Search NASA⌕ Search

SEARCH · Search NASA

Results for “Inlets”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,315 records · Page 73
All sourcesNASA NTRSDOE OSTI
NASA NTRS1971

Flight investigation of airframe installation effects on an auxiliary inlet ejector nozzle on an underwing engine nacelle

The local flow field approaching an installed nozzle may vary from isolated test conditions, thereby affecting exhausting nozzle performance. An installation of general interest is a podded engine mounted near the aft lower surface of the wing. The effect of this installation on the performance of an auxiliary inlet ejector nozzle was investigated over a Mach number range of 0.7 to 1.3 by using a modified F-106B aircraft. Both floating and fixed-open door configurations were examined. The ejector nozzle trailing-edge flaps were simulated in the closed position with rigid structure which provided a boattail angle of 15 deg. Primary nozzle area was varied as exhaust gas temperature was varied between 982.2 and 2003.3 K.

Burley, R. R.↗
NASA NTRS1972

High-capacity compact vortex valve for increasing stability of supersonic mixed-compression inlets

A special vortex valve was developed for increasing the stability margin of supersonic jet-engine inlets without the use of moving mechanical parts. A compact valve with high flow capacity and with high gain was obtained by using a unique outer wall in the vortex chamber instead of the usual cylindrical shape. The physical features of the valve are described, and the steady pressure-flow characteristics measured on scale models are given. Procedures are provided for adjusting the operating pressure, flow capacity, and gain through systematic changes in geometry.

Gebben, V. D.↗
NASA NTRS1972

Dynamic flow angle measurements at the diffuser exit of a Mach 2.5 mixed compression inlet

An exploratory investigation was made to determine the magnitude of the dynamic flow angle at a single point in the diffuser exit of a Mach 2.50 inlet. Results indicate that the maximum flow angle variation was + or - 3 degrees except when vortex generators were installed in the subsonic diffuser. The amplitude of these flow angle fluctuations was directly related to the amplitude of the total pressure fluctuations at the probe survey point. Flow angle fluctuations as high as + or - 11 degrees were recorded when vortex generators were installed near the probe survey point.

Prati, W. M.↗
NASA NTRS1972

Performance of a bicone inlet designed for Mach 2.5 with internal distributed compression and 40 percent internal contraction

The inlet was designed to have the minimum internal contraction consistent with high total-pressure recovery and low cowl drag. Without a bypass system, the peak pressure recoveries increased from 0.890 to 0.936 when the supercritical bleed mass flow ratio was varied from 0.035 to 0.060. With an operating bypass system and installed centerbody vortex generators, a slight increase in peak pressure recovery was obtained. The values of steady-state distortion and dynamic distortion were below 0.10 and 0.02, respectively, near critical operation. Simulation of a turbofan engine with concentric pipes showed no effect on compressor face flow profiles with varying bypass flow ratio.

Wasserbauer, J. F.↗
NASA NTRS1972

Identification of boiler inlet transfer functions and estimation of system parameters

An iterative computer method is described for identifying boiler transfer functions using frequency response data. An objective penalized performance measure and a nonlinear minimization technique are used to cause the locus of points generated by a transfer function to resemble the locus of points obtained from frequency response measurements. Different transfer functions can be tried until a satisfactory empirical transfer function of the system is found. To illustrate the method, some examples and some results from a study of a set of data consisting of measurements of the inlet impedance of a single tube forced flow boiler with inserts are given.

Miles, J. H.↗