Search NASA⌕ Search

SEARCH · Search NASA

Results for “Simulation Results”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 127 records · Page 7

Preliminary Benchmarking and MCNP Simulation Results for Homeland Security

The purpose of this article is to create Monte Carlo N-Particle (MCNP) input stacks for benchmarked measurements sufficient for future perturbation studies and analysis. The approach was to utilize historical experimental measurements to recreate the empirical spectral results in MCNP, both qualitatively and quantitatively. Results demonstrate that perturbation analysis of benchmarked MCNP spectra can be used to obtain a better understanding of field measurement results which may be of national interest. If one or more spectral radiation measurements are made in the field and deemed of national interest, the potential source distribution, naturally occurring radioactive material shielding, and interstitial materials can only be estimated in many circumstances. The effects from these factors on the resultant spectral radiation measurements can be very confusing. If benchmarks exist which are sufficiently similar to the suspected configuration, these benchmarks can then be compared to the suspect measurements. Having these benchmarks with validated MCNP input stacks can substantially improve the predictive capability of experts supporting these efforts.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Comparison of laser-produced plasma spatio-temporal electron density evolution measured using interferometry with simulation results

Due to the difficulties associated with experimental measurements of laser-produced plasma (LPP) properties during the earliest stages of plasma evolution, radiation hydrodynamic codes are often used. However, although these codes have been extensively validated in the higher intensity regimes, validation at low to moderate intensities has been limited. In this study, the spatio-temporal electron density evolution in an LPP generated at moderate laser intensities and at various laser wavelengths was validated against the FLASH code for times up to 20 ns. The LPP was generated by focusing the fundamental and various harmonics radiation (1064, 532, and 266 nm) from a 6 ns full width half maximum Nd:YAG laser, at a laser intensity of 10 GW cm -2 , onto a copper target. The spatio-temporal density evolution of the expanding plasma was analyzed using Nomarski interferometry. Experimental measurements were found to be consistent with FLASH simulations, and the dependence of electron densities on wavelength was found to be in agreement with analytical models, varying as n e ∝ λ -0.7 . However, slight differences were noted in the widths and shape functions of the experimental and simulated electron density profiles.

2D fast imaging↗

Cryogenic Vibrationally Resolved Photoelectron Spectroscopy of OH–(H2O): Confirmation of Multidimensional Franck-Condon Simulation Results for the Transition State of the OH + H2O Reaction

We present a transition state spectroscopic study of the OH + H2O reaction using the experimental technique of cryogenic Negative Ion Photoelectron Spectroscopy (NIPES). The recorded NIPE spectrum at 193 nm exhibits multiple vibrational progressions that include excitations to the shared H atom antisymmetric stretching mode with an interval of 0.32 eV as well as other progressions, mainly involving the H bending and O…O symmetric stretching modes. The Vertical Detachment Energy (VDE) was measured at 3.53 eV, whereas an upper limit for the Adiabatic Detachment Energy (ADE) was estimated at 2.90 eV. These values are in excellent agreement with the theoretically computed values of 3.51 eV and 2.83 eV respectively, obtained at the CCSD(T)/aug-cc-pV5Z level of theory. The recorded NIPE spectrum is in very good agreement when compared to the one recently reported from four-dimensional Franck-Condon simulations, in which a similar spectral profile was predicted. Besides observing the ground state, a charge-transfer excited state in the form of [OH–(H2O)+] is identified with a relative energy of 1.39 eV, well matching the previous prediction of 1.36 eV. This work was supported by U.S. Department of Energy (DOE), Office of Science, Office of Basic Energy Sciences, Division of Chemical Sciences, Geosciences, and Biosciences, and performed using EMSL, a national scientific user facility sponsored by DOE’s Office of Biological and Environmental Research and located at Pacific Northwest National Laboratory, which is operated by Battelle Memorial Institute for the DOE. The theoretical calculations were conducted on EMSL’s “Cascade” Supercomputer. This research also used resources of the National Energy Research Scientific Computing Center, which is supported by the Office of Science of the U.S. Department of Energy under Contract No. DE-AC02-05CH11231.

