1974

Gaseous exhaust emissions from a J-58 engine at simulated supersonic flight conditions

Emissions of total oxides of nitrogen, unburned hydrocarbons, carbon monoxide, and carbon dioxide from a J-58 engine at simulated flight conditions of Mach 2.0, 2.4, and 2.8 at 19.8 km altitude are reported. For each flight condition, measurements were made for four engine power levels from maximum power without afterburning through maximum afterburning. These measurements were made 7 cm downstream of the engine primary nozzle using a single point traversing gas sample probe. Results show that emissions vary with flight speed, engine power level, and with radial position across the exhaust.

Holdeman, J. D.↗
NASA NTRS1974

State of technology on hydrogen fueled gas turbine engines

A series of investigations was conducted episodically from the 1950's to the early 1970's to investigate the feasibility and potential problem areas in the use of hydrogen fuel for gas turbine engines. A brief summary and bibliography are presented of the research that has been conducted by NASA, its predecessor NACA, and by industry under U. S. Air Force sponsorship. Although development efforts would be required to provide hydrogen fueled gas turbine engines for aircraft, past research has shown that hydrogen fueled engines are feasible, and except for flight weight liquid hydrogen pumps, there are no problem areas relating to engines requiring significant research.

Esgar, J. B.↗
NASA NTRS1974

Erosion and the gas turbine engine, part 2

Procedures for protecting aircraft engines from impact damage due to sand and dust particles are discussed. One system is to develop a filtration system to remove most of the solid particles. Another method is to design blade materials and blade protection coatings. The concepts of erosion within aircraft engines are explained. Curves are presented to show the effect of impingement angle on ductile and elastic modes of erosion. Engine sand and dust ingestion tests were conducted on T63-A-5A engines and the results are produced in graph form. The results of tests conducted in a dynamic erosion facility are analyzed.

Newhart, J. E.↗
NASA NTRS1974

Emission calibration of a J-58 afterburning turbojet engine at simulated supersonic stratospheric flight conditions

Emissions of total oxides of nitrogen, unburned hydrocarbons, and carbon monoxide from a J-58 engine at simulated flight conditions of Mach 2.0, 2.4, and 2.8 at 19.8 km altitude are reported. For each flight condition, measurements were made for four engine power levels from maximum power without afterburning through maximum afterburning. These measurements were made 7 cm downstream of the engine primary nozzle using a single point traversing gas sample probe. Results show that emissions vary with flight speed, engine power level, and with radial position across the exhaust.

Holdeman, J. D.↗
NASA NTRS1974

Investigation of the stall-induced shock wave (hammershock) at the inlet to the engine

The peak static pressures measured at the inlet to the engine during stall are presented for a turbojet and two turbofan engines. It is shown for one turbofan and the turbojet that the static pressure ratio across the hammershock does not exceed significantly the normal shock pressure ratio necessary to stop the flow. The second turbofan engine did not follow this rule. Possible reasons for the departure are discussed. For the two turbofan engines the influence of the stall method on the hammershock intensity was investigated. Data related to the spatial distribution of pressure in the hammershock are also presented.

Kurkov, A. P.↗
NASA NTRS1973

The problem of carrying out a diagnosis of an internal combustion engine by vibroacoustical parameters

The physics of noise formation in an internal combustion engine is discussed. A dependence of the acoustical radiation on the engine operating process, its construction, and operational parameters, as well as on the degree of wear on its parts, has been established. An example of tests conducted on an internal combustion engine is provided. A system for cybernetic diagnostics for internal combustion engines by vibroacoustical parameters is diagrammed.

Lukanin, V. N.↗
NASA NTRS1974

Analysis of combustion instability in liquid propellant engines with or without acoustic cavities

Analytical studies have been made of the relative combustion stability of various propellant combinations when used with hardware configurations representative of current design practices and with or without acoustic cavities. Two combustion instability models, a Priem-type model and a modification of the Northern Research and Engineering (NREC) instability model, were used to predict the variation in engine stability with changes in operating conditions, hardware characteristics or propellant combination, exclusive of acoustic cavity effects. The NREC model was developed for turbojet engines but is applicable to liquid propellant engines. A steady-state combustion model was used to predict the needed input for the instability models. In addition, preliminary development was completed on a new model to predict the influence of an acoustic cavity with specific allowance for the effects the nozzle, steady flow and combustion.

Oberg, C. L.↗
NASA NTRS1974

Effect of engine shroud configuration on the static aerodynamic characteristics of a 0.00563 scale 142-inch diameter solid rocket booster (SA10F)

A test of a 0.563 percent scale space shuttle Solid Rocket Booster (SRB) model, MSFC Model 449, was conducted in a trisonic wind tunnel. Test Mach numbers were 0.4, 0.6, 0.9, 1.2, 1.96, 3.48, 4.0, 4.45, and 4.96. Test angles-of-attack ranged from minus 10 degrees to 190 degrees. Test Reynolds numbers ranged from 3.0 million per foot to 8.6 million per foot. Test roll angles were 0, 11.25, 22.5, 45, and 90 degrees. In addition to the static stability evaluation of the primary SRB configuration, five parametric investigations were made: (1) effect of Reynolds number, (2) effect of engine shroud flare angle, (3) effect of engine shroud length, (4) effect of engine shroud strakes, and (5) effect of engine shroud strakes and trust vector control bottles.

