Search NASA⌕ Search

SEARCH · Search NASA

Results for “pump efficiency”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 127 records · Page 7

Optical Detection of Long Electron Spin Transport Lengths in a Monolayer Semiconductor

Using a spatially resolved optical pump-probe experiment, we measure the lateral transport of spin-valley polarized electrons over very long distances (tens of micrometers) in a single WSe 2 monolayer. By locally pumping the Fermi sea of 2D electrons to a high degree of spin-valley polarization (up to 75%) using circularly polarized light, the lateral diffusion of the electron polarization can be mapped out via the photoluminescence induced by a spatially separated and linearly polarized probe laser. In this work, up to 25% spin-valley polarization is observed at pump-probe separations up to 20 μm. Characteristic spin-valley diffusion lengths of 18 ± 3 μm are revealed at low temperatures. The dependence on temperature, pump helicity, pump intensity, and electron density highlight the key roles played by spin relaxation time and pumping efficiency on polarized electron transport in monolayer semiconductors possessing spin-valley locking.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Design study of a laser-cooled infrared sensor

The performance of a solid-state optical refrigerator is the result of a complex interplay of numerous optical and thermal parameters. We present a first preliminary study of an optical cryocooler using ray-tracing techniques. A numerical optimization identified a non-resonant cavity with astigmatism. This geometry offered more efficient pump absorption by the YLF:10%Yb laser-cooling crystal compared to non-resonant cavities without astigmatism that have been pursued experimentally so far. Ray tracing simulations indicate that ~80% of the incident pump light can absorbed for temperatures down to ~100 K. Calculations of heat loads, cooling power, and net payload heat lift are presented. They show that it is possible to cool a payload to a range of 90–100 K while producing a net payload heat lift of 80 mW and 300 mW when pumping a YLF:10%Yb crystal with 20 W and 50 W at 1020 nm, respectively. This performance is suited to cool HgCdTe infrared detectors that are used for sensing in the 8–12 μm atmospheric window. While the detector noise would be ~6× greater at 100 K than at 77 K, the laser refrigerator would introduce no vibrations and thus eliminate sources of microphonic noise that are limiting the performance of current systems.

47 OTHER INSTRUMENTATION↗

Predicted third-order sweet spots for phi-junction Josephson parametric amplifiers

Hybrid superconductor-semiconductor nanowire Josephson junctions exhibit skewed and phi-shifted current phase relations when an in-plane magnetic field is applied along the weak link's spin-orbit effective field direction. These junctions can have an asymmetric Josephson potential with odd-order nonlinearities. A dominant third-order nonlinearity can be achieved by tuning the magnetic field to a sweet spot. Sweet spots persist when higher order Josephson harmonics are included. This makes it possible to have a single Josephson junction dipole element with three-wave mixing capability, which is favorable for pump-efficient amplification. Electrostatic gate tunability of the semiconductor weak link can make it operable within an extended range of working frequencies, and the inclusion of micromagnets can facilitate near-zero magnetic field operation.

Reza, Tasnum [Univ. of Pittsburgh, PA (United Stat↗

Rectangular-bore, high-gain laser plasma tube

Rectangular-bore tube improves population inversion obtained from upper and terminal laser states, resulting in a significant increase in unsaturated gain factor. Radial field produces efficient pumping of upper laser state. Narrow tube dimensions cause increased diffusion flow of neon is metastable states to tube walls.

Mollo, R. A.↗

Fabrication and test of a space power boiler feed electromagnetic pump. Part 1: Design and manufacture of pump

A three-phase helical induction electromagnetic (EM) pump has been designed and built. This pump was designed for use as the boiler-feed pump of a potassium Rankine-cycle space electric power system. The pump is constructed of high temperature materials including a T-111 duct, Hiperco 27 magnetic material, nickel clad silver conductor wire, and a completely inorganic insulation system. The pump is designed to deliver 3.25 lb/sec potassium at 1000 F with a developed head of 240 psi while being cooled by 800 F NaK. At these conditions, the overall pump efficiency is expected to be 18%.

