Search NASA⌕ Search

SEARCH · Search NASA

Results for “Simulated Probes”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 127 records · Page 7
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Surface friction of rock in terrestrial and simulated lunar environments

The conventional probe-on-the rotating-disk concept was used to determine the surface friction in mineral probe/specimen interfaces. Nine rocks or minerals and two stainless steels were tested in both new (NT) and same track (ST) tests under three different pressure environments-atmospheric, UHV, and dry nitrogen. Each environment was further subdivided into two testing conditions, that is, ambient and elevated (135 C) temperatures. In NT tests, friction was the lowest in an atmospheric pressure condition for all rock types and increased to the largest in UHV ambient condition except for pyroxene and stainless steel. Friction values measured in dry nitrogen ambient condition lie between the two extremes. Heating tends to increase friction in atmospheric and dry nitrogen environment but decreases in UHV environment with the exception of stainless steel, basalt, and pyroxene. In ST tests, friction was the lowest in the first run and increased in subsequent runs except for stainless steel where the reverse was true. The increases leveled off after a few runs ranging from the second to the seventh depending on rock types.

Roepke, W. W.↗
NASA NTRS2002

Measurement and Computation of Supersonic Flow in a Lobed Diffuser-Mixer for Trapped Vortex Combustors

The trapped vortex combustor (TVC) pioneered by Air Force Research Laboratories (AFRL) is under consideration as an alternative to conventional gas turbine combustors. The TVC has demonstrated excellent operational characteristics such as high combustion efficiency, low NO(x) emissions, effective flame stabilization, excellent high-altitude relight capability, and operation in the lean-burn or rich burn-quick quench-lean burn (RQL) modes of combustion. It also has excellent potential for lowering the engine combustor weight. This performance at low to moderate combustor mach numbers has stimulated interest in its ability to operate at higher combustion mach number, and for aerospace, this implies potentially higher flight mach numbers. To this end, a lobed diffuser-mixer that enhances the fuel-air mixing in the TVC combustor core was designed and evaluated, with special attention paid to the potential shock system entering the combustor core. For the present investigation, the lobed diffuser-mixer combustor rig is in a full annular configuration featuring sixfold symmetry among the lobes, symmetry within each lobe, and plain parallel, symmetric incident flow. During hardware cold-flow testing, significant discrepancies were found between computed and measured values for the pitot-probe-averaged static pressure profiles at the lobe exit plane. Computational fluid dynamics (CFD) simulations were initiated to determine whether the static pressure probe was causing high local flow-field disturbances in the supersonic flow exiting the diffuser-mixer and whether shock wave impingement on the pitot probe tip, pressure ports, or surface was the cause of the discrepancies. Simulations were performed with and without the pitot probe present in the modeling. A comparison of static pressure profiles without the probe showed that static pressure was off by nearly a factor of 2 over much of the radial profile, even when taking into account potential axial displacement of the probe by up to 0.25 in. (0.64 cm). Including the pitot probe in the CFD modeling and data interpretation lead to good agreement between measurement and prediction. Graphical inspection of the results showed that the shock waves impinging on the probe surface were highly nonuniform, with static pressure varying circumferentially among the pressure ports by over 10 percent in some cases. As part of the measurement methodology, such measurements should be routinely supplemented with CFD analyses that include the pitot probe as part of the flow-path geometry.

Brankovic, Andreja↗
NASA NTRS1993

Probe Compensation Characterization in Cylindrical Near-Field Scanning

This paper presents a useful computer simulation methodology to properly characterize the role of probe compensation in cylindrical near-field scanning. The methodology is applied to a linear test array antenna and has been applied to other antenna configurations.

probe compensation near-field scanning waveguide r↗
NASA NTRS1973

Multiring probe in a flowing ionospheric plasma.

Description of a multiring probe placed in an ionospheric flow simulation chamber utilizing a modified Kaufman ion engine for its plasma source. The pertinent details of the probe design, instrumentation, and operating procedures are discussed, and the preliminary results obtained are presented.

Sheldon, J. W.↗
NASA NTRS1978

Pioneer Venus probe models instrumented prop tests

Models of both the small and large Pioneer Venus probes were dropped from a helicopter to simulate the conditions of Mach and Reynolds numbers to be encountered by the probes upon entry into the Venus atmosphere. The models were dropped at an average Mach number of .10 and at an average Reynolds number of 2.84 million for the small probe and 2.90 million for the large probe. After the large amplitude launching oscillations were damped, the small probe oscillations in angle of attack and in sideslip were generally less than 2 degrees. The large probe oscillations were generally less than 10 degrees. Both exhibited distinct frequencies. The motion of the small probe in a place perpendicular to the z axis was random while the large probe rotated (corkscrewed) at 1.1 cycles per second about the z axis. The average drag coefficients of the probe models were .714 for the small probe and .663 for the large probe.

