Search NASA⌕ Search

SEARCH · Search NASA

Results for “THORIUM”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 127 records · Page 7
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Lead isotope systematics of mare basalt 75075

Uranium, thorium and isotopic lead data are reported for two bulk samples and separated pyroxene, ilmenite and plagioclase from basalt 75075. In a concordia diagram the whole rock, ilmenite and four pyroxene samples define a chord intersecting the concordia curve at approximately 4.25 and 2.8 AE. Three plagioclase samples plot distinctly off the chord. The crystallization age of 75075 is accurately determined at 3.74 AE by Rb-Sr, Sm-Nd and K-Ar measurements from other laboratories. It is not possible to adjust the isotopic composition of initial lead so as to reconcile the U-Pb data with a crystallization age of 3.74 AE. The data therefore indicate some type of post-crystallization disturbance of the U-Pb system that is not detected by the other systems. The 75075 data are one of the few examples of this type of age pattern found on the moon. If the disturbance was a single event, it probably occurred around 2.8 AE ago, the time indicated by the pyroxene, whole rock and ilmenite data.

Chen, J. H.↗
NASA NTRS1978

Gravitational and radiative effects on the escape of helium from the moon

On the moon, and probably on Mercury and other similar regolith-covered bodies with tenuous atmosphere, the dominant gas is He-4. It arises as the radiogenic product of the decay of uranium and thorium within any planet, but its major source appears to be the alpha particle flux of the solar wind. The moon intercepts solar wind helium at an average rate of 1.1 times 10 to the 24th atom/sec, and loses it at the same rate. Some helium may escape directly as the result of the process of solar wind soil bombardment which may release previously trapped helium at superthermal speeds. Atmospheric models have been calculated with the total helium influx as source. Subsequent comparison of model and measured helium concentrations indicates that the fraction of helium escaping via the atmosphere may range from 20% to 100% of the solar wind influx. Of the escaping atmosphere, most of the helium (about 93%) becomes trapped in earth orbit, while about 5% gets trapped in satellite orbits about the moon. Owing to a 6 month lifetime for helium in solar radiation, the satellite atoms form a lunar corona that exceeds the lunar atmosphere in total abundance by a factor of 4 to 5.

Hodges, R. R., Jr.↗
NASA NTRS1979

Commercial use of materials processing in space

The paper examines the scientific and commercial aspects of Materials Processing in the Space program. The elimination of gravity driven convection in molten materials can preclude undesirable stirring and mixing during crystal growth, and improve the casting of alloys and composites, chemical reactions, and the separation of biological materials. The elimination of hydrostatic pressure will allow alloy heat-treatment without distortion and growth of heavy crystals, such as thorium oxide, and containerless processing of liquids and molten materials. On the other hand, more sophisticated process control and diagnostic methods in sample preparation and temperature control must be developed, concluding that space made products of commercial interest are likely to be low volume, high value items.

Zoller, L. K.↗
NASA NTRS1979

Lead isotope systematics of three Apollo 17 mare basalts

The paper deals with new and more accurate determinations of uranium, thorium, and isotopic lead data for five bulk samples and separate pyroxene, ilmenite, and plagioclase from basalt 71055. In a concordia diagram, the samples suggest a postcrystallization disturbance of the U-Pb systems of the rock. There is no compelling reason, from U-Pb data, to believe that the moon is younger than 4.55 AE.

Tilton, G. R.↗
NASA NTRS1980

Core formation, evolution, and convection - A geophysical model

A model for the formation and evolution of the earth's core, which provides an adequate energy source for maintaining the geodynamo, is proposed. A modified inhomogeneous accretion model is proposed which leads to initial iron and refractory enrichment at the center of the planet. The probable heat source for melting of the core is the decay of Al-26. The refractory material is emplaced irregularly in the lowermost mantle with uranium and thorium serving as a long-lived heat source. Fluid motions in the core are driven by the differential heating from above and the resulting cyclonic motions may be the source of the geodynamo.

Ruff, L.↗
NASA NTRS1982

Deposition and dose from the 18 May 1980 eruption of Mount St. Helens

The downwind deposition and radiation doses was calculated for the tropospheric part of the ash cloud from the May 18, 1980 eruption of Mount St. Helens, by using a large cloud diffusion model. The naturally occurring radionnuclides of radium and thorium, whose radon daughters normally seep very slowly from the rocks and soil, were violently released to the atmosphere. The largest dose to an individual from these nuclides is small, but the population dose to those affected by the radioactivity in the ash is about 100 person rem. This population dose from Mount St. Helens is much greater than the annual person rem routinely released by a typical large nuclear power plant. It is estimated that subsequent eruptions of Mount St. Helens have doubled or tripled the person rem calculated from the initial large eruption. The long range global ash deposition of the May 18 eruption is estimated through 1984, by use of a global deposition model. The maximum deposition is nearly 1000 kg square km and occurs in the spring of 1981 over middle latitudes of the Northern Hemisphere.