Cao, Wenjin↗

Fast Plasma Instrument for MMS: Data Compression Simulation Results

Magnetospheric Multiscale (MMS) mission will study small-scale reconnection structures and their rapid motions from closely spaced platforms using instruments capable of high angular, energy, and time resolution measurements. To meet these requirements, the Fast Plasma Instrument (FPI) consists of eight (8) identical half top-hat electron sensors and eights (8) identical ion sensors and an Instrument Data Processing Unit (IDPU). The sensors (electron or ion) are grouped into pairs whose 6 deg x 180 deg fields-of-view (FOV) are set 90 deg apart. Each sensor is equipped with electrostatic aperture steering to allow the sensor to scan a 45 deg x 180 deg fan about its nominal viewing (0 deg deflection) direction. Each pair of sensors, known as the Dual Electron Spectrometer (DES) and the Dual Ion Spectrometer (DIS), occupies a quadrant on the MMS spacecraft and the combination of the eight electron/ion sensors, employing aperture steering, image the full-sky every 30-ms (electrons) and 150-ms (ions), respectively. To probe the results in the DES complement of a given spacecraft generating 6.5-Mbs(exp -1) of electron data while the DIS generates 1.1-Mbs(exp -1) of ion data yielding an FPI total data rate of 6.6-MBs(exp -1). The FPI electron/ion data is collected by the IDPU then transmitted to the Central Data Instrument Processor (CIDP) on the spacecraft for science interest ranking. Only data sequences that contain the greatest amount of temporal/spatial structure will be intelligently down-linked by the spacecraft. Currently, the FPI data rate allocation to the CIDP is 1.5-Mbs(exp -1). Consequently, the FPI-IDPU must employ data/image compression to meet this CIDP telemetry allocation. Here, we present simulations of the CCSDS 122.0-B-1 algorithm-based compression of the FPI-DES electron data. Compression analysis is based upon a seed of re-processed Cluster/PEACE electron measurements. Topics to be discussed include: review of compression algorithm; data quality; data formatting/organization; and, implications for data/matrix pruning. To conclude a presentation of the base-lined FPI data compression approach is provided.

Barrie, A.↗

Test Facility Simulation Results for Aerospace Loss-of-Lubrication of Spur Gears

Prior to receiving airworthiness certification, extensive testing is required during the development of rotary wing aircraft drive systems. Many of these tests are conducted to demonstrate the drive system's ability to operate at extreme conditions, beyond that called for in the normal to maximum power operating range. One of the most extreme tests is referred to as the loss-of-lubrication or run dry test. During this test, the drive system is expected to last at least 30 min without failure while the primary lubrication system is disabled for predetermined, scripted flight conditions. Failure of this test can lead to a partial redesign of the drive system or the addition of an emergency lubrication system. Either of these solutions can greatly increase the aircraft drive system cost and weight and extend the schedule for obtaining airworthiness certification. Recent work at NASA Glenn Research Center focused on performing tests, in a relevant aerospace environment, to simulate the behavior of spur gears under loss-of-lubrication conditions. Tests were conducted using a test facility that was used in the past for spur gear contact fatigue testing. A loss-oflubrication test is initiated by shutting off the single into mesh lubricating jet. The test proceeds until the gears fail and can no longer deliver the applied torque. The observed failures are typically plastically deformed gear teeth, due to the high tooth temperatures, that are no longer in mesh. The effect of several different variables to gear tooth condition during loss-of-lubrication have been tested such as gear pitch, materials, shrouding, lubrication condition, and emergency supplied mist lubrication in earlier testing at NASA. Recent testing has focused on newer aerospace gear steels and imbedding thermocouples in the shrouding to measure the air-oil temperatures flung off the gear teeth. Along with the instrumented shrouding, an instrumented spur gear was also tested. The instrumented spur gear had five thermocouples installed at different locations on the gear tooth and web. The data from these two types of measurements provided important information as to the thermal environment during the loss-of-lubrication event. This data is necessary to validate on-going modeling efforts.

