SEARCH · Search NASA

Results for “decelerators”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 127 records · Page 7

All sources NASA NTRS DOE OSTI

NASA NTRSDate not supplied

Aftbody Aeroheating Wind Tunnel Measurements on a Hypersonic Inflatable Aerodynamic Decelerator

The aftbody aeroheating environment of a Hypersonic Inflatable Aerodynamic Decelerator (HIAD) was investigated in the NASA Langley 31-Inch Mach 10 Air Tunnel. The wind tunnel model geometry was representative of the Low-Earth Orbit Flight Test of an Inflatable Decelerator (LOFTID) vehicle. Aeroheating data were obtained for a range of Reynolds numbers and angles-of-attack using global phosphor thermography. Aeroheating data were also obtained using a developmental IR thermography technique for evaluation of data quality.

Elizabeth F Rieken↗

NASA NTRSDate not supplied

Small Satellite-sized Hypersonic Inflatable Aerodynamic Decelerators for Interplanetary Science Missions

To make the most of ridesharing opportunities, small satellite (SmallSat) mission designers endeavor to pack as much payload into a SmallSat-class form factor as possible. The mass and volume constraints of this smaller vehicle class present a challenge for interplanetary mission sets that require a means of achieving orbit insertion at their destination of interest. For a fully propulsive orbit insertion design, this may translate to the propellant mass being a significant fraction of the overall vehicle mass and prolonged insertion time. Aerocapture is a single quick maneuver that can significantly reduce the required propellant mass for orbit insertion. Because aerocapture uses a planet’s atmosphere to achieve the necessary change in velocity, a protective aeroshell is needed. The constraints imposed on secondary payloads render traditional rigid aeroshells mass and space prohibitive for the SmallSat class of vehicles; thus, warranting consideration of deployable designs that can be stowed compactly until needed for atmospheric entry. The Hypersonic Inflatable Aerodynamic Decelerator (HIAD) is a deployable aeroshell that leverages inflatable toroids to achieve the large drag area needed for aerodynamic deceleration. While the technology is currently being analyzed for Mars human-scale missions, it has the potential applicability for interplanetary SmallSat-scale missions as well. This paper highlights a study conducted during an internship at NASA Langley Research Center to investigate the feasibility of using a scaled-down HIAD design in SmallSat aerocapture missions. Several scaling methodologies are investigated including use of parametric models and direct computer-aided design (CAD) model scaling. Candidate HIAD configurations that conform to secondary payload adapter requirements are identified. The Program to Optimize Simulated Trajectories II (POST2) is utilized to conduct orbit insertion performance and trajectory sensitivity studies using the candidate configurations at Earth, Venus, and Mars. The results of the study indicate that multiple SmallSat-sized HIAD designs, targeting a range of SmallSat payload classes, are feasible for planetary aerocapture missions to Mars and Venus as well as Earth-based aerocapture missions.

Shelly C. Mann↗

NASA NTRSDate not supplied

Fiber Optics Sensing System (FOSS) deployment on Low-Earth Orbit Flight Test of an Inflatable Decelerator (LOFTID)

Low-Earth Orbit Flight Test of an Inflatable Decelerator (LOFTID) is a technology demonstration of an inflatable aeroshell to slow down and protect heavy and valuable payloads when entering atmospheres such as those of the Earth and Mars. The ultimate project goal is to enable future payload deliveries to Mars. The LOFTID is based on more than a decade of development of the hypersonic inflatable aerodynamic decelerator (HIAD) technology, which consists of a stack of the inflatable concentric rings that make up the inflatable structure that is covered with a Flexible Thermal Protection System (FTPS) and, when combined, form the inflatable aeroshell. The goal of the LOFTID demonstration was to verify that a flexible heat shield, packed into a small-volume payload, can be inflated exoatmospherically to sizes much larger than that of the launch vehicle fairing and survive re-entry into the Earth atmosphere while withstanding a temperature excess of 1,600 °C. The LOFTID is part of Technology Demonstration Missions (TDM) under the National Aeronautics and Space Administration (NASA) Space Technology Mission Directorate (STMD). The NASA Armstrong Flight Research Center (AFRC) (Edwards, California) is part of the LOFTID program, where a space-launch version of the fiber optic sensing system (FOSS) is integrated into the avionics bay of the re-entry vehicle to provide high-spatial-density temperature measurements in three strategic locations of the vehicle. The program is part of a partnership agreement between the NASA Launch Service Program (LSP) at Kennedy Space Center (KSC) (Merritt Island, Florida) and the main Center of the LOFTID program at NASA Langley Research Center (LaRC) (Hampton, Virginia). This paper will first give a brief introduction of the FOSS, then discuss how the FOSS was integrated into LOFTID, in terms of fiber sensor integration into various sections of the vehicle, as well as integration of the FOSS interrogator into the avionics bay. Finally, data analysis during the LOFTID re-entry will be discussed.