Gahan, J. W.↗

Stark effect applicable to optically pumped far-infrared laser

Absorption measurements at CO2 laser frequencies were carried out as a function of Stark fields and CH3OH gas pressures to assess the effect of low electric field Stark tuning on methanol absorption at the P(12) 9.4 micron CO2 laser line, in a continuing search for coherent emitters at submillimeter wavelengths (far infrared). The line center absorption coefficient is found to increase five-fold with a 2.3 kV/cm Stark field at the 220 mtorr methanol pressure optimal for methanol far infrared lasing. The low electric field Stark tuning encourages efforts to enhance the pumping efficiency of a methanol far infrared laser at its normal optimum operating pressure, and suggests that significant Stark field induced frequency modulation of the far IR laser output is feasible.

Claspy, P. C.↗

Design criteria for FIR waveguide laser cavities

The geometrical design parameters of coherently pumped far infrared waveguide laser cavities are analyzed with respect to minimization of pump power losses. The advantages of highly degenerate cavities and off axis displacement of the injection hole are outlined. Relations between the cavity parameters are given which simplify the design of cavities with high pumping efficiency.

Koepf, G. A.↗

Laser excited fluorescence in the cesium-xenon excimer and the cesium dimer

Argon ion laser lines are used to excite fluorescence in a mixture of cesium and xenon. Excimer band fluorescence is observed at higher pressures (about 1 atm) while at lower pressures (several torr) a diffuse fluorescence due to the cesium dimer is observed whose character changes with exciting wavelength. The excimer fluorescence is shown to be directly related to the location of the exciting wavelength within previously measured Cs/Xe line shapes. This fact suggests that the excimer systems may be efficiently pumped through these line shapes. Qualitative energy-level schemes are proposed to explain the observations in both the excimer and dimer systems.

Exton, R. J.↗

X-ray heating and ionization of broad-line emission regions in QSOs and active galaxies

The absorption of X-rays deep within the broad-line emitting clouds in quasars and the nuclei of active galaxies produces extensive zones of warm (about 10,000 K), partially ionized gas. Because Lyman-alpha photons are trapped in these regions, the X-ray energy is efficiently channeled into Balmer lines collisionally excited from the n = 2 level. These H I regions and the H II regions created by UV photons illuminating the surfaces of the clouds gives rise to integrated Lyman-alpha/H-alpha lines emission ratios between 1 and 2. Enhanced Mg II line emission from the H I regions gives rise to integrated Mg II/H-alpha ratios near 0.5. The O I line at 8446 A is efficiently pumped by trapped H-alpha photons; and an intensity ratio of I(8446 A)/I(H-alpha) of approximately equal to and not greater than 0.1 is calculated for the X-ray heated zone.

Weisheit, J. C.↗

Estimating Pump Blockage

Blockage predicted for all components including inducers, impellers and diffusers. Pump performance predicted by semiempirical method shows excellent agreement with test results in Space Shuttle main-engine highpressure fuel turbopump. Comparisons of pump efficiency show equally good agreement of calculated values with experimental ones. Method improves current estimation methods based solely on subjective engineering judgment.

Chung, W.↗

Losses in fountain-effect pumps

Three loss mechanisms in fountain-effect pumps are identified and analyzed. Two of these mechanisms reduce the mechano-caloric effect, by reducing the mass transferred per unit heat input. The first loss mechanism of these losses is the result of normal fluid leakage through the pump. The second loss mechanism is the result of the finite separation between the porous plug and the heater. The third loss mechanism reduces the thermomechanical effect. It results from the Gorter-Mellink interaction within the porous plug. All three of these loss mechanisms are shown to reduce pump efficiency. They are then applied to an example to illustrate the relative significance of the three mechanisms.

Kittel, P.↗

Pumping the stellar hydroxyl maser

IRAS far-IR flux data for 163 OH maser stars were analyzed to quantify the contributions 35 and 53 microns inversions make to pumping of the hydroxyl maser. The 35 microns transition is from the 3,3 ground state to the 1,5 rotationally excited level and subsequent decay; the 53 microns transition is a change from the ground state to the 1,3 excited level and relaxation. The stars examined included Mira, short period semi-regular and long-period semi-regular variables. Both transition lines had rough parity in contributing to the approximately 8 percent pumping efficiency at 1612 MHz. However, the individual contributions of the lines could not be determined for the stellar population studied.

Dickinson, Dale F.↗

OH megamasers in high-luminosity IRAS galaxies

OH megamaser emission and H I and CO profiles from the distant infrared galaxies IRAS 10173 + 0828, III Zw 035, and Zw 475.056 are reported. The OH isotropic luminosities at 1667 MHz are 463, 534, and 6.6 solar luminosities, respectively. Far-infrared pumping efficiencies of the OH greater than 1 percent are found in IRAS 10173 + 0828 and III Zw 035. These two galaxies show anomalously large 1667/1665 MHz emission line ratios. OH megamasers reside in the nuclei of superluminous far-infrared galaxies that have a high content of molecular gas, high efficiency of star formation, and in some instances, a striking deficiency of atomic hydrogen.

Mirabel, I. F.↗

Computational analysis of the flowfield of a two-dimensional ejector nozzle

A time-iterative full Navier-Stokes code, PARC, is used to analyze the flowfield of a two-dimensional ejector nozzle system. A parametric study was performed for two controlling parameters, duct to nozzle area ratio and nozzle pressure ratio. Results show that there is an optimum area ratio for the efficient pumping of secondary flow. At high area ratios, a freestream flow passes directly through the mixing duct without giving adequate pumping. At low area ratios, the jet boundary blocks the incoming flow. The nozzle pressure ratio variation shows that the pumping rate increases as the pressure ratio increases, provided there is no interaction between the shroud wall and the shock cell structure.

Choi, Y. H.↗

Computational analysis of the flowfield of a two-dimensional ejector nozzle

A time-iterative full Navier-Stokes code, PARC, is used to analyze the flowfield of a two-dimensional ejector nozzle system. A parametric study was performed for two controlling parameters, duct to nozzle area ratio and nozzle pressure ratio. Results show that there is an optimum area ratio for the efficient pumping of secondary flow. At high area ratios, a freestream flow passes directly through the mixing duct without giving adequate pumping. At low area ratios, the jet boundary blocks the incoming flow. The nozzle pressure ratio variation shows that the pumping rate increases as the pressure ratio increases, provided there is no interaction between the shroud wall and the shock cell structure.

Choi, Y. H.↗

Pseudomorphic Single-Quantum-Well Lasers Emit At 980 Nm

Narrow-stripe semiconductor lasers emitting at 980 nm include pseudomorphic In0.2Ga0.8As/GaAs/AlxGa1-xAs graded-index-of-refraction, separate-confinement-heterostructure single quantum well(GRINSCH SQW) with overlaid ridge waveguide. 980 nm chosen as one that yields most efficient pumping because there is no absorption in excited states at this wavelength. Suitable for pumping Er(Sup3+)-doped optical-fiber amplifiers in optical-fiber communication systems and optical phased-array ranging systems.

Larsson, Anders↗

Propulsion systems using in situ propellants for a Mars ascent vehicle

The indigenous propellants of oxygen and carbon monoxide were studied for use in a Mars Ascent Vehicle (MAV). Both the oxygen and carbon monoxide were evaluated as turbine working fluids for a full expander engine cycle used in the MAV. Two oxygen working fluid engines and four carbon monoxide engines were investigated. The maximum hot-gas-side wall temperature was limited to either 445 K (800 R) or 556 K (1000 R) over a range of working fluid mass flows. An engine thrust of 44.5 kN (1,000 lb(sub f)) was assumed. The engine characteristics of coolant inlet pressure, total engine length, specific impulse, pump efficiencies, and turbine power required were optimized. Of the six engines evaluated, the study showed that either type of working fluid was feasible for a MAV engine. Using carbon monoxide as the working fluid resulted in the best engine characteristics.

Wadel, Mary F.↗

Propulsion systems using in situ propellants for a Mars Ascent Vehicle

The indigenous propellants of oxygen and carbon monoxide were studied for use in a Mars Ascent Vehicle (MAV). Both the oxygen and carbon monoxide were evaluated as turbine working fluids for a full expander engine cycle used in the MAV. Two oxygen working fluid engines and four carbon monoxide engines were investigated. The maximum hot-gas-side wall temperature was limited to either 445 K (800R) or 556 K (1000 R) over a range of working fluid mass flows. An engine thrust of 44.5 kN (1,000 lb(sub f)) was assumed. The engine characteristics of coolant inlet pressure, total engine length, specific impulse, pump efficiencies, and turbine power required were optimized. Of the six engines evaluated, the study showed that either type of working fluid was feasible for a MAV engine. Using carbon monoxide as the working fluid resulted in the best engine characteristics.

Wadel, Mary F.↗