Muirhead, V. U.↗
NASA NTRS1979

Particle acceleration by propagating interplanetary shocks

The process of charged particle acceleration in interplanetary shocks has been simulated for typical parameters. Since space probe observations of charged particle fluxes are the principle means of inferring the action of an acceleration mechanism, the simulation was designed to follow particles backwards in time from a given observing point, usually 1 AU. This allowed a full diagnosis of which observed particles had interacted with an oncoming shock, where the interacting occurred, and by how much the energy had been changed by the shock interaction. Simple assumptions about the preshock energy spectrum allow the construction of a full temporal profile of the expected intensity, anisotropy, and energy spectrum. The simulations are apparently capable of reproducing the main features of the less than 10 MeV/nuc ion flux enhancements observed at interplanetary shocks using only a laminar interplanetary magnetic field, Archimidean spiral, and a spherical oblique shock with typical speed, strength, and shock normal-magnetic field angle.

Armstrong, T. P.↗
NASA NTRSDate not supplied

The View From Out Here: The Solar System Planets as Exoplanet Analogs

As we begin to characterize planets orbiting other stars, one of the most important tools available to us is the collection of disk-integrated solar system observations. To date, these have been limited in how they match up with expected exoplanet observations in terms of wavelength, time, viewing geometry, and separations. The Interstellar Probe mission could push the boundaries of planetary science by providing a much-needed and unique dataset for the solar system viewed as an extrasolar system in advance of the next generation of ground and space-based telescopes. Viewing the solar system at large separations over a long period serves several purposes. It acts as a practical test directly analogous to exoplanet observations under realistic conditions, including such effects as zodiacal dust (e.g., Roberge et al., 2012). Secondly, it allows for both the validation of forward models (that is, simulating a planet and generating spectra) and retrievals (where some of the planetary properties are not known) (e.g., Robinson et al., 2011; Agarwal and Wettlaufer, 2017). Third, the mission pro le would be able to collect data at both high- and low-phase angles, which are lacking for most of the solar system planets (e.g., Mallama and Hilton, 2018). Lastly, the long duration of the proposed mission would allow not only snapshots, but time resolved observations using the same instrument, highlighting the dynamic nature of the planets (e.g., seasonality, storms). The planets need not be resolved to make these observations, which eases instrumentation requirements. Here, we show simulations of what an Interstellar Probe imager would see, improving on work that was part of a white paper submitted to the Planetary Science and Astrobiology Decadal Survey. The opportunity for multiple full orbits for most of the solar system planets, including a full phase curve of Saturn, is unique and worth pursuing during the development of the Interstellar Probe mission.

Chester Harman↗
NASA NTRS2019

Use of Polarimetric Radar Measurements to Constrain Simulated Convective Cell Evolution: A Pilot Study with Lagrangian Tracking

To probe the potential value of a radar-driven field campaign to constrain simulation of isolated convection subject to a strong aerosol perturbation, convective cells observed by the operational KHGX weather radar in the vicinity of Houston, Texas, are examined individually and statistically. Cells observed in a single case study of onshore flow conditions during July 2013 are first examined and compared with cells in a regional model simulation. Observed and simulated cells are objectively identified and tracked from observed or calculated positive specific differential phase (K(sub DP)) above the melting level, which is related to the presence of supercooled liquid water. Several observed and simulated cells are subjectively selected for further examination. Below the melting level, we compare sequential cross sections of retrieved and simulated raindrop size distribution parameters. Above the melting level, we examine time series of KDP and radar differential reflectivity (Z(sub DR)) statistics from observations and calculated from simulated supercooled rain properties, alongside simulated vertical wind and supercooled rain mixing ratio statistics. Results indicate that the operational weather radar measurements offer multiple constraints on the properties of simulated convective cells, with substantial value added from derived K(sub DP) and retrieved rain properties. The value of collocated three-dimensional lightning mapping array measurements, which are relatively rare in the continental US, supports the choice of Houston as a suitable location for future field studies to improve the simulation and understanding of convective updraft physics. However, rapid evolution of cells between routine volume scans motivates consideration of adaptive scan strategies or radar imaging technologies to amend operational weather radar capabilities. A 3-year climatology of isolated cell tracks, prepared using a more efficient algorithm, yields additional relevant information. Isolated cells are found within the KHGX domain on roughly 40 % of days year-round, with greatest concentration in the northwest quadrant, but roughly 5-fold more cells occur during June through September. During this enhanced occurrence period, the cells initiate following a strong diurnal cycle that peaks in the early afternoon, typically follow a south-to-north flow, and dissipate within 1 h, consistent with the case study examples. Statistics indicate that ∼ 150 isolated cells initiate and dissipate within 70 km of the KHGX radar during the enhanced occurrence period annually, and roughly 10 times as many within 200 km, suitable for multi-instrument Lagrangian observation strategies. In addition to ancillary meteorological and aerosol measurements, robust vertical wind speed retrievals would add substantial value to a radar-driven field campaign.