Allen R Parker↗

NASA NTRSDate not supplied

Heritage to Flight; The Test Program that Brought an Inflation System Back to Life for the Low Earth Orbit Flight Test of an Inflatable Decelerator (LOFTID)

Following the success of the Inflatable Reentry Vehicle Experiment-3 (IRVE-3) project, the Terrestrial Hypersonic Inflatable Aerodynamic Decelerator (HIAD) Orbital Reentry (THOR) project was stood up with a “built to print” Inflation System utilizing the IRVE-3 flight spares. When THOR was canceled, this Inflation System had already been tested and assembled, ready for use. Thus, when the Low Earth Orbit Flight Test of an Inflatable Decelerator (LOFTID) was spun up, the THOR system seemed like a good candidate to salvage flight ready hardware. There were, however, some key differences in the IRVE/THOR system and the LOFTID one. LOFTID’s HIAD was two times the size of IRVE for starters and would require much higher flows to accommodate inflating such an article within a specific timeframe. With new requirements and a tight schedule, the LOFTID Inflation team set to work to verify flight readiness under LOFTID conditions and eliminate the need to requalify new hardware. LOFTID, utilizing an Inflation System built primarily hardware from IRVE-3 spares, successfully flew in November of 2022. This paper will outline the mission differences, the test campaign used to prepare LOFTID’s Inflation System for flight, and some lessons learned in repurposing older hardware.

Inflation System↗

NASA NTRSDate not supplied

Development of an Ejectable Data Recorder Ejection Mechanism for the Low Earth Orbit Flight Test of an Inflatable Decelerator

On November 10, 2022, the 1100kg (2,425 lbs.) LOFTID Reentry Vehicle (RV) was launched on a United Launch Alliance Atlas V as a secondary payload with the Joint Polar Surveyor System-2. The 6-meter diameter (~20 ft.) aeroshell (a type of heat shield) entered the atmosphere at 8 kilometers per second (18,000 miles per hour), and flew nominally, enduring the intended heat pulse that saw temperatures exceeding 1371˚C (2500˚F) on the front side while the payload skin remained only about 38˚C (100˚F). The RV exceeded Mach 30 and the heat-affected aeroshell withstood a pressure pulse that exerted 9g’s deceleration maintaining stable flight through the hypersonic, supersonic, transonic, and subsonic regimes to the parachute deployment. As part of the Agency’s strategic goal “to extend human presence deeper into space and to the moon for sustainable long-term exploration and utilization”, the LOFTID inflatable aerodynamic decelerator or aeroshell technology could one day help land humans on Mars. As with any flight test, data collection is of utmost importance. Without a data downlink and a possibility of the RV sinking before the recovery crew got to it, a secondary data collection method was introduced. The RV would eject a data recorder, which would have a duplicate copy of the on-board flight date, before splashdown and be retrieved separately. This paper discusses the development of the ejection mechanism used to eject the data recorder from the RV during the test flight. The development includes discussions of design constraints, a design overview, the testing program, and lessons learned throughout the process all the way through successful data recorder recovery.

mechanism↗

NASA NTRSDate not supplied

Design and Qualification or the Low-Earth Orbit Flight Test of an Inflatable Decelerator(LOFTID) Payload Adapter Separation System (PASS)

On November 10, 2022, NASA and United Launch Alliance (ULA) launched Low-Earth Orbit Flight Test of an Inflatable Decelerator (LOFTID) as a secondary payload on an Atlas V Centaur from Vandenburg Space Force Base (VSFB). After deploying the primary payload, JPSS-2, to a sun-synchronous orbit, the Centaur reoriented LOFTID for reentry, ejecting the Payload Adaptor to expose the stowed LOFTID reentry vehicle (RV). The Hypersonic Inflatable Aerodynamic Decelerator (HIAD) was then deployed and inflated, and the Centaur reoriented the RV to the desired entry attitude, spun the vehicle to roughly three rpm, and separated the reentry vehicle. After nearly half an orbit of free flight, LOFTID reentered the atmosphere at >8 km/sec, demonstrating stable flight from hypersonic entry through subsonic parachute deployment. A mission-unique Payload Adapter Separation System (PASS) enabled the successful LOFTID flight demonstration, allowing the launch vehicle to accommodate a superstack of two independent, similarly sized payloads. This paper discusses the design, development, and qualification of the LOFTID PASS along with lessons learned.

HIAD↗

NASA NTRSDate not supplied

Hypersonic Inflatable Aerodynamic Decelerator Earth-based Applications

Hypersonic Inflatable Aerodynamic Decelerators technology has been developed by NASA to enable challenging entry, descent, and landing missions at various planetary destinations. In the last two decades, HIAD technology has been developed through a series of ground tests and flight tests, culminating in the 2022 Low-Earth Orbit Flight Test of an Inflatable Decelerator flight demonstration of a 6 m diameter vehicle from orbital velocities. Past studies have considered application of HIAD for human-scale missions, especially return from the Moon or human-class missions to Mars. However, recent commercial interest in the HIAD technology following LOFTID’s success shows HIAD applications are possible for cislunar return, Earth aerocapture, return from low Earth orbit, and even launch vehicle component recovery. This paper describes the flight performance range for these new, Earth-based applications.

Soumyo Dutta↗

NASA NTRSDate not supplied