Gears↗

An Exploratory Energy Analysis of Electrochromic Windows in Small and Medium Office Buildings - Simulated Results Using EnergyPlus

The Department of Energy’s (DOE) Building Technologies Program (BTP) has had an active research program in supporting the development of electrochromic (EC) windows. Electrochromic glazings used in these windows have the capability of varying the transmittance of light and heat in response to an applied voltage. This dynamic property allows these windows to reduce lighting, cooling, and heating energy in buildings where they are employed. The exploratory analysis described in this report examined three different variants of EC glazings, characterized by the amount of visible light and solar heat gain (as measured by the solar heat gain coefficients [SHGC] in their “clear” or transparent states). For these EC glazings, the dynamic range of the SHGC’s between their “dark” (or tinted) state and the clear state were: (0.22 - 0.70, termed “high” SHGC); (0.16 - 0.39, termed “low” SHGC); and (0.13 - 0.19; termed “very low” SHGC). These glazings are compared to conventional (static) glazing that meets the ASHRAE Standard 90.1-2004 energy standard for five different locations in the U.S. All analysis used the EnergyPlus building energy simulation program for modeling EC windows and alternative control strategies. The simulations were conducted for a small and a medium office building, where engineering specifications were taken from the set of Commercial Building Benchmark building models developed by BTP. On the basis of these simulations, total source-level savings in these buildings were estimated to range between 2 to 7%, depending on the amount of window area and building location.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Studies of Multipactor in Dielectric-Loaded Accelerator Structures: Comparison of Simulation Results with Experimental Data

In this paper new results of numerical studies of multipactor in dielectric-loaded accelerator structures are presented. The results are compared with experimental data obtained during recent studies of such structures performed by Argonne National Laboratory, the Naval Research Laboratory, SLAC National Accelerator Laboratory and Euclid TechLabs, LLC. Good agreement between the theory and experiment was observed for the structures with larger inner diameter, however the structures with smaller inner diameter demonstrated a discrepancy between the two. Possible reasons for such discrepancy are discussed.

43 PARTICLE ACCELERATORS↗

Preliminary Benchmarking Efforts and MCNP Simulation Results for Homeland Security

It is shown in this work that basic measurements made from well defined source detector configurations can be readily converted in to benchmark quality results by which Monte Carlo N-Particle (MCNP) input stacks can be validated. Specifically, a recent measurement made in support of national security at the Nevada Test Site (NTS) is described with sufficient detail to be submitted to the American Nuclear Society’s (ANS) Joint Benchmark Committee (JBC) for consideration as a radiation measurement benchmark. From this very basic measurement, MCNP input stacks are generated and validated both in predicted signal amplitude and spectral shape. Not modeled at this time are those perturbations from the more recent pulse height light (PHL) tally feature, although what spectral deviations are seen can be largely attributed to not including this small correction. The value of this work is as a proof-of-concept demonstration that with well documented historical testing can be converted into formal radiation measurement benchmarks. This effort would support virtual testing of algorithms and new detector configurations.

61 RADIATION PROTECTION AND DOSIMETRY↗

BEPAM Model Code and CABBI Simulation Results for "Assessing the Additional Carbon Savings with Biofuel"

This dataset consists of various input data that are used in the GAMS model. All the data are in the format of .inc which can be read within GAMS or Notepad. Main data sources include: acreage data (acre), crop budget data ($/acre), crop yield data (e.g. bushel/acre), Soil carbon sequestration data (KgCO2/ha/yr). Model details can be found in the "Assessing the Additional Carbon Savings with Biofuel" and GAMS model package. ## File Description (1) GAMS Model.zip: This includes all the input files and scripts for running the model (2) Table*.csv: These files include the data from the tables in the manuscript (3) Figure2_3_4.csv: This contains the data used to create the figures in the manuscript (4) BaselineResults.csv: This includes a summary of the model results. (5) SensitivityResults_*.csv: Model results from the various sensitivity analyses performed (6) LUC_emission.csv: land use change emissions by crop reporting district for changes of pasturelands to annual crops.

Anticipated baseline approach↗

Compartmentalized Storage Reservoir Model and Simulation Results

A hypothetical closed (or compartmentalized) reservoir was created based on the numerical mesh used for Wainwright et al. (2013). The reservoir extent is smaller than the original model and limited between the two faults. The caprock properties are assumed in the rest of the storage formation.

Carbon Storage↗

An Analysis of Home Energy Score and REM/ Rate Energy Simulation Results for Homes in Three Climates

Energy ratings and scores for homes attempt to give homeowners a understandable metric to compare the energy efficiency of homes. Two rating systems in the marketplace include RESNET's Home Energy Rating System (HERS) and DOE's Home Energy Score (HEScore) and include differing energy calculation methodologies. This report compares the energy predictions from both REM/Rate and Home Energy Score for populations of real homes in three climates and determines some features of homes that lead to the greatest differences between energy predictions.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