Fridlind, Ann M.↗
NASA NTRS1985

Orbits: Computer simulation

In rotating machinery dynamics an orbit (Lissajous curve) represents the dynamic path of the shaft centerline motion during shaft rotation and resulting precession. The orbit can be observed with an oscilloscope connected to XY promixity probes. The orbits can also be simulated by a computer. The software for HP computer simulates orbits for two cases: (1) Symmetric orbit with four frequency components with different radial amplitudes and relative phase angles; and (2) Nonsymmetric orbit with two frequency components with two different vertical/horizontal amplitudes and two different relative phase angles. Each orbit carries a Keyphasor mark (one-per-turn reference). The frequencies, amplitudes, and phase angles, as well as number of time steps for orbit computation, have to be chosen and introduced to the computer by the user. The orbit graphs can be observed on the computer screen.

Muszynska, A.↗
NASA NTRS1976

Pioneer Venus entry simulator

To assure successful tracking of the four Pioneer Venus probes, it is necessary for the deep space station receiver operators to be familiar with the characteristics of the received signals. As an aid for training the operators for this mission, signal simulators have been developed which completely duplicate the probe signals. This article describes the method used for generating these test signals.

Johns, C. E.↗
NASA NTRS1986

The flight and impact dispersion of the Comet Nucleus Penetrator - A six-degree-of-freedom simulation

The flight dynamics of a Penetrator probe which, as part of a Comet Rendezvous and Asteroid Flyby mission will impact a known periodic comet, possibly Hempel 2, and penetrate beneath the surface to obtain measurements, is discussed. The mission is described, including the penetrator-separation dynamics, the dynamics during initial coast and rocket thrust phase, and the final coast to impact. The effects on the results that may be caused by the comet nucleus gravity field variations, uncertainty in the spacecraft state vector, the spacecraft pointing accuracy, initial separation errors, and rocket motor thrust errors are examined.

Mascy, A. C.↗
NASA NTRS1995

Probing the structure of cometary ice

Computer simulations of bulk and vapor deposited amorphous ices are presented. The structure of the bulk low density amorphous ice is in good agreement with experiments on pressure disordered amorphous ice. Both the low density bulk ice and the vapor deposited ices exhibit strong ordering. Vapor deposition of hot (300 K) water molecules onto a cold (77 K) substrate yields less porous ices than deposition of cold (77 K) water molecules onto a cold substrate. Both vapor deposited ices are more porous than the bulk amorphous ice. The structure of bulk high density amorphous ice is only in fair agreement with experimental results. Attempts to simulate high density amorphous ice via vapor deposition were not successful. Electron diffraction results on vapor deposited amorphous ice indicate that the temperature of the nucleation of the cubic phase depends upon the amount of time between the deposition and the onset of crystallization, suggesting that freshly deposited ice layers reconstruct on time of the order of hours. The temperature dependence of the microporosity of the vapor deposited amorphous ices might affect laboratory experiments that are aimed at simulating astrophysical ices in the context of the origin of prebiotic organic material and its transport to the Earth.

Wilson, Michael A.↗
NASA NTRS1998

Prediction of Particle Number Density and Particle Properties in the Flow Field Observed by the Nephelometer Experiment on the Galileo Probe

This report summarizes the work performed to assist in the analysis of data returned from the Galileo Probe's Nephelometer instrument. A computation of the flow field around the Galileo Probe during its descent through the Jovian atmosphere was simulated. The behavior of cloud particles that passed around the Galileo probe was then computed and the number density in the vicinity of the Nephelometer instrument was predicted. The results of our analysis support the finding that the number density of cloud particles was not the same in each of the four sampling volumes of the Nephelometer instrument. The number densities calculated in this study are currently being used to assist in the reanalysis of the data returned from the Galileo Probe.

Naughton, Jonathan W.↗
NASA NTRS1998

Prediction of Particle Number Density and Particle Properties in the Flow Field Observed by the Nephelometer Experiment on the Galileo Probe

This report summarizes the work performed to assist in the analysis of data returned from the Galileo Probe's Nephelometer instrument. A computation of the flow field around the Galileo Probe during its descent through the Jovian atmosphere was simulated. The behavior of cloud particles that passed around the Galileo probe was then computed and the number density in the vicinity of the Nephelometer instrument was predicted. The results of our analysis support the finding that the number density of cloud particles was not the same in each of the four sampling volumes of the Nephelometer instrument. The number densities calculated in this study are currently being used to assist in the reanalysis of the data returned from the Galileo Probe.

Naughton, Jonathan W.↗