Search NASA⌕ Search

SEARCH · Search NASA

Results for “Positioning System”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,315 records · Page 73

High-resolution observation of the Venus dayglow spectrum 1250-1430 angstroms

The spectrum of the dayglow of Venus between 1250 and 1430 A was measured in high resolution with the International Ultraviolet Explorer. Seven exposures which were made with the short wavelength camera in the high dispersion mode using the large aperture were combined to give a total exposure time of 309 min. The atomic oxygen lines at 1302.2, 1304.9, 1306.0, and 1355.6 A are present. In addition, the (14,3) and (14,4) bands of the carbon monoxide fourth positive system at 1317 and 1354 A respectively are identified. These bands are compared with synthetic spectra, showing the excitation mechanism to be fluorescent scattering of solar Lyman alpha radiation.

Lane, A. L.↗

Civil Application of Differential GPS Using a Single Channel Sequential Receiver

The Global Positioning System (GPS) and its potential for area navigation, landing, and takeoff under minimum ceilings and advanced air traffic control operation is discussed. The following topics are reported: status of the GPS system; GPS signal availability for the civil community; alternative differential GPS concepts; predicted performance enhancement achievable with differential GPS and the operational improvements which will result; and a development program to test and evaluate differential GPS concepts, performance and operational procedures applicable to helicopters. Potential benefits which will be derived from helicopter use of GPS in the differential mode are identified.

Source record↗

The application of NAVSTAR Differential GPS to civil helicopter operations

Principles concerning the operation of the NAVSTAR Global Positioning Systems (GPS) are discussed. Selective availability issues concerning NAVSTAR GPS and differential GPS concepts are analyzed. Civil support and market potential for differential GPS are outlined. It is concluded that differential GPS provides a variation on the baseline GPS system, and gives an assured, uninterrupted level of accuracy for the civilian community.

Beser, J.↗

REFSAT/GPS breadboard: Test terminal hardware design report

All users of the NAVSTAR Global Positioning System (GPS) located within a rather large geographical area are currently required to perform a number of identical, common operations in order to accomplish a navigation "fix" (additional "location dependent" operations are also required). Under the REFSAT concept, the common operations are performed at a central location and results broadcast via a geostationary reference satellite (REFSAT). This concept allows a considerable reduction in the cost and complexity of individual civil user terminals. The hardware design of a REFSAT/GPS receiver terminal and the REFSAT transmitter simulator is described. Since six of the Phase 1 NAVSTAR GPS satellites are now operational a demonstration test plan utilizing the one-to-two hour per day viewing window is also described. Equipment check-out preliminary test results are presented.

Source record↗

A comparative analysis of GPS range, Doppler and interferometric observations for geodetic positioning

Geodetic positioning accuracies obtained from range, integrated Doppler and double differenced interferometric phase observations from a constellation of twenty-four Global Positioning System satellites are presented. It is demonstrated the GPS range and Doppler observations will provide sufficient accuracy for the estimation of geodetic coordinates. However the instability of the receiver atomic oscillator will limit the usefulness of these observations in providing rapid first-order baseline determination. Interferometric phase measurements twice differenced to eliminate clock error appear as an alternate procedure for providing such accuracies.

Fell, P. J.↗

Precise time dissemination via portable atomic clocks

The most precise operational method of time dissemination over long distances presently available to the Precise Time and Time Interval (PTTI) community of users is by means of portable atomic clocks. The Global Positioning System (GPS), the latest system showing promise of replacing portable clocks for global PTTI dissemination, was evaluated. Although GPS has the technical capability of providing superior world-wide dissemination, the question of present cost and future accessibility may require a continued reliance on portable clocks for a number of years. For these reasons a study of portable clock operations as they are carried out today was made. The portable clock system that was utilized by the U.S. Naval Observatory (NAVOBSY) in the global synchronization of clocks over the past 17 years is described and the concepts on which it is based are explained. Some of its capabilities and limitations are also discussed.

