Search NASA⌕ Search

SEARCH · Search NASA

Results for “AVIATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,369 records · Page 76

Performance and noise of a low pressure ratio variable pitch fan designed for general aviation applications

A limited study has been conducted to establish the performance and noise characteristics of a low design tip speed (168 m/s, 550 ft/sec) low pressure ratio (1.04) variable pitch fan which was tested in the Langley 30 X 60 tunnel. This fan was designed for minimum noise when installed in the tail mount location of a twin engine aircraft which normally has both nose and tail mounted propulsors. Measurements showed the fan noise to be very close to predictions made during the design of the fan and extremely low in level (65 dBA at 1000 ft) with no acoustic treatment. This is about 8 dB lower than the unshrouded 2 blade propeller normally used in this installation. On the basis of tests conducted during this program, it appears that this level could be further reduced by 2 dBA if optimized acoustic treatments were installed in the fan duct. Even the best of the shrouded propellers tested previously were 7 dB higher in level than the Q-Fan without acoustic treatment. It was found that the cruise performance of this fan was within 5% of the predicted efficiency of 72%. Evaluation of the performance data indicated that disturbances in the inflow to the fan were the probable cause of the reduced performance.

Metzger, F. B.↗

Aviation noise overload in the immediate proximity of the Warsaw-Okecie airport

The results are presented for investigations on noise overload around the Warszawa-Okecie airport on persons inhabiting the area where it exceeds 100 dB for a single aircraft flight. Of 256 subjects, 91.1 percent complained about aircraft noise overload. In the population studied considerable differences were noted respecting the subjective sensitivity scale. Statistical analysis showed numerous correlations between the individual noise sensitivity threshold and the subject's state of health, age, sex, type of work, etc. At the same time investigations demonstrated various forms and levels of disturbance in the organism for individual subjects and groups. The most frequent complaint was chronic fatigue (68.1 percent), followed by nervousness (36.6 percent), frequent headaches (36.2 percent), hearing disturbances (30.0 percent) and sleep disorders (23.9 percent).

Koszarny, Z.↗

Forecast of future aviation fuels: The model

A conceptual models of the commercial air transportation industry is developed which can be used to predict trends in economics, demand, and consumption. The methodology is based on digraph theory, which considers the interaction of variables and propagation of changes. Air transportation economics are treated by examination of major variables, their relationships, historic trends, and calculation of regression coefficients. A description of the modeling technique and a compilation of historic airline industry statistics used to determine interaction coefficients are included. Results of model validations show negligible difference between actual and projected values over the twenty-eight year period of 1959 to 1976. A limited application of the method presents forecasts of air tranportation industry demand, growth, revenue, costs, and fuel consumption to 2020 for two scenarios of future economic growth and energy consumption.

Ayati, M. B.↗

A status report on NASA general aviation stall/spin flight testing

The NASA Langley Research Center has undertaken a comprehensive program involving spin tunnel, static and rotary balance wind tunnel, full-scale wind tunnel, free flight radio control model, flight simulation, and full-scale testing. Work underway includes aerodynamic definition of various configurations at high angles of attack, testing of stall and spin prevention concepts, definition of spin and spin recovery characteristics, and development of test techniques and emergency spin recovery systems. This paper presents some interesting results to date for the first aircraft (low-wing, single-engine) in the program, in the areas of tail design, wing leading edge design, mass distribution, center of gravity location, and small airframe changes, with associated pilot observations. The design philosophy of the spin recovery parachute system is discussed in addition to test techniques.

Patton, J. M., Jr.↗

Microbursts as an aviation wind shear hazard

The downburst-related accidents or near-misses of jet aircraft have been occurring at the rate of once or twice a year since 1975. A microburst with its field comparable to the length of runways can induce a wind shear which endangers landing or liftoff aircraft; the latest near miss landing of a 727 aircraft at Atlanta, Ga. in 1979 indicated that some microbursts are too small to trigger the warning device of the anemometer network at major U.S. airports. The nature of microbursts and their possible detection by Doppler radar are discussed, along with proposed studies of small-scale microbursts.

Fujita, T. T.↗

Icing tunnel tests of a glycol-exuding porous leading edge ice protection system on a general aviation airfoil

Tests were conducted in the Icing Research Tunnel at the NASA Lewis Research Center to determine the characteristics of an ice protection system that distributes a glycol solution onto the leading edge of an airfoil through a porous surface material. Minimum fluid flow rates required to achieve anti-icing (no ice formation) were determined for various flight conditions and angles of attack. The ability of the system to remove ice formed on the airfoil before system activation was also investigated.

Kohlman, D. L.↗

Core noise measurements from a small, general aviation turbofan engine

As part of a program to investigate combustor and other core noises, simultaneous measurements of internal fluctuating pressure and far field noise were made with a JT15D turbofan engine. Acoustic waveguide probes, located in the engine at the combustor, at the turbine exit and in the core nozzle wall, were used to measure internal fluctuating pressures. Low frequency acoustic power determined at the core nozzle exit corresponds in level to the far-field acoustic power at engine speeds below 65% of maximum, the approach condition. At engine speeds above 65% of maximum, the jet noise dominates in the far-field, greatly exceeding that of the core. From coherence measurements, it is shown that the combustor is the dominant source of the low frequency core noise. The results obtained from the JT15D engine were compared with those obtained previously from a YF102 engine, both engines having reverse flow annular combustors and being in the same size class.