Peterson, K. R.↗
NASA NTRS1982

The intercrater plains of Mercury and the Moon: Their nature, origin and role in terrestrial planet evolution. Alternative thermal histories

Interpretations supporting a differentiated, once active Mercury are listed. Alternative scenarios of the planet's thermal history involve: different distributions of accreted materials, including uranium and thorium-rich materials; variations of early melting; and different modes of plains and scarp formation. Arguments are advanced which strongly favor plains formation by volcanism, lack of a primordial surface, and possible identification of remnant tensional features. Studies of remotely sensed data which strongly suggest a modestly homogeneous surface of silicates imply core separation. Reasons for accepting or rejecting various hypotheses for thermal histories of the planet are mentioned.

Leake, M. A.↗
NASA NTRS1981

Heat pipes containing alkali metal working fluid

A technique for improving high temperature evaporation-condensation heat-transfer devices which have important and unique advantage in terrestrial and space energy processing is described. The device is in the form of a heat pipe comprising a sealed container or envelope which contains a capillary wick. The temperature of one end of the heat pipe is raised by the input of heat from an external heat source which is extremely hot and corrosive. A working fluid of a corrosive alkali metal, such as lithium, sodium, or potassium transfers this heat to a heat receiver remote from the heat source. The container and wick are fabricated from a superalloy containing a small percentage of a corrosion inhibiting or gettering element. Lanthanum, scandium, yttrium, thorium, and hafnium are utilized as the alloying metal.

Morris, J. F.↗
NASA NTRS1983

Evaluation of GOES encoder lamps

Aging characteristics and life expectancies of flight quality, tungsten filament, encoder lamps are similar to those of 'commercial' grade gas filled lamps of similar construction, filament material and filament temperature. The aging and final failure by filament burnout are caused by single crystal growth over large portions of the filament with the concomitant development of facets and notches resulting in reduction of cross section and mechanical weakening of the filament. The life expectancy of presently produced lamps is about one year at their nominal operating voltage of five volts dc. At 4.5 volts, it is about two years. These life times are considerably shorter, and the degradation rates of lamp current and light flux are considerably higher, than were observed in the laboratory and in orbit on lamps of the same type manufactured more than a decade ago. It is speculated that the filaments of these earlier lamps contained a crystallization retarding dopant, possibly thorium oxide. To obtain the desired life expectancy of or = to four years in present lamps, operating voltages of or = to four volts dc would be required.

Viehmann, W.↗
NASA NTRS1984

Phenomenology of plasma engine cathodes at high current rates and low pressures

The effects of low surrounding pressures on cathodes of arc jet engines with electromagnetic acceleration are investigated for pressure and current energies of 20 to 100 Torr. and 400 to 1000 A. Experiments with 50 mm long and 8 mm diameter tungsten-thorium cathode in a coaxial gas flow show that pre-heating of the cathode reduces the duration of the instable arc discharge and thus material loss. The use of lighter gases also reduces instability effects, as well as the use of increased pressures and a massive gas influx.

Huegel, H.↗
NASA NTRS1985

Crustal radiogenic heat production and the selective survival of ancient continental crust

It is pointed out that the oldest terrestrial rocks have so far revealed no evidence of the impact phase of Earth evolution. This observation suggests that processes other than impact were dominant at the time of stabilization of these units. However, a use of the oldest terrestrial rocks as a sample of the early terrestrial crust makes it necessary to consider the possibility that these rocks may represent a biased sample. In the present study, the global continental heat flow data set is used to provide further evidence that potassium, uranium, and thorium abundances are, on the average, low in surviving Archean crust relative to younger continental crust. An investigation is conducted of the implications of relatively low crustal radiogenic heat production to the stabilization of early continental crust, and possible Archean crustal stabilization models are discussed.

Morgan, P.↗
NASA NTRS1985

The spectrum of neutrons at 60 hg m(-2)

The rate of neutron interactions was measured for the energy range 7.5 to 60 MeV, using a 3.85 kg cell of liquid scintillator. The neutrons are selected by pulse shape discrimination, with anticoincidence counters used to reduce interference from muons transversing the scintillator. The observed flux is interpreted in terms of neutrons produced from environmental uranium and thorium, those resulting from the capture of negative muons in nuclei and those from fast muon interactions.