Putkovich, K.↗

Design approach for a microprocessor-based GPS time transfer receiver

The design concept and characteristics of a self-contained microprocessor-based Global Positioning System time transfer receiver is described. A prototype of this unit is currently in the test phase. It employs two-bit digital baseband correlation rather than analog IF correlation of the signals with the reference code. The correlator, numerically controlled oscillators and code generator are implemented in a special-purpose digital signal processor. The time is recovered in the digital code tracking loop, and final corrections are applied in the control processor. Other features of this design are: (1) drift-free digital mechanization; (2) high reliability of digital circuits; (3) flexible control capability of the microprocessor; and (4) potential for a high degree of digital VLSI chip development leading to compact, low-cost units.

Ould, P. C.↗

Long term frequency stability analysis of the GPS NAVSTAR 6 Cesium clock

Time domain measurements, taken between the NAVSTAR 6 Spacecraft Vehicle (SV) and the Vandenberg Global Positioning System (GPS) Monitor Site, by a pseudo random noise receiver, were collected over an extended period of time and analyzed to estimate the long term frequency stability of the NAVSTAR 6 onboard frequency standard, referenced to the Vandenberg MS frequency standard. The technique employed separates the clock offset from the composite signal by first applying corrections for equipment delays, ionospheric delay, tropospheric delay, Earth rotation and the relativistic effect. The data are edited and smoothed using the predicted SV ephemeris to calculate the geometric delay. Then all available passes from each of the four GPS monitor stations, are collected at 1-week intervals and used to calculate the NAVSTAR orbital elements. The procedure is then completed by subtracting the corrections and the geometric delay, using the final orbital elements, from the composite signal, thus leaving the clock offset and random error.

Mccaskill, T. B.↗

Unprecented syntonization and syncronization accuracy via simultaneous viewing with GPS receivers: Construction characteristics of an NBS/GPS receiver

The National Bureau of Standards/Global Positioning System (NBS/GPS) receiver is discussed. It is designed around the concept of obtaining high accuracy, low cost time and frequency comparisons between remote frequency standards and clocks with the intent to aid international time and frequency coordination. Preliminary tests of this comparison technique between Boulder, CO and Washington, D.C indicate the ability to do accurate time transfer to better that 10 ns, and frequency measurements to better than 1 part in 10 to the 14th power. The hardware and software of the receiver is detailed. The receiver is fully automatic with a built-in 0.1 ns resolution time interval counter. A microprocessor does data processing. Satellite signal stabilities are routinely at the 5 ns level for 15 s averages, and the internal receiver stabilities are at the 1 ns level.

Davis, D. D.↗

Crustal dynamics project session 4 validation and intercomparison experiments 1979-1980 report

As part of the Crustal Dynamics Project, an experiment was performed to verify the ability of Satellite Laser Ranging (SLR), Very Long Baseline interferometry (VLBI) and Doppler Satellite Positioning System (Doppler) techniques to estimate the baseline distances between several locations. The Goddard Space Flight Center (GSFC) lasers were in operation at all five sites available to them. The ten baselines involved were analyzed using monthly orbits and various methods of selecting data. The standard deviation of the monthly SLR baseline lengths was at the 7 cm level. The GSFC VLBI (Mark III) data was obtained during three separate experiments. November 1979 at Haystack and Owens Valley, and April and July 1980 at Haystack, Owens Valley, and Fort Davis. Repeatability of the VLBI in determining baseline lengths was calculated to be at the 2 cm level. Jet Propulsion Laboratory (JPL) VLBI (Mark II) data was acquired on the Owens Valley to Goldstone baseline on ten occasions between August 1979 and November 1980. The repeatability of these baseline length determinations was calculated to be at the 5 cm level. National Geodetic Survey (NGS) Doppler data was acquired at all five sites in January 1980. Repeatability of the Doppler determined baseline lengths results were calculated at approximately 30 cm. An intercomparison between baseline distances and associated parameters was made utilizing SLR, VLBI, and Doppler results on all available baselines. The VLBI and SLR length determinations were compared on four baselines with a resultant mean difference of -1 cm and a maximum difference of 12 cm. The SLR and Doppler length determinations were compared on ten baselines with a resultant mean difference of about 30 cm and a maximum difference of about 60 cm. The VLBI and Doppler lengths from seven baselines showed a resultant mean difference of about 30 cm and maximum difference of about 1 meter. The intercomparison of baseline orientation parameters were consistent with past analysis.