Johnson, J. D.↗
NASA NTRS1974

Calculation procedures for potential and viscous flow solutions for engine inlets

The method and basic elements of computer solutions for both potential flow and viscous flow calculations for engine inlets are described. The procedure is applicable to subsonic conventional, short-haul, and vertical takeoff aircraft engine nacelles operating in a compressible viscous flow. The calculated results compare well with measured surface-pressure distributions for a number of model inlets. The uses of the program in both the design and analysis of engine inlets are discussed, with several examples given for VTOL lift fans, acoustic splitters, and for STOL engine nacelles. Several test support applications are also given.

Albers, J. A.↗
NASA NTRS1974

Jet engine soot emission measured at altitude

The state of knowledge concerning engine design to minimize air pollution is believed to be such that emission products can be reliably predicted while the engine is still on the drawing board. More effort is now being made to measure emission products from engines operating under cruise conditions. The use of an instrumented aircraft to obtain the appropriate data is perhaps a more realistic and less expensive approach. The results of this study taken at face value indicate that the emission index of typical jet engines calculated from the ground level measurements is comparable to the actual in-flight emission index for altitudes up to 30,000 ft.

Rosen, J. M.↗
NASA NTRS1974

Quiet engine from NASA

Engine designs resulting from the NASA sponsored quiet engine program are described in terms of their possible use on the DC-8. These engines have high bypass ratios for low jet noise and low-speed, low-noise fans. Experiments were carried out on various fan designs with different tip speeds. The advantage of low tip speeds and high lift coefficients has been demonstrated. The engines are equipped with flight-standard nacelles with acoustic suppression. It is estimated that these improvements will reduce DC-8 noise by about 26EPNdB-29EPNdB.

Sanders, N. D.↗
NASA NTRS1974

MSFC engineering support to Skylab operations

Major engineering support provided during the Skylab mission from the Marshall Space Flight Center and its contractors to the Mission Control Center at Houston was essential to Skylab success. The need for this type of support was anticipated during premission preparations due to the complexity and first-flight nature of the Skylab, but the requirements were greatly magnified by the problems encountered early in the mission. The MFSC engineering support organization and its interface to the Mission Control Center is described. The importance of close cooperation between the operating and engineering organizations in this type of mission is discussed. Illustrations are given from more than 1800 systems analysis actions worked out during the nine-month Skylab mission by more than 600 support engineers.

Kurtz, H. F., Jr.↗
NASA NTRS1974

Investigation of the stall-induced shock wave /hammershock/ at the inlet to the engine

The peak static pressures measured at the inlet to the engine during stall are presented for a turbojet and two turbofan engines. It is shown for one turbofan and the turbojet that the static pressure ratio across the hammershock does not exceed significantly the normal shock pressure ratio necessary to stop the flow. The second turbofan engine did not follow this rule. Possible reasons for the departure are discussed. For the two turbofan engines, the influence of the stall method on the hammershock intensity has been investigated. Data related to the spatial distribution of pressure in the hammershock are also presented.

Kurkov, A. P.↗
NASA NTRS1974

Scale model testing of the jet noise characteristics of the JT8D refan engine nozzle system

The results are presented of static scale model acoustic tests of the nozzle system for the JT8D-9 baseline engine and candidate nozzle systems for JT8D-109, JT8D-115, and JT8D-117 refan engines. The objective of these tests was to determine the jet noise benefit of the three refan engine cycles relative to the baseline JT8D-9, and to provide acoustic information toward selection of the optimum primary-secondary area match and centerbody contour for the refan engine cycles. One of the nozzle configurations was tested with and without simulated turbine exit swirl to determine what effect, if any, swirl has no jet noise. The JT8D-109 cycle was found to afford approximately 9 db (0ASPL) jet noise reduction relative to the JT8D-9 when compared on an equal static thrust basis. The JT8D-115 and JT8D-117 afford an 8 db and 6 db reduction, respectively, relative to the JT8D-9, at equal static thrust. Turbine exit swirl was found to have no significant effect on the jet noise of the JT8D-109 nozzle system.

Reed, D. H.↗
NASA NTRS1974

Interim prediction method for low frequency core engine noise

A literature survey on low-frequency core engine noise is presented. Possible sources of low frequency internally generated noise in core engines are discussed with emphasis on combustion and component scrubbing noise. An interim method is recommended for predicting low frequency core engine noise that is dominant when jet velocities are low. Suggestions are made for future research on low frequency core engine noise that will aid in improving the prediction method and help define possible additional internal noise sources.

Huff, R. G.↗