Barton, J. C.↗
NASA NTRS1985

Crustal radiogenic heat production and the selective survival of ancient continental crust

It is pointed out that the oldest terrestrial rocks have so far revealed no evidence of the impact phase of earth evolution. This observation suggests that processes other than impact were dominant at the time of stabilization of these units. However, a use of the oldest terrestrial rocks as a sample of the early terrestrial crust makes it necessary to consider the possibility that these rocks may represent a biased sample. In the present study, the global continental heat flow data set is used to provide further evidence that potassium, uranium, and thorium abundances are, on the average, low in surviving Archean crust relative to younger continental crust. An investigation is conducted of the implications of relatively low crustal radiogenic heat production to the stabilization of early continental crust, and possible Archean crustal stabilization models are discussed.

Morgan, P.↗
NASA NTRS1985

Influence of the temperature of electrode material on its disintegration under the action of an arc discharge in hydrogen

An analysis is made of the electrophysical processes occurring at the end surface of rod electrodes during constant and alternating arc discharge in hydrogen. Experiments are reported on the effect of surface temperature of tungsten electrodes on their erosion. The influence of activating additions of thorium oxide, the structure of the tungsten, and the gas surrounding the electrode on the specific thermal loading and the erosion of the electrodes is discussed.

Bolotov, A. V.↗
NASA NTRS1986

The dating of pre-exposure times of lunar rocks and soils

Xenon produced by fission of uranium, thorium and plutonium has repeatedly been observed in lunar rocks and soils. In two basaltic rocks and in two soils Xe was found originating from fission of U-235 induced by neutrons which are due to the interactions of cosmic ray particles with lunar matter. Two facts lead to this conclusion: (1) fission Xe is present in excess of that expected for the U, Th, and Pu concentrations and for the gas retention age of the samples; and (2) the Xe-134/Xe-136 ratio of excess fission Xe is close to 1.25 as expected for neutron induced fission of U-235. Information on the duration of the exposure to cosmic rays was obtained from the Kr-81-Kr systematics whereas the effective shielding conditions were derived from the depth sensitive cosmogenic ratio Xe-131/Xe-126. For the four samples the exposure to cosmic rays in the lunar regolith is described by a two stage exposure model. The history of the four samples was derived in terms of duration and shielding depth of the two stages.

Eugster, O.↗
NASA NTRS1987

Implications of convection in the Moon and the terrestrial planets

The early thermal and chemical evolution of the Moon is discussed. The rubidium-strontium, neodymium-samarium, and uranium-thorium-lead systems were studied. The relation of source region heterogeneity to the mixing associated with mantle convection is considered. Work on the application of fractal concepts to planetary geology and geophysics is also discussed. The fractal concept was applied to fragmentation, including the frequency-size distribution of meteorites, asteroids and particulate matter produced by impacts.

Turcotte, Donald L.↗
NASA NTRS1987

Alpha-decay-induced fracturing in zircon - The transition from the crystalline to the metamict state

Zonation due to alpha-decay damage in a natural single crystal of zircon from Sri Lanka is discussed. The zones vary in thickness on a scale from one to hundreds of microns. The uranium and thorium concentrations vary from zone to zone such that the alpha decay dose is between 0.2 x 10 to the 16th and 0.8 x 10 to the 16th alpha-events per milligram. The transition from the crystalline to the aperiodic metamict state occurs over this dose range. At doses greater than 0.8 x 10 to the 16th alpha events/mg there is no evidence for long-range order. This type of damage will accumulate in actinide-bearing, ceramic nuclear waste forms. The systematic pattern of fractures would occur in crystalline phases that are zoned with respect to actinide radionuclides.

Chakoumakos, Bryan C.↗
NASA NTRS1988

Analysis of a used pair of arcjet electrodes

The anode and cathode of a 30-kW class arcjet engine have been sectioned and analyzed. This arcjet was operated for a total time of 573 hours at power levels between 25 and 30 kW with ammonia at flow rates of 0.25 and 0.27 gm/s. The accumulated run time was sufficient to clearly establish erosion patterns and their causes. The type of electron emission from various parts of the cathode surface was made clear by Scanning Electron Microscope analysis. A Scanning Electron Microscope was used to study recrystallization on the hot anode surface. These electrodes were made of 2 percent thoriated tungsten and the surface thorium content and gradient perpendicular to the surfaces was determined by quantitative microprobe analysis. The results of this material analysis on the electrodes and recommendations for improving electrode operational life time are presented.

Pivirotto, Thomas J.↗