Liebrecht, P.↗

LANDSAT-D flight segment operations manual, volume 2

Functions, performance capabilities, modes of operation, constraints, redundancy, commands, and telemetry are described for the thematic mapper; the global positioning system; the direct access S-band; the multispectral scanner; the payload correction; the thermal control subsystem; the solar array retention, deployment, and jettison assembly; and the boom antenna retention, deployment, and jettison assembly for LANDSAT 4.

Varhola, J.↗

A Covariance Analysis for the Determination of Baseline Observing GPS Satellites

Results of covariance analyses are presented for the determination of baseline vectors of length from 150 m to 4000 km. The data are doubly differenced ranges derived from the signals transmitted by the satellites of the Global Positioning System. The modeling of various error sources is described. The results indicate the low cost baseline determination system is capable of subdecimeter accuracy for baselines up to 1000 km in length.

Wu, S. C.↗

Test results of the STI GPS time transfer receiver

Global time transfer, or synchronization, between a user clock and USNO UTC time can be performed using the Global Positioning System (GPS), and commercially available time transfer receivers. This paper presents the test results of time transfer using the GPS system and a Stanford Telecommunications, Inc. (STI) Time Transfer System (TTS) Model 502. Tests at the GPS Master Control Site (MCS) in Vandenburg, California and at the United States Naval Observatory (USNO) in Washington, D.C. are described. An overview of GPS, and the STI TTS 502 is presented. A discussion of the time transfer process and test concepts is included.

Hall, D. L.↗

One nanosecond time synchronization using series and GPS

Subnanosecond time sychronization between two remote rubidium frequency standards is verified by a traveling clock comparison. Using a novel, code ignorant Global Positioning System (GPS) receiver developed at JPL, the SERIES geodetic baseline measurement system is applied to establish the offset between the 1 Hz. outputs of the remote standards. Results of the two intercomparison experiments to date are presented as well as experimental details.

Buennagel, A. A.↗

Landsat-D, about to be reality

The space and ground segments of the Landsat-D thematic mapper (TM) for remote sensing of a 185 km swath with 30 m resolution are described. Scanning the full earth once every 16 days from its 705 km sunsynchronous orbit, Landsat-D will relay its data on the ku-band through the TDRSS satellite to a ground station. The X-band will also be used to transmit data directly to foreign and domestic ground stations; the S-band will be reserved for MSS data only. Landsat-D comprises the multimission modular spacecraft and the instrument module, which features the MSS and TM, a wideband communication subsystem, a solar array, and an L-band global positioning system. Three computers on the ground provide a high degree of automation for reception, storage, retrieval, back-up, and transmission of data and commands. Additionally, a van is equipped with transportable equipment, including an antenna. Procedures followed for image generation from the MSS and TM are detailed, noting storage at Goddard until dispersal of tapes under the direction of the EROS data center.

Aepli, T. C.↗

Calibrating for Ionospheric Phase Delays

Technique determines ionospheric phase delay on real-time universally applicable basis in terms of electrons per meter squared by coherently modulating two L-band carrier frequencies received from two Global Positioning System satelites. Two pseudorandom number sequences cross-correlated to derive delay time.

Macdoran, P. F.↗

First Results of GPS Time Transfer to Australia

A global positioning system (GPS) time transfer unit was installed at Tidbinbilla Deep Space Communications Complex of the DSN in June 1983. It was used to estimate the relationship to UTC(USNO MC) of the Tidbinbilla frequency and time system TID(FTS) based on a hydrogen maser, and to estimate the performance of the Australian free-running time scale UTC(AUS). Data from the first 3 months were analyzed three ways: by two-hop common view using JPL as intermediary; by long-arc interpolation of measurements against space vehicle clocks; and by long arc interpolation of GPS-Time results. Residuals from a single quadratic fit through 3 months of UTC(USNO MC) -TID(FTS) results were white noise with standard error 15 ns, and a flying clock measurement gave 70 ns agreement. A straight line fit through results UTC(USNO MC) - UTC(AUS) gave 90 ns standard error and 120 ns agreement. It is proposed to use the GPS measurements to steer UTC(AUS) to UTC(BIH), and to rename the existing time scale TA(AUS).

Mck.luck, J.↗