Reshotko, M.↗

Summary of high-lift and control surface research on NASA general aviation airfoils

Summary findings and bibliographical information are presented for airfoil and airfoil-related research conducted at Wichita State University during the past decade. Topics include flap, aileron, and spoiler design data for new airfoils, extensive flow measurements, modifications to older airfoils, new symmetrical sections and contributions to analytical methods for cases with partial separation.

Wentz, W. H., Jr.↗

A general aviation simulator evaluation of a rate-enhanced instrument landing system display

A piloted-simulation study was conducted to evaluate the effect on instrument landing system tracking performance of integrating localizer-error rate with raw localizer and glide-slope error. The display was named the pseudocommand tracking indicator (PCTI) because it provides an indication of the change of heading required to track the localizer center line. Eight instrument-rated pilots each flew five instrument approaches with the PCTI and five instrument approaches with a conventional course deviation indicator. The results show good overall pilot acceptance of the display, a significant improvement in localizer tracking error, and no significant changes in glide-slope tracking error or pilot workload.

Hinton, D. A.↗

Cabin Noise Control for Twin Engine General Aviation Aircraft

An analytical model based on modal analysis was developed to predict the noise transmission into a twin-engine light aircraft. The model was applied to optimize the interior noise to an A-weighted level of 85 dBA. To achieve the required noise attenuation, add-on treatments in the form of honeycomb panels, damping tapes, acoustic blankets, septum barriers and limp trim panels were added to the existing structure. The added weight of the noise control treatment is about 1.1 percent of the total gross take-off weight of the aircraft.

Vaicaitis, R.↗

Simulator study of a pictorial display for general aviation instrument flight

A simulation study of a computer drawn pictorial display involved a flight task that included an en route segment, terminal area maneuvering, a final approach, a missed approach, and a hold. The pictorial display consists of the drawing of boxes which either move along the desired path or are fixed at designated way points. Two boxes may be shown at all times, one related to the active way point and the other related to the standby way point. Ground tracks and vertical profiles of the flights, time histories of the final approach, and comments were obtained from time pilots. The results demonstrate the accuracy and consistency with which the segments of the flight are executed. The pilots found that the display is easy to learn and to use; that it provides good situation awareness, and that it could improve the safety of flight. The small size of the display, the lack of numerical information on pitch, roll, and heading angles, and the lack of definition of the boundaries of the conventional glide slope and localizer areas were criticized.

Adams, J. J.↗

Meteorological impact on aviation fuel efficiency

The connection between fuel consumption and weather data is discussed. Fuel efficient flights creating adequate near real time weather information are examined. The lack of highly resolved real time and near real time wind and temperature data at flight altitudes is investigated. The existing systems, which is based on twice a day balloon observations, supplemented by pilot reports or other occasional data, is not adequate for optimum flight planning. The impacts of upper winds and temperatures on fuel efficiency and flight planning are not widely appreciated and developing new weather products are considered.

Winer, D. E.↗

A Loran-C prototype navigation receiver for general aviation

The design, fabrication and evaluation of a prototype Loran-C receiver is described. Hardware, and microcomputer programming for addition of area navigation capability are reported. The receiver is an envelope processor, offering simplicity of RF processor circuitry.

Lilley, R. W.↗

Effects of wing-leading-edge modifications on a full-scale, low-wing general aviation airplane: Wind-tunnel investigation of high-angle-of-attack aerodynamic characteristics

Wing-leading-edge modifications included leading-edge droop and slat configurations having full-span, partial-span, or segmented arrangements. Other devices included wing-chord extensions, fences, and leading-edge stall strips. Good correlation was apparent between the results of wind-tunnel data and the results of flight tests, on the basis of autorotational stability criterion, for a wide range of wing-leading-edge modifications.

Newsom, W. A., Jr.↗

Flight-test verification of a pictorial display for general aviation instrument approach

Results of flight tests of the pictorial "follow me" box display results of the simulator study. The most important item of agreement was the frequency of the vertical and lateral models of motion of the pilot-aircraft-display system, which was 0.4 rad/sec in each study. Successful short, curved, descending approaches, such as are often suggested for use with microwave landing systems, can be executed with the "follow me" box display. Variations of the value of distance from the aircraft to the box were also examined using values of 736 m, 368 m, and 184 m. The results show that successful approaches can be made with all of these values. A sharper final turn and greater precision of position control are obtained with the shorter distance. Deletion of distance measuring equipment from the system was also studies. It was shown that successful approaches can be made with no distance measures included in the system, but the values of distance from the aircraft to the box that can be used are restricted.

Adams, J. J.↗

A research program to reduce interior noise in general aviation airplanes. Influence of depressurization and damping material on the noise reduction characteristics of flat and curved stiffened panels

Some 20 x 20 aluminum panels were studied in a frequency range from 20 Hz to 5000 Hz. The noise sources used were a swept sine wave generator and a random noise generator. The effect of noise source was found to be negligible. Increasing the pressure differential across the panel gave better noise reduction below the fundamental resonance frequency due to an increase in stiffness. The largest increase occurred in the first 1 psi pressure differential. The curved, stiffened panel exhibited similar behavior, but with a lower increase of low frequency noise reduction. Depressurization on these panels resulted in decreased noise reduction at higher frequencies. The effect of damping tapes on the overall noise reduction values of the test specimens was small away from the resonance frequency. In the mass-law region, a slight and proportional improvement in noise reduction was observed by adding damping material. Adding sound absorbtion material to a panel with damping material beneficially increased noise reduction at high frequencies.

Navaneethan, R.↗