Search NASA⌕ Search

SEARCH · Search NASA

Results for “Floating”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,315 records · Page 73
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

On the inversion of block tridiagonals without storage constraints

A strategy was developed to permit trade-offs between the number of floating point operations required and the storage requirements for the solution of certain difference problems, such as block tridiagonal systems of equations. This is done by recomputing some intermediate results instead of storing them. Reducing the storage to the square root of the current requirement roughly doubles the number of computations. Reducing the storage more than this tends to make the number of computations prohibitively large. In theory, if m is the order of each sub-matrix in the block tridiagonal matrix, one can solve any linear system with only 5m(2) + 1 temporary storage cells. In many cases m is a constant and quite small. For example, in solving a factored form of the three-dimensional Navier-Stokes equations, the size m of the block tridiagonals is 5. This method lends itself to efficient use on computers with parallel processing or vector processing architectures. On these computers the larger number of floating point operations is more than offset by the decrease in I/O and the increased percentage of vector operations made possible by this algorithm.

Merriam, M. L.↗
NASA NTRS1981

Material and processing needs for silicon solar cells in space

The technical concerns of NASA in the area of space grade solar cells are summarized. Solar power needs are projected through 1987. The degradation of solar cell performance due to the effects of radiation on impurities and crystal defects and the improved performance of float zone silicon are illustrated. The reduction of oxygen and carbon in float zone silicon allows for much faster low temperature annealing of the defects. The effects of improved crystal purity on cell performance are summarized.

Brandhorst, H. W., Jr.↗
NASA NTRS1982

Space Shuttle solid rocket booster dewatering system

After the launch of the Space Shuttle, the two solid rocket boosters (SRB's) are jettisoned into the ocean where they float in a spar (vertical) mode. It is cost effective to recover the SRB's. A remote controlled submersible vehicle has been developed to aid in their recovery. The vehicle is launched from a support ship, maneuvered to the SRB, then taken to depth and guided into the rocket nozzle. It then dewaters the SRB, using compressed air from the ship, and seals the nozzle. When dewatered, the SRB floats in a log (horizontal) mode and can be towed to port for reuse. The design of the remote controlled vehicle and its propulsion system is presented.

Fishel, K. R.↗
NASA NTRS1983

Vibration isolation and pressure compensation apparatus for sensitive instrumentation

A system for attenuating the inherent vibration associated with a mechanical refrigeration unit employed to cryogenically cool sensitive instruments used in measuring chemical constituents of the atmosphere is described. A modular system including an instrument housing and a reaction bracket with a refrigerator unit floated there between comprise the instrumentation system. A pair of evacuated bellows that "float' refrigerator unit and provide pressure compensation at all levels of pressure from seal level to the vacuum of space. Vibration isolators and when needed provide additional vibration damping for the refrigerator unit. A flexible thermal strap (20 K) serves to provide essentially vibration free thermal contact between cold tip of the refrigerator unit and the instrument component mounted on the IDL mount. Another flexible strap (77 K) serves to provide vibration free thermal contact between the TDL mount thermal shroud and a thermal shroud disposed about the thermal shaft.

Averill, R. D.↗
NASA NTRS1984

A real-time, portable, microcomputer-based jet engine simulator

Modern piloted flight simulators require detailed models of many aircraft components, such as the airframe, propulsion system, flight deck controls and instrumentation, as well as motion drive and visual display systems. The amount of computing power necessary to implement these systems can exceed that offered by dedicated mainframe computers. One approach to this problem is through the use of distributed computing, where parts of the simulation are assigned to computing subsystems, such as microcomputers. One such subsystem, such as microcomputers. One such subsystem, a real-time, portable, microcomputer-based jet engine simulator, is described in this paper. The simulator will be used at the NASA Ames Vertical Motion Simulator facility to perform calculations previously done on the facility's mainframe computer. The mainframe will continue to do all other system calculations and will interface to the engine simulator through analog I/0. The engine simulator hardware includes a 16-bit microcomputer and floating-point coprocessor. There is an 8 channel analog input board and an 8 channel analog output board. A model of a small turboshaft engine/control is coded in floating-point FORTRAN. The FORTRAN code and a data monitoring program run under the control of an assembly language real-time executive. The monitoring program allows the user to isplay and/or modify simulator variables on-line through a data terminal. A dual disk drive system is used for mass storage of programs and data. The CP/M-86 operating system provides file management and overall system control. The frame time for the simulator is 30 milliseconds, which includes all analog I/0 operations.

Blech, R. A.↗
NASA NTRS1984

Predictability of the Earth's polar motion

A comprehensive, experimental study of the predictability of the polar motion using a homogeneous BIH (Bureau International de l'Heure) data set is presented. Based on knowledge of the physics of the annual and the Chandler wobbles, the numerical model for the polar motion is constructed by allowing the wobble periods to vary. Using an optimum base length of 6 years for prediction, this floating-period model, equipped with a non-linear least-squares estimator, is found to yield polar motion predictions accurate from 0.012 to 0.024 inches depending on the prediction length up to one year, corresponding to a predictability of 91-83%. This represents a considerable improvement over the conventional fixed-period predictor, which does not respond to variations in the apparent wobble periods. The superiority of the floating-period predictor to other predictors based on critically different numerical models is also demonstrated.

Chao, B. F.↗
NASA NTRS1984

DSS 13 Microprocessor Antenna Controller

A microprocessor based antenna controller system developed as part of the unattended station project for DSS 13 is described. Both the hardware and software top level designs are presented and the major problems encounted are discussed. Developments useful to related projects include a JPL standard 15 line interface using a single board computer, a general purpose parser, a fast floating point to ASCII conversion technique, and experience gained in using off board floating point processors with the 8080 CPU.

Gosline, R. M.↗
NASA NTRS1984

Research in the design of high-performance reconfigurable systems

An initial design for the Bit Processor (BP) referred to in prior reports as the Processing Element or PE has been completed. Eight BP's, together with their supporting random-access memory, a 64 k x 9 ROM to perform addition, routing logic, and some additional logic, constitute the components of a single stage. An initial stage design is given. Stages may be combined to perform high-speed fixed or floating point arithmetic. Stages can be configured into a range of arithmetic modules that includes bit-serial one or two-dimensional arrays; one or two dimensional arrays fixed or floating point processors; and specialized uniprocessors, such as long-word arithmetic units. One to eight BP's represent a likely initial chip level. The Stage would then correspond to a first-level pluggable module. As both this project and VLSI CAD/CAM progress, however, it is expected that the chip level would migrate upward to the stage and, perhaps, ultimately the box level. The BP RAM, consisting of two banks, holds only operands and indices. Programs are at the box (high-level function) and system level. At the system level initial effort has been concentrated on specifying the tools needed to evaluate design alternatives.

Slotnick, D. L.↗
NASA NTRS1984

Reel Down - A balloon borne winch system for stratospheric sounding from above

A balloon-borne winch system has been developed and flight tested which permits the repetitive lowering and hoisting of a stratospheric sampling payload for distances of up to 20 km from a float altitude of 35-40 km. This new approach to in situ stratospheric measurements permits multiple scans of various depths and velocities, closely spaced over a period of hours or days, thus dramatically increasing observational effectiveness. The motor driven winch permits control of ascent velocities from 0-9 m/s with energy derived from a large battery; for descent, the motors are used as generators, velocity is controlled over the same range, and the energy is dumped radiatively to space. The 1.75 mm diameter tether is of braided Kevlar construction with a nylon jacket; it exhibits a 2900 N break strength. Both the winch and the payload suspended by the tether are fully instrumented to evaluate potentially destructive system-induced dynamics and the effects of stratospheric wind shears. The system was successfully flight tested by lowering a 62 kg payload for a distance of 12 km from a float altitude of 38.5 km and hoisting it back up again, both at velocities ranging between 5-9 m/s. Observations indicated minimal system-induced dynamical effects, and no adverse effects due to the 8 m/s wind shear present during flight.

Hazen, N. L.↗
NASA NTRS1984

Plasma sheath structure surrounding a large powered spacecraft

Various factors determining the floating potential of a highly biased (about 4-kV) spacecraft in low earth orbit are discussed. While the common rule of thumb (90 percent negative; 10 percent positive) is usually a good guide, different biasing and grounding patterns can lead to high positive potentials. The NASCAP/LEO code can be used to predict spacecraft floating potential for complex three-dimensional spacecraft.

Mandell, M. J.↗
NASA NTRS1984

Atmospheric Modeling And Sensor Simulation (AMASS) study

The capabilities of the atmospheric modeling and sensor simulation (AMASS) system were studied in order to enhance them. This system is used in processing atmospheric measurements which are utilized in the evaluation of sensor performance, conducting design-concept simulation studies, and also in the modeling of the physical and dynamical nature of atmospheric processes. The study tasks proposed in order to both enhance the AMASS system utilization and to integrate the AMASS system with other existing equipment to facilitate the analysis of data for modeling and image processing are enumerated. The following array processors were evaluated for anticipated effectiveness and/or improvements in throughput by attachment of the device to the P-e: (1) Floating Point Systems AP-120B; (2) Floating Point Systems 5000; (3) CSP, Inc. MAP-400; (4) Analogic AP500; (5) Numerix MARS-432; and (6) Star Technologies, Inc. ST-100.

Parker, K. G.↗
NASA NTRS1984

Formal verification of mathematical software

Methods are investigated for formally specifying and verifying the correctness of mathematical software (software which uses floating point numbers and arithmetic). Previous work in the field was reviewed. A new model of floating point arithmetic called the asymptotic paradigm was developed and formalized. Two different conceptual approaches to program verification, the classical Verification Condition approach and the more recently developed Programming Logic approach, were adapted to use the asymptotic paradigm. These approaches were then used to verify several programs; the programs chosen were simplified versions of actual mathematical software.

Sutherland, D.↗
NASA NTRS1984

High-purity silicon crystal growth

Crystal growth parameter effects on minority carrier lifetime and solar cell efficiencies were investigated using high purity techniques such as float zoning. Study objectives include the following: (1) optimize dopants and minority carrier lifetime in FZ material for high efficiency silicon solar cell applications; (2) improve the understanding of lifetime degradation mechanisms (point defects, impurities, thermal history, surface effects, etc.), and (3) crystallographic defect characterization of float zone and ribbon crystals via X-ray topography.

Ciszek, T.↗
NASA NTRS1985

Hardware math for the 6502 microprocessor

A floating-point arithmetic unit is described which is being used in the Ground Facility of Large Space Structures Control Verification (GF/LSSCV). The experiment uses two complete inertial measurement units and a set of three gimbal torquers in a closed loop to control the structural vibrations in a flexible test article (beam). A 6502 (8-bit) microprocessor controls four AMD 9511A floating-point arithmetic units to do all the computation in 20 milliseconds.

Kissel, R.↗
NASA NTRS1985

On the factorization of block-tridiagonals without storage constraints

In many programs solving difference equations, problem size is restricted by the number of available memory cells. A strategy has been developed to permit trade-offs between the number of floating point operations required and storage requirements for the solution of certain problems such as block tridiagonal systems of equations. This is done by recomputing some intermediate results instead of storing them. Reducing the storage to the square root of the current requirement will roughly double the number of computations. In theory, if m is the order of each sub-matrix in the block tridiagonal matrix, one can solve any linear system with only 5 sq m + 1 temporary storage cells. This method lends itself to efficient use on computers with parallel processing or vector processing architectures. On these computers the larger number of floating point operations is more than offset by the decrease in I/O and the increased percentage of vector operations made possible by this algorithm.

Merriam, M. L.↗
NASA NTRS1983

Deposition of silicon nitride from SiCl4 and NH3 in a low pressure RF plasma

Silicon nitride coatings were deposited in a low-pressure (1-10 Torr) RF plasma from SiCl4 and NH3 in the presence of argon onto stainless martensitic steel grounded and floating substrates at 300 C and 440 C respectively. The heating of the substrates depends mainly on the position and the induced RF power. The coatings were identified as silicon nitride by X-ray investigation and were found to contain chlorine by energy-dispersive analysis of X-rays. The growth rate, the microhardness and the chlorine concentration of the coatings were determined as a function of the total gas pressure, the RF power input and the NH3-to-SiCl4 ratio. It was observed that the coatings on the floating substrates have higher deposition rates and are of superior quality.

Ron, Y.↗
NASA NTRS1986

MOSFET Power Controller

High current and voltage controlled remotely. Remote Power Conroller includes two series-connected banks of parallel-connected MOSFET's to withstand high current and voltage. Voltage sharing between switch banks, low-impedance, gate-drive circuits used. Provided controlled range for turn on. Individually trimmable to insure simultaneous switching within few nanoseconds during both turn on and turn off. Control circuit for each switch bank and over-current trip circuit float independently and supplied power via transformer T1 from inverter. Control of floating stages by optocouplers.

Mitchell, J.↗
NASA NTRS1985

Thermocapillary Flows and Their Stability: Effects of Surface Layers and Contamination

The objective is to study quantitatively thermocapillary flows in two-dimensional and axisymmetric geometries in order to learn the impact of such flows on float-zone refining configurations. The work begins with the analytical study of steady flows in slots and zones to obtain predictions of surface curvature, flow and heat transport. It then examines the instability of such flows. Three new instability mechanisms have been identified and the results show that thermocapillary flows of high Prandtl number fluid become convectively unstable while those of low Prandtl number fluid become hydrodynamically unstable. The work includes numerical simulations of steady, high Marangoni number flows in unit aspect ratio boxes and asymptotic solutions in large boxes. Furthermore, the effect of surface contamination on the steady thermocapillary flows was examined. This fundamental study focused on fluid dynamical systems used to understand events in the flow of melts in float-zone geometries both on Earth and in microgravity environments.

Davis, S